• Journal of the Korean Society of Visualization
• /
• v.16 no.2
• /
• pp.16-22
• /
• 2018

This study investigates dynamic wetting behaviors of a water droplet placed on surfaces with different wettability and nano-structures. Hydrophobic and hydrophilic properties on as-received silicon wafers were prepared by fabricating thin films of hydrophobic polymer and hydrophilic nanoparticles via layer-by-layer coating. Dynamic advancing contact angle of droplets on the prepared surfaces was measured at various moving velocities of triple contact line with a high-speed video camera. As advancing velocity of triple contact line increased, dynamic advancing contact angle on the as-received silicon and hydrophobic surfaces sharply increased up to $80^{\circ}$ in the range of order of mm/sec whereas the SiO2 nanoparticle-coated hydrophilic surface maintained low contact angles of about $30^{\circ}$ and then it gradually increased in the velocity range of order of hundred mm/sec. The improved dynamic wetting ability observed on the nanostructured hydrophilic surface can benefit the performance of various phase-change heat transfer phenomena under forced convective flow.

• Economic and Environmental Geology
• /
• v.16 no.4
• /
• pp.269-276
• /
• 1983

This paper describes three-dimensional (3-D) standard curves for single prismatic buried bodies in induced polarization (IP) method. Dipole-dipole IP responses for the bodies are calculated by the numerical modeling technique using an integral equation solution. The pattern of IP responses for conductive targets depends on the ratio of the width of body to the depth extent. The IP response of a body of six units in strike length approximates that of a two-dimensional body. In addition, if the strike length is long enough, a layered-earth interpretation is applicable for a body much longer than four units in width. Moving an IP line away from the center of a body alon gstrike produces an effect similar to that of increasing the depth. Moving the location of body along line has little effect to the pattern of IP responses.

• International Journal of Fuzzy Logic and Intelligent Systems
• /
• v.10 no.1
• /
• pp.25-30
• /
• 2010

This paper is proposed about three axis motion control camera design method based on wires. Original motion control camera consists of track, boom, L-Head, Camera and so on and is enormous and expensive. But proposed motion control camera adjusts wire length using encoders and motors. And position control use position based straight line of straight-line move method for moving precise position. Proposed simple design is able to use various place and inexpensive than original motion control camera. But, camera was vibrated and rotated due to basic property of wire. So we proposed solutions that connected method of wire and using a tensional object for reducing rotation. For proposed algorithm verification, we realized three axis motion control camera based on wire and measured oscillation while moving same trace. We confirmed the results that standard deviation of oscillation was reduced 4.93 degree than before design method.

• Journal of The Korea Institute of Healthcare Architecture
• /
• v.10 no.1
• /
• pp.47-57
• /
• 2004

Recently the elderly care facilities have increased according to the increase in the needs of the elderly care. However architectural studies of elderly facilities still leave much to be desired. The results of this thesis are as follows 1) There are three types of residential unit for elderly care facility such as the linear-type, and loop-type, the hall-type. 2) In the elderly care facilities, staffs' affairs are not separated distinctively, instead all of them join the service for the elders. 3) Since both case being easy and being difficult to find a way for elders are decided by the type of the building, space organization should be planned to be recognized the way for elders and organized straightly with joint area between buildings. This study analyzes the effects of the movement and the moving line of elders and staffs for the estimation of each residential space unit. The purpose of this study is to propose residential space organization of the elderly care facilities.

• Journal of Korea Multimedia Society
• /
• v.24 no.9
• /
• pp.1251-1260
• /
• 2021

This paper discusses missing data processing using simple moving average (SMA) and kalman filter. Also SMA and kalman predictive value are made a comparative study. Time series analysis is a generally method to deals with time series data in photovoltaic field. Photovoltaic system records data irregularly whenever the power value changes. Irregularly recorded data must be transferred into a consistent format to get accurate results. Missing data results from the process having same intervals. For the reason, it was imputed using SMA and kalman filter. The kalman filter has better performance to observed data than SMA. SMA graph is stepped line graph and kalman filter graph is a smoothing line graph. MAPE of SMA prediction is 0.00737%, MAPE of kalman prediction is 0.00078%. But time complexity of SMA is O(N) and time complexity of kalman filter is O(D²) about D-dimensional object. Accordingly we suggest that you pick the best way considering computational power.

• Journal of The Korean Astronomical Society
• /
• v.35 no.4
• /
• pp.175-185
• /
• 2002

Almost half of primeval galaxies show P-Cygni type profiles in the Ly$\alpha$ emission line. The main underlying mechanism for the profile formation in these systems is thought to be the frequency re-distribution of the line photons in expanding scattering media surrounding the emission source. A Monte Carlo code is developed to investigate the Ly$\alpha$ line transfer in an optically thick and moving medium with a careful consideration of the scattering in the damping wings. Typical column densities and expansion velocities of neutral hydrogen investigated in this study are $N_{H1}{\~}10^{17-20}\;cm^{-2}$ and ${\Delta}V{\~} 100 km\;s^{-1}$. We investigate the dependence of the emergent profiles on the kinematics and on the column density. Our numerical results are applied to show that the damped Ly$\alpha$ absorbers may possess an expanding H I supershell with bulk flow of ${\~}200 km\;s^{-l}$ and H I column density $N_{H1}{\~}10^{19}\;cm^{-2}$. We briefly discuss the observational implications.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.4 no.2
• /
• pp.103-111
• /
• 2000

The objectives of the study are to know the strain distribution and modal dynamic behaviour of steel bridge girders by actual traffic load. The live load effect depends on many parameters including the span length, gross vehicle weight, axle weight, axle configuration so on. For the estimation of static and dynamic characteristic, strain data caused by moving loads and traffic characteristics of passing vehicle under actual traffic load have measured using Bridge Weigh in Motion. To confirm the reliability of BWIM system, strain data measured using the $120{\Omega}$ strain gauge under the same condition. It is considered that the data acquired from BWIM system have reliability through the analysis and comparison between stress measured by strain data from BWIM and computed by FEM. Additionally according to the measured strain data of up-line and down-line on the highway, the up-line bridge grows more faster than the down-line bridge and girder 4 and 5 carry more load when vehicles pass the inner line and girder 2 and 3 does when vehicles pass the outer line as this case(the bridge composed with 5 girders).

• Journal of the Ergonomics Society of Korea
• /
• v.29 no.4
• /
• pp.495-503
• /
• 2010

The packing and sorting processes of grape are required repetitive movements to need considerable physical load for a long time. And thereby, there is strong possibility to cause musculoskeletal disorders. In this study, ergonomically designed convenience equipments of worktable and handcart are introduced for improvement of the working movements and less physical load to increase the work efficiency. For objective analysis of the movements and the workload between the ones before and after the improvement, we measured heart rate, OWAS, RULA, REBA, LMM, moving Line and work time. Also, we used a checklist of physical fatigue regions to confirm the subjective evaluation of physical load of workers. As the result of study, it showed lower heart rate, value of Working Postures (OWAS, RULA, REBA) and LMM in the work after introduction of those convenient equipments than the work of before the introduction. The work time and moving Line were shortened and the number of grape boxes packed within the same work time was increased, too. Also the overall load as the subjective evaluation was reduced.

• Journal of Institute of Control, Robotics and Systems
• /
• v.7 no.1
• /
• pp.1155-1161
• /
• 2001

We propose an adaptive nonlinear control algorithm for high precision tracking and stabilization of LOS(Line-of-Sight). The friction parameters of the LOS gimbal are estimated by off-line evolutionary strategy and the friction is compensated by estimated friction compensator. Especially, as the nonlinear control input in a small tracking error zone is enlarged by the nonlinear function, the steady state error is significantly reduced. The proposed algorithm is a direct adaptive control method based on the Lyapunov stability theory, and its convergence is guaranteed under the limited modeling error or torque disturbance. The performance of the pro-posed algorithm is verified by computer simulation on the LOS gimbal model of a moving vehicle.

• Journal of The Korean Astronomical Society
• /
• v.36 no.spc1
• /
• pp.49-54
• /
• 2003

We introduce the two-dimensional spectral observations of solar flares using the Solar Tower Tele-scope of Nanjing University, China. In particular, we introduce three typical events and the methods used to analyze the data. (1) The flare of November 11, 1998, which is a limb flare. We derive the temperature and density within the flaring loop using non-LTE calculations. The results show that the loop top may be hotter and denser than other parts of the loop, which may be a result of magnetic reconnect ion above the loop. (2) The flare of March 10, 2001, which is a white-light flare that shows an emission enhancement at the near infrared continuum. We propose a model of non-thermal electron beam heating plus backwarming to interpret the observations. (3) The flare of September 29, 2002, which shows unusual line asymmetries at one flare kernel. The line asymmetries are caused by an upward moving plasma that is accelerated and heated during the flare development.