• Textile Coloration and Finishing
• /
• v.15 no.4
• /
• pp.39-42
• /
• 2003

Automatic concentration control system for pretreatment of dyeing was set up with adaptive control system supported by Fuzzy logic for the high speed successive pretreatment of fabric. Concentration of pretreatment bath was determined by the conductivity due to the ionized NaOH. Usability of this system was also evaluated with 30wt% of NaOH (conductivity of 0.25 S/cm) as an initial concentration. Conductivity fluctuated between 0.31 and 0.17 S/cm. This range accorded with the 21-35wt% of NaOH concentration.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.15 no.4
• /
• pp.349-355
• /
• 2002

The ionic conductivity of cubic solid solutions in the systems of CaO-$ZrO_2$, $Y_2O_3-ZrO_2$ prepared by SHS was examined. The higher conductivity appears to be related to a lower activation energy rather than to the number of oxygen vacancies dictated by composition. Conductivity-temperature data was obtained at 1000 $^{\circ}C$ in atmosphere of low oxygen partial pressure (~$10^{-40}$ atm) for $Y_2O_3-ZrO_2$ cubic solid solutions. The data indicated that these materials could be reduced, and the decree of reduction would be related with the measuring electric field.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1997.11a
• /
• pp.418-420
• /
• 1997

We synthesized the polymer that can have function group and improvement of mechnical strength and then confirmed the possibility of molecular device made by LB method. In this paper, the $\pi$-A isotherm has been investigated as to the kinds and various concentrations of the metal ions complexed with imidazole group. The experimental results for the electrical properties of MIM fabricated has been obtained as following. There is no change in limiting area as to the kinds of the metal ions, also the shift of conductivity as to the metal ions couldn't be observed, which was 10$\^$-14/[S/cm]. There are some changes in limiting area as to the concentration of the metal ions, the conductivity shift was increased with the occupied molecular area.

• Journal of environmental and Sanitary engineering
• /
• v.16 no.1
• /
• pp.40-46
• /
• 2001

Conventional membrane systems was difficult to treatment for pulp and paper mills waste warter. Technological advances in membrane filtration systems have created opportunity for pulp and paper mills to treat effluent streams in order to meet stricter environmental constraints. "Vibratory Shear Enhanced Processing(VSEP)" developed by new logic international makes if possible to filter effluent streams without the fouling problems exhibited by conventional membrane systems. Various kinds of waste water occurred to and paper mills experiment with "VSEP" set up conventional membrane. The results were as followes : Excepting ultra filter($0.1{\mu}\textrm{m}$ Teflon, C-100, G-50), Nano filter(NTR-7450, DS-5, PVD-1) and reverse osmosis(ACM-4) was treated with very excellent weight of treatment, electric conductivity, removal COD, TDS, turbidity.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1998.06a
• /
• pp.223-226
• /
• 1998

In this paper, we have investigated how morphology and electrical properties in Polyphenylene sulfide(PPS) are changed by uniaxial elongation. XRD pattern shows that interplanar distance and crystallinities are decreased by increasing elongation ratio. Electrical conduction mechanism of PPS is explained as schottky emission from analysis of electrical current. The electrical current is decreased by increasing elongation ratio. The conductivity is changed remarkably above the glass transition temperature around $(82^{\circ}C)$. The band gap of PPS is evaluated as 3.9-4(eV) from the results of photoconductivity. Increarnent of elongation ratio gives us some information about deep trap formation from photocurrent.

• Journal of the Korean Society for Precision Engineering
• /
• v.14 no.1
• /
• pp.101-107
• /
• 1997

Recently, as the raw water quality becomes to be polluted and the seasonal and local variation of water quality becomes to be severe, an exact control of coagulant dosing have been required in the water treat- ment plant. The amounts of coagulant is related to the raw water quality such as turbidity, alkalinity, water temperature, pH and edectrical conductivity. However the process of chemical reaction has not been clarified so far, so the dosing rate has been decided by jar-test, which is taken one or two hours. For the sake of this coagulant dosing control, fuzzy neural network to fuse fuzzy logic and neural network was proposed, and the scheme was applied to automatic determination of coagulant dosing rate. This controller can automatically identify the if-then rules and tune the membership functions by utilizing expert's cintrol data. It is shown that determination of coagulant dosing rate according to real time sensing of water quality is very effect.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.08a
• /
• pp.114-114
• /
• 2012

Even though graphene was introduced with a great hope to replace silicon in future, small (or zero) band gap and poor stability have become major challenges in graphene electronics. Especially, rectification and amplification function which are the elemental functions of silicon device, is very difficult to implement without a bandgap. However, the graphene can still be used in many other device applications if the merits of graphene are creatively utilized. For example, graphene can be applied to almost any kind of substrate. Its conductivity can be varied in some degree using electric field, charge dipole, attached molecules, and many other ways. Recently, graphene stacked with ferroelectric materials or piezoelectric materials has been actively studied for various device applications. In this talk, various device applications of graphene using hybrid stack or novel device structure will be introduced and their prospect will be discussed.

• IE interfaces
• /
• v.17 no.4
• /
• pp.397-406
• /
• 2004

It is widely known that labor costs are continuously and rapidly growing in terms of the raw cost of products in Korea. The increased labor costs are degrading the competitiveness of dairy industry sector as in the other major industrial fields. Furthermore, the number of dairy farms is constantly decreasing while that of dairy cattle is increasing. Thus, mechanized and/or automated stockbreeding management systems are crucially required to support professional stockbreeding management, as well as to enhance the productivity of the sector. Hence this paper develops an IIS (Integrated Information System) for dairy cattle stockbreeding management. IIS is composed of five application modules and associated utility programs. The five modules are individual stock management, milking management, feeding management, propagation management, and disease management. The utility programs are involved in stock farm accounting, and handy unloading of individual stock data into a personal data acquisition device. Compared with existing foreign products, the developed system takes advantages of various stock body measurement data such as body weight, body temperature, milk conductivity, milking amount, and the number of walking steps. All the measured data are transmitted into a programmable logic controller that monitors and controls measurement devices. The transmitted data are finally aggregated into an integrated database located in the main personal computer. The integrated data are analyzed and reformed in the five modules of IIS, then, used for providing farmers with various farm states and information through application module scenes. Hence, IIS keeps the each module work in a systematic and compatible manner, while supervising the whole stockbreeding management system.