• Bulletin of the Korean Chemical Society
• /
• v.17 no.1
• /
• pp.39-42
• /
• 1996

A new oscillator for electrochemical quartz crystal microbalance (EQCM) was developed by using an operational amplifier without any LC component. The home-made EQCM using this oscillator showed only 0.02 Hz frequency noise at 0.3 s gate time when a 6 MHz AT-cut crystal was used. Pb underpotential deposition on gold substrate in nitric acid media was examined to demonstrate the performance of this EQCM. The derivative of frequency change could be obtained without averaging multiple scans.

• Bulletin of the Korean Chemical Society
• /
• v.17 no.9
• /
• pp.781-786
• /
• 1996

Mass transport behavior of C60 films on electrodes with different thicknesses has been studied by an Electrochemical Quartz Crystal Microbalance (EQCM) during electrochemical reduction-oxidation processes in the presence of water. C60 films were found to be reduced in the presence of water and they remains quite stable. In thin films, the mass on electrode decreased after a complete cycle while X-ray Photoelectron Spectroscopy (XPS) study does not support the existence or formation of C60-epoxides during electrochemical reduction processes in the presence of water or oxygen.

• Korean Chemical Engineering Research
• /
• v.51 no.2
• /
• pp.233-239
• /
• 2013

A quartz crystal microbalance (QCM) system coated with poly (isobutylene), polystyrene, and poly (methyl methacrylate) has been prepared to measure the adsorption amounts of benzene, toluene, and p-xylene at very low pressures. The resonant frequency shift of the QCM system is proportional to the increase in pressure in all experiments. The Henry's constants for all adsorbates on the polymer films are obtained from experimental data and compared with the minimum adsorption potential energies between adsorbates and the polymer films. In general, there is an explicit correlation between adsorption amount and the minimum adsorption potential energy.

• Journal of Korean Society for Atmospheric Environment
• /
• v.26 no.1
• /
• pp.77-84
• /
• 2010

The diffusion and partition coefficients of polyurethane foam (PUF) are estimated using a microbalance experiment and small chamber test. The microbalance is used to measure sorption/desorption kinetics and equilibrium data. When the diffusion condition is controlled in the chamber of the sample, interactions between volatile organic compounds (VOCs) and PUF can lead to the estimation of a relatively homogenous rate of mass transfer in the interiors and surfaces of PUF. The estimates of the material/air partition coefficient (K) and the material-phase diffusion coefficient (D) are shown to be independent of the concentrations of VOCs. This approach, if applied to a diffusion-controlled or physically-based model, can facilitate more precise prediction of their source/sink behavior. Although further research and more rigorous validation is needed, an emission model applied with the diffusion and partition coefficients from this research holds promise for the improvement of reliability in predicting the behavior of VOCs emitted from porous building materials by D and K.

• Asian Pacific Journal of Cancer Prevention
• /
• v.13 no.7
• /
• pp.3423-3426
• /
• 2012

Background: The objective of this study was to measure the antibody content of NuTu-19 ovarian cancer cells in serum samples using a quartz crystal microbalance (QCM) immunosensor. Materials and Methods: NuTu-19 cells were first cultured onto the electrode surfaces of crystals in Dulbecco's modified Eagle medium, and then specified amounts of immunized serum samples of immunized rabbit were also added. The change in mass caused by specific adsorbtion of antibodies of NuTu-19 to the surfaces of the crystals was detected. Results: The change in resonance frequency of crystals caused by immobilization of NuTu-19 cells was from 83 to 429Hz. The antibody content of NuTu-19 detected was 341ng/ul. The frequency shifts were linearly dependent on the amount of antibody mass in the range of 69 to 340ng. The positive detection rate and the negative detection rate were 80% and 100%, respectively. Conclusion: This immunoassay provides a viable alternative to other early ovarian cancer detection methods and is particularly suited for health screening of the general population.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2005.11a
• /
• pp.256-257
• /
• 2005

We fabricated self-assembled monolayers(SAMs) onto quartz crystal microbalance(QCM) using viologen, which has been widely used as electron acceptor and electron transfer mediator. The viologen derivative exist in three redox states, namely. These redox reactions are highly reversible and can be cycled many times without significant side reactions, respectively. We studied the characteristics of charge transfer using different electrolyte solutions by electrochemical quartz crystal microbalance (EQCM). From the data, the redox peak currents were nearly equal charges during redox reaction and existed to an excellent linear interrelation between the scan rates and first redox peak currents. The redox reactions of viologen were highly reversible and the EQCM has been employed to monitor the electrochemically induced adsorption of SAMs during the redox reactions.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.10
• /
• pp.820-825
• /
• 1998

We deposited stearic acid LB films by using Langmuir-Blodgett (LB)method and investigated anisotropy electrical conduction characteristics by I-V measurement for horizontal direction and vertical direction. Also, we measured gad response between deposited LB films and organic gas for various temperature(0~8$0^{\circ}C$) by 9MHz At-cut quartz crystal microbalance. The LB films have electrical conduction characteristics such as semiconducting and insulating properties. The is, the conductivity of LB films for the horizontal and vertical direction is about 10\ulcornerS/cm and 10\ulcorners/cm, respectively. the frequency shift of stearic acid LB films for the organic gases depended on the mass change by the surface adsorption and the inner penetration to the sensing films. The resonant frequency shift of the quartz crystal microbalance for temperature properties of LB films is thought to the effect of the rearrangement or the damage pf LB films above the melting point and the mobility increasement of the organic gas by the temperature rising.

• Journal of Environmental Health Sciences
• /
• v.34 no.3
• /
• pp.219-225
• /
• 2008

Many building materials may contain high concentrations of volatile organic compounds (VOCs) and other hazardous pollutants(HAPs). Specifically, VOCs discharged by indoor building material may cause "new house" syndrome, atopic dermatitis etc. The diffusion coefficient and initially contained total VOC quantity were determined using microbalance experiments and small chamber tests. Interactions between volatile organic compounds (VOCs) and vinyl flooring (VF), a relatively homogenous, diffusion-controlled building material, were characterized. Rapid determination of the material/air partition coefficient (K) and the material-phase diffusion coefficient (D) for each VOC was achieved by placing thin VF slabs in a dynamic microbalance and subjecting them to controlled sorption/desorption cycles. K and D are shown to be independent of concentration for all of the VOCs and water vapor. This approach can be applied to other diffusion-controlled materials and should facilitate the prediction of their source/sink behavior using physically-based models.

• Journal of Sensor Science and Technology
• /
• v.17 no.5
• /
• pp.380-386
• /
• 2008

Quartz crystal microbalance immunosensor has a capacity to perform a label-free and real time detection of a trace amount of analyte through the specific interaction between antibody and antigen. However, immobilization of antibody molecules on the sensor surface is a troublesome procedure for researchers who are not experienced in chemistry. Protein G has a specific affinity to antibody and would serve as a capturing agent for antibody when immobilized on the sensor surface. In this work, we prepared a protein G sensor chip by immobilizing protein G on the surface of quartz crystal microbalance and examined its capability to detect human haptoglobin or human transferrin with unpurified corresponding antiserum. Specific and dose dependent response was observed when the protein G chip was used for detection of antigens after saturated with antiserum. We also verified several advantageous aspects of the protein G chip such as improved flexibility and sensitivity.

• Journal of Sensor Science and Technology
• /
• v.32 no.3
• /
• pp.147-153
• /
• 2023

Metal-organic frameworks (MOFs) of cobalt gallate were synthesized and deposited on gold electrodes using self-assembly monolayers (SAMs) and hydrothermal processing. These MOF films exhibit strong adsorption capabilities for gaseous particulates, and the use of SAMs allows the synthesis and deposition processes to be completed in a single step. When cobalt gallate is mixed with SAMs, a coordination bond is formed between the cobalt ion and the carboxylate or hydroxyl groups of the SAMs, particularly under hydrothermal conditions. Additionally, the quartz crystal microbalance (QCM) gas sensor accurately measures the number of particulates adsorbed on the MOF films in real-time. Thus, the QCM gas sensor is a valuable tool for quantitatively measuring gases, such as SO₂, NO₂, and CO₂. Furthermore, the QCM MOF film gas sensor was more effective for gas adsorption than the MOF particles alone and allowed the accurate modeling of gas adsorption. Moreover, the QCM MOF films accurately detect the adsorption-desorption mechanisms of SO₂ and NO₂, which exist as gaseous particulate matter, at specific gas concentrations.