• Structural Engineering and Mechanics
• /
• 제83권6호
• /
• pp.745-756
• /
• 2022

This study aims to determine the cause of the load resistance loss in storage racks that can be attributed to external forces such as earthquakes and to improve safety by developing reinforcement systems that can prevent load resistance loss. To this end, a static cyclic loading test was performed on pallet racks commonly used in logistics warehouses. The test results indicated that a pallet rack exposed to an external force loses more than 50% of its load resistance owing to the damage caused to column-beam joints. Three reinforcement systems were developed for preventing load resistance loss in storage racks exposed to an external force and for performing differentiated target functions: column reinforcement device, seismic damper, and viscoelastic damper. Shake table testing was performed to evaluate the earthquake response and verify the performance of these reinforcement systems. The results confirmed that, the maximum displacement, which causes the loss of load resistance and the permanent deformation of racks under external force, is reduced using the developed reinforcement devices. Thus, the appropriate selection of the developed reinforcement devices by users can help secure the safety of the storage racks.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2010년도 춘계학술대회 논문집
• /
• pp.10-10
• /
• 2010

The solar cell energy is considered as a clean energy source in the world. However, because the output of solar cell is not constant, it needs to study the relationships of the DC voltage, the DC current and the DC power of the solar cell. This paper presents the solar cell output characteristics and the maximum power point of the solar cell under different irradiation conditions.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1999년도 추계학술대회 논문집
• /
• pp.129-131
• /
• 1999

Driving generator of USMs(ultrasonic motors) with low noise, high efficiency was designed and fabricated. It was focused on merits such as size-reduction, thermal resistance, To control revolution speed, input frequency was varied. Output of generator had frequency range of 39.1 ∼ 43.5 MHz and voltage of 120 V. USM with resonant frequency 40.3 kHz exhibited a maximum torque of 2.5 kg $.$ cm and a maximum revolution speed of about 130 rpm.

• 한국유기농업학회지
• /
• 제24권4호
• /
• pp.699-717
• /
• 2016

본 연구는 시설하우스 재배에서 앞그루작물 재배 시 형성된 두둑을 재활용하여 뒷그루 작물을 무경운으로 재배할 경우 토양의 이화학성과 생육 및 수량에 미치는 영향을 구명하고자 추진한 연구 결과의 일부이다. 중동통(jd)의 두둑에서 토양 균열은 관찰되었으나 고랑에서는 관찰되지 않았다. 관행 경운 토양 두둑의 길이 방향으로 경운 5개월 후에 최대 폭 30 mm, 최대 깊이 15.3 cm, 길이 37~51 cm 정도 되는 균열이 3개 정도 발생되었다. 그리고 두둑의 폭 방향에서는 길이 7~28 cm 정도 되는 균열이 7.5개 정도 발생되었다. 무경운 1년차는 두둑의 길이 방향에서 최대 폭 18 mm, 최대 깊이는 30 cm, 길이는 140~200 cm 정도 되는 균열이 1개 정도 발생되었으며, 두둑 폭 방향의 균열은 최대 폭 22 mm, 최대 깊이는 18.5 cm에 길이는 6~22 cm 정도 되는 균열이 11개 정도 발생되었다. 한편 모래함량이 많은 중동통(jd)의 무경운 2년차 토양에서 균열은 관찰되지 않았으나, 점토함량이 많은 지산통(jd) 무경운 7년차 토양에서는 균열이 관찰되었다. 중동통(jd) 시설재배의 미사질양토의 관행 경운토양 표토 1 cm 깊이의 관입저항은 59 kPa에 비하여 무경운 1년차는 유의적으로 높았다. 경운 토양 20 cm 깊이의 관입저항은 161~185 kPa 수준이었고 36~39 cm 깊이의 관입저항 503~507 kPa을 정점으로 감소되었다. 무경운 1년차 토양 관입저항은 5~30 cm 깊이까지 167~172 kPa을 유지하였으나, 43 cm 깊이에서 437 kPa를 최대값으로 감소되었다. 무경운 2년차 표토의 관입저항은 1 cm 깊이의 81 kPa에서 6 cm 깊이는 243 kPa로 직선적인 증가를 하였다. 논에서 전환한 지산통(ji) 시설 재배지의 관행 경운 토양 관입저항은 표토 1 cm 깊이로부터 52 cm 깊이까지 토양이 깊어짐에 따라서 직선적인 증가를 하였으나, 그 이상의 깊이에서는 증가되지 않았다. 그러나 두둑을 재활용한 무경운 7년차 토양의 표토 1 cm와 2 cm 깊이의 관입저항은 직선적인 증가를 보여 경운 토양에 비하여 현저하게 증가되었으나, 그 이상의 깊이에서는 거의 변동이 없었다. 지산통(ji)과 중동통(jd)의 쟁기 바닥층은 표토에서 10~12 cm 깊이, 작토층은 21 cm 깊이까지로 추정되었다. 그러나 지산통(ji)의 경운 토양의 경반층은 33~35 cm 깊이로 추정되었으나 무경운 7년차는 경반층이 토양 38~44 cm 깊이에서 흔적으로만 존재하였다. 표토의 수분함량은 관행 경운 토양과 두둑을 재활용한 무경운 토양에서 경운 방법 간에 차이가 없었으나, 20 cm 깊이의 무경운 토양 수분함량은 14%로 경운 토양 25%에 비하여 현저하게 낮았다. 1 Bar와 15 Bar에서 측정한 표토의 보수력은 관행 경운토양 비하여 두둑을 재활용한 무경운 1년차와 무경운 2년차에서 증가되었다. 그리고 무경운 2년차 심토의 보수력은 1 Bar와 3 Bar에서 경운 토양과 무경운 1년차에 비하여 증가되는 경향이었다.

• 대한물리의학회지
• /
• 제15권4호
• /
• pp.75-85
• /
• 2020

PURPOSE: Cerebral palsy is a common cause of disability in children, requiring constant rehabilitation. Improving balance in children with cerebral palsy helps to alleviate daily movement and the quality of life. This study examines a program that combines Resistance Exercise and Group Exercise, and investigates the effect on trunk control ability, balance ability, maximum grip strength, and quality of life of children with cerebral palsy. METHODS: Totally, 9 children with cerebral palsy participated in this study. Resistance exercise was performed for 8 weeks, 40 minutes every day. Group Exercise was conducted for 8 weeks, 40 minutes each Sunday. All participants were evaluated by the Korean version of the trunk control measurement scale, pediatric reach test, grip strength test, and KIDSCREEN-52. RESULTS: The trunk control ability was significantly improved in all subcategories (p < .05). In the pediatric reach test, the left and right directions were significantly improved (p < .05). Maximum grip strength was significantly improved in both hands (p < .05). The quality of life significantly improved in total score, physical well-being, general moods, self-perception, autonomy, relationship with parents, and home life (p < .05). CONCLUSION: Considering the encouraging results, we propose to use Resistance Exercise and Group Exercise as programs other than rehabilitation treatment in hospitals, to improve motor function and quality of life of children with cerebral palsy.

• 대한물리의학회지
• /
• 제10권3호
• /
• pp.101-108
• /
• 2015

PURPOSE: This study researched the effects of the changes of elbow joint angle and of arm position in PNF pattern on muscle activation of the contralateral shoulder muscles while performing PNF pattern exercise. METHODS: The research subjects were 16 male physical therapists who had no neuromuscular or neurological disorders. To measure the muscle activation of the contralateral shoulder muscles, EMG electrodes were attached to the muscle valley of the middle and posterior areas of the deltoid and triceps muscles of the arm. Muscle activation while performing the ulnar thrust PNF pattern exercise was measured with the elbow joint positioned at angles of $30^{\circ}$, $45^{\circ}$, and $60^{\circ}$. Resistance points were at the initial, middle, and end ranges of PNF pattern exercise. RESULTS: Muscle activation of the middle and posterior portions of the deltoid muscle increased significantly according to the changes of elbow joint angle. In each resistance point the middle range was significantly higher than at other points. A significant difference on muscle activation was demonstrated throughout each range depending on the type of muscle. Muscle activation of the middle and posterior portions of the deltoid muscle was higher than muscle activation of the triceps. CONCLUSION: The results of this study demonstrate that the PNF pattern exercising method used in this study is a selective exercising method focusing on the deltoid muscle over the triceps muscle. In order to increase the muscle strength to the maximum level, it is necessary to provide the maximum level of resistance in the middle range of the elbow joint.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1999년도 봄 학술발표회 논문집(I)
• /
• pp.319-324
• /
• 1999

This study is to investigate the properties on the load-deflection and fracture behaviors of the steel fiber reinforced concrete(SFRC) slab model specimens, Steel fibers of indent, crimp, and end hook shape were considered to reinforce the matrix under various mixing conditions and proportions. Initial cracking load, maximum load, and energy absorption capacity(load carrying capacity) of SFRC panel specimen increased with increase of steel fiber contents. And the plain concrete slab was fractured abruptly after maximum load but SRFC slabs were fractured smoothly by steel fibers in concrete matrix operated as cracking resistance force after maximum load. Indent, crimp and end hook shape steel fibers were effective in reinforcing the matrices but end hook type fiber were superior to indent and crimp type fibers.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2008년도 제39회 하계학술대회
• /
• pp.1110-1111
• /
• 2008

The life time of PV module is semi-permanent. But, because of installation and module fabrication process, its important part can not be finished. In this paper, we analyze 15 years old modules made from different company. Among the PV modules, the maximum power drop ratio was 12.23% minimum and 80.63% maximum. Also the effect of solar cell's short circuit current difference was analyzed. The PV module exposed about 65days, its the maximum power drop ratio was 1.29% minimum and 23.43% maximum. It is for reduction of current value. And the reason for current reduction was due to reduction of parallel resistance of solar cell. To prevent early degradation, it is need to have attention to fabrication, installation and maintenance.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2007년도 춘계학술대회B
• /
• pp.1942-1947
• /
• 2007

A thermoelectric module can be used for cooling or power generation. The basic requirements to achieve a significant thermoelectric performance are the same for both generators and coolers. Thermoelectric modules with $Bi_2Te_3$ materials are usually employed in the cooling applications below room temperature but it can also be used for the power generation in the similar temperature range. In the present study, the power generation with a $Bi_2Te_3$ thermoelectric module has been investigated. The temperature difference between the hot and cold sides of the module is maintained with electric heater and cold water from the circulating water bath. The result shows that the electric current generated increases with temperature difference and decreases with the load resistance. However, the voltage increases with both the temperature difference and load resistance. The electric power increases with temperature difference and it has the maximum value when the load resistance is about 4 ${\Omega}$ for a given device.

• 한국축산식품학회지
• /
• 제38권5호
• /
• pp.1055-1063
• /
• 2018

The aim of study was to investigate the correlation between the level of 17 antibiotic residues and 6 antibiotic resistances of Escherichia coli isolates in chicken meats. A total of 58 chicken meats were collected from retail grocery stores in five provinces in Korea. The total detection rate of antibiotic residues was 45% (26 out of 58). Ten out of 17 antibiotics were detected in chicken meats. None of the antibiotics exceeded the maximum residue level (MRLs) in chicken established by the Ministry of Food and Drug Safety (MFDS). The most detected antibiotics were amoxicillin (15.5%), followed by enrofloxacin (12.1%) and sulfamethoxazole (10.3%). In a total of 58 chicken meats, 51 E. coli strains were isolated. E. coli isolates showed the highest resistance to ampicillin (75%), followed by tetracycline (69%), ciprofloxacin (65%), trimethoprim/sulfamethoxazole (41%), ceftiofur (22%), and amoxicillin/clavulanic acid (12%). The results of study showed basic information on relationship between antibiotic residue and resistance for 6 compounds in 13 chicken samples. Further investigation on the antibiotic resistance patterns of various bacteria species is needed to improve food safety.