• Aerospace Engineering and Technology
• /
• v.3 no.2
• /
• pp.229-237
• /
• 2004

In this paper, the design method and algorithms of the signal processor for a multipurpose radar system are analyzed. The signal processor, operating at the two modes-collision avoidance mode and weather mode, has 4 steps of ADC, NCI, STC, CFAR. Several algorithms of NCI and CFAR are analyzed and the optimal design is proposed to the system. CVI and CMLD algorithm have good performance in decreasing the false alarm rate and increasing detection probability, Regarding processor computational capacity, K=12 for CVI, M=16~20, Ko=M-4 for CMLD is suggested. CVI processing needs much time, two or more processors need to be allocated to CVI. So, for the system with four processors, two processors should be allocated to VID of NCI with ADC input and CFAR with STC, and two processors are should be allocated to CVI.

• The Bulletin of The Korean Astronomical Society
• /
• v.37 no.1
• /
• pp.65.1-65.1
• /
• 2012

MIRIS (Multipurpose Infra-Red Imaging System) is the first Korean Infrared Space Telescope developed by KASI (Korea Astronomy and Space Science Institute), and is the main payload of STSAT-3 (Science and Technology Satellite-3). The FM (fight model) of MIRIS has been recently completed, and various performance tests have been made to measure system parameters such as readout noise, system gain, linearity, and dark current. Final thermal-vacumm test of the MIRIS and the vibration test of the electronics box have been performed. Band response tests showed good agreement with the initial design requirements. No significant dark difference was measured within the expected temperature variation range during observation in orbit. Using Pa-alpha band from a uniform source, the readout noise and system gain were measured by mean variance test. To obtain uniform flat image, flat fielding tests were made for each band, and the data will be compared to that obtained in orbit for calibration. The final version of MIRIS FM will be delivered in March, and it will be integrated into the satellite system for the AIT (Assembly Integration, Test) procedure. The launch of MIRIS is expected in November 2012.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.5 no.1
• /
• pp.91-100
• /
• 1985

This study is on the gate operation of dams, which are for the hydropower and multipurpose in Han River Basin, considering the safety under the emergency. The results of the study on the safety of dams in Han River Basin associated with the gate operation of dams against the design flood flow and the combined inflow are as follows; 1) The empirical formula (1) can be used for gate operation with the informations of reservoir's water level and the inflow. 2) The applicability of the multiple regression formula (2) among the gate opening area, inflow, water level, and outflow is assured. 3) From the safety analysis of dams for the emergency by the procedures developed in this study, six dams are safe except Soyanggang, Euiam, and Cheongpyung Dam, but the above three dams can be safe with the lowering of the starting water level of gate opening by the pre-discharges.

• The Bulletin of The Korean Astronomical Society
• /
• v.35 no.2
• /
• pp.56.1-56.1
• /
• 2010

MIRIS(Multipurpose InfraRed Imaging System)는 과학기술위성 3호의 주 탑재체로서 2011년 발사예정인 다목적 적외선 카메라 시스템이다. MIRIS는 우주관측 카메라와 지구관측 카메라로 구성되어 있으며, 우주관측 카메라는 $0.9-2.0{\mu}m$ 영역에서 3.67 deg. x 3.67 deg. FOV로 우리 은하평면 survey 관측과 우주배경복사(CIB) 관측을 수행할 것이다. 현재 MIRIS는 비행모델 개발 마무리 단계에 있으며, 검교정 시험, 열-진공 시험, 진동 시험 등을 수행하고 나면 2010년 말 위성 본체와의 조립을 진행할 것이다. 우주관측 카메라는 궤도상에서 태양, 지구의 적외선 복사와 망원경과 검출기 주변에서 발생하는 열잡음을 줄이기 위해 냉각이 필요하며, 제한된 위성의 무게와 부피, 전력등의 요구조건들 때문에 망원경 및 구조체의 복사냉각(Passive Cooling) 방법을 선택하였다. Passive cooling으로 우주관측 카메라의 망원경이 200K 이하로 냉각되면, dewar에 설치된 소형 냉각기를 가동하여 적외선 센서를 80K로 냉각한다. 위성체 내벽과 우주관측카메라의 각 구조체들 사이의 복사를 차단하기위해 30층의 MLI를 적용 하였고, 각 구조체들간의 열전도를 최소화하기위해 GFRP supporter를 적용하였다. 이 실험은 천문(연)에서 자체 제작한 열-진공 챔버를 활용하여 진행하였으며, 이미 인증모델에 대한 passive cooling 실험을 두 차례 실시하였고, 그 실험 결과를 반영하여 최종 비행모델에 대한 실험을 수행하였으며, 그 실험 결과에 대해 논의 하고자 한다.

• Journal of Technologic Dentistry
• /
• v.33 no.4
• /
• pp.271-281
• /
• 2011

Purpose: The aim of this study is to investigate the changes in hardness and microstructure of a dental multipurpose alloy after simulated complete firing with controlled cooling rate and holding time by characterizing the changes in hardness and microstructure after simulated firing with various cooling rates and holding times. Methods: Before hardness testing, the specimens were solution treated and then were rapidly quenched into ice brine. The specimens were completely fired in furnace. Hardness measurements were made using a Vickers microhardness tester. The specimens were examined at 15 kV using a field emission scanning electron microscope. Results: The maximum hardness value was obtained at stage 0 after simulated firing with various cooling rates (quick cooling, stage 0, stage 1, stage 2, stage 3). By the repetitive firing, the hardness of the tested alloy decreased gradually. By holding the specimen at $500^{\circ}C$ for 10-20min after simulated firing, the hardness increased apparently. However, to hold the alloy for long periods of time in the relatively high temperature after simulated firing resulted in the formation of thick oxidation layer. The oxide film formed on the surface of the alloy after simulated complete firing with controlled cooling rate, which was mainly composed of O and Zn. Conclusion: It is reasonable to hold the alloy at $500^{\circ}C$ for 10-20min after complete firing in other to improve the final hardness of the alloy.

• Journal of Environmental Science International
• /
• v.25 no.9
• /
• pp.1253-1267
• /
• 2016

After large-scale flooding damage occurred along the Imjin river in 1996, 1998, and 1999, the Hantan river flood control dam was planned, and it has since been under construction. Unlike existing dams in Korea, the Hantan river flood control dam will remain fully open except during high floods, when the dam will store flood water temporarily to reduce flood peaks and flood water volume downstream. During past flooding seasons, floating debris has caused difficulties in the management of large-scale dams. Most of the existing multipurpose dams in Korea have installed nets to collect floating debris based on many years of experience with and data about inflow and distribution of floating debris in the dams. For the Hantan river flood control dam, however, collection of data about inflow and distribution of floating debris is not possible as the dam is located near the border area between North and South Korea. In order to devise a preliminary plan to collect floating debris in the Hantan river flood control dam, an EFDC hydrodynamic model was used to analyze the behavior of floating debris during high floods. The Lagrangian particle tracking method was utilized to simulate the behavior of floating debris in the dam. Based on the analysis of paths and final destinations of the particles, seven collection points were selected where it seemed to be effective to collect floating debris, as debris is likely to accumulate there in high density.

• Journal of the Korean housing association
• /
• v.27 no.5
• /
• pp.55-63
• /
• 2016

This study intended to establish a direction for the revitalization of youth culture centers by examining the current status of youth centers operated in Daejeon and how they have been used. Four youth centers in Daejeon were visited and a survey was conducted targeting 180 people using the centers. Frequency, Mean, and ${\chi}^2$ analysis were performed by using SPSS statistics package, and major research outcomes are as follows; There were 6 youth culture centers in Daejeon and showed a lower construction rate of 7.4% on the basis of 81 up, myun and dong. Most youth centers were small, around $300-500m^2$ in total floor area, and accommodated 100-200 people, and the space comprised multipurpose hall, cafeteria, open space, club space, multimedia space, information service room, and guide booth. There were no sports spaces among the target facilities. So, it has created the need for physical activity space to promote health & development. Most users visited centers with their friends and simply to use the facilities, and the satisfaction with the facilities was relatively high at 4.32. The role of the local community and financial support of the government is required to activate the youth culture. Also, for the role of youth culture center, it was suggested that the youth culture center should develop program which corresponds with the level of the youth and boast the interest of the youth.

• Journal of the Korean Society of Safety
• /
• v.32 no.2
• /
• pp.52-58
• /
• 2017

One of the most important elements of the management of chemical accident is threat zone estimation of fires, explosions and toxic gas dispersion based on chemical releases. The threat zone estimation is going to be standard of emergency response for the first defender and base line data of off-site risk assesment (hereinafter referred to as "ORA") and risk management plan (hereinafter referred to as "RMP"). Generally, ALOHA form EPA(U.S.) and Kora(from KOREA MINISTRY OF ENVIRONMENT) has been used for the off-site consequence analysis in Korea. However it is hard to predict accurate consequences rapidly in case of emergency. Hydrochloric acid is a multipurpose raw material used in many industrial applications such as chemical, metal and food industries. It is usually treated in concentrations from 10 ~ 35 %, and release accident have occurred frequently. In this study, we have developed a simplified estimating method and equation to calculate threat zone easily in case of emergency due to release accident of hydrochloric acid.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.10 no.3
• /
• pp.115-126
• /
• 1990

In the past, seawall and sea dike very higher than sea-water elevation had been constructed mainly to prevent the wave overtopping volume. However, the coastal zone is recently developed for the multipurpose of not only preventing from the coastal disaster but conserving the coastal environment and utilizing the coastal space. In this sense, this paper deals with the artificial reef being able to reduce the overtopping volume. Relations of the overtopping volume to the breaking wave are briefly reviewed theoretically, and fundamental factor affecting it are also obtained experimentally form the artificial reef with the irregular waves, In addition, the numerical simulation is developed to investigate the effects of spectral band width for the overtopping volume. The most effective artificial reef section to reduce the overtopping volume is proposed.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.36 no.3
• /
• pp.407-416
• /
• 2016

The purpose of this study is to develop regional regression models to estimate mean low flow for ungauged basins. The unregulated streamflow data observed at 12 multipurpose dams and 4 irrigation dams were analyzed for determining mean low flows. Various types of regression models were developed using the relationship between mean low flows and various sets of watershed characteristics such as drainage area, average slope, drainage density, mean annual precipitation, runoff curve number. The performance of each regression model for estimating mean low flows was assessed by comparison with the results obtained from the observed data. It was found that a regional regression model explained by drainage area, the mean annual precipitation, and runoff curve number showed the best performance. The regression model presented in this study also gives better estimates of mean low flow than the estimates by the drainage-area ratio method and the previous regression model.