• ETRI Journal
• /
• v.34 no.5
• /
• pp.779-782
• /
• 2012

$CuIn_{1-x}Ga_xSe_2$ (CIGS) thin films are grown on Mo/soda lime glass using a reactive sputtering process in which a Se cracker is used to deliver reactive Se molecules. The Cu and $(In_{0.7}Ga_{0.3})_2Se_3$ targets are simultaneously sputtered under the delivery of reactive Se. The effects of Se flux on film composition are investigated. The Cu/(In+Ga) composition ratio increases as the Se flux increases at a plasma power of less than 30 W for the Cu target. The (112) crystal orientation becomes dominant, and crystal grain size is larger with Se flux. The power conversion efficiency of a solar cell fabricated using an 800-nm CIGS film is 8.5%.

• Journal of the Korean Chemical Society
• /
• v.7 no.2
• /
• pp.144-152
• /
• 1963

A study was made of the effect of composition changes and particle size on appearance of raw bristol glazes fired at cones 5, 8, and 11. Alumina and silica, alkali and lime variations were made to get some of the more promising glazes determining maturing ranges, modulus of rupture, and other factors such as gloss, smoothness, opacity, eggshelling, crazing, pinholing and crawling for each glaze. Modulus of rupture was measured for the glazes fired at only cone 11.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2017.11a
• /
• pp.113-114
• /
• 2017

In this study, the change of composition of cement hardened at high temperature through XRD was observed. The specimen was made of cement paste and the heating rate condition was applied at rapid thermal annealing (10.0℃ / min). The decrease of calcium hydroxide was not confirmed, but the calcium carbonate tended to be impossible or decreased after 800℃. Calcium silicate and larnite were observed to increase with increasing temperature. It is considered that silicic acid, which is a stable structure due to the decomposition of calcium silicate, is changed into a phase such as lime.

• Journal of the Korean Chemical Society
• /
• v.42 no.3
• /
• pp.251-265
• /
• 1998

Punch'ong and whiteware sherds excavated from four kilns located in Ch'unghyodong, Kwangju, Chollanamdo were analyzed for their body and glaze composition. They are classified into eight different groups by the site and layer from which they were collected. In principal component analysis of major composition, the punch'ong body separates out into several different groups. CHE2, made in early fifteenth century, has a higher aluminum and lower iron content compared to the later groups of lower grade. Whiteware body has a very high aluminum content of around 30 wt. in both soft type and hard type. Punch'ong glaze was determined to be lime type and whiteware alkali-lime type.

• Korean Journal of Materials Research
• /
• v.20 no.10
• /
• pp.524-534
• /
• 2010

Glass was fabricated using refused coal ore obtained from the Dogye coal mine in Samcheok. We additionally used soda ash and calcium carbonate to make a glass with the chemical composition of soda-lime glass, and we also used white, brown, and green glass cullet to make various kinds of colored glass. Transparent glass was fabricated by melting batch materials including refused coal ore at $1550^{\circ}C$ for 1 hr in an electrical furnace. The light transmittance and color chromaticity were measured by a UV/VIS/NIR spectrometer. Transparent glass with a light transmittance of over 80% was fabricated using normal refused coal ore and white glass cullet. Various kinds of colored glass with a light transmittance of 30-80% were fabricated using refused coal ore and brown or green glass cullet. The light transmittance of the mixed color glass samples, fabricated using normal refused coal ore and brown glass cullet and green glass cullet, indicated 30-47%, a relatively low value, in the condition of a cullet ratio of 20-50%. The characteristics of the color chromaticity of the glass samples were indicated in a chromaticity diagram by x-coordinates, y-coordinates, Y (lightness). The values of x-coordinates and y-coordinates were moved with a regular directional property according to the kind and amount of glass cullet. Therefore, we concluded that refused coal ore can be used for raw materials of color glass products like art glass and glass tile.

• Journal of the Korea Safety Management & Science
• /
• v.9 no.6
• /
• pp.197-204
• /
• 2007

Ceramic pigments were developed by using 4 kinds of Brass scraps. Each Brass scraps were mixed with same weight-ratio of Husk ash, and fine-ground by Rotate ring mill(RRG-120, Armstech industrial. co. Ltd, Korea) after firing at $900^{\circ}C$, $1000^{\circ}C$ and $1100^{\circ}C$. As a result, analysis of particle size of synthetic pigments by particle size analyser, they are $3{\mu}m$ as average. The resulting pigments were characterized by using XRD, FT-IR, SEM Structure of the crystals are Zn2SiO4,, and ZnO, Cu2O, CuO, and cristobalite are existed and particles' shape are plate or needle. As a result of analysis of chemical composition by XRF, synthetic pigments have high SiO2 and CuO content and have SnO2, ZnO and NiO, too. 1wt%, 3wt% and 5wt% pigments were added in each lime glaze, lime-barium glaze and lime-magnesia glaze, and fired at oxidation and reducing atmosphere to figure hue in glazes out. As a result of analysis of color, chroma and brightness by UV, colors of glazes fired at oxidation atmosphere turned into green from sky blue, and colors of glazes fired at reducing atmosphere turned into pink and red.

• Analytical Science and Technology
• /
• v.26 no.3
• /
• pp.211-221
• /
• 2013

This research aims to examine compositional and microstructural properties of grayish-blue-powdered celadon in Wonju Beopcheon-temple site. X-ray fluorescence sequential spectroscopy (XRF) with micro-point analysis, scanning electron microscopy (SEM) with energy dispersive spectroscopy (EDS) and X-ray diffraction (XRD) were applied to determine the chemical composition, microstructure and crystallinity of samples, respectively. As a result, the average compositions of bodies were low silica ($RO_2$) and high flux (RO+$R_2O$). Owing to the high content of calcium oxide the glaze is considered lime type between limealkali type. The body of celdon sheard was found quarts, mullite, microcline, albite. Especially, the body's chemical compositions were compared to the results of previous studies by using a Seger formula. The compositional properties of Grayish-blue-powdered celadon in Wonju Beopcheon-temple site showed diffrently from the the other grayish-blue-powdered celadon.

• Journal of the Korean GEO-environmental Society
• /
• v.23 no.1
• /
• pp.5-13
• /
• 2022

In tropical regions, lateritic soil is frequently used in road embankment. However, it is one of the sources of road failure owing to its low strength. Generally, cement and lime are used as stabilizers for lateritic soil, but they are not environmentally friendly. Some studies try to use eggshells, for they are food waste and share the same chemical composition as lime. Previous researchs have shown that eggshell powder could enhance the strength of lateritic soil. This research investigated the effect of particle size of the eggshell powder and the effect of the protein-membrane presence in the eggshell on stabilizing capacity of soil. Through laboratory tests, unconfined compressive strength was examined for various particle sizes. The particle size of eggshell powder ranging between 150 ㎛ and 88 ㎛ was appropriate size that made an excellent stabilizer at 3% concentration. On the other hand, the protein-membrane reduced the stabilizing ability of the eggshell powder when the content of eggshell powder is less than 4% in soil. Numerical analysis of road embankment was performed based on the results obtained in the laboratory tests. It is shown that the eggshell powder has improved the stability of the sub-base of the road embankment.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.66-66
• /
• 2008

Most of the properties of ITO films depend on their substrate nature, deposition techniques and ITO film composition. For the display panel application, it is normally deposited on the glass substrate which has high strain point (>575 degree) and must be deposited at a temperature higher than $250^{\circ}C$ and then annealed at a temperature higher than $300^{\circ}C$ in order to high optical transmittance in the visible region, low reactivity and chemical duration. But the high strain point glass (HSPG) used as FPDs is blocking popularization of large sizes FPDs because it is more expensive than a soda lime glass (SLG). If the SLG could be used as substrate for FPDs, then diffusion of Na ion from the substrate occurs into the ITO films during annealing or heat treatment on manufacturing process and it affects the properties. Therefore proper care should be followed to minimize Na ion diffusion. In this study, we investigate the electrical, optical and structural properties of ITO films deposited on the SLG and the Asahi glass(PD200) substrate by rf magnetron sputtering using a ceramic target ($In_2O_3:SnO_2$, 90:10wt.%). These films were annealed in $N_2$ and air atmosphere at $400^{\circ}C$ for 20min, 1hr, and 2hrs. ITO films deposited on the SLG show a high electrical resistivity and structural defect as compared with those deposited on the PD200 due to the Na ion from the SLG on diffuse to the ITO film by annealing. However these properties can be improved by introducing a barrier layer of $SiO_2$ or $Al_2O_3$ between ITO film and the SLG substrate. The characteristics of films were examined by the 4-point probe, FE-SEM, UV-VIS spectrometer, and X-ray diffraction. SIMS analysis confirmed that barrier layer inhibited Na ion diffusion from the SLG.

• Journal of Conservation Science
• /
• v.16 s.16
• /
• pp.104-109
• /
• 2004

The characteristics and composition of the ancient glasses excavated at Songdong-ri, Sangju, Kyongsangbuk-do were analyzed using Scanning Electron Microscope attached with Energy Dispersive Spectrometer. As the results, the glass beads of Songdong-ri showed that there were changed the composition, the color and types according to the periods. There were appeared potash and soda glass group at A.D.4 century and potash and mixed alkali glass group at A.D. 17 century. The potash glasses of A.D. 4c. were colored blue and contained low $Al_2O_3$ and CaO composition as below $5\%$. The soda glasses of This period were colored blue and red, and contained $Al_2O_3$ composition as upper $5\%$. But the potash glasses of A.D.17c. showed the transparent yellow color and considerably higher CaO, $11.7\%$. 'Coil glasses' typed unique were colored yellow-brown, Cu-blue and colorless, were classified the mixed alkali glass as upper $5\%\;of\;Na_2O\;and\;K_2O$. The composition of coil glasses were presented first at this study.