• Ocean and Polar Research
• /
• v.30 no.4
• /
• pp.373-378
• /
• 2008

Long-term tide-gauge data from around the Korean Peninsula were reanalyzed. Both the coastal water and the open sea surrounding the Korean Peninsula appeared to have been influenced by global warming. The long-term change in relative sea levels obtained from tidal stations showed a general rising trend, especially near Jeju Island. It is proposed that global warming may have caused shifting of the path of the Kuroshio branch (Tsushima Warm Current) toward Jeju Island, causing a persistent increase in the water levels along the coast of the island over the last few decades.

• Proceedings of the IEEK Conference
• /
• 2001.06b
• /
• pp.293-296
• /
• 2001

This paper describes an implementation of 4$^{th}$ order single-loop Butterworth noise shaper for a 16-bit $\Delta$$\Sigma$ DAC with the viewpoint of minimum hardware overhead. we adopt simple bit-shifting scheme and ROM selection technique for the multiplication, and propose a new buffer-and-routing method for the ROM circuits. The behavioral level and timing simulations reveal that our proposal is valid for the target specificationrget specificationn

• Journal of Electrical Engineering and Technology
• /
• v.10 no.4
• /
• pp.1610-1620
• /
• 2015

A major problem in conventional multilevel inverter is that an increase in power semiconductor switches causes an increase in cost and switching losses of the inverter. The multicarrier strategy adopted for the multilevel inverters has become more popular due to reduced cost, lower harmonic distortion, and higher voltage capability than the conventional switching strategy applied to inverters. Various topologies and modulation strategies have been reported for utility and drive applications. Level shifted based pulse width modulation techniques are proposed to investigate the performance of the multilevel inverter. The proposed work focuses on reducing the utilized switches so that the cost and the switching losses of the inverter do not go up and the consistent efficiency could be achieved. This paper presents the detailed analysis of these topologies. The analysis is based on the number of switches, DC sources, output level, maximum voltage, and the efficiency. As an illustration, single phase cascaded multilevel inverter topologies are simulated using MATLAB/SIMULINK and the experimental results demonstrate the viability of these inverters.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.25 no.6
• /
• pp.484-489
• /
• 2020

This study proposes a new soft-switching three-level flying capacitor converter with low filter inductance. The proposed converter can achieve zero voltage switching (ZVS) turn-on of all switches by using auxiliary components La and Ca. It can also reduce filter inductance because the applied voltage of the filter inductor is decreased by using the flying capacitor. Furthermore, filter inductance can be reduced because the operating frequency of the filter inductor is doubled by the phase shifting between switches S3 and S4. The operation principle, design of passive components for ZVS turn-on, interleaving effects, and comparison of different topologies are presented. The experimental waveforms of a 1 kW two-phase interleaved converter prototype are provided to verify the validity of the proposed converter.

• Management & Information Systems Review
• /
• v.34 no.5
• /
• pp.213-231
• /
• 2015

In this paper, I examine whether the listed companies in Korea tend to manage operating cash flows upward via classification shifting after the adoption of K-IFRS. As proxies for cash flow management, I derive a measure of abnormal operating cash flows borrowing from Lee(2012). Alternative proxies include a series of categorical variables designed to identify the types of classification shifting of interest and dividend payments among others, in the statement of cash flows. Higher level of estimated abnormal operating cash flows, and the classification of interest/dividend payments in non-operating activity sections are considered to indicate the managerial intention to maximize reported operating cash flows. I consider several potential incentives to manage operating cash flows, which include financial distress, the credit rating proximity to investment/non-investment cutoff threshold, avoidance of negative or decreasing operating cash flows relative to previous period and so forth. In a series of empirical analyses, I do not find evidence in support of the opportunistic classification shifting explanation, inconsistent with several previous literature in Korea. In contrast, I observe negative associations between the CFO management proxies and selected incentives, which suggest that the classification is likely to represent above average cash flow performance rather than opportunistic motives exercised to maximize reported operating cash flows. I reckon that this observation is, in part, driven by the K-IFRS requirement to maintain temporal consistency in classifying interest and dividend receipts/payments in cash flow statement.

• Journal of Power Electronics
• /
• v.13 no.5
• /
• pp.779-786
• /
• 2013

A highly efficient sustaining driver is proposed for plasma display panels (PDPs). When the PDP is charged and discharged, the proposed sustaining driver employs an address voltage source used in an addressing period. A voltage source is used for fully charging the panel to the sustaining voltage, and an initial inductor current helps the panel discharge to 0 V. The resonance between the panel and an inductor is made by shifting the voltage and current bias level when charging and discharging the panel. As a result, the proposed circuit can reduce power consumption, switching loss, heat dissipation, and production cost. Experimental results of a 42-inch PDP are provided to verify the operation and features of the proposed circuit.

• Journal of the Semiconductor & Display Technology
• /
• v.5 no.3 s.16
• /
• pp.11-16
• /
• 2006

A low cost PDP sustain power supply is proposed based on flyback topology. By using Boundary Conduction Method(BCM) to control input current regulation, DCM condition can be met under all load conditions. Another feature of the proposed method is that a excessive voltage stress due to the link voltage increase can be suppressed by removing link capacitor and suggest new 'Level-shifting switch driver'. this new gate driver is improved 66% of efficiency than switching loss of a existed push-pull amplifier. The proposed converter is tested with a 400W(200V-2A output) prototype circuit.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2015.05a
• /
• pp.107-108
• /
• 2015

It's became essential that Korea construction companies should enter into the overseas construction market for their growth and sustainability. In order to comply with the client's required global standard and to compete with in the international market, the shifting the construction project management system to global level is required. In accordance with the demand, this paper proposes the top-level document of construction project management system as a to-be model that utilized in overseas construction projects. The project management plan ("PMP") suggested in this paper is not only the most appropriate one, which complies with the global standard, to be used when companies bid for international construction projects against foreign competitors but also has the process modeling and hierarchical structure.

• Journal of the Korea Society of Computer and Information
• /
• v.22 no.10
• /
• pp.63-71
• /
• 2017

In this paper, we develop the system for audio volume equalization of video on demand(VoD) content and propose the solution for it. In recent years, there has been a steady increase in the number of VoD users in addition to linear channels. However, viewers ought to sit in an uncomfortable way, adjusting the volume intermittently while they are broadcasted. Sudden changes of volume occur between the broadcasting channels, the programs from the co-channel, or the linear channels and the VoDs. Especially, upsurged dissatisfaction from the televiewers has been found due to the unequalized volume when shifting between the linear channel and the VoD. In order to solve this problem, multilateral efforts were put forth, such as a system for keeping the volume at a certain level in digital broadcasting program has been legislated domestically. It leads success in equalizing linear channel volume. On contrary, too little notice has been taken for distorted volume problem of video on demand(VoD) content. In this paper, we developed and applied the volume equalization system into VoD content to achieve uniformization, a similar condition with linear channel(-24LKFS). This suggestion helped uneven current of volume which was in the stage -16 ~ -20LKFS to stable condition by lowering into the stage of -24LKFS. It also brought 20% increase in perspective of volume quality satisfaction level.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2005.11a
• /
• pp.431-434
• /
• 2005

Generally, noise in a reciprocating compressor is attributed to the driving force of a pump. However, close examination shows that the noise heard by customers finally results from radiation of a shell in a compressor, the noise caused by both transmission through a shell and resonance with the natural frequency of a shell. Therefore, the peak frequencies contributing to the overall level of a compressor' noise are closely concerned with vibration of a shell. That's why radiated noise by vibration can be reduced by changing the mode of a shell and by shifting the peak frequencies to other ranges, which are not globally related with the overall noise level. In this paper, the main peak frequencies are analyzed to reduce the radiated noise of a shell, and the vibration characteristics of a shell are examined through Frequency Response Function and Finite Element Analysis. Moreover, the Operational Deflection Shape for a shell is measured with consideration of real driving force of a pump. Finally, the optimum position on a shell, closely related to the main peak frequencies, is found, and the overall noise level caused by radiated noise of a shell is noticeably reduced by mass or stiffness modification of the position.