• 한국세라믹학회지
• /
• 제53권4호
• /
• pp.381-385
• /
• 2016

Recently, white LEDs, especially, warm white LEDs have been intensively investigated due to outstanding optical properties, long term stability and low power consumption. In this study, mixed type and patterned type of remote phosphors were prepared by screen printing process employing green and red phosphor. Each type of remote phosphor exhibited distinctive photoluminescence spectrum. For example, the mixed type of remote phosphor exhibited unique spectrum, while the patterned type showed expectable spectrum depending on the concentration of phosphors. This indicates that a small amount of red phosphor dramatically reduced the green photoluminescence in the case of mixed-type remote phosphor, whereas the effect was negligible in the patterned-type remote phosphor. The possibility of undesirable chemical reaction was further investigated by using scanning electron microscopy and X-ray diffraction.

• Journal of the Korean Wood Science and Technology
• /
• 제42권4호
• /
• pp.420-427
• /
• 2014

제재과정에서 발생되는 톱밥과 농업부산물인 왕겨의 활용방안을 찾고자 왕겨의 혼합비율에 따라 혼합보드를 제조하고 수지함침 및 탄화과정을 거쳐 혼합세라믹을 제조하여 왕겨의 혼합비율에 따라 물성을 조사하였다. 같은 수지함침율에서 왕겨혼합비율이 증가함에 따라 탄화 후 밀도 및 휨강도는 증가하였으나 중량감소율은 감소하였다. 또한 같은 탄화온도에서 밀도와 휨강도는 왕겨혼합비율이 40%일 때 가장 큰 것으로 나타났다.

• 한국세라믹학회지
• /
• 제32권1호
• /
• pp.63-70
• /
• 1995

A crack-free ceramic composite membrane with micropores has been synthesized by the pressurized sol-gel coating technique using the mixed Al2O3-SiO2 sols. The mixed sols were prepared by mixing nanoparticulate SiO2 and boehmite sols. These sols were more stable at lower pH, but very unstable when their copositions were in the range of 50~75mol% of SiO2 at the same pH. The mixed Al2O3-SiO2 membrane prepared from the mixed sol (0.2mol/$\ell$ of solid content and pH=2) containing 40mol% of SiO2 had the mean pore radius of 0.80nm and the specific surface area of 280$m^2$/g. The nitrogen permeability through the coated Al2O3-SiO2 layer was 42$\times$107mol/$m^2$.s.Pa. It was found that the thermal stability of aluminosilicate membranes, even through similar to that of SiO2 membranes, was much improved in comparison with ${\gamma}$-alumina membranes.

• 한국세라믹학회지
• /
• 제53권4호
• /
• pp.435-443
• /
• 2016

Coal ash, a material generated from coal-fired power plants, can be classified as fly ash and bottom ash. The amount of domestic fly ash generation is almost 6.84 million tons per year, while the amount of bottom ash generation is 1.51 million tons. The fly ash is commonly used as a concrete admixture and a subsidiary raw material in cement fabrication process. And some amount of bottom ash is used as a material for embankment and block. However, the recyclable amount of the ash is limited since it could cause deterioration of physical properties. In Korea, the ashes are simply mixed and used as a replacement material for cement. In this study, an attempt was made to mechanically activate the ash by grinding process in order to increase recycling rates of the fly ash. Activated fly ash was prepared by controlling the mill types and the milling times and characteristics of the mortar containing the activated fly ash was analyzed. When the ash was ground by using a vibratory mill, physical properties of the mortar mixed with such fly ash were higher than the mortar mixed with fly ash ground by a planetary mill.

• 한국세라믹학회지
• /
• 제39권10호
• /
• pp.970-976
• /
• 2002

본 논문에서는 수중불분리혼화제와 수중불분리혼화제+방청제를 병용(1 type)한 혼화제를 사용하여 콘크리트의 slump flow, 탁도, pH, 방청효과, 블리딩, 압축강도의 특성을 분석하였다. 그 결과 slump flow, 탁도, pH, 압축강도등 콘크리트의 물리적인 특성에서는 차이가 없었으나 부식촉진서험결과 수중불분리혼화제만을 사용한 콘크리트와 방청제를 병용(1 type)하여 사용한 것의 방청율이 큰 차이를 나타내었으며, 수중불분리혼화제만을 사용하였을 경우 5.4, 방청제와 병용하여 사용하였을 경우 0.07%로 방청제를 병용(1 type)하여 사용한 큰크리트의 내부식성이 높게 나타났다.

• 한국세라믹학회지
• /
• 제24권4호
• /
• pp.357-363
• /
• 1987

This study consists of two powder preparation process. One is that the synthesized Forsterite at 1400$^{\circ}C$ mixed with Zirconia powder. Another, theoretical Forsterite composition mixed with Zirconia. These two Forsterite bodies were heat-treated at 1400$^{\circ}C$, 1450$^{\circ}C$. Synthesized Foresterite composition showed higher density, strength than Forsterite composite which was directly mixed with Zirconia KIC value was measured by Microhardness Indentation method. It shows the highest value when 15 weight percent Zirconia dispersed.

• 한국미생물·생명공학회지
• /
• 제23권6호
• /
• pp.755-762
• /
• 1995

A phenolic resin industrial wastewater containing about 41,000 mg/l of phenol and 2,800 mg/l of formaldehyde was biologically treated by a mixed culture GE2 immobilized on ceramic beads. This study was carried out with three experimental groups : Control-only added the sludge of papermill wastewater ; GE2 treatment-added GE2 to Control ; Ceramic treatment-applied ceramic carrier to GE2 treatment. When the original wastewater was diluted 80 times with aerated tap-water, influent COD$_{Mn}$ WaS 1,140 mg/l and that of the effluent was in the range of 22-35 mg/l, which was not much different among the experimental groups. However, at 20-times dilution, influent COD$_{Mn}$ was 4,800 mg/l and the effluent COD$_{Mn}$ of Control, GE2 treatment and Ceramic treatment was 179, 128 and 94 mg/l, respectively. COD$_{Mn}$, removal efficiency by Ceramic treatment was the highest, at 98.0%. At this time, the effluent phenol concentration of Control, GE2 treatment and Ceramic treatment was 10.71, 7.93 and 5.60, respectively. As the dilution times decreased, the removal efficiency of COD$_{Mn}$ and phenol did not change much, but COD$_{Mn}$ and phenol concentration of the effluent increased. Consequently, it is likely that the phenolic industrial wastewater containing phenol and formaldehyde can be biologically treated using a GE2 and ceramic carrier and that at 40-times dilution, the effluent completely meets the effluent standards for industrial wastewater treatment plant.

• 대한치과보철학회지
• /
• 제28권1호
• /
• pp.203-216
• /
• 1990

The purpose of this study was to evaluate the cervical margin fitness in the collarless metal ceramic crowns formed by different techniques. Specimens were divided as follows : the metal ceramic crowns with metal butt margin as group I, the collarless metal ceramic crowns formed with resin binder technique as group II, and the collarless metal ceramic crowns formed with shoulder powder mixed with phosphate-bonded investment liquids on a refractory die as group III. Each group was made of five specimens, and their marginal fitness on each epoxy die was evaluated under scanning electron microscope of x200 magnification at three measuring points : mesial, central, distal. The following results were obtained. 1. The metal ceramic crowns with metal butt margin exhibited significantly better marginal fitness than the collarless metal ceramic crowns. The marginal fitness in descending order was group I, III, II. 2. The collarless metal ceramic crown formed with resin binder technique had the worst marginal fitness & showed cervical color variation and dermacation between the corrected porcelain & the dentin porcelain. 3. The collarless metal ceramic crowns formed with shoulder powder mixed with phosphate-bonded investment liquids on a refractory die exhibited significantly better marginal fitness & sharper marginal configuration than the other collarless group.

• 한국콘텐츠학회논문지
• /
• 제21권3호
• /
• pp.602-608
• /
• 2021

임상에서 사용되는 Co-Cr 합금과 도재 간의 접착 강도를 비교하기 위해 대조군으로 전통적인 주조(Casting) 방법, 실험군으로 Milling(Milling group), SLM(3d printing group) 시편을 제작하여 금속과 도재(ceramic) 간의 접착 강도를 비교 하였다. 합금과 도재간의 접착강도를 측정하기 위해 universal testing machine를 이용하여 3점 굴곡 시험을 시행하고, 결합강도 측정 후 금속-도재간의 계면을 관찰하였다. 금속-도재(ceramic) 간의 실험 결과 casting group 53.59 MPa, milling group 45.90 MPa, 3d printing group 58.34 MPa의 결과값을 보였고, 통계적으로 유의성은 없었다. 파절양상은 두 집단 시편의 대부분이 복합 파절양상(mixed failure)을 보였다. 본 연구는 3D 프린팅로 제작된 합금으로 합금-도재의 결합 강도값을 측정하였을 때 임상적으로 적용 가능한 수치를 보여 주었다.

• 동의생리병리학회지
• /
• 제18권4호
• /
• pp.1159-1162
• /
• 2004

We studied on the production of the ceramic by the mineral-Oriental medicine and the property of the clean active water depositting on the ceramic stone. The results are as follows: We properly mixed of maifanshi, mica, ochre, and added to a small amount cinnabar, and therefore formed the ceramic stone. By the plasticity process and the irradiating magnetic force recovered the disappeared a part of constitutent elements. The recovered effects were become higher the freshness, maintenance, deodoriztion, clean water. As well as having the ability on capture of the notoxious heavy metal on human. The ceramic powder were mixed proper dose maifanshi, mica. And the powder had ionization, absorption, adhesion by the plasticity process and magnetic force. The clean active water of depositting on the ceramic stone during 24hours were observed significant the content of micro element, dissolved oxygen, abstraction on Herbs.