• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.9B
• /
• pp.793-805
• /
• 2003

In OBS (Optical Burst Switching) networks which decouple the burst from its header, the fault of a fiber link can lead to the failure of all the light-path that traverses the fiber. Because each light-path is expected to operate at a rate of a few Gbps by using WDM (Wavelength Division Multiplexing) technology, any failure may lead to large data loss. Therefore, an efficient recovery scheme must be provided. In this paper, we analyze network utilization and BCP (Burst Control Packet) loss rate according to each link failure by applying the conventional restoration schemes in OBS networks. And through these simulation results, an ASPR scheme is proposed improve the fault management scheme in terms of recovery time and throughput. Finally, We compare the performance of our proposed scheme with that of the conventional one with respect to burst loss rate, resource utilization and throughput by OPNET simulations.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.10 no.2
• /
• pp.107-114
• /
• 2007

This paper describes the Petri Net(PN) model for reliability analysis of fault-tolerant dual Ethernet which Is applied in Naval Combat System. The network for Naval Combat System performs failure detection and auto path recovery by handling redundant path in case of temporary link failure. After studying the behavior of this kind of network, the reliability analysis model is proposed using stochastic Petri Net and continuous-time Markov chains. Finally, the numerical result is analyzed according to changing the failure rate and the recover rate of link.

• Annual Conference of KIPS
• /
• 2016.04a
• /
• pp.124-126
• /
• 2016

Successful deployment of the Software Defined Network (SDN) depends on its ability to cope up with network failures. There are various types of failures that may occur in an SDN. The most common are switch and link failures. It is necessary to recover the network from failures for a continuous service availability. But for the real-time services fast recovery from the failure is required to minimize the service disruption time. In the proposed work, we focused on minimizing the recovery time after the failure is detected. Once the failure is detected, the controller involvement is needed to dynamically reroute the failure disrupted flows from the failed component to an alternate path. The aim of the proposed scheme is to provide a traffic management scheme which can react to the dynamic network events by rapidly modifying the forwarding behavior of the switches for faster in-band network adaptability. The proposed scheme (1) Considers the shared data and control path delay (2) Optimally utilize the network resources (3) Eliminates the need of constant monitoring overhead at the controller which results into faster detouring and ultimately rapid recovery.

• International Journal of Computer Science & Network Security
• /
• v.21 no.1
• /
• pp.119-124
• /
• 2021

Elastic Optical Networks (EONs) allow to solve the high demand for bandwidth due to the increase in the number of internet users and the explosion of multicast applications. To support multicast applications, network operator computes a tree-shaped path, which is a set of optical channels. Generally, the demand for bandwidth on an optical channel is enormous so that, if there is a single fiber failure, it could cause a serious interruption in data transmission and a huge loss of data. To avoid serious interruption in data transmission, the tree-shaped path of a multicast connection may be protected. Several works have been proposed methods to do this. But these works may cause the duplication of some resources after recovery due to a link failure. Therefore, this duplication can lead to inefficient use of network resources. Our work consists to propose a method of protection that eliminates the link that causes duplication so that, the final backup path structure after link failure is a tree. Evaluations and analyses have shown that our method uses less backup resources than methods for protection of a multicast connection.

• The Transactions of the Korea Information Processing Society
• /
• v.7 no.9
• /
• pp.2969-2979
• /
• 2000

A mobile host has failure causes such as failure of the mobile host, disconnection of the mobile host, and wireless link failure that have not been seen in traditional computing environments. So far there have been few studies on fault tolerance of a mobile host in mobile computing environments. The Lazy scheme, a failure recovery technique of the mobile host, is a cost-effective one. However, this scheme has a defect that the mobile host cannot be recovered from failure of the base station with acheckpoint of the mobile host. In this paper, we propose and evaluate the Redundant Lazy scheme for performance improvement of the Lazy scheme.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.7
• /
• pp.1541-1548
• /
• 2012

This paper proposes a new multipath-based routing protocol on MANETs with Fast-Recovery of failures. The proposed protocol establishes the primary and secondary paths between a source and a destination considering the end-to-end packet reception reliability of routes. The primary path is used to transmit messages, and the secondary path is used to recover the path when detecting failures on the primary path. If a node detects a link failure during message transmission, it can recover the path locally by switching from the primary to the secondary path. By allowing the intermediate nodes to recover locally the route failure, the proposed protocol can reduce the number of packet loss and the amount of control packets for setting up new paths. The simulation result using QualNet simulator shows that the proposed protocol was about 10-20% higher than other protocols in terms of end-to-end message delivery ratio and the fault recovery time in case of link fault was about 3 times faster than the other protocols.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.5B
• /
• pp.397-404
• /
• 2006

As an increase in recent optical network-based IP services, GMPLS management framework becomes more important than ever before. In this paper, we propose the dynamic GMPLS path management algorithm, which can satisfy the users with their traffic engineering recovery requirements and find out the best backup service path under multiple link failures. To be more specific, we are deriving the soluble conditions of a backup path which is satisfied in a GMPLS network. In addition, through proposing the fast backup path selection algorithm, we can sufficiently satisfy a user's recovery requirement and minimally protect the suspension of the service against a link failure.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.7 no.2
• /
• pp.271-287
• /
• 2013

We propose a new multipath-based reliable routing protocol on MANETs, Multipath-based Reliable routing protocol with Fast-Recovery of failures (MRFR). For reliable message transmission, MRFR tries to find the most reliable path between a source and a destination considering the end-to-end packet reception reliability of the routes. The established path consists of a primary path that is used to transmit messages, and the secondary paths that are used to recover the path when detecting failures on the primary path. After establishing the path, the source transmits messages through the primary path. If a node detects a link failure during message transmission, it can recover the path locally by switching from the primary to the secondary path. By allowing the intermediate nodes to locally recover the route failure, the proposed protocol can handle the dynamic topological change of the MANETs efficiently. The simulation result using the QualNet simulator shows that the MRFR protocol performs better than other protocols in terms of the end-to-end message delivery ratio and fault-tolerance capability.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.6 no.12
• /
• pp.3081-3099
• /
• 2012

We propose a new multipath-based reliable routing protocol on MANETs, Multipath-based Reliable routing protocol with Fast-Recovery of failures (MRFR). For reliable message transmission, MRFR tries to find the most reliable path between a source and a destination considering the end-to-end packet reception reliability of the routes. The established path consists of a primary path that is used to transmit messages, and the secondary paths that are used to recover the path when detecting failures on the primary path. After establishing the path, the source transmits messages through the primary path. If a node detects a link failure during message transmission, it can recover the path locally by switching from the primary to the secondary path. By allowing the intermediate nodes to locally recover the route failure, the proposed protocol can handle the dynamic topological change of the MANETs efficiently. The simulation result using the QualNet simulator shows that the MRFR protocol performs better than other protocols in terms of the end-to-end message delivery ratio and fault-tolerance capability.

• Journal of KIISE:Information Networking
• /
• v.31 no.2
• /
• pp.233-241
• /
• 2004

In this paper, we propose a packet-lossless fast rerouting scheme at a link/node fault in MPLS (Multiprotocol Label Switching) network with minimized accumulated buffer delay problem at ingress node. The proposed scheme uses a predefined, alternative LSP (Label Switched Path) In order to restore user traffic. We propose two restoration approaches. In the first approach, an alternative LSP is initially allocated with more bandwidth than the protected working LSP during the failure recovery phase. After the failure recovery, the excessively allocated bandwidth of the alternative LSP is readjusted to the bandwidth of the working LSP. In the second approach, we reduce the length of protected working LSP by using segment-based restoration. The proposed approaches have merits of (ⅰ) no buffer delay problem after failure recovery at ingress node, and (ⅱ) the smaller required buffer size at the ingress node than the previous approach.