• Proceedings of the KIEE Conference
• /
• 1992.07a
• /
• pp.279-281
• /
• 1992

In this paper, an LQG/LTR procedure for stable nonminimum phase systems is suggested using predictor scheme. In the method, the performance of the target feedback loop can be easily adjusted and the recovery error is less dependent on the location of NMP zeros than previous methods. The gain and phase margin and the robust ness for modeluncertainty of the suggested control system are obtained.

• Language and Information
• /
• v.11 no.1
• /
• pp.39-52
• /
• 2007

Noun phrase coordination is an extremely productive phenomenon. Based on an observation that conjuncts tend to denote semantically related concepts, we collect four hundred thousand pairs of conjuncts from the British National Corpus, in an attempt to build an is-a hierarchy of English noun concepts. The modifiedness patterns of the two words in these pairs point to three distinct semantic relations: sibling, cousin, and ancestor-or-ancestor' sibling. The process of finding them and how these pairs are used to motivate groups of quasi-synonyms and then to locate the hypernyms are discussed.

• Journal of Astronomy and Space Sciences
• /
• v.27 no.2
• /
• pp.153-160
• /
• 2010

We modified the optical system of 500 mm wide-field telescope of which point spread function showed an irregularity. The telescope has been operated for Near Earth Space Survey (NESS) located at Siding Spring Observatory (SSO) in Australia, and the optical system was brought back to Korea in January 2008. After performing a numerical simulation with the tested value of surface figure error of the primary mirror using optical design program, we found that the surface figure error of the mirror should be fabricated less than root mean square (RMS) $\lambda$/10 in order to obtain a stellar full width at half maximum (FWHM) below $28\;{\mu}m$. However, we started to figure the mirror for the target value of RMS $\lambda$/20, because system surface figure error would be increased by the error induced by the optical axis adjustment, mirror cell installation, and others. The radius of curvature of the primary mirror was 1,946 mm after the correction. Its measured surface figure error was less than RMS $\lambda$/20 on the table of polishing machine, and RMS $\lambda$/15 after installation in the primary mirror cell. A test observation performed at Daeduk Observatory at Korea Astronomy and Space Science Institute by utilizing the exiting mount, and resulted in $39.8\;{\mu}m$ of stellar FWHM. It was larger than the value from numerical simulation, and showed wing-shaped stellar image. It turned out that the measured-curvature of the secondary mirror, 1,820 mm, was not the same as the designed one, 1,795.977 mm. We fabricated the secondary mirror to the designed value, and finally obtained a stellar FWHM of $27\;{\mu}m$ after re-installation of the optical system into SSO NESS Observatory in Australia.

• Journal of Biosystems Engineering
• /
• v.24 no.4
• /
• pp.293-300
• /
• 1999

The objectives of this study were to analyze the load acting on the transmission when tractor performed rotary operations in the poorly drained paddy fields and to compare its severeness with those obtained under different operational conditions. The loads were measured at the input shaft of the transmission and the load spectrum was constructed using the rain-flow cycle counting method. The severeness of the loads was represented by the partial damage sum which was determined by suing the modified Miner's rule. In the field with a shallow hardpan PTO speed affected severeness of the rotary operations greater than the forward speed did. In the field with deep hardpan, on the other hand, the effect of the forward speed was greater. the severeness in the well drained fields did not differ significantly from that in the field with a shallow hardpan. The severest load was recorded in the field with a deep hardpan.

• Steel and Composite Structures
• /
• v.29 no.3
• /
• pp.319-332
• /
• 2018

This paper investigates the free vibration of geometrically imperfect functionally graded car-bon nanotube-reinforced composite (FG-CNTRC) beams that are integrated with two sur-face-bonded piezoelectric layers and subjected to a combined action of a uniform temperature rise, a constant actuator voltage and an in-plane force. The material properties of FG-CNTRCs are assumed to be temperature-dependent and vary continuously across the thick-ness. A generic imperfection function is employed to simulate various possible imperfections with different shapes and locations in the beam. The governing equations that account for the influence of initial geometric imperfection are derived based on the first-order shear deformation theory. The postbuckling configurations of FG-CNTRC hybrid beams are determined by the differential quadrature method combined with the modified Newton-Raphson technique, after which the fundamental frequencies of hybrid beams in the postbuckled state are obtained by a standard eigenvalue algorithm. The effects of CNT distribution pattern and volume fraction, geometric imperfection, thermo-electro-mechanical load, as well as boundary condition are examined in detail through parametric studies. The results show that the fundamental frequency of an imperfect beam is higher than that of its perfect counterpart. The influence of geometric imperfection tends to be much more pronounced around the critical buckling temperature.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.14 no.6
• /
• pp.1487-1494
• /
• 1990

In this paper the dynamic characteristics of self acting air lubricated slider bearing of hard disk/head system are investigated. The dynamic equations of magnetic head mechanism considering both parallel and pitch motion and the time dependent modified Reynolds equation are analyzed and the dynamic pressure distribution of air film is numerically calculated in frequency domain by small perturbation method and finite difference scheme with variable grid. The dynamic response of the slider spacing is obtained accordingly as the moving recording surface vibrates in parallel mode.

• Tribology and Lubricants
• /
• v.25 no.1
• /
• pp.20-24
• /
• 2009

TiC-derived carbon coatings have been synthesized at $600^{\circ}C$ temperature treatment with $H_2/Cl_2$ mixture gases. From Raman spectroscopy measurements, the modified layer was covered with carbon and the thick-ness of the layer was increased with increasing reaction time. And $I_D/I_G$ ratio was decreased with increasing reaction time. The superior tribological property was obtained from TiC reacted with $Cl_2$ gas for 2 hrs. And the tribological property measurements indicate that TiC-derived carbon layer has $0.9{\times}10_{-6}mm^3/Nm$ in wear coefficient and 0.13 in friction coefficient.

• Journal of Korean Academy of Nursing
• /
• v.23 no.4
• /
• pp.617-630
• /
• 1993

Factors related to health promotion activities and quality of life in Korean women with arthritis have not been clearly identified. Predictors of health promotion might be identified that will enhance the well - being of this group. Accordingly, the findings of the study will contribute additional information about the relationship between health promotion and quality of life and will add to the research on quality of life of individuals with a leading cause of disability--arthritis. The purpose of the study was to examine the relationship of selected background factors (years of illness, perceived severity of illness, uncertainty in illness), perceived self- efficacy, and health promoting behaviors to the quality of life of Korean women with arthritis. A cross - sectional descriptive design was used in this study to investigate relationships among the variables of interest. The sample was composed of 96 women who had arhtrits and visited large university hospital in Seoul for regular check up or pre-scription of medication. The purpose of a descriptive correlational design was to determine the absence or presence of relationships among variables that were measurable (Polit & Hungler, 1981, p.147). The design of this study was appropriate because it yielded answers to the research questions and hypotheses regarding the relationships among the model variables. the Questionnaire contained demographic information, translated Mishel Uncertainty in illness Scale-Community form (MUIS-C) (Mishel, 1987), translated and modified Disease Course Graphic Scale(DCGS) which was developed by Braden (1990), translated Sherer. et al.’s General Self-Efficacy Scale (1982), The Health -Promoting Lifestyle Profile (HPLP), developed by Walker, Sechrist, and Fender (1987) and traslated to Korean by Ha, and quality of life was measured by Face Scale (Andrew, 1976). Several steps of verification for the translation process were carefully conducted. Data analysis included descriptive correlational statistics and multiple regression techniques. Health promotion was the only contributor to pre-dict quality of life. Results showed that enabling cognitive perceptual factor (self-efficacy) mediates the disruptive force (uncertainty in ill-ness) on achieving a health promoting self- help behavior. The findings of this study also indicated that illness - related variable of severity of illness was mediated by health promotion, which buffered it's impact on quality of life.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.22 no.1
• /
• pp.78-84
• /
• 1993

This study was conducted to investigate the effect of various polyethylene (PE) film packaging on the quality of strawberry during storage at low temperature. Gas composition in film was changed rapidly at early stage of storage and then kept at the level of 5~10% $CO_2$and 1~3% $O_2$. Weight loss and decay rate were low at 0.08mm PE film packed strawberries. Titratable acidity, pH and soluble solids were changed slightly during storage but its large difference according to film thickness was not observed. Decrease of flesh firm-ness and a value was restrained by PE film packaging. Free sugar of strawberry was composed of glucose and fructose in similar content and it was decreased a little during storage but the difference according to film thickness was not observed. The organic acids in strawberry were citric acid, malic acid, succinic acid, ascorbir acid, oxalic acid, tartaric acid and pyruvic acid and the major organic acid was citric acid. The contents of citric acid, malic acid, succinir acid and ascorbic acid were decreased and oxalic acid and tartaric arid were not changed during storage but pyruvic acid was increased in early stage and then decreased. These changes of organic acid were slight in packaged with 0.08mm PE film strawberry.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.34 no.8
• /
• pp.1274-1283
• /
• 2005

The sensory acceptability, texture profile analysis and nutritional evaluation were peformed in Korean traditional mungbean pancake (MPC) and modified MPC containing squid meat and soybean to standardize the recipes for healthy fast food market potentiality. Optimal ingredient formulations were revealed as mung-bean 55$\%$, pork 13$\%$ and vegetables 32$ \%$ for traditional MPC, and pork 3$\%$, squid 42$\%$ and soybean 55$\%$ for modified MPC using response surface methodology. Flavor and hardness correlated highly with overall accept-ability rather than appearance and color of traditional MPC. Higher squid levels raised adhesiveness, springi-ness and resiliences of modified MPC, but soybean decreased these textural attributes. Protein, lipid and total calorie of modified MPC were lower than those of traditional MPC. Computed protein efficiency ratio (C-PER) and degree of gelatinization of modified MPC were superior than traditional MPC.