• Geophysics and Geophysical Exploration
• /
• v.23 no.1
• /
• pp.13-21
• /
• 2020

The acquisition and processing of long-offset data are essential for imaging deep geological structures in marine seismic surveys. It is challenging to derive an accurate subsurface image by employing conventional data processing to long-offset data owing to the normal moveout (NMO) stretch and non-hyperbolic moveout phenomena induced by seismic anisotropy. In 2017, the Korea Institute of Geoscience and Mineral Resources conducted a simultaneous two-dimensional multichannel streamer and ocean-bottom seismic survey using a 5.7-km streamer and an ocean-bottom seismometer to identify the deep geological structure of the Ulleung Basin. Herein, the actual geological subsurface structure was obtained via the sequential iterative updating of the velocity and anisotropic parameters of the long-offset data obtained using a multichannel streamer, and anisotropic prestack Kirchhoff migration was performed using the updated velocity and anisotropic parameters as input parameters. As a result, the reflection energy in the long-offset traces, which showed non-hyperbolic moveout owing to seismic anisotropy, was well aligned horizontally and NMO stretches were also reduced. Thus, a more precise and accurate migrated image was obtained, minimizing the distortion of reflectors and mispositioned reflection energy.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.64 no.2
• /
• pp.67-73
• /
• 2015

Distance relay is widely used for the protection of long transmission line. Most of distance relay used to calculate line impedance by measuring voltage and current using DFT. So if there is a computation error due to the influence of phasor by DC offset component, due to excessive vibration by measuring line impedance, overreach or underreach can be occurs, and then abnormal and non-operation of distance relay can be issue. It is very important to implement the robust distance relaying that is not affected by DC offset component. This paper describes an enhanced distance relaying based on the DC offset elimination filter to minimize the effects of DC offset on a long transmission line. The proposed DC offset elimination filter has not need any prior information. The phase angle delay of the proposed DC offset filter did not occurred and the gain error was not found. The enhanced distance relay uses fault current as well as residual current. The behavior of the proposed distance relaying using off-line simulation has been verified using data about several fault conditions generated by the ATP simulation software.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.6C
• /
• pp.626-633
• /
• 2009

ISO/IEC/WD 24753 defines new modem specifications for a long-range RFID communications and application protocol for a sensor tag system. According to the standard, the frequency offset of the tag is 4%. In general wireless communications systems, it is known that a coherent receiver is superior to a non-coherent receiver. However, if the frequency offset is large, it is difficult to restore the original data accurately with a coherent receiver, and the performance of a coherent receiver is easily degraded. In this paper, a non-coherent receiver structure is adopted to solve the frequency offset problem of long-range RFID communications. We designed a frequency estimation block to find an optimal frequency from the received signal with 4% frequency offset and proposed a start frame delimiter (SFD) detection algorithm to determine the start position of the payload. The frequency estimation block finds the optimal frequency from the received signal using 9-correlators. And the SFD detection block searches the received signal to find the start position of the payload with dual correlator. We implemented a long-range RFID reader with the proposed methods and evaluated its performance in a wired/wireless test network. The implemented long-range RFID reader showed more superior performance than the commercial RFID reader in terms of recognition range.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.6
• /
• pp.955-961
• /
• 2016

Fault location estimation is an important element for rapid recovery of power system when fault occur in transmission line. In order to calculate line impedance, most of fault location algorithm uses by measuring relaying waveform using DFT. So if there is a calculation error due to the influence of phasor by DC offset component, due to large vibration by line impedance computation, abnormal and non-operation of fault locator can be issue. It is very important to implement the robust fault location algorithm that is not affected by DC offset component. This paper describes an enhanced fault location algorithm based on the DC offset elimination filter to minimize the effects of DC offset on a long transmission line. The proposed DC offset elimination filter has not need any erstwhile information. The phase angle delay of the proposed DC offset filter did not occurred and the gain error was not found. The enhanced fault location algorithm uses DFT filter as well as the proposed DC offset filter. The behavior of the proposed fault location algorithm using off-line simulation has been verified by data about several fault conditions generated by the ATP simulation program.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.47 no.1
• /
• pp.30-40
• /
• 2010

The hard disk is one of the most frequently used storage in IPTV sep-top box. It has large storage capacity and provides fast I/O speed compared to its price whereas it causes high power consumption due to mechanical characteristics of spindle motor. In order to play streaming data in the set-top box, spindle motor of hard disk keeps active mode and it causes high power consumption. In this paper, We propose an offset-buffering and multi-mode spin-down method to reduce power consumption for streaming data playback. The offset-buffering inspects the user's viewing pattern and performs buffering based on the analysis of viewing pattern. So, it can maintain the status of spindle motor as idle mode for long time. Besides, it can reduce power consumption by spinning down according to offset-buffer size. The experimental result shows that proposed offset-buffering and multi mode spin-down method is about 28.3% and 12.5% lower than the full-Buffering method in terms of the power consumption and spin-down frequency, respectively.

• Korean Journal of Remote Sensing
• /
• v.34 no.3
• /
• pp.495-506
• /
• 2018

Global interest in climate change and sea level rise has led to active research on the velocities of glaciers. In studies about the velocity of glaciers, in-situ measurements can obtain the most accurate data but have limitations to acquire periodical or long-term data. Offset tracking using SAR is actively being used as an alternative of in-situ measurements. Offset tracking has a limitation in that the accuracy of observation is lower than that of other observational techniques, but it has been improved by recent studies. Recent studies in the $Uv{\hat{e}}rsbreen$ glacier area have shown that glacier altitudes decrease at a rate of 1.5 m/year. The glacier displacement velocities in this region are heavily influenced by climate change and can be important in monitoring and forecasting long-term climate change. However, there are few concrete examples of research in this area. In this study, we applied the improved offset tracking method to observe the two-dimensional velocity in the $Uv{\hat{e}}rsbreen$ glacier. As a result, it was confirmed that the glacier moved at a maximum rate of 133.7 m/year. The measruement precisions for azimuth and line-of-sight directions were 5.4 and 3.3 m/year respectively. These results will be utilized to study long-term changes in elevation of glaciers and to study environmental impacts due to climate change.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.1
• /
• pp.1-12
• /
• 2004

In this paper, we take advantage of the characteristics of optical burst switching (OBS) to support service-differentiation in optical networks. With the offset time between control packet and burst data, the proposed scheme uses different offset time of each service class. As contrasted with the Previous method, in which the high Priority service use only long offset time, it derives the burst loss rate as a QoS parameter in consideration of conservation law and given service-differential ratios and decides a reasonable offset time for this QoS finally Firstly proposed method classifies services into one of high or low class and is an algorithm deciding the offset time for supporting the required QoS of high class. In order to consider the multi-classes environment, we expand the analysis method of first algorithm and propose the second algorithm. It divides services into one of high or low group according to their burst loss rate and decides the offset time for high group, and lastly cumulates the offset time of each class. The proposed algorithms are evaluated through simulation. The result of simulation is compared with that of analysis to verify the proposed scheme.

• Industry Promotion Research
• /
• v.8 no.1
• /
• pp.35-45
• /
• 2023

This paper addressed the analysis of the trend and direction of the US defense strategy based on their third offset strategy and presented the practical policy implication of ensuring the security of South Korea appropriately in the future national defense environment. The countermeasures for the development ability of advanced weapon systems and secure core technologies for Korea were presented in consideration of the US third offset strategy for the future national defense environment. First, to carry out the innovation of national defense in Korea based on artificial intelligence(AI), the long-term basis strategy for the operation of the unmanned robot and autonomous weapon system should be suggested. Second, the platform for AI has to be developed to obtain the development of algorithms and computing abilities for securing the collection/storage/management of national defense data. Lastly, advanced components and core technologies are identified, which the Korean government can join to develop with the US on a basis of the Korea-US alliance, and the technical cooperation with the US should be stronger.

• Proceedings of the KIEE Conference
• /
• 2005.05a
• /
• pp.21-23
• /
• 2005

NARX(Nonlinear AutoRegressive with eXogenous input) neural network was used for prediction of nuclear reactor behavior which was influenced by control rods in short-term period and also by xenon and boron in long-term period in load following operations. The developed model was designed to predict reactor power, xenon worth and axial offset with different burnup rates when control rod and boron were adjusted in load following operations. Data of UCN 3 were collected by ONED94 code. The test results presented exhibit the capability of the NARX neural network model to capture the long term and short term dynamics of the reactor core and seems to be utilized as a handy tool for the use of a plant simulation.

• The Transactions of the Korean Institute of Electrical Engineers D
• /
• v.54 no.9
• /
• pp.567-569
• /
• 2005

NARX(Nonlinear AutoRegressive with eXogenous input) neural network was used for prediction of nuclear reactor behavior which was influenced by control rods in short-term period and also by the concentration of xenon and boron in long-term period in load following operations. The developed model was designed to predict reactor power, xenon worth and axial offset with different burnup states when control rods and boron were adjusted in load following operations. Data of the Korea Next Generation PWR were collected by ONED94 code. The test results presented exhibit the capability of the NARX neural network model to capture the long term and short term dynamics of the reactor core and the developed model seems to be utilized as a handy tool for the use of a plant simulation.