• Tribology and Lubricants
• /
• 제22권5호
• /
• pp.290-300
• /
• 2006

The dielectric constants of used diesel engine oils were obtained at a few temperatures and a frequency. Through analyzing the characteristics of dielectric constant, the related correlation between the changes in dielectric constants of oil and the degree of oil deterioration is going to be found. The dielectric constant was calculated using cross capacitances measured by a sensor tube. As results of the measurement of the fresh engine oil's dielectric constant, it was found that the value of dielectric constant was set down below $60^{\circ}C$ regardless changing frequency. Further, above 6 kHz, the dielectric constant was set down even if temperature was above $100^{\circ}C$. Therefore, for the measurement of used oils, it was selected the frequency of 6 kHz, and the temperature of $80^{\circ}C$ preventing a certain ionic-conduction effects on the measured dielectric constant and the evaporation of a certain fluid mixed with engine oil. Specially, the effects of the mixing fluid like coolant, water and fuel on the fresh engine oil's dielectric constant were studied. It was found that the oil mixed with coolant showed the highest value, next water, and the lowest fuel. As results of the measurement of the used engine oil's dielectric constant, it was found that the possible changed rate of the used engine oil's dielectric constant based on the warning limit for engine oil in service was below 10% for diesel engine oil.

• Toxicological Research
• /
• 제27권3호
• /
• pp.137-141
• /
• 2011

This study was conducted to assess the exposure risk through inhalation to baby powder for babies and adults under simulated conditions. Baby powder was applied to a baby doll and the amount of baby powder consumed per application was estimated. The airborne exposure to baby powder during application was then evaluated by sampling the airborne baby powder near the breathing zones of both the baby doll and the person applying the powder (the applicator). The average amount of baby powder consumed was 100 mg/application, and the average exposure concentration of airborne baby powder for the applicator and baby doll was 0.00527 mg/$m^3$ (range 0.00157~0.01579 mg/$m^3$) and 0.02207 mg/$m^3$ (range 0.00780~0.04173 mg/$m^3$), respectively. When compared with the Occupational Exposure Limit of 2 mg/$m^3$ set by the Korean Ministry of Labor and the Threshold Limit Value (TLV) of 2 mg/$m^3$ set by the ACGIH (American Conference of Governmental Industrial Hygienists), the exposure concentrations were much lower. Next, the exposure to asbestos-containing baby powder was estimated and the exposure risk was assessed based on the lung asbestos contents in normal humans. As a result, the estimated lung asbestos content resulting from exposure to asbestos-containing baby powder was found to be much lower than that of a normal Korean with no asbestos-related occupational history.

• 한국정보통신학회논문지
• /
• 제17권4호
• /
• pp.1034-1041
• /
• 2013

지체상금은 채무에 대한 이행이 가능함에도 불구하고 채무자가 자신의 귀책사유로 인해 이행하지 아니한때 즉, 이행 지체가 발생한 경우에 채무자가 지급해야 하는 지연 배상금을 말한다. 그런데 현행 국내 업체와의 계약 시 이행 지체가 발생 할 경우, 지연 배상금의 개념이 아닌, Penalty개념으로 지체상금을 무한정 부과 하므로 써 분쟁이 지속되고 있으며, 이에 따라 방위사업청의 행정낭비와 업체의 비용부담이 가중 되고 있다. 따라서 국내 방산 및 군수조달분야의 지체상금 제도 개선이 요구되고 있다. 본 논문에서는 국내 방산 업체에 적용하고 있는 지체상금제도에 대한 문제점을 분석하고, 주요 선진국 제도와 비교하여, 지체상금제도 중에서 가장 문제가 되고 있는 지체상금 상한제 설정 방안을 연구 하고자 한다.

• 대한전자공학회논문지
• /
• 제12권3호
• /
• pp.13-19
• /
• 1975

CuCl, KDP 결정체를 이용한 지그재그형 진헹파 전기광학적 레이저 변조기에 대해 자세히 해석했다. 변조기와 크기와 대역폭은 변조용 결정체의 광학적 특성및 M/W유전특성에 의해 결정됨을 알수 있다. 더욱 광손실과 M/W손실의 영향, 입사각, 회절등의 영향을 규명했고 최적 설계법을 제시했다. 중요한 결과를 요약하면 다음과 같다. (1) CuCl, KDP로 10(GHz)이상의 대역폭에서 3(watt)이하의 변조전력으로 50%변조를 얻었다. (2) 변조주파수 한계의 상한은 레이저 빔폭에 의한 차단주파수로 인해 제한된다. A detailed analysis has been carried out of a zigzag traveling wave electro-optic laser modulator usin3 CuCl, KDP Crystal. The inclusion of such practical factors as M/W and optical loss results in an optimum design in which modulator dimensions and bandwidth limitation are uniquely determined by optical and M/W dielectic properties of modulating crystal. The main conclusion of the analysis are: (1) CuCl, KDP may be used to produce 50% modulation over bandwidth of 10(GHz) with less than (watt) of modulating power. (2) The upper modulation frequency limit is set by a cutoff frequency which arises from finite width of optical beam.

• 농업과학연구
• /
• 제46권1호
• /
• pp.183-194
• /
• 2019

Adulteration of argan oil with some other cheaper oils with similar chemical compositions has resulted in increasing demands for authenticity assurance and quality control. Fast and simple analytical techniques are thus needed for authenticity analysis of high-priced argan oil. Raman spectroscopy is a potent technique and has been extensively used for quality control and safety determination for food products In this study, Raman spectroscopy in combination with a net analyte signal (NAS)-based methodology, i.e., hybrid linear analysis method developed by Goicoechea and Olivieri in 1999 (HLA/GO), was used to predict the different concentrations of olive oil (0 - 20%) added to argan oil. Raman spectra of 90 samples were collected in a spectral range of $400-400cm^{-1}$, and calibration and validation sets were designed to evaluate the performance of the multivariate method. The results revealed a high coefficient of determination ($R^2$) value of 0.98 and a low root-mean-square error (RMSE) value of 0.41% for the calibration set, and an $R^2$ of 0.97 and RMSE of 0.36% for the validation set. Additionally, the figures of merit such as sensitivity, selectivity, limit of detection, and limit of quantification were used for further validation. The high $R^2$ and low RMSE values validate the detection ability and accuracy of the developed method and demonstrate its potential for quantitative determination of oil adulteration.

• 대한전기학회논문지:전력기술부문A
• /
• 제53권11호
• /
• pp.596-603
• /
• 2004

This paper proposes an expert system based on the pattern recognition method which can enhance the accuracy and effectiveness of real-time bus reconfiguration strategy for the transfer of faulted load when a main transformer fault occurs in the automated substation. The minimum distance classification method is adopted as the pattern recognition method of expert system. The training pattern set is designed MTr by MTr to minimize the searching time for target load pattern which is similar to the real-time load pattern. But the control pattern set, which is required to determine the corresponding bus reconfiguration strategy to these trained load pattern set is designed as one table by considering the efficiency of knowledge base design because its size is small. The training load pattern generator based on load level and the training load pattern generator based on load profile are designed, which are can reduce the size of each training pattern set from max L/sup (m+f)/ to the size of effective level. Here, L is the number of load level, m and f are the number of main transformers and the number of feeders. The one reduces the number of trained load pattern by setting the sawmiller patterns to a same pattern, the other reduces by considering only load pattern while the given period. And control pattern generator based on exhaustive search method with breadth-limit is designed, which generates the corresponding bus reconfiguration strategy to these trained load pattern set. The inference engine of the expert system and the substation database and knowledge base is implemented in MFC function of Visual C++ Finally, the performance and effectiveness of the proposed expert system is verified by comparing the best-first search solution and pattern recognition solution based on diversity event simulations for typical distribution substation.

• 해양환경안전학회지
• /
• 제18권5호
• /
• pp.423-430
• /
• 2012

해상에서 제한속력은 항만 정온도(Calmness) 유지와 원활한 교통흐름 유도, 해양사고 방지에 목적이 있다. 우리나라는 현재 19개 항만에서 제한속력을 지정하여 사용 중에 있으나, 제한속력 적절성과 설정 기준에 대하여 문제가 제기되고 있다. 본 연구는 현재 시행중인 제한속력에 대한 검토와 제한속력 설정 기준과 표준 모델 개발의 필요성을 확인하기 위한 기초 연구로서, 우리나라 항만과 접근수로에 대한 제한속력과 선박 통항 실태를 조사 분석하였다. 조사 분석 결과 전체 평균 48 %의 위반율을 보이고 있었으며 여객선과 5.000톤 이상의 중 대형 선박에서 위반율이 높았다. 또한 평균속력이 제한속력 보다 높은 지역이 있었으며 선박간의 속력 편차도 4.2-5.2노트로 조사되었다. 평균속력과 속력 편차가 높은 항만일수록 해양사고율도 높았다. 따라서 선박 통항속력 관리에 대한 제도적 검토와 개선이 필요한 실정이다.

• 대한기계학회논문집
• /
• 제17권9호
• /
• pp.2223-2233
• /
• 1993

An engineering method is suggested to calculate the applied load versus crack extension in the elastic-plastic fracture. The condition for an increment of crack extension is set by a critical increment of crack-up opening displacement(CTOD). The ratio of the CTOD increment to the incremental crack extention is a critical crack-tip opening angle(CTOA), assumed to be constant for a material of a given thickness. The Dugdale model of crack-tip deformation in an infinite plate is applied to the method, and a complete solution for crack extension and crack instability is obtained. For finite-size specimens of arbitrary geometry in general yielding, an approximate generalization of the Dugdale model is suggested so that the approximation approaches the small-scale yielding solution in a low applied load and the finite-element solution in a large applied load. Maximum load is calculated so that an applied load attains either a limit load on an unbroken ligament or a peak load during crack extension. The proposed method was applied to three-point bend specimens of a carbon steel SM45C in various sizes. Reasonable agreements are found between calculated maximum loads and experimental failure loads. Therefore, the method can be a viable alternative to the J-R curve approach in the elastic-plastic fracture analysis.

• 한국항만경제학회지
• /
• 제20권2호
• /
• pp.73-87
• /
• 2004

The purpose of this paper is to setup reasonable criterion for underwriters to reimburse the expenses of suing and labouring incurred by assured, using game theory. As for the upper limit for the reimbursement, MIA and ICC do not mention at all but stipulate that proper and reasonable expenses shall be reimbursed, while ITC-Hulls set the amount insured as the upper limit to compensate the sum of expenses and damage loss. And as for failed measures of averting and minimizing loss, MIA and ICC do not mention either, while ITC-Hulls stipulates underwriters shall compensate the expenses and damage loss within the amount insured. The main results of this paper are as follows: First, it is for the benefit of underwriters to reimburse the expenses incurred to take such reasonable measures to avert or minimizing a loss which would be recoverable under the insurance. Second, the expenses of single measure should not be above the amount insured. Third, even if the measures failed, the expense should be reimbursed if it is less than the expected value of the subject-matter insured that could be recovered by the measures. Last, if the measures are taken several times individually, even if the sum of expenses might be above the amount insured, it should be reimbursed.

• 대한수의학회지
• /
• 제48권1호
• /
• pp.9-16
• /
• 2008

A method for the quantification of eugenol in the medicinal herb Clove was developed and validated. For preparation of sample solutions clove was dried at $60^{\circ}C$ for 2h and ground by mixer and extracted with 95% ethanol for shaking extraction. The elutes were analyzed by HPLC system included a reversed phase column, a isocratic mobile phase of 60% methanol and PDA detector set at 280 nm. Calibration graphs were linear with very good correlation coefficients ($r^2>0.9999$) from $0.0125~1{\mu}g/ml$. The limit of detection per sample injection ($20{\mu}l$) was $0.81ng/{\mu}l$ and limit of quantification was $2.47ng/{\mu}l$. The method showed good intra-day precision (%RSD 0.08 ~ 0.27%) and inter-day precision (%RSD 0.32 ~ 1.19%).