• Journal of Environmental Science International
• /
• v.11 no.4
• /
• pp.375-382
• /
• 2002

The total hydrocarbon distribution of oil products obtained from the pyrolysis of four kinds of mixtures of polyethylene-polystyrene waste has been studied by multidimensional chromatography(high performance liquid chromatography followed by capillary gas chromatography)/mass spectrometry. Saturated, unsaturated and aromatic hydrocarbons in oil products were selectively pre-separated according to structural groups by HPLC and the weight fraction of each group was estimated by analysis of each component using GC-FID response factors. The hydrocarbon distribution of aliphatic fraction consists of $C_{5}$ to $C_{25}$ saturated and unsaturated hydrocarbons. And that of aromatics fraction consists of benzene, toluene, xylene, styrene, propenyl benzene, naphthalene, and some of derivatives. Pyrolysis temperature did not affect the ratio of total weight fraction of aliphatic over aromatic hydrocarbon distribution in case of PS only and PE-PS mixtures (1:1 and 1:4 wt. ratio) as a feed while affected the ratio of total wt. fraction in case of PE only. The optimal temperature for the maximum oil production was $600^{\circ}C$ for pyrolysis of PS and 1:1 and 1:4 mixtures of PE and PS. The optimal condition for aromatic recovery was $600^{\circ}C$ with 1:1 mixture of PE and PS. In this condition, aromatic was produced up to 90% of total oil product. The maximum yield of toluene, xylene, styrene, and propenyl benzene were 8.6, 8.9, 51.0 and 7.4% of feed for pyrolysis PS at $700^{\circ}C$, respectively. However, only 1.3% naphthalene was recovered at $700^{\circ}C$ with 1:1 PE:PS(by wt.).

• Proceedings of the Korea Committee for Ocean Resources and Engineering Conference
• /
• 2004.11a
• /
• pp.62-67
• /
• 2004

Many ships in voyage experience weight and buoyancy distribution change by various reasons such as change of sea water density and waves, weather condition, and consumption of fuel, provisions, etc . The weight and buoyancy distribution change can bring the ships out of allowable trim, heeling angle. In these case, the ships should adjust trim and heeling angle by shifting of liquid cargo or ballasting, deballasting of ballast tanks for recovery of initial state or for a stable voyage. But, if the adjustment is performed incorrectly, ship's safety such as longitudinal strength, intact stability, propeller immersion, wide visibility, minimum forward draft cannot be secured correctly. So it is required that the adjustment of trim and heeling angle should be planned not by human operators but by optimization computer algorithm. To make an optimized plan to adjust trim and heeling angle guaranteeing the ship's safety and quickness of process, Uk! combined mechanical analysis and optimization algorithm. The candidate algorithms for the study were heuristic algorithm, meta-heuristic algorithm and uninformed searching algorithm. These are widely used in various kinds of optimization problems. Among them, heuristic algorithm $A^\ast$ was chosen for its optimality. The $A^\ast$ algorithm is then applied for the study. Three core elements of $A^\ast$ Algorithm consists of node, operator, evaluation function were modified and redefined. And we analyzed the $A^\ast$ algorithm by considering cooperation with loading instrument installed in most ships. Finally, the algorithm has been applied to tanker ship's various conditions such as Normal Ballast Condition, Homo Design Condition, Alternate Loading Condition, Also the test results are compared and discussed to confirm the efficiency and the usefulness of the methodology developed the system.

• Bulletin of the Korean Chemical Society
• /
• v.30 no.7
• /
• pp.1489-1496
• /
• 2009

This study was done for the determination and excretion profile of adrenosterone and its metabolites in human urine using both liquid chromatography with atmospheric pressure chemical ionization mass spectrometry and gas chromatography with mass spectrometry. Adrenosterone and its two metabolites were detected in human urine after administration a healthy volunteer with 75 mg of adrenosterone. We found that adrenosterone-M1 ($C_{19}H_{26}O_3$) was a reduction and adrenosterone-M2 ($C_{19}H_{26}O_4$) was a hydroxylation at C-ring, which did not know the exact position of the C-ring. The adrenosterone parent was detected by GC/TOF-MS, but not detected by LC/APCI/MS because of low intensity. Adrenosterone and its two metabolites were excreted as their glucuronided fractions. The recovery of this method ranged from 100.7 to 118.4% and the reproducibility and accuracy test were 85.5 to 112.0% and 1.1 to 8.4%, respectively. The excretion studies showed that adrenosterone and its metabolites were detectable in human urine during a 48 h period after oral administration, with maximum level of excretion at 4.1 h. The glucuro-/sulfaconjugated ratio of adrenosterone, M1 and M2 was 0.73 ${\pm}$ 0.03, 0.96 ${\pm}$ 0.06 and 0.89 ${\pm}$ 0.03 (n = 6), respectively. The amounts of adrenosterone excreted in urine were 14.75 ng for 48 h. Also, the maximum level of androsterone and 11$\beta$-hydroxy androsterone, which were endogenous steroids, were reached 4.1 h after the oral administration of adrenosterone.

• Clinical and Experimental Reproductive Medicine
• /
• v.17 no.2
• /
• pp.167-172
• /
• 1990

This study was carried out to clarify the effects of various kinds of cryoprotectants which were frequently used in freezing embryos of domestic animals on the survival of frozen-thawed mouse embryos. Mouse embryos were collected by hyperstimulation induction of ICR mouse. The samples were slowly cooled ($l^{\circ}C/min$) to temperatures between $-7^{\circ}C$ and $-30^{circ}C$ before direct transfer to liquid nitrogen ($-196^{\circ}C$) and thawed rapidly ($-500^{\circ}C$/min). As cryoprotectants, Glycerol, DMSO, Ethylene glycol and Propylene glycol were used and applied each 2 cell, 8 cell, morula in embryo stage. After normal mouse embryos developed to blastocyst by in vitro culture, we observed recovery rate and developing rate of embryos at thawing. The results obtained in these experiments were as follows : 1. The in vitro development rate from the frozen-thawed 2 cell embryos to the blastocyst were 67.7% in ethylene glycol, 65.7% in Propylene glycol, 55.2% in glycerol and 50.0% in DMSO respectively. 2. The in vitro development rate from the frozen-thawed 8 cell embryos to the blastocyst were 83.6% in DMSO, 75.7% in glycerol, 52.2% in propylene glycol respectively. 3. The in vitro development rate from the frozen-thawed morula to the blastocyst were 84.2% in glycerol, 80.0% in DMSO, 66.6% in propylene glycol and 55.2% in ethylene glycol respectively.

• Journal of ILASS-Korea
• /
• v.16 no.3
• /
• pp.119-125
• /
• 2011

Due to the oxygen contents in biodiesel, application of the fuel to compression ignition engines has significant advantages in terms of lowering PM formation in the combustion chamber. In recent days, considerable studies have been performed to extend the low temperature combustion regime in diesel engines by applying biodiesel fuel. In this work, low temperature combustion characteristics of biodiesel blends in dilution controlled regime were investigated at a fixed engine operating condition in a single cylinder diesel engine, and the comparisons of engine performances and emission characteristics between biodiesel and conventional diesel fuel were carried out. Results show that low temperature combustion can be achieved at $O_2$ concentration of around 7~8% for both biodiesel and diesel fuels. Especially, by use of biodiesel, noticeable reduction (maximum 50% of smoke was observed at low and middle loads compared to conventional diesel fuel. In addition, THC(total hydrocarbon) and CO(Carbon monoxide) emissions decreased by substantial amounts for biodiesel fuel. Results also indicate that even though about 10% loss of engine power as well as 14% increase of fuel consumption rate was observed due to lower LHV(lower heating value) of biodiesel, thermal efficiencies for biodiesel fuel were slightly elevated because of power recovery phenomenon.

• Solar Energy
• /
• v.19 no.1
• /
• pp.19-27
• /
• 1999

In this study, basic design data which were required for development of highly efficient ice storage system with low temperature latent heat were experimentally obtained. The ice storage system considered in this study was the one that has been widely used in the developed country and called the ice-on-coil type. Using the system, the ice storage performance for various design parameters which were the flow direction and the inlet temperature of the secondary fluid was tested. In addition, the clockwise variation of the heat transfer characteristics of the PCM in the ice storage tank were investigated. During the melting processes in the ice storage tank with several vertical tubes, decrease of the solid-liquid interface area, which was the heat transfer area, between the floating ice and the water made the decreasing rate of IPF less. Also, the total melting energy for the upward flow of the secondary fluid was higher than that for the downward flow during the melting process, but this trend did not appear if the initial temperature of the PCM was $4^{\circ}C$. The average ice recovery efficiency for the upward flow of the secondary fluid was higher than that for the downward flow.

• KSBB Journal
• /
• v.21 no.3
• /
• pp.199-203
• /
• 2006

Precipitation and reactive distillation were employed to recover lactic acid from fermentation broth. Lime was initially added to fermentation broth in order to convert soluble lactic acid to an insoluble calcium lactate form. Drowning-out crystallization was used to decrease the solubility of calcium lactate by adding ethanol as a co-precipitant. In the ideal solution of organic acids as well as fermentation broth, precipitation experiments were performed with varying amounts of ethanol. Precipitation process was followed by reactive distillation. Carboxylate salts formed in the previous precipitation process were mixed with carbon dioxide and triethylamine to precipitate as calcium carbonate. The remaining liquid was distilled for 1 hr at different temperatures. Triethylamine and water were recovered from the top of the distiller, while organic acids, inducing lactic acid as a main component remained in feeding bottle. The yield of recovered lactic acid was 67.5% with the purity of 99.7%.

• Journal of Korean Society of Environmental Engineers
• /
• v.35 no.2
• /
• pp.75-83
• /
• 2013

We applied a sensitive method based on on-line solid-phase extraction (SPE) and liquid chromatography/mass spectrometry (LC/MSD) using an electrospray interface for the determination of eleven perfluorinated compounds (PFCs) in water. The on-line connection suppressed the target loss by keeping the cartridge from drying, which resulted in improvement of the recovery and saving of the analytical time. For the on-line solid-phase extraction of 10 mL water samples, recoveries were between $80.4{\pm}5.2%{\sim}109.5{\pm}1.4%$ and limit of quantification (LOQ) were 3.6~15.9 ng/L for the PFCs. The total PFCs concentrations of the tributaries and main stream of Nakdong River water samples were in the range of $8.0{\sim}678.6{\mu}g/L$.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.31 no.1
• /
• pp.85-96
• /
• 2003

For a design of rocket engine nozzle, chemical equilibrium analysis which shares the same numerical characteristics with frozen flow analysis can be used as an efficient design tool for predicting maximum thermodynamic performance of the nozzle. 10 this study, a chemical equilibrium flow analysis code was developed for the design of hydrocarbon fueled rocket engines. 10 oder to understand the thermochemical characteristics occurring in a nozzle through the expansion process, such as recombination of chemical components and the accompanying energy recovery, chemical equilibrium flow analysis was carried out for the KSR-III rocket engine nozzles together with frozen flow and non-equilibrium flow analyses. The performance evaluation based on the present KSR-III nozzle flow analyses has provided an understanding of the thermochemical process in the nozzle and additionally, it has confirmed that the newly designed nozzle shape modified to have a reduced exit area ratio is an adequate design for obtaining an increased ground thrust.

• Applied Biological Chemistry
• /
• v.40 no.5
• /
• pp.442-446
• /
• 1997

A new analytical method was developed by HPLC after supercritical fluid extraction and fluorogenic derivatization for the determination of quinclorac (3,7-dichloro-8-quinoline carboxylic acid) in soil. The graminicide quinclorac was extracted from soil by supercritical fluid extraction. Supercritical carbon dioxide at 7000 psi $(80^{\circ}C)$ modified with 30% of methanol extracted quinclorac from soil samples at the level of $0.1ng\;g^{-1}$ with 96% recovery. Extracted quinclorac was determined by HPLC as a fluorescent derivative. Derivatization was made with 4-bromomethyl-7-methoxycoumarin (4-Br-Mmc) using 18-crown-6-ether as a catalyst. The conversion was completed within 30 min and the limit of detection was 0.5 ppb to prove that the procedure could be used in the residue analysis of the pesticides containing carboxylic acid group.