• Proceedings of the SAREK Conference
• /
• 2005.11a
• /
• pp.193-198
• /
• 2005

The present experiments have been performed for obtaining the melting heat transfer characteristics of micro-encapsulated solid-liquid phase change material and water mixed slurry flow in a circular tube heated with constant wall heat flux. The phase change material having a low melting point was selected for a domestic cooling system in the present study. The governing parameters were found to be latent heat material concentration, heat flux, and the slurry velocity. The experimental results revealed that the increase of tube wall temperature of latent microcapsule slurry was lower than that of water caused by the heat absorption of fusion.

• Journal of Plant Biology
• /
• v.21 no.1_4
• /
• pp.33-38
• /
• 1978

Phosphate absorption from a Na2H32PO4 solution by Oryza sativa L. was studied in order to elucidate kinetic mechanisms of ion transport. The rates of phosphate absorption from different concentraitons indicated the presence of dual mechanisms in root tips, one in the low (1$\times$10-6 to 8$\times$10-5M) and the other in the high (1$\times$10-4 to 8$\times$10-3M). A phosphate compensation point of phosphate transport was revealed with a 1$\times$10-6M solution of Na2H32PO4. The kinetic model that ion transport involves an exchange reaction of absorption and desorptin is prosposed as follows: where C represents an ionic-specific organic carrier in the membrane; M, Mo and Mi are the mineral ions, M-outside and M-inside; MC is a carrier-ion complex; and the K's represent rate constants. In this model, the Mi velocity, v, is given by: {{{{v= {dMi} over {dt}= {(K1K3Mo-K2K4Mi) Ct} over {(K2＋K3)＋K1Mo＋K4Mi} }} where Ct is equal to C＋MC, and t is time.

• Journal of the Optical Society of Korea
• /
• v.19 no.6
• /
• pp.560-565
• /
• 2015

We report efficient direct coupling of THz dipole antenna pulses onto air spaced two-wire transmission lines and Teflon covered two-wire lines. The air spaced two-wire lines show TEM mode propagation with very small group velocity dispersion (GVD) and relatively low attenuation. The Teflon covered two-wire lines showed comparatively much higher attenuation and GVD. However, the Teflon covered two-wire lines show a very good guiding property when the lines are curved. Although the lines are circled only 5.0 cm in diameter, there is no additional attenuation compared to straight the lines.

• Proceedings of the Optical Society of Korea Conference
• /
• 2001.02a
• /
• pp.250-251
• /
• 2001

There is a considerable interest in the generation of a cold atomic beam having a narrow velocity spread that can be used in various experiments in physics such as ultrahigh resolution atomic and molecular spectroscopy, atom optics, atom interferometry, study of solid surfaces, and low energy collision experiments. The invention of the techniques of laser cooling has stimulated developments in the production of cold and bright atomic beams. (omitted)

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.18 no.12
• /
• pp.3305-3314
• /
• 1994

In this study, the influence of a frost formed on the vertical plate for different operating conditions(the temperature of the air, the humidity of the air, the velocity of the air, and the temperature of the cooling plate) is investigated. The performance of the heat exchanger is examined by introducing a parameter such as the energy transfer resistance. Correlations which relate frost density, frost thickness and energy transfer resistance to Reynolds number, air temperature and humidity, and cooling plate temperature are developed. Static pressure drop and air flow rate are expressed as a function of free flow area of air.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.19 no.9
• /
• pp.2105-2113
• /
• 1995

The compressive tests under impact conditions were performed to establish a design guide for impact damage tolerance. The composition of layup was selected for the real cases of composite aircraft structure. The energy level of visible of visible damage threshold was determined as 7 Joules. It was found that the normalized bending stiffnesses in the direction of closely fixed boundary affected the area of damage. Graphite/epoxy used in the tests exhibited 60% reduction in compression strength at the energy level of visible damage threshold. Wet-conditioned specimens represented 9% reduction in residual compressive strength in comparison with room temperature ambient specimens. In this study, a design factor of 2.1 was proposed for the low velocity impact damage.

• Ocean and Polar Research
• /
• v.21 no.2
• /
• pp.87-97
• /
• 1999

To estimate absolute transports by advection in the southwestern East Sea (Japan Sea), an inverse method was applied to CTD data obtained in July 1993. The relative velocities are calculated using the thermal wind equation. The inverse model was formulated to obtain a reference velocity based on the mass conservation in each of four vertical layers within a region enclosed by hydrographic sections and the coastal boundary. The flow patterns in the surface layer are clockwise and anti-clockwise in the regions south and northwest of Ulleung Island, respectively, and a strong northward flow appears in between them. In the second layer, the flow fields are generally weak. The inverse calculation yields the southward flow along the coast, and this suggests that the subsurface low salinity water in the Ulleung Basin is supplied by the southward transport along the east coast of Korea.

• Environmental Engineering Research
• /
• v.11 no.3
• /
• pp.164-171
• /
• 2006

Numerical modeling of the flow velocity fields for the near corona wire electrohydrodynamic (EHD) flow was conducted. The steady, two-dimensional momentum equations have been computed for a wire-plate type electrostatic precipitator (ESP). The equations were solved in the conservative finite-difference form on a fine uniform rectilinear grid of sufficient resolution to accurately capture the momentum boundary layers. The numerical procedure for the differential equations was used by SIMPLEST algorithm. The Phoenics (Version 3.5.1) CFD code, coupled with Poisson's electric field, ion transport equations and the momentum equation with electric body force were used for the numerical simulation and the Chen-Kim ${\kappa}-{\varepsilon}$ turbulent model numerical results that an EHD secondary flow was clearly visible in the downstream regions of the corona wire despite the low Reynolds number for the electrode ($Re_{cw}=12.4$). Secondary flow vortices caused by the EHD increases with increasing discharge current or EHD number, hence pressure drop of ESP increases.

• Journal of Surface Science and Engineering
• /
• v.41 no.1
• /
• pp.28-32
• /
• 2008

In this paper CdS thin films, which were widely used window layer of the CdS/CdTe and the CdS/$CuInSe_2$ heterojunction solar cell, were grown by chemical bath deposition, which is a very attractive method for low-cost and large-area solar cells, and the structural, optical and electrical properties of the films was studied. As the thiourea/$CdAc_2$ mole ratio was increased, the deposition rate of CdS films prepared by CBD was increased due to increasing reaction velocity in solution and the optical bandgap was increased at higher thiourea/$CdAc_2$ mole ratio due to larger grain size and continuous microstructure. The minimum resistivity of the films was at thiourea/$CdAc_2$ mole ratio of 3.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.5 no.1
• /
• pp.141-148
• /
• 2001

Dynamic compaction is the ground improvement method by applying the impact energy. This impact energy can damage to adjacent structure in urban area. Therefore, if dynamic compaction method is applied, careful attention should be payed to surrounded structures. In this study, the method was performed in waste landfill and the frequency of vibrations were measured according to each distances, drop-heights, and vibrating directions. The measured data show that particle velocity bas low frequency and it is greatest in longitudinal direction. There was little differences between Maynes suggestion and measured data. Therefore, Maynes suggestion can be adopted if the range of vibration can be predicted. Also, It was found that minimum 45m distance is needed in order to satisfy the administrative code if dynamic compaction method is applied.