• Applied Microscopy
• /
• v.32 no.3
• /
• pp.285-290
• /
• 2002

The therapeutic effect of safflower seed powder on experimental osteoporosis in the rat induced by ovariectomy was evaluated. Thirty Sprague-Dawley rats were ovariectomized at the age of 12 weeks. Seven weeks postovariectomy, rats were divided into two groups: control and safflower seed powder treated group. Five animals from each group were sacrificed at the following time points: 1, 3, and 5 weeks. Scanning electron microscopic observation and morphometric analysis of the tibiae epiphysis showed that the administration of safflower seed powder significantly prevented reduction of cortical bone width and bone volume compared with the control group. In conclusion, safflower seed powder contains something that prevent bone loss due to estrogen deficiency, and was effective in preventing the osteoporotic decrease of bone mass.

• Applied Microscopy
• /
• v.38 no.4
• /
• pp.285-291
• /
• 2008

We have evaluated the effects of experimental factors on transmitted electron beam intensities for quantitative analysis in electron tomography. For the correct application of Beer's law in electron tomography, the transmitted beam intensity should reflect the net effect of mass properties on beam path. So, the any other effects of the objective aperture and the specimen holder on beam path should be removed. The cut-off effects of objective aperture were examined using Quanti-foil holey carbon film and a transmission electron microscope operated at 120 kV. The transmitted beam intensities with $30{\mu}m$ objective aperture dropped about 16.7% compared to electron beam intensities without the objective aperture. Also, the additional losses of about 14.2% at high tilt angles were occurred by cut-off effects of the objective apertures. For the precise quantitative analysis in electron tomography, the effect of the objective aperture on transmitted electron beam intensities should be considered. It is desirable that 2-D tilt series images are obtained without the objective aperture for correct application of Bee's law.

• Membrane Journal
• /
• v.19 no.3
• /
• pp.252-260
• /
• 2009

The effects of the treatment of an acidic solution at pH 2 on polyacrylonitrile ultrafiltration (UF) membranes were investigated using a circular cross-flow filtration bench with a membrane module. A substantial reduction in the membrane permeability was observed after 80 hours' treatment of the acidic solution. In addition, the analyses of the sample solutions by ultraviolet/visible absorption spectroscopy and gas chromatography/mass spectrometry (GC/MS), which were taken from the feed tank as a function of the treatment time, showed that a new organic compound was produced in the course of the treatment. From a thorough search of the mass spectral library we presumed the new compound to be 1,6-dioxacyclododecane-7,12-dione (DCD), one of the well-known additives for polyurethane. Based on further experimental results, including the scanning electron microscope (SEM) images and the solid-state NMR spectra of the membranes used for the treatment of the acidic solution, we suggested that the decrease of the permeate flux resulted not from the deformation of the membranes, but from the fouling by DCD eluted from the polyurethane tubes in the filtration bench during the treatment. Those results imply that the reactivity to an acidic solution of the parts comprising the filtration bench is as important as that of the membranes themselves for effective treatments of acidic solutions, for efficient chemical cleaning by strong acids, and also in determining the pH limit of the solutions that can be treated by the membranes.

• The Korean Journal of Mycology
• /
• v.27 no.4 s.91
• /
• pp.256-273
• /
• 1999

Seventy two isolates of Cordyceps militaris collected from 11 sites in Korea, including two isolates from ATCC, were used to assess genetic variation within Cordyceps militaris. The anamorph stage and cultural characteristics of C. militaris were observed through microscope and investigated on PDA respectively. The anamorphs of C. militaris were identified to be Verticillium. Isolates of C. militaris showed different growth rates, morphology and color. Fifty six isolates of single ascospore and seventy two isolates of mass ascospore from C. militaris were analysed using by Random Amplified Polymorphic DNA (RAPD) for genetic relationship analysis. Fifty six single ascospore isolates fell into two groups by phenogram constructed from distance values using the UPGMA method in NTSYS-pc software: group A from artificial fruit body of C18 except for isolate 51; group B from artificial fruit body of C738. The average genetic distance value within group A is 0.150 and group B is 0.163. The average genetic distance value between the two groups is 0.221. The average genetic distance value within 56 single ascospores is 0.207 and 72 mass ascospores is 0.330. Genetic relationships were not found among 72 mass ascospore isolates obtained from eleven geographically distant populations.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.24 no.1
• /
• pp.1-17
• /
• 1997

The purpose of this study was to investigate the aspects of proliferation and bone nodule formation of osteogenic precursor cells. To determine the effects of ascorbic acid and dexamethasone upon capacity of osteoblast proliferation and bone nodule formation, cells were maintained in the presence of one or some of these additives for up to 30 days. Group I culture was maintained in standard medium(DMEM plus 10% plus antibiotics), group II was maintained in supplemented medium containing dexamethasone, group III was maintained in supplemented medium containing ascorbic acid and sodium-${\beta}$-glycerophosphate, and group IV was maintained in supplemented containing ascorbic acid, sodium-${\beta}$-glycerophosphate and dexamethasone. Morphology of bone nodules was observed with light microscope and electron microscope. The results were as follows: ${\bullet}$ Proliferation capacity of osteoblasts was not affected by single use of dexamethasone, but it was chiefly affected by ascorbic acid. ${\bullet}$ Cellular morphology was fibroblastic appearance initially, but, it was gradually changed to polygonal shape accompanied by confluency stage. ${\bullet}$ Pluripotent mesenchymal cells existed during primary culture, they were differentiated to adipocyte, chondrocyte, osteocyte according to culture condition. ${\bullet}$ Dexamethasone increased bone nodule formation under the condition that the culture was maintained with supplemented medium ascorbic acid and sodium-${\beta}$-glycerophosphate. ${\bullet}$ when the cultures were stained with alizarin red, the group supplemented with dexamethasone, ascorbic acid and sodium-${\beta}$-glycerophosphate showed the marked increase of bone nodule formation, but the group supplemented with ascorbic acid and sodium-${\beta}$-glycerophosphate revealed only small amounts of bone nodules. And the groups cultured without ascorbic acid showed no observed any of bone-like mass independent of dexamethasone addition.

• Journal of the Korea Concrete Institute
• /
• v.25 no.4
• /
• pp.457-465
• /
• 2013

This study discussed the influence of mixtures and curing conditions on the development of strength and microstructure of RPC using ternary pozzolanic materials. Through pilot experiment, various RPC was manufactured by adding single or mixed ternary pozzolanic materials such as silica fume, blast furnace slag and fly ash by mass of cement, up to 0~65%, and cured by using 4 types of method which are water and air-dried curing at $20^{\circ}C$, steam and hot-water curing at $90^{\circ}C$. The results show that the use of ternary pozzolanic materials and a suitable curing method are an effective method for improving development of strength and microstructure of RPC. The unit volume of cement was greatly reduced in RPC with ternary pozzolanic materials and unlike hydration reaction in cement, the pozzolanic reaction noticeably contributes to a reduction in hydration heat and dry shrinkage. A considerable improvement was found in the flexural strength of RPC using ternary pozzolanic materials, and then the utilization of a structural member subjected to bending was expected. The X-ray diffractometer (XRD) analysis and Scanning Electronic Microscope (SEM) revealed that the microstructure of RPC was denser by using the ternary pozzolanic materials than the original RPC containing silica fume only.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.38 no.8
• /
• pp.695-700
• /
• 2014

In the present study, the melting temperature depression of Sn nanoparticles manufactured using the modified evaporation method was investigated. For this purpose, a modified evaporation method with mass productivity was developed. Using the manufacturing process, Sn nanoparticles of 10 nm size was manufactured in benzyl alcohol solution to prevent oxidation. To examine the morphology and size distribution of the nanonoparticles, a transmission electron microscope was used. The melting temperature of the Sn nanoparticles was measured using a Differential scanning calorimetry (DSC) which can calculate the endothermic energy during the phase changing process and an X-ray photoelectron spectroscopy (XPS) used for observing the manufactured Sn nanoparticle compound. The melting temperature of the Sn nanoparticles was observed to be $129^{\circ}C$, which is $44^{\circ}C$ lower than that of the bulk material. Finally, the melting temperature was compared with the Gibbs Thomson and Lai's equations, which can predict the melting temperature according to the particle size. Based on the experimental results, the melting temperature of the Sn nanoparticles was found to match well with those recommended by the Lai's equation.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.39 no.6
• /
• pp.527-534
• /
• 2015

This study offers a novel method for improving the physical contact between the anode and fuel in a direct carbon fuel cell (DCFC): a direct generation of carbon in a porous Ni anode through the thermal decomposition of gaseous hydrocarbons. Three kinds of alkane hydrocarbons with different carbon numbers (CH4, C2H6, and C3H8) are tested. From electron microscope observations of the carbon particles generated from each hydrocarbon, we confirm that more carbon spheres (CS), carbon nanotubes (CNT), and carbon nanofibers (CNF) were identified with increasing carbon number. Raman scattering results revealed that the carbon samples became less crystalline and more flexible with increasing carbon number. DCFC performance was measured at $700^{\circ}C$ with the anode fueled by the same mass of each carbon sample. One-dimensional carbon fuels of CNT and CNF more actively produced and had power densities 148 and 210 times higher than that of the CS, respectively. This difference is partly attributed to the findings that the less-crystalline CNT and CNF have much lower charge transfer resistances than the CS.

• Journal of Mushroom
• /
• v.11 no.1
• /
• pp.1-8
• /
• 2013

In this study, twelve of Lepista nuda were collected from various localities in Korea. Also thirteen exotic L. nuda species were collected from Japan, France, Switzerland and Portugal. Spores were isolated under optical microscope. These spores were placed on the surface of YM medium for inducing to germination. Eleven mating-groups were selected by morphological characters of fruit body such as size, color and stipe patterns. Intra-isolate crosses were made between two single-spore isolates derived from mating-groups. Also, dikaryotic crossing using the isolates from L. nuda were carried out to evaluated tetrakaryon formation. Cross-mating compatibility tests also verified its dikaryotic state by microscopic or molecular genetic observation of clamp connection and Random Amplified Polymorphic DNA (RAPD) band pattern. To analyze the growth rate of hybrids and parents mycelium in dikaryons obtained from compatible mating groups were placed on PDA medium. Intra-isolate crosses determined eleven mating-groups within L. nuda. The typical clamp connection were mostly observed in mating-groups of Korean L. nuda in $K1{\times}K2$, $K1{\times}K3$, $K1{\times}K4$, $K1{\times}K6$, $K1{\times}K5$, $K2{\times}K4$, $K2{\times}K3$, $K2{\times}K6$, $K3{\times}K4$, $K4{\times}K5$, and $K4{\times}K6$. Korean L. nuda type of dikaryon, shown to cross-incompatibility with L. sordida, it seemed that mating induce more rapidly than wild types in a view of growth rate. In conclusion, it would be useful to improve mass production with better morphological characteristics through a special mating of L. nuda.

• Journal of Plant Biotechnology
• /
• v.35 no.2
• /
• pp.109-114
• /
• 2008

The aim of this research is to establish the conditions for Agrobacterium-mediated genetic transformation using microspore. The embryo induction from the microspore was examined under several Kanamycin concentration in media, and the induction rate decreased about 4, 8, 10 times when the Kanamycin concentration increased 10, 50, 100 mg/L, respectively. This indicates that the transformation rate would be much lower if the Kanamycin was used for selection marker. In order to apply the GFP gene as a reporter gene for Agrobacterium-mediated genetic transformation, GFP expression from the microspore-mediated embryos was observed using GFP filter under microscope. The GFP expression occurred when the microspore cultured toward the embryo development for 12, 24 and 48 days. The microspore formed a cluster by microspore division from 12 days culture and continuously became a bigger mass. We obtained a total of 8 GFP-expressing embryos suggesting that the transformation of microspore occurred. However, those young embryos were not fully developed. Further study pertinent to culture conditions is required to fulfill the Agrobacterium-mediated genetic transformation using microspore.