• Bulletin of the Korean Chemical Society
• /
• 제19권11호
• /
• pp.1156-1160
• /
• 1998

Alternating multilayer films of a cationic bipolar amphiphile and an anionic polyelectrolyte were prepared by a self-assembly method based on electrostatic attraction between opposite charges. The bipolar amphiphile contains an azobenzene unit in order to allow for a trans-cis photoisomerization to take place. Optical birefringence or dichroism was induced in the self-assembled film upon linearly polarized light irradiation. This dichroism could be reversibly written and erased by irradiation with light of an appropriate wavelength.

• KSBB Journal
• /
• 제28권3호
• /
• pp.170-176
• /
• 2013

The purpose of this study was to determine optimum condition of Pavlova lutheri and Phaeodactylum tricornutum. Detailed studies were carried out on the effects of various wavelengths of light-emitting diodes (LEDs), light intensities and air flow rations. For the Pa. lutheri, cell growth rates and maximum cell concentrations were similar regardless of wavelengths and air flow rates. Among the different light intensities, cell concentration increased when light intensity of red LED increased. For Ph. tricornutum, red LED was found to be the most effective light source, and light intensity of 3,100 Lux resulted in the most effective for the cultivation of Ph. tricornutum. Different air flow rates were tested to overcome shading effects due to denser cell concentration in the solution. Aeration of 0.8 vvm was determined to be the optimum aeration rate for the cultivation of Ph. tricornutum. Especially, five and two times greater cell concentrations of Pa. lutheri and Ph. tricornutum, respectively, were observed when air was applied.

• ETRI Journal
• /
• 제23권1호
• /
• pp.1-8
• /
• 2001

The performance of a long wavelength-band erbium-doped fiber amplifier (L-band EDFA) using 1530nm-band pumping has been studied. A 1530nm-band pump source is built using a tunable light source and two C-band EDFAs in cascaded configuration, which is able to deliver a maximum output power of 23dBm. Gain coefficient and noise figure (NF) of the L-band EDFA are measured for pump wavelengths between 1530nm and 1560nm. The gain coefficient with a 1545nm pump is more than twice as large as with a 1480nm pump. It indicates that the L-band EDFA consumes low power. The noise figure of 1530nm pump is 6.36dB at worst, which is 0.75dB higher than that of 1480nm pumped EDFA. The optimum pump wavelength range to obtain high gain and low NF in the 1530nm band appears to be between 1530nm and 1540nm. Gain spectra as a function of a pump wavelength have bandwidth of more than 10nm so that a broadband pump source can be used as 1530nm-band pump. The L-band EDFA is also tested for WDM signals. Flat Gain bandwidth is 32nm from 1571.5 to 1603.5nm within 1dB excursion at input signal of -10dBm/ch. These results demonstrate that 1530nm-band pump can be used as a new efficient pump source for L-band EDFAs.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2011년도 춘계학술대회 초록집
• /
• pp.118.1-118.1
• /
• 2011

The dye-sensitized solar cell (DSSC) is a device for the conversion of visible light into electricity, based on the sensitization of wide bandgap semiconductors. The performance of the cell mainly depends on a dye used as sensitizer. The absorption spectrum of the dye and the anchorage of the dye to the surface of TiO2 are important parameters determining the efficiency of the cell. Generally, transition metal coordination compounds(ruthenium polypyridyl complexes) are used as the effective sensitizers, due to their intense charge-transfer absorption in the whole visible range and highly efficient metal-to ligand charge transfer. However, ruthenium polypyridyl complexes contain a heavy metal, which is undesirable from point of view of the environmental aspects. Moreover, the process to synthesize the complexes is complicated and costly. Alternatively, organic dyes can be used for the same purpose with an acceptable efficiency. The advantages of organic dyes include their availability and low cost. We designed and synthesized a series of organic sensitizers containing long wavelength absorption-chromophores for the dye sensitized solar cell. The DSSC composed of Blue-chromophores for the sensitization absorbed long wavelength region which is different also applied into the dye-cocktail (mixing) system. The photovoltaic property of DSSCs organic long wavelength absorption-chromophores were measured and evaluated by comparison with that of individual chromophores.

• 한국분무공학회지
• /
• 제7권4호
• /
• pp.32-41
• /
• 2002

The breakup characteristics of liquid sheets formed by like-doublet injector were investigated in the cold-flow and atmospheric ambient pressure condition. The sheet breakup wavelength, which induces the sheet to be broken into ligaments, as well as the sheet breakup length, which is important for the flame location, was measured using a stroboscopic light. The liquid ligaments are formed intermittently after the breakup of sheet, and the wavelength of ligaments has been believed to have a relation to the combustion instability of liquid rocket engine. Therefore, the wavelength of ligaments and the breakup length of ligaments into fine drops were also measured. Since these spray characteristics are affected by the flow characteristics of two liquid jets before they impinge on each other, we focused on the effects of orifice internal flow such as the cavitation phenomenon that occurs inside the sharp-edged orifice. From the experimental results, we found that the liquid jet turbulence delays the sheet breakup and makes shorter wavelengths for both sheets and ligaments. Since the turbulent strength of sharp-edged orifice is stronger than that of round-edged orifice, the shape of orifice entrance results in large differences in the spray characteristics. Using these results, we proposed empirical models on the spray characteristics of the like-doublet injector, and these models are believed to provide some useful and actual data for designing liquid rocket combustors.

• 한국기계가공학회지
• /
• 제15권6호
• /
• pp.95-100
• /
• 2016

We suggest and simulate an optical filter that a red wavelength range cannot transmit to protect the psychological stress that originates from the cognition of red color in emergency medical technicians. When a nanohole hexagonal array is fabricated on gold film using Anodic Aluminum Oxide (AAO), the blocked wavelength can be tuned by the hole diameter and film thickness. The characteristic of the transmittance for normal incident white light is simulated with Finite Element Method (FEM) in the MATLAB platform. Although the transmittance of the overall wavelength is reduced by 50% by the gold film, the transmittance of the red wavelength range is decreased by over 87%.

• The Journal of Korean Physical Therapy
• /
• 제13권1호
• /
• pp.189-195
• /
• 2001

The Sun's ray is composed of Infared(49%), Visible light(40%) and Ultra violet(11%), however the ray getting to the earth is FIR(60%). IR(20%), and UV(20%). Human beings has utilized FIR already from time immemorial. Hershel found out Infrared for the first time, in the Industrial Revolution the Infrared and FI R had been begun to use making products. In asia. also, asian already has made use of FIR to treat the body, product things and make warm the house in the winter, as it had been called Wull therapy, fermentation. and On-Dol system. In these days, with contemporary science FIR would be begun to clear up the implication in the human body and organic compounds. IR classified by wavelength three parts NIR, MIR, FIR. There is FIR which is radiated from healthy human body the wave length is 8-14 m. It is difficult to standardized the wavelength of IR, since each related associations have a different opinion, so we suggested ideal IR wavelength and biological, phsiotherapical, medical FIR wavelength.

• 한국정보통신학회:학술대회논문집
• /
• 한국정보통신학회 2012년도 추계학술대회
• /
• pp.1009-1011
• /
• 2012

본 논문에서는 두개의 Unpolarized F-P LD를 이용한 상호주입 잠김 기반의 파장 가변 광원을 구현하였고, 온도 변화에 따른 특성을 분석하였다. 온도 변화에 따라 파장의 가변 범위가 최대 약 2nm이고, 상대적 밀도 잡음(RIN)는 최저 -110dB/Hz임을 확인하였다. 또한 온도가 높을수록 상대적 밀도 잡음(RIN)는 높아지고, Eye Pattern에 Beating Noise가 발생하는 것을 알 수 있었다.

• Journal of the Optical Society of Korea
• /
• 제20권5호
• /
• pp.601-606
• /
• 2016

In this study, in order to analyze the low-temperature sintering process of silver and copper nanoparticles, we calculate their melting temperatures and surface melting temperatures with respect to particle size. For this calculation, we introduce the concept of mean-squared displacement of the atom proposed by Shi (1994). Using a parameter defined by the vibrational component of melting entropy, we readily obtained the surface and bulk melting temperatures of copper and silver nanoparticles. We also calculated the absorption cross-section of nanoparticles for variation in the wavelength of light. By using the calculated absorption cross-section of the nanoparticles at the melting temperature, we obtained the laser threshold energy for the sintering process with respect to particle size and wavelength of laser. We found that the absorption cross-section of silver nanoparticles has a resonant peak at a wavelength of close to 350 nm, yielding the lowest threshold energy. We calculated the intensity distribution around the nanoparticles using the finite-difference time-domain method and confirmed the resonant excitation of silver nanoparticles near the wavelength of the resonant peak.

• E2M - 전기 전자와 첨단 소재
• /
• 제8권5호
• /
• pp.558-563
• /
• 1995

Dynamic characteristics of TbFeCo magneto-optical recording media at 680nm wavelength region were studied by means of computer simulation of disc structure and optimization of process variables during sputter deposition. With the slightly reduced Kerr rotation angle due to the reduced wavelength of optical laser source, the improved recording density in TbFeCo magneto optical media showing the CNR greater than 50dB could be achieved by only adjusting the thickness of dielectric and the recording layers when the wavelength of light source is changed from 780nm to 680nm. In addition, the recording power margin of 5mW and the 2mW minimum recording power was realized, It was shown from the present study that the increase in laser power density demonstrated feasibility of low cost and low power laser diode with the reduced optimum recording power.