• The Journal of Korean Physical Therapy
• /
• v.11 no.1
• /
• pp.71-77
• /
• 1999

The purpose of this study was to investigate the changes of muscle power by transcutaneous electrical nerve stimulation(TBNS), low frequency-low intensity(20pps, invisible muscle contraction intensity), low frequency-high intensity(20pps, visible muscle contraction), high frequency-low intensity(100pps, invisible muscle contraction intensity) and high frequency-high intensity(100pps, visible muscle contraction). The results were as follows. 1. Increased muscle power after 30 minutes of treatment by low frequency-low intensity TENS, and post-treatment 30 minutes muscle power were increased more than pre-treatment power(p<0.05). 2. Decreased muscle power after a 30 minute treatment by low frequency-high intensity TENS, and after the 30 minute treatment was terminated muscle power didn't recover to pre-treatment levels. 3. Decreased muscle power after 30 minute treatment by high frequency-low intensity TENS, but post-treatment 30 minute, muscle power didn't recover to pre-treatment levels. 4. The muscle power was remarkably decreased by high frequency-high intensity TENS after 30 minute treatment, in addition treatment terminated after 30minutes didn,t recover to pre-treatment power(p<0.05). 5. Lower frequency-low intensity TENS are good methods for preventing muscle fatigue, buty high intensity (TENS) are increased muscle fatigue. 6. Traditional TENS by high frequency-low intensity is a good method for preventing muscle fatigue.

• Journal of Korea Society of Industrial Information Systems
• /
• v.20 no.1
• /
• pp.49-55
• /
• 2015

This paper proposes a 2.4 GHz RF oscillator with a very low close-in phase noise performance. This is composed of a low frequency crystal oscillator and three frequency multipliers such as two doubler (X2) and one tripler (X3). The proposed oscillator is implemented as a hybrid type circuit design using a discrete silicon bipolar transistor. The measurement results of the proposed oscillator structure show -115 dBc/Hz close-in phase noise at 10 kHz offset frequency, while only dissipating 5 mW from a 1-V supply. Its close-in phase noise level is very close to that of a low frequency crystal oscillator with little degradation of noise performance. The proposed structure which is consisted of a low frequency crystal oscillator and a frequency multiplier provides new method to implement a low power low close-in phase noise RF local oscillator.

• Proceedings of the Earthquake Engineering Society of Korea Conference
• /
• 2002.09a
• /
• pp.35-42
• /
• 2002

Frequency responses for most of the local seismic sensors in Korea have been roughly checked by mutual comparison of Fourier spectra of seismic records from accelerometer and seismometer, both of which are installed at the same location. Especially, because the frequency content of the seismic energy is usually above 1 Hz for local earthquakes, the reliability of low frequency response could have not been evaluated. Fortunately a recent large earthquake, Ms=7.2 on 02/06/29 containing dominant low frequency energy makes it possible to check the low frequency response of the seismic sensors, especially EpiSensor and JC-V100. Considering two types of sensor pairs, (STS-2 and EpiSensor, JC-V100 and EpiSensor), the low frequency response of EpiSensor is confirmed first by comparison with STS-2 which has proved low frequency response. Second, reliable low frequency limit of instrumentally corrected seismic data from JC-V100 data is estimated to be about 0.03 Hz by comparison with EpiSensor data.

• 한국연소학회:학술대회논문집
• /
• 2007.05a
• /
• pp.197-201
• /
• 2007

The reattachment characteristics of propane lifted flames in laminar coflow jets influenced by AC electric fields have been investigated experimentally in low AC frequency range. The reattachment velocity and height have been measured by varying the applied AC voltage and frequency. The results showed that the reattachment of lifted flame occurred at relatively higher jet velocity with AC electric fields, comparing to that without having AC electric fields. The effect of AC electric fields became more effective at higher voltage and lower frequency in the AC frequency range larger than 30 Hz. However, in the low frequency range below 30 Hz, the reattachment velocity decreased with decreasing frequency. Consequently, there existed a transition regime, for the frequency smaller than about 30 Hz. Also, when the AC voltage was applied to the fuel nozzle at very low frequency, the reattachment process exhibited an oscillatory behavior, synchronized with the applied AC frequency.

• Journal of Korean Physical Therapy Science
• /
• v.13 no.2
• /
• pp.27-36
• /
• 2006

The purpose of this study would like to analyze statically significant difference for low back-pain frequency of mother after development-disability children. Seven nursery children with disability conducted survey from 122 mothers cared children with disability. Survey data was obtained from April 14. 2006 to May 23. 2006. The results were as follows: According to walking-existence, assistance walking, and disability-degree, low back pain incidence frequency of mothers were statically significant difference, (p<0.05). Low back pain incidence frequency of walker-ability population was 51.4%, but low back pain incidence frequency of walker-disability population was 80.0%. then low back pain incidence frequency of mothers to walking-existence was differed amount. Disabled not statically significant difference to encephalopathy and disability-type1 and disability -type2 (p>0.05). children with disability-degree and assistance walking benchmarked low back pain disability-measure. Low back pain degree not relevancy statically significant. Physical load was statically significant difference between Oswestry's low back pain score and reach effect to child-cared(p<0.05). As development-children with disability of disable degree, Mother appeared to highly low back pain frequency rate and appeared to large reach effect child-cared owing to physical load of low back pain. So hereafter, location and person request to approach with more clinical and objectively. As approach result, it will help to stress solution of children with disability owing to develop to low back pain class and family capable strengthening program and so on.

• Journal of KSNVE
• /
• v.10 no.6
• /
• pp.991-997
• /
• 2000

The objective of this study is to examine the onset condition and the frequency characteristics of the low-frequency combustion oscillation in a surface burner. For this purpose, extensive parametric studies have been performed experimentally and the effects of size of each section, the equivalence ratio, and the entrance velocity on oscillatory behavior explored. The experimental results were discussed in comparison with the other combustors associated tilth the low-frequency combustion oscillation. The combustion mode is driven at high combustion rate by the lift of unstable flame near the lower limit of the combustible equivalence ratio. The oscillation frequency is dependent not on the burner geometry but on the equivalence ratio and the combustion load. Low-frequency combustion mode was formed to be divided into two different modes, named C1 and C2 respectively. Two modes occurred individually, simultaneously or transitionally according to the equivalence ratio and combustion load. The characteristics of low-frequency oscillation is different from each other depending on the type of combustors. The surface burner has also its own characteristics of low -frequency oscillation.

• Journal of the Korean Society of Physical Medicine
• /
• v.13 no.4
• /
• pp.67-74
• /
• 2018

PURPOSE: This study was conducted to investigate the effects of vibration frequency and amplitude on scapular winging during the knee push-up plus exercise. METHODS: A total of 26 female subjects with scapular winging were evaluated while performing the knee push-up plus exercise with no vibration, low-frequency/low-amplitude (5 Hz/3 mm) vibration, low-frequency/high-amplitude (5 Hz/9 mm) vibration, high-frequency/low-amplitude (15 Hz/3 mm) vibration, and high-frequency/high-amplitude (15 Hz/9 mm) vibration. The surface EMG of the serratus anterior (SA) muscle was compared between the vibration frequency and amplitude. The EMG amplitude was normalized using the maximal voluntary isometric contraction (MVIC). The statistical significance of the results was evaluated using one-way ANOVA. RESULTS: The SA muscle EMG values increased at low-frequency/low-amplitude vibration and at low-frequency/high-amplitude vibration compared to no vibration. Furthermore, the same values increased at high-frequency/low-amplitude vibration and high-frequency/high-amplitude vibration compared to no vibration. In general, a higher vibration frequency and amplitude was associated with higher EMG values of the SA muscle, with particularly greater increases observed during high-frequency/high-amplitude vibration. There was also a significant difference between each condition with a high-frequency/high-amplitude vibration (p<.05). CONCLUSION: This study suggests that there were remarkable clinical effect of the knee push-up plus exercise with vibration, which enhanced the SA muscle activation in persons with scapular winging. Furthermore, applying a higher vibration frequency and amplitude more effectively increased for increasing SA muscle activation.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 1996.10a
• /
• pp.148-152
• /
• 1996

A method of deminishing low frequency noise by acoustic acoupling with compliant wall is described. The coupled governing equations and boundary conditions are derived and solved. The coupled system shows very interesting behavior in the low frequency region; in the low frequency, acoustic wave doesn't propagate, but decay to satisfy the boundary condition with the compliant wall. Henceforth using this mechanism, we propose a method of reducing low frequency noise, which is infact related with the physical properties of compliant wall. The method has been experimentally verified.

• Speech Sciences
• /
• v.13 no.3
• /
• pp.35-48
• /
• 2006

The present study examined whether words with higher frequency have more exposure to the lenition process such as intervocalic stop voicing or /h/ reduction in the production of the Korean speakers. Experiment 1 and Experiment 2 tested if word-internal intervocalic voicing and /h/ reduction occur more often in the words with higher frequency than less frequent words respectively. Results showed that the rate of voicing was not significantly different between the high frequency group and the low frequency group; rather both high and low frequency words were shown to be fully voiced in this prosodic position. However, intervocalic /h/s were deleted more in high frequency words than in low frequency words. Low frequency words showed that other phonetic variants such as [h] and [w] were found more often than in high frequency group. Thus the results of the present study are indefinitive as to the relationship between the word frequency and lenition with the data at hand.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2009.10a
• /
• pp.254-258
• /
• 2009

In this paper, the low frequency vibration forming system is developed for micro-patterns formation on the metal substrate. many researchers have studied about micro-forming technologies such as micro deep drawing, press forming, forging, extrusion etc. for the formation of precise micro-patterns on the surface of metal substrates, multi-step forming process must be used to improve qualifies of the deformed patterns. Since the low frequency vibration forming system could easily deform the surface of metal substrates, several steps of multi-step forming process should be removed by using the low frequency vibration forming system. In order to find optimal process conditions, we have carried out low frequency vibration forming process with varying the vibration frequency from 110Hz to 500Hz.