• The Proceedings of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.13 no.2
• /
• pp.144-144
• /
• 1999

Phantom phenomena on the signal light was observed and change of perception-reaction time of the observer was measured. If phantom phenomena occurs, signal light perception- reaction time by the drivers is prolonged, the extent of which may disturb driving. Length of the perception-reaction time is affected by the luminance contrast between the turned-on and tuned-off signals. Based on the measured results, several methods to prevent phantom phenomena were suggested.

• Korean Chemical Engineering Research
• /
• v.44 no.4
• /
• pp.345-349
• /
• 2006

Conversion of DME (dimethyl ether) or methanol to light olefins (ethylene, propylene, butenes) over SAPO-34 were systematically studied, where it was observed that DME was dehydrated to light olefins and partially converted to by-products such as CO and $CO_2$ at various reaction temperatures on the time-on-stream. SAPO-34 catalyst during the DTO (dimetyl ether-to-olefins) reaction was significantly deactivated compared with MTO (methanol-toolefins) reaction. By addition of water to the reaction feed, the yield to light olefins was not only increased, but the life time of the catalyst was also prolonged by the suppression of the coke formation by steam.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.52 no.3
• /
• pp.183-190
• /
• 2016

This study carried out an experiment to find out the reaction of hairtail, Trichinus lepturus to the colors of LED light as a basic study on the development of the trolling gear and a method to enable the day-night operation. We used hairtails caught around Seongsan-po, Jeju Island by set nets and hairtail angling. The seven hairtails of the average length 68.9 cm (SD 9.2 cm) and the average weight 135.9 g (SD 47.9 g) were adapted themselves in the experimental water tank, 15 m Self-Governing 1.7 m in height and 1.5 m in depth, and then they were studied. We conducted experiment at the Ocean and Fisheries Research Institute in Jeju Special Self-Governing Province, from November to December 2015, and the sea surface temperature was between 16.5 and $19.5^{\circ}C$. The four colors of LED light, blue, white, green and red, were set up to transmit downward from the marginal area of tank. The 1 meter depth light intensity of LED colors is as follows: $0.09w/m^2/s$ (blue), $0.18w/m^2/s$ (white), $0.04w/m^2/s$ (green) and $0.007w/m^2/s$(red) To know the optimum LED color light, we selected one with better reaction rate after comparison of two colors simultaneously and the selected color was again compared to the other color in a tournament style two times a day (day and night) and ten times totally. The reaction rates were shown as the frequencies of hairtail appearance for 5 minutes in the lighting zone after turning on the LED lights. The reaction rate of the blue was at 97% unlike the red 3% (p < 0.001). The blue was at 75% unlike the green at 25% (p < 0.001). The blue was at 67% unlike the white at 33% (p < 0.001). Therefore, the color of light source showing the highest reaction rate was the blue.

• Journal of Plant Biology
• /
• v.19 no.3
• /
• pp.71-84
• /
• 1976

In order to observe the phosphate metabolism in chloroplast, the contents of inorganic phosphate and various compounds in chloroplast from spinach leaf tissues were investigated during the reaction in the light and dark in the reaction mixture and the turnover of phosphate in chloroplast was compared with that of whole cell system: 1. The phosphorus of DNA in chloroplast appears to be transferred from inorganic phosphate, while in whole cell system from phosphate pool. 2. $^{32}P-phosphate$ content of acid soluble fraction in chloroplast as well as in whole cell system was more increased in the light than dark during the reaction. It was noted to be caused by the stimulation of sugar phosphate synthesis in the light. 3. It was confirmed that polyphosphate exists in chloroplast as well as whole cell. Acid insoluble polyphosphate content in whole cell system was significantly decreased during the reaction and the similar tendency was also observed in chloroplst. It is, therefore, considered that acid insoluble polyphosphate also play an most important role as a phosphate pool respectively in chloroplast and in cytoplasm. 4. Protein and lipid phosphorus in chloroplast as well as whole cell system were transferred from acid insoluble polyphosphate.

• Journal of Environmental Science International
• /
• v.15 no.7
• /
• pp.677-688
• /
• 2006

Currently, the application of $TiO_2$ photocatalyst has been focused on purification and treatment of wastewater. However, the use of conventional $TiO_2$ slurry photocatalyst results in disadvantage of stirring during the reaction and of separation after the reaction. And the usage of artificial UV lamp has made the cost of photocatalyst treatment system high. Consequently, we studied that solar light/$TiO_2$ film system was designed and developed in order to examine disinfection characteristics of sewage wastewater treatment. The optimum conditions for disinfection such as solar light intensity, characteristic of sewage wastewater, amounts of $TiO_2$ and comparison of solar ligth/$TiO_2$ systems with UV light/$TiO_2$ system was examined. The results are as follows: (1) photocatalytic disinfection process with solar light in the presence of $TiO_2$ film more effectively killed total coliform (TC) than solar light or $TiO_2$ film absorption only. (2) The survival ratio of TC and residual ratio of organic material (BOD, CODcr) decreased with remain resistant material. (3) The survival ratio of TC and residual ratio of organic material (BOD, CODcr) decreased with the increase of amounts of $TiO_2$. (4) TC survival ratio decreased linearly with increasing UV light intensity. (5) The disinfection effect of solar light/$TiO_2$ slurry system decreased more than UV light/$TiO_2$ film systems. (6) The disinfection reaction followed first-order kinetics. We suggest that solar light instead of using artificial UV light was conducted to investigate the applicability of alternative energy source in the disinfection of TC and the degradation of organic material.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.10 no.2
• /
• pp.48-54
• /
• 2002

Since photocatalysts are activated by lights of UV wavelengths, plasma is alternatively used as a light source for a photocatalytic reactor. Light intensity generated by plasma is proportional to the surface area of catalytic material, and this, in many practical applications, is prescribed by the geometry of a plasma generator. Thus, it is crucial to increase the surface area far sufficient light intensity for photocatalytic reaction. For example, in a pack-bed type reactor, multitudes of beads are used as a substrate in order to increase the surface area. Honeycomb monolith type substrate, which has very good surface area to volume ratio, has been difficult to apply plasma as a light source due to the fact that light penetration depth through the honeycomb monolith was too short to cover sufficient area, thus resulting in poor intensity for photocatalytic reaction. In this study, nonthermal plasma generation through a photocatalytic reactor of honeycomb monolith substrate is investigated to lengthen this short penetration depth. The ceramic honeycomb monolith substrate used in this study has the same length as a three way catalyst used fur automotive applications, and it is shown that sufficient light intensity for photocatalytic reaction can also be obtained with honeycomb monolith type reactor.

• Nuclear Engineering and Technology
• /
• v.32 no.6
• /
• pp.531-536
• /
• 2000

The extraction of precious metals from aqueous solutions is performed by using a photoredox reaction with a Q-switched Nd:YAG laser. The metallic silver was efficiently precipitated and extracted from the silver nitrate solution by laser photolysis. An optimum reaction condition for silver extraction was determined by adjusting various experimental factors such as type of reducing agent, type of acids and reaction time. The composition of the reaction product was analyzed and it was identified as metallic silver, not other molecular types. The photoreaction of chromium(III) chloride in an acidic aqueous solution was also investigated. The 355 nm laser light was better suited for the reaction of silver nitrate as well as chromium(III) chloride in an acidic solution compared to the 532 nm light.

• Korean Journal of Materials Research
• /
• v.26 no.2
• /
• pp.73-78
• /
• 2016

$TiO_2$ nanoparticles were synthesized by a sol-gel process using titanium tetra isopropoxide as a precursor at room temperature. Ag-doped $TiO_2$ nanoparticles were prepared by photoreduction of $AgNO_3$ on $TiO_2$ under UV light irradiation and calcinated at $400^{\circ}C$. Ag-doped $TiO_2$ nanoparticles were characterized for their structural and morphological properties by X-ray diffractometry (XRD), scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS), and transmission electron microscopy (TEM). The photocatalytic properties of the $TiO_2$ and Ag-doped $TiO_2$ nanoparticles were evaluated according to the degree of photocatalytic degradation of gaseous benzene under UV and visible light irradiation. To estimate the rate of photolysis under UV (${\lambda}=365nm$) and visible (${\lambda}{\geq}410nm$) light, the residual concentration of benzene was monitored by gas chromatography (GC). Both undoped/doped nanoparticles showed about 80 % of photolysis of benzene under UV light. However, under visible light irradiation Ag-doped $TiO_2$ nanoparticles exhibited a photocatalytic reaction toward the photodegradation of benzene more efficient than that of bare $TiO_2$. The enhanced photocatalytic reaction of Ag-doped $TiO_2$ nanoparticles is attributed to the decrease in the activation energy and to the existence of Ag in the $TiO_2$ host lattice, which increases the absorption capacity in the visible region by acting as an electron trapper and promotes charge separation of the photoinduced electrons ($e^-$) and holes ($h^+$). The use of Ag-doped $TiO_2$ nanoparticles preserved the option of an environmentally benign photocatalytic reaction using visible light; These particles can be applicable to environmental cleaning applications.

• Journal of the Ergonomics Society of Korea
• /
• v.36 no.5
• /
• pp.459-466
• /
• 2017

Objective: This study examined two traffic signals with a countdown indicator in terms of driver's reaction time and subjective satisfaction score and their performance was compared with a standard traffic signal in driving simulation. Background: Dilemma zone is created when a traffic light changes at intersections. It often pushes drivers to rush in urgent and premature decision making whether to go or stop and thus induces unnecessary mental load among drivers, which may lead to sudden conflicts with following vehicles at intersections. Method: Forty college students (male: 20, female: 20) participated in this driving simulation study. Three traffic signals were employed: (1) standard traffic signal; (2) countdown-separated signal; and (3) countdown-overlaid signal. The countdown-separated and countdown-overlaid signals were designed to inform drivers of the remaining time of a green light before tuning to an amber light. Reaction times (sec) and satisfaction scores (7-point scale) for the two signals with a countdown indicator were compared with those for the standard traffic signal. Results: Reaction times of the countdown-separated (0.49 sec) and countdown-overlaid (0.43 sec) signals were significantly shorter than that of the standard signal (0.67 sec). Satisfaction scores of the countdown-separated (5.3 point) and countdown-overlaid (5.6 point) signals were greater than that of the standard signal (3.8 point). Lastly, the countdown-overlaid signal showed better performance than the countdown-separated signal, but their differences in reaction time (0.06 sec) and satisfaction score (0.3 point) were small. Conclusion: Traffic signals with a countdown indicator can improve drivers' reaction time and satisfaction score than the standard traffic signal. Application: Traffic signals with a countdown indicator will be useful for reducing the length of dilemma zone at intersections, by allowing drivers to predict the remaining time of a green light.

• Journal of Environmental Science International
• /
• v.8 no.2
• /
• pp.241-248
• /
• 1999

The photocatalytic decolorization and photodegradation of wastewater contamininated with dyes such as methyleneblue tetrahydrate(MBT), methyl orange(MO), phenol red(PR) and the mixed dyes have been studied using a batch reactor in the presence of aerotropic and titania. Degussa P25 titanium oxide was used as the photocatalyst and proved to be effective for the dyes-degradation when irradiated with UV-light source emitting the wavelength of 253.7 nm in the presence of air. In addition to removing the color from the wastewater, the photocatalytic reaction simultaneously reduced the COD and optical density which suggests that the dissolved organic compounds have been photooxidized. The reaction rate of disappearance of the dyes were measured as a function of the irradiation times. The photooxidative procedure of the aquatic solution have the first order reaction-kinetics. The rate constants were increased in the order of PR < MBT < $gL^{-1}-TiO_2$ powder were irradiated with the UV -light source.