• Journal of Positioning, Navigation, and Timing
• /
• v.10 no.3
• /
• pp.229-234
• /
• 2021

In this paper, a study was conducted on the power amplifier control required to design an eLoran transmitter system using a low-height antenna. The eLoran transmitter developed during the eLoran technology development project conducted in Korea used a small 35 m antenna due to the difficulty of securing a site for antenna installation. This antenna height is very low compared to the height of 750 m which is required for eLoran 100 kHz signal transmission without any radiation loss. In the case of using such a small antenna, not only the radiation efficiency of the transmission is lowered, but also the power module control must be performed more precisely in order to transmit the eLoran standard signal. The equivalent RLC circuit of the transmitter system was implemented and transient analysis was conducted to derive the input required voltage for satisfying the output requirement. The voltage waveform was also generated by the RLC circuit analysis to generate the eLoran signal. Furthermore, we suggest power width modulation method to control eLoran power amplifier module more sophisticatedly.

• Journal of the Korean Society of Radiology
• /
• v.5 no.6
• /
• pp.357-361
• /
• 2011

In this study, the liquid-crystal optical modulation X-ray detection system using a CdS which is a family of II-IV compound semiconductor was proposed. The system consist of the detector, the signal processing part, the liquid-crystal driving parts, microcontroller, and I/O parts, and was designed to be suitable for miniaturization and portable. In addition, the system can measure a wide range X-ray by using the detecting range selection. In order to evaluate the performance of the proposed system, the CdS sensor's output characteristics were confirmed in accordance with changes of dose, and excellent correlation was determined. And also, the optical penetration ratio was discussed in accordance with changes of the applied voltage by measuring the change of the liquid-crystal in accordance with changes of the applied voltage. Through these results, the characteristics of the liquid-crystal optical modulation system such as the excellent reproducibility and the noise immunity were confirmed. And we considered that the CdS cell-based liquid-crystal optical modulated portable X-ray detection system could be applied to compact, low-cost, portable system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.5
• /
• pp.531-538
• /
• 2016

In this paper, we have proposed MIMO-IBFD system that can transmit and receive multiple data stream at the same time in the single band, and analyze the system. We have confirmed that MIMO-IBFD system requires multiple RF cancellation and multiple Digital cancellation techniques. In simulation, we have analyzed characteristic of received signal on MIMO-IBFD system, and evaluate system performance of conventional $2{\times}2$ MIMO system and MIMO-IBFD system. As simulation results, we have confirmed that MIMO-IBFD system can transmit and receive multiple data stream at the same time in the single band by using multiple RF and digital cancellation techniques. Additionally, we have confirmed that BER performance of $2{\times}2$ MIMO-IBFD system with low-level QAM modulation is similar to performance of $2{\times}2$ MIMO system, and BER performance of $2{\times}2$ MIMO-IBFD system with high-level QAM modulation is degraded in comparison with $2{\times}2$ MIMO system with high-level QAM modulation. We can confirm that MIMO-IBFD system requires high level self-interference cancellation technique in order to use high level modulation.

• Journal of Power Electronics
• /
• v.14 no.6
• /
• pp.1322-1333
• /
• 2014

To track the sinusoidal current under stationary frame and suppress the effects of low-order grid harmonics, the multi-resonant quasi-proportional plus resonant (PR) controller has been extensively used for digitally controlled LCL-type pulse-width modulation (PWM) converters with capacitor-current-feedback active damping. However, designing the controller is difficult because of its high order and large number of parameters. Moreover, the computation and PWM delays of the digitally controlled system significantly affect damping performance. In this study, the delay effect is analyzed by using the Nyquist diagrams and the system stability constraint condition can be obtained based on the Nyquist stability criterion. Moreover, impact analysis of the control parameters on the current loop performance, that is, steady-state error and stability margin, identifies that different control parameters play different decisive roles in current loop performance. Based on the analysis, a simplified controller design method based on the system specifications is proposed. Following the method, two design examples are given, and the experimental results verify the practicability and feasibility of the proposed design method.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.32A no.6
• /
• pp.41-50
• /
• 1995

A state-of-the-arts GaAs power metal semiconductor field effect transistor (MESFET) for 3.3V operation digital hand-held phone at 900 MHz has been developed for the first time, The FET was fabricated using a low-high doped structures grown by molecular beam epitaxy (MBE). The fabricated MESFETs with a gate width of 16 mm and a gate length of 0.8 .mu.m shows a saturated drain current (Idss) of 4.2A and a transconductance (Gm) of around 1700mS at a gate bias of -2.1V, corresponding to 10% Idss. The gate-to-drain breakdown voltage is measured to be 28 V. The rf characteristics of the MESFET tested at a drain bias of 3.3 V and a frequencyof 900 MHz are the output power of 32.3 dBm, the power added efficiency of 68%, and the third-ordr intercept point of 49.5 dBm. The power MESFET developed in this work is expected to be useful as a power amplifying device for digital hand-held phone because the high linear gain can deliver a high power added efficiency in the linear operation region of output power and the high third-order intercept point can reduce the third-order inter modulation.

• International Journal of Ocean System Engineering
• /
• v.1 no.4
• /
• pp.205-210
• /
• 2011

High data-rate underwater communications is demanded. This demand imposes stringent requirements on underwater communication equipment of phase-locked-loop (PLL). Phase noise in PLL is unwanted and unavoidable. In this paper, we investigate the PLL phase noise effect on high order QAM for underwater communication systems. The phase noise model using power spectral density is adopted for performance evaluation. The phase noise components considered in PLL are reference oscillator, voltage controlled oscillator (VCO), filter and divider. The filters in PLL noise are assumed to be second order active and passive low pass filters. Through simulation, we analyze the phase noise characteristics of the four components and then investigate the performance improvement factor of each component. Consequently, we derive specifications of VCO, phase detector, divider to meet performance requirement of high data-rate communication using QAM under phase noise influence.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.7C
• /
• pp.627-634
• /
• 2007

When a higher-order modulation scheme (16QAM or 64QAM) is applied to the communications system using the nonlinear high power amplifier (HPA), the performance can be degraded by the nonlinear distortion of the HPA. The nonlinear distortion can be compensated by the adaptive nonlinear Volterra equalizer using the low-complexity LMS algorithm at the receiver. However, the LMS algorithm shows very slow convergence performance. So, in this paper, the parallel M-band discrete wavelet transformed LMS algorithm is proposed in order to improve the convergence speed. Throughout the computer simulations, it is shown that the convergence performance of the proposed method is superior to that of the conventional time-domain and transform-domain LMS algorithms.

• Korean Journal of Remote Sensing
• /
• v.25 no.6
• /
• pp.517-529
• /
• 2009

Many satellite image fusion techniques have been developed in order to produce a high resolution multispectral (MS) image by combining a high resolution panchromatic (PAN) image and a low resolution MS image. Heretofore, most high resolution image fusion techniques have used IKONOS and QuickBird images. Recently, GeoEye-1, offering the highest resolution of any commercial imaging system, was launched. In this study, we have experimented with GeoEye-1 images in order to evaluate which fusion algorithms are suitable for these images. This paper presents compares and evaluates the efficiency of five image fusion techniques, the $\grave{a}$ trous algorithm based additive wavelet transformation (AWT) fusion techniques, the Principal Component analysis (PCA) fusion technique, Gram-Schmidt (GS) spectral sharpening, Pansharp, and the Smoothing Filter based Intensity Modulation (SFIM) fusion technique, for the fusion of a GeoEye-1 image. The results of the experiment show that the AWT fusion techniques maintain more spatial detail of the PAN image and spectral information of the MS image than other image fusion techniques. Also, the Pansharp technique maintains information of the original PAN and MS images as well as the AWT fusion technique.

• Journal of Advanced Navigation Technology
• /
• v.11 no.1
• /
• pp.9-16
• /
• 2007

In this paper, the Bit Error Ratio (BER) performances of the D8PSK modulation schemes for VDL Mode-2 are analyzed according to the matched and unmatched cases of the channel filters. The carrier frequency and phase offset effects are analyzed with unmatched case. Generally in digital transmission techniques, the Root Raised Cosine filters which are used as channel filters are applied to both sides at transmitter and receiver in order to achieve no ISI, but in VDL Mode-2, the Raised Cosine Filter is used only in transmission section and the receiver section uses general low pass filter, therefore we could not achieve ISI reduction effects but can have better spectrum quality. From the simulation results, the error probability is increased slightly (1~2dB) with use of un-matched channel filter, we got the conclusions that carrier phase offset do not effect to bit error ratio, but the frequency offset effect is so serious. Finally, narrow band D8PSK modulation signals are generated by the use of Digital Up-Converter and then its features are compared with analog modulator.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.12B
• /
• pp.2382-2390
• /
• 1999

In this paper, we employed a new quantization scheme called sample-adaptive product quantizer (SAPQ) to quantize image data based on the differential pulse code modulation (DPCM) coder, which has fixed length outputs and high bit rates. In order to improve the performance of traditional DPCM coders, the scalar quantizer should be replaced by the vector quantizer (VQ). As the bit rate increases, it will be nearly impossible to implement a conventional VQ or modified VQ, such as the tree-structured VQ, even if the modified VQ can significantly reduce the encoding complexity. SAPQ has a form of the feed-forward adaptive scalar quantizer having a short adaptation period. However, since SAPQ is a structurally constrained VQ, SAPQ can achieve VQ-level performance with a low encoding complexity. Since SAPQ has a scalar quantizer structure, by using the traditional scalar value predictors, we can easily apply SAPQ to DPCM coders. For synthetic data and real images, by employing SAPQ as the quantizer part of DPCM coders, we obtained a 2~3 dB improvement over the DPCM coders, which are based on the Lloyd-Max scalar quantizers, for data rates above 4 b/point.