• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 2006.07a
• /
• pp.370-370
• /
• 2006

• Proceedings of the KIPE Conference
• /
• 2018.07a
• /
• pp.288-289
• /
• 2018

In this paper, the coupled inductor scheme instead of noncoupled inductors is suggested to reduce the dimension, weight and cost of the magnetic core. The simulation results have verified the effectiveness of the flying-capacitor MMC with coupled inductors and its control method for medium-voltage induction motor drives at low-speed operation.

• Proceedings of the KIPE Conference
• /
• 2012.07a
• /
• pp.327-328
• /
• 2012

대용량 계통 연계형 태양광 인버터는 그 중요성이 부각되면서 현재는 수MW~수백MW에 이르는 발전소 개념으로 시장이 더욱 확대되고 있다. 이에 따라 본 논문에서는 대용량 태양광 발전소에 적합한 멀티 센트럴 구성 방식과 기존 토폴로지의 접근을 통한 시장의 최신 동향에 대해 기술하고자 한다.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.53 no.3
• /
• pp.142-147
• /
• 2004

In this study, We developed the microprocessor based controller for Auto Section Switch(ASS). This is installed at consumer's medium-high voltage(load capacity is below 4,000 kVA) switchgear. This function is cooperate with protection device of fault section and automatically dividing the section. And It is designed by Air putter type extinction structure and adopt the mechanism and breaking part module of existing Load Breaker Switch. In addition, We successfully conducted the operation test and checked main function of proto-type.

• Proceedings of the KIPE Conference
• /
• 2018.11a
• /
• pp.173-174
• /
• 2018

This paper proposes the coupled inductor instead of four non-coupled inductors in each leg of the flying-capacitor modular multilevel converter (MMC) to reduce the dimension, weight and cost of the magnetic core. The simulation results have verified the effectiveness of the proposed coupled inductor.

• Proceedings of the KIPE Conference
• /
• 2018.11a
• /
• pp.27-29
• /
• 2018

본 논문은 모듈형 멀티레벨 컨버터 기반 특고압 직류 배전망의 수전 계통 사고 대응 기법을 제안한다. 수전 계통의 순간적인 저전압 및 단락 사고 발생 시 전력변환장치는 계통 전압의 정상화를 지원하기 위해 연계를 유지해야 하며 계통 측의 요구에 따라 전압 변동률에 따른 무효 전력을 공급해야 한다. 제안하는 기법은 계통 사고 발생 시 계통 코드에 따라 무효 전류를 공급하여 수전 계통의 전압 레벨 복구를 지원한다. 시뮬레이션을 통해 제안하는 계통 사고 대응 기법의 타당성을 확인한다.

• Journal of Advanced Marine Engineering and Technology
• /
• v.35 no.5
• /
• pp.675-681
• /
• 2011

In this paper, we dealt with the design and fabrication of a medium pressure ultra-violet (UV) lamp and a magnetic ballast which are main components for ballast water treatment systems (BWTS). To acquire an optimal discharge condition of UV lamp, electrical and optical characteristics depending on the argon gas volume and the amount of mercury were experimentally analyzed. Rated voltage, current and power consumption of a prototype lamp were 490 [V], 8.6 [A] and 4.0 [kW], respectively. UV intensity of the lamp was 15 [%] higher than that of an equivalent lamp which is used in a BWTS. The magnetic ballast was designed in a UI core type through theoretical analysis and simulation. The open voltage and the rated power consumption of the ballast were 920 [V] and 8.5 [kVA] respectively. The disinfection efficacy which is carried out in a BWTS equipped with the UV lamp and magnetic ballast was over 99.99 [%], and this satisfy the IMO regulations.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.17 no.3
• /
• pp.80-86
• /
• 2003

A study on the insulation aging assessment and maintenance for submarine medium voltage power cable systems has been performed The purpose of this work is the economic discrimination and maintenance of bad cables which is likely to cause cable system failure. 1 have found that aging status of submarine cable systems are very poor and in progress. Therefore, we have the replacement of cable terminations and repeat the diagnostic measurement Insulation status were improved with the replacement of cable terminations. I have confirmed, with the electrical md structural analysis of terminations, that the poor aging status of cables are mainly caused not by the cable insulations but by the aging of cable terminations. From the above results, I have also confirmed that the domestic diagnostic system is successful and convenient for the discrimination and maintenance of the damaged cables economically.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.27 no.1
• /
• pp.85-91
• /
• 2013

This paper studied surface discharge characteristics by a dielectric constant and diameter of solid dielectrics in $N_2/O_2$ mixture gas. Applied electric field strength at $N_2/O_2$ mixture gas was changed from the dielectric constant and diameter of the solid dielectrics, and insulation performance of the $N_2/O_2$ mixture gas determined surface discharge voltage. In each of the diameter at the solid dielectrics, the surface discharge voltage was increased by lengthening surface distance, whereas increasing rate of the surface discharge voltage was different from gas pressure. Thus, In this paper, main factors of surface discharge are as follows. 1) Insulation performance of $N_2/O_2$ mixture gas, 2) Dielectric constant of solid dielectrics, 3) Surface discharge path. It was clear that the surface discharge voltage depend on the main factors. These results will be applied to useful data for an eco-friendly composite insulation design.

• Journal of Power Electronics
• /
• v.18 no.5
• /
• pp.1458-1469
• /
• 2018

This paper proposes a novel common-mode voltage (CMV) elimination (CMV-EL) method based on model predictive control (MPC) to eliminate CMV for three-level T-type inverters (3LT2Is). In the proposed MPC method, only six medium and one zero voltage vectors (VVs) (6MV1Z) that generate zero CMV are considered as candidates to perform the MPC. Moreover, the influence of dead-time effects on the CMV of the MPC-based 6MV1Z method is investigated, and the candidate VVs are redesigned by pre-excluding the VVs that will cause CMV fluctuations during the dead time from 6MV1Z. Only three or five VVs are included to perform optimization in every control period, which can significantly reduce the computational complexity. Thus, a small control period can be implemented in the practical applications to achieve improved grid current performance. With the proposed CMV-EL method, the CMV of the $3LT^2Is$ can be effectively eliminated. In addition, the proposed CMV-EL method can balance the neutral point potentials (NPPs) and yield satisfactory performance for grid current tracking in steady and dynamic states. Simulation and experimental results are presented to verify the effectiveness of the proposed method.