• Proceedings of the KOSOMBE Conference
• /
• v.1997 no.11
• /
• pp.511-514
• /
• 1997

The objective of this study is to propose a finite element based design of the dental implant replacing unction and shape of natural teeth. For this, geometric actors were varied to investigate stress distribution of the alveolar bone around dental implant. In this study, the results were obtained based on the theory of linear elastic, with geometrically axisymmetric assumption. Geometric actors determining implant shape are ranged as 0.2mm-0.6mm, 0.04mm-0.1mm, 0.46mm-0.84mm or height of thread, radius of curvature of thread, and pitch, respectively. The stresses in the alveolar bone caused by biting force playa major role in determining implant stability. Especially, the stress concentration in the cortical bone causes bone resorption and finally makes the implant unstable. Therefore, the stress distributions were investigated on the side of the alveolar bone focusing on the area of cortical bone. The maximum von Mises stress was found to increase up to 6% as the height of thread increases, while its value was to decrease to 19% when the radius of curvature increase within the assigned ranges. For the variation of pitch, the larger size of pitch results in greater maximum von Mises stress when the length of the implant under consideration is fixed. The existence of the neck below the shoulder did not affect the stress distribution in the region of alveolar bone. However, the stresses on the side of the implant near the neck were found to be different by 20% approximately. Therefore, the neck can provide the stability of the implant against continuing biting movement. As a conclusion, the finite element based study shows a potential in designing the dental implant systematically.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.18 no.2
• /
• pp.153-159
• /
• 2012

This study gives the vertical motion analysis in multi-directional irregular waves using a commercial code(MAXSURF v.16) based on linear strip theory for a training ship. To verify the commercial code prior to the analysis, we guarantees the reliability of this paper's results using the commercial code by comparing with the results(Flokstra, 1974) of same hull and experimental conditions on a Panamax container. The analysis conditions are Beaufort wind scale No. 5($\bar{T}=5.46$, $H_{1/3}=2m$) based on ITTC wave spectrum, encounter angle Head & bow seas($150^{\circ}$) and Froude number Fn=0.257. Finally, we calculates heave RAO, pitch RAO and obtains the result of ship's response spectra for heave and pitch motions. In the motion response spectrum under the multi-directional irregular waves, heave motion reacts slightly high in short-crested waves and pitch motion reacts high in long-crested waves.

• Membrane Journal
• /
• v.12 no.2
• /
• pp.97-106
• /
• 2002

Small angle light scattering (SALS) and field emission scanning electron microscope (FE-SEM) have been used to investigate the light scattering patterns with time evolved during water vapor quenching (relative humidity of 53 (${\pm}3)%$ at $26^{\circ}C$ of polysulfone (PSf)/NMP/Alcohol and chlorinated poly(vinyl chloride) (CPVC)/THF/Alcohol, respective1y. Time dependence of the position of the light scattering maximum was observed at PSf dope solutions, confirming spinodal decomposition (SD), while CPVC dope solutions showed a decreased scattered light intensity with an increased q-value, indicating nucleation & growth (NG). For the each system, domain growth rate in the intermediate and late stage of phase separation decreased with increasing the number of carbon of alcohol used as additive (non-solvent). Also, in the early stage for SD, the scattering intensity with time was in accordance with Cahn's linear theory of spinodal decomposition, regardless of types of non-solvent additive. Also, the size scales obtained by SALS were mutually compared to domain sizes gained by FE-SEM measurement. These observations of scattering pattern were much clearly observed for the 20PSf/70NMP/10n-butanol (w/w%) and agreed with the theoretical predictions for scattering patterns of each stage like the early, the intermediate, and the late stage of SD type phase separation. As the scattering maximum was observed at the larger angles (larger q) in the order of n-butanol > n-propanol > methanol > no alcohol, the pore size of final morphology decreased.

• Korean Journal of Food Science and Technology
• /
• v.22 no.1
• /
• pp.1-6
• /
• 1990

The thermal diffusivity of defatted and nondefatted starches were measured on the basis of one dimensional semi-infinitive theory. Differential scanning calorymetry was used to study the effects of cooling rate, fat and water contents on the enthalpy and entropy changes with the cooling rate of $-2.5{\sim}10^{\circ}C/min$. Thermal diffusivity of defatted and nondefatted straches were determined to be $4.14{\times}10^{-4}{\sim}4.96{\times}10^{-4}(m^2/h),\;4.09{\times}10^{-4}{\sim}4.81{\times}10^{-4}(m^2/h)$ in unfrozen state, and $2.78{\times}10^{-3}{\sim}3.91{\times}10^{-3}(m^2/h),\;2.26{\times}10^{-3}{\sim}3.57{\times}1-^{-3}(m^2/h)$ in frozen state respectively. On decreasing temperatures in frozen state, thermal diffusivities of starches were increased and entropy and enthalpy were decreased, and more rapid cooling rates resulted in a decrease in entropy. A linear relation was observed between enthropy, enthaly and water content. Thermal diffusivity was decreased, and entropy was increasing fat content. With water content ranging from 35 to 90%, enthalpy and entropy of straches were found to be $107{\sim}216 (kcal /moi),\;0.45{\sim}0.94(kcal/mol.\;K)$, respectively.

• Korean Journal of Optics and Photonics
• /
• v.24 no.5
• /
• pp.245-250
• /
• 2013

The Wiener-Khinchin theorem, which means that the autocorrelation function of a signal corresponds to the power spectrum of the signal, is very important in signal processing, spectroscopy and telecommunications engineering. However, because of needs for some relatively expensive equipments such as a correlator and the signal processing system, its demonstration in most undergraduate class is not easy so far. Recently, digital oscilloscopes whose functions can be replaced foresaid equipments are marketed with development of digital engineering. In this paper, a simple demonstration of the theorem is given by a digital storage oscilloscope and a personal computer with its theoretical background. The reason that deals again with this theorem which has been introduced in 1930 is that it has been not well informed yet to us and theoretical background of the demonstration is directly introduced from its driving process. Through deriving process of the theorem, some extended physical meanings of the impedance, power, power factor, Wiener spectrum, linear system response and, furthermore, basic idea of the Planck's quantization in the black body theory reveal themselves naturally. Hence it can be referred to lectures in general physics, modern physics, spectroscopy and material characterization experiment.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.42 no.4 s.304
• /
• pp.111-118
• /
• 2005

In this paper, we employ the modulation technique for improving the characteristics of beamformer in the low frequencies and thus improving the overall noise reduction performance. In the 1-dimensional uniform linear microphone arrays, we can suppress the narrowband noise component using the delay-and-sum beamforming. But, for the wideband noise signal, the delay-and-sum beamformer does not work well for the reduction of low frequency component because the inter-element spacing is usually set to avoid spatial aliasing at high frequencies. Hence, the beamwidth is not uniform with respect to each frequency and it is usually wider at the low frequencies. In order to obtain the beamwidth independent of frequencies, subarray systems[1][2][3][4] and multi-beamforming[5] have been proposed. However these algorithms need large space and more microphones since they are based on the theory that the size of the array is proportional to the wavelength of the input signal. In the proposed beamformer, we reduce the low frequency noise by using modulation technique that does not need additional sensors or non-uniform spacing. More Precisely, the array signals are split into subbands, and the low frequency components are shifted to high frequencies by modulation and reduced by the delay-and-sum beamforming techniques with small size microphone array. Experimental results show that the proposed technique Provides better performance than the conventional ones, especially in the low frequency band.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.23 no.1
• /
• pp.1-8
• /
• 2010

The Fourier series uses a vibrating wave that possesses an amplitude that is like the one of the sine curve. Therefore, the functions used in the Fourier series do not change due to the value of the frequency and that set a limit to express irregular signals with rapid oscillations or with discontinuities in localized regions. However, the wavelet series analysis(WSA) method supplements these limits of the Fourier series by a linear combination of a suitable number of wavelets. By using the wavelet that is focused on time, it is able to give changes to the range in the cycle. Also, this enables to express a signal more efficiently that has singular configuration and that is flowing. The main objective of this study is to propose a scheme called wavelet series analysis for the application of wavelet theory to one-dimensional problems represented by the second-order elliptic equation and to evaluate theperformance of proposed scheme comparing with the finite element analysis. After a through evaluation of different types of wavelets, the HAT wavelet system is chosen as a wavelet function as well as a scaling function. It can be stated that the WSA method is as efficient as the FEA method in the case of axial bars with distributed loads, but the WSA method is more accurate than the FEA method at the singular points and its computation time is less.

• Journal of the Korean Society for Library and Information Science
• /
• v.50 no.1
• /
• pp.331-351
• /
• 2016

Digitalized data and literature in scholarly community has developed the concept of digital humanities and cyberscholarship which indicate the characteristics of a new aspect and approach in scholarly activities with digitalized resources or new media. This study was performed in order to identify the changes in national research activities of art and humanities by using a multi-modal approach. The combined methodology of in-depth interview and content analysis on publishing and citing behaviors in literature was executed. The steps of research process is identified as a non-linear combination of 3 parts: developing research idea, developing the research idea to write, and submitting manuscript to publish. Prominent implementations of cyberscholarship were found in the 2nd step for accessing and using research data and literatures. Understanding the characteristics of scholar communication using cyberscholarhip factors in humanities for interdisciplinarity, sophisticating the environment of cyberscholarhip for data sharing, investing and developing archivist and archives, and providing a various platform for accelerating scholarly communication were derived by the panel discussion for developing interdisciplinary research for humanities.

• Journal of the Korean GEO-environmental Society
• /
• v.8 no.4
• /
• pp.47-55
• /
• 2007

Using the results of the Piezocone Penetration Test (PCPT) which were executed at the Yangsan-Mulgum site, the applicability of the interpretation methods for estimating the coefficient of consolidation ($C_v$) of soft clay was evaluated. At the same time, laboratory soil tests using the total of 172 undisturbed soft clay samples from the 44 regions of the Yangsan-Mulgum site were performed to study the differency in the coefficient of consolidation ($C_v$) compared to the results of PCPT. The calculated constrained modulus ($M_{\varepsilon}$) and coefficient of consolidation ($C_v$) using the results of consolidation laboratory tests which are based upon the consolidation theory of Terzaghi were compared with the predicted constrained modulus ($M_p$) and coefficient of consolidation ($C_{v-{M_p}}$) from the PCPT. The relationship between the predicted constrained modulus ($M_p$) and the calculated constrained modulus($M_c$) were showed good correlation. The $M_p$ by the Jones & Rust method were showed mostly similar to the calculated constrained modulus ($M_c$). The relationship between the coefficient of consolidation ($C_v$) obtained from the consolidation tests and the calculated coefficient of consolidation ($C_{v-{M_p}}$) were showed a linear relationship. The results of the calculated coefficient of consolidation ($C_{v-{M_p}}$) were about 54% of the value of the coefficient of consolidation ($C_v$) obtained from the consolidation tests.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.29 no.2
• /
• pp.77-82
• /
• 2017

Recently, the possibility of abnormal waves of which height is greater than design wave height have been increased due to the climate change, and therefore it has been urgent to secure the stability for harbor structures. As a countermeasure for improving the stability of conventional caisson breakwaters, a method has been proposed in which adjacent caissons are interlocked with each other to consecutively resist the abnormal wave forces. In order to reflect this research trend, the reduction effect of the maximum wave force resulted from introducing a long caisson has been presented in the revision to the design criteria for ports and fishing harbors and commentary. However, no method has been proposed to evaluate the stability of interlocking caisson breakwater. In this study, we consider the effect of the phase difference of the oblique incidence of the wave based on the linear wave theory and apply the Goda pressure formula for considering design wave pressure distribution in the vertical direction. Sliding stability assessment formula of an interlocking caisson breakwater is proposed for regular, irregular, and multi-directional irregular wave conditions.