• Wind and Structures
• /
• v.22 no.4
• /
• pp.455-476
• /
• 2016

In both structural and environmental wind engineering, the vertical variation of wind direction is important as it impacts both the torsional response of the high-rise building and the pedestrian level wind environment. In order to systematically investigate the vertical variation of wind directions (i.e., the so-called 'twist effect') induced by hills with idealized geometries, a series of wind-tunnel tests was conducted. The length-to-width aspect ratios of the hill models were 1/3, 1/2, 1, 2 and 3, and the measurements of both wind speeds and directions were taken on a three-dimensional grid system. From the wind-tunnel tests, it has been found that the direction changes and most prominent at the half height of the hill. On the other hand, the characteristic length of the direction change, has been found to increase when moving from the windward zone into the wake. Based on the wind-tunnel measurements, a descriptive model is proposed to calculate both the horizontal and vertical variations of wind directions. Preliminarily validated against the wind-tunnel measurements, the proposed model has been found to be acceptable to describe the direction changes induced by an idealized hill with an aspect ratio close to 1. For the hills with aspect ratios less than 1, while the description of the vertical variation is still valid, the horizontal description proposed by the model has been found unfit.

• Journal of the Korea Concrete Institute
• /
• v.16 no.1 s.79
• /
• pp.10-17
• /
• 2004

Shear tests were performed on four ends of full scale U-type beams which were designed by optimum process for the depth with a live load of 4903Pa. The ratio of width to depth of full scale 10.5 m-span, composite U-type beams with topping concrete was greater than 2. Following conclusions were obtained from the evaluation on the shear performance of these precast prestressed beams. 1) Those composite U-type beams performed homogeneously up to the failure load, and conformed to ACI Strength design methods in shear and flexural behaviors. 2) The anchorage requirements on development length of strand In the ACI Provisions preyed to be a standard to determine a failure pattern within the limited test results of the shallow U-type beams. 3) Those all shear crackings developed from the end of the beams did not lead to anchorage failure. However, initiated strand slip may leads the bond failure by increasing the size of diagonal shear crackings. 4) The flexural mild reinforcement around the vertical center of beam section was effective for developments of a ductile failure.

• Journal of Ginseng Research
• /
• v.6 no.1
• /
• pp.38-45
• /
• 1982

To determine the optimum light intensity for growth of ginseng plants, change of temperature, moisture content in son, occurrence alternaria blight, defoliation rate, chlorophyll contents, and growth of shoots and roots were investigated under different light intensity such as 5%, 10%, 20% and 30% light transmittance rare(L.T.R.). The results obtained were as follows. 1. Maximum temperature under the shading was increased as the increase of light intensity, whereas soil moisture content decreased 2. As the increase of light intensity, stem and Peduncle length, leaf area, and chlorophyll contents decreased significantly but length and width of the leaf was not significant, while stem diameter, special leaf weight and chlorophyll a/chl. b ratio increased 3. Stem color was shown dark purp!e as the increase of light intensity. 4. Photosynthesis during the day was highest at 9 A.M. and decreased as time passed in all plots. The means of photouynthesis during the day showed in the order of 20%, 10%, 30%, 5% L.T.R., and optimum light intensity for highest photosxthesis was 18.4% L.T.R. by theoritical equation. 5. It was showed a tendency that alternaria leaf blight of ginseng plants was increased as the increase of light intensity. 6. Defoliation rate of ginseng plants was increased as the increase of light intensity, especially all plants were defoliated by late June without shading. 7. Yield percentage of the rear line was increased as the increase of light intensity. Root weight per plant showed in the order of 20%, 10%, 30%, 5% L.T.R., and optimum light intensity for the best yield was 18.5% L.T.R. by theeritical equation.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2017.06a
• /
• pp.265-265
• /
• 2017

This study was carried out to develop rice variety integrated with rice bacterial blight resistance gene and to know the information of major agronomic traits of developed variety. Advanced backcross Lines 21 having Xa3 and Xa21 gene cross from japonica cultivar Hwanggeumnuri and indica variety IRBB21. Days after seeding and culm length of ABLs21 were 108 days (Aug. 16) and 76 cm, respectively. Ripened grain rates was 87.4 %, which was similar to the parents. 1000 grain weight of brown rice of ABLs21 was 21.4g, which was lower than the donor parent. Milled rice yield of ABLs21 was 532 kg/10a, which was smaller than recurrent parent and higher than the donor parent. Grain length/width ratio of brown rice was form of japonica with short-ellipse and glossiness of cooked rice has japonica trait. Head rice rate showed a large difference compare to the donor parent and similar to the recurrent parent. ABLs21 would be useful genetic resources for resistance breeding program against bacterial blight.

• Journal of Environmental Science International
• /
• v.21 no.5
• /
• pp.597-603
• /
• 2012

Non-thermal plasma processing using a dielectric barrier discharge (DBD) has been investigated as an alternative method for the degradation of non-biodegradable organic compounds in wastewater. The active species such as OH radical, produced by the electrical discharge may play an important role in degrading organic compound in water. The degradation of N, N-Dimethyl-4-nitrosoaniline (RNO) was investigated as an indicator of the generation of OH radical. The DBD plasma reactor of this study consisted of a plasma reactor, recycling pump, power supply and reservoir. The effect of diameter of external reactor (15 ~ 40 mm), width of ground electrode (2.5 ~ 30 cm), shape (pipe, spring) and material (copper, stainless steel and titanium) of ground electrode, water circulation rate (3.1 ~ 54.8 cm/s), air flow rate (0.5 ~ 3.0 L/min) and ratio of packing material (0 ~ 100 %) were evaluated. The experimental results showed that shape and materials of ground were not influenced the RNO degradation. Optimum diameter of external reactor, water circulation rate and air flow rate for RNO degradation were 30 mm, 25.4 cm/s and 4 L/min, respectively. Ground electrode length to get the maximum RNO degradation was 30 cm, which was same as reactor length. Filling up of glass beads decreased the RNO degradation. Among the experimented parameters, air flow rate was most important parameters which are influenced the decomposition of RNO.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.8 no.3
• /
• pp.159-167
• /
• 2004

The objective of this study is development of the optimum design program to minimize the cost for PSC box girder bridge using the full staging method to indicate the necessity for the optimum design applied many types of bridges. It also considered the proper span length to girder depth ratio and the cell number along the width of bridge. This program used SUMT procedure and Kavlie's extended penalty function to allow infeasible design points in the process. Powell's direct method was used in searching design points and Gradient Approximate Method was used to reduce design hours. This study showed the convergence in design parameter and correlation of totally optimized cost according to cell numbers, span lengths, and lane numbers.

• Korean Journal of Plant Taxonomy
• /
• v.41 no.2
• /
• pp.108-112
• /
• 2011

The pollen of 5 taxa on Korean Oldenlandia L. was investigated by LM and SEM. The pollen grains were monads, $20.7-36.0{\mu}$m in polar length, with an equatorial diameter of $21.0-38.4{\mu}m$. The pollen shapes were oblate-spheroidal or spherical (P/E ratio 0.93-1.00). The apertures numbered 3-7 in number, colporate in shape, with a colpus length of $4.2-20.4{\mu}m$ and a colpus width of $2.6-3.4{\mu}m$. The sexine was $0.9-2.4{\mu}m$ in terms of its thickness, the surface pattern was reticulate, scabrate or neither. Based on these results, the size of the pollen grain, the number of apertures, and the surface pattern of the sexine were all useful for an interspecific classification. The genus Neanotis, established via the pollen characteristics, was thought to be reviewed in its entity regarding the continuous variation of generic characteristics.

• Journal of Korean Neurosurgical Society
• /
• v.47 no.1
• /
• pp.42-47
• /
• 2010

Objective: To investigate the morphometric characteristics of the pituitary gland and diaphragma sellae in Korean adults. Methods: Using the 33 formaline fixed adult cadavers (23 male, 10 female), the measurements were taken at the diaphragma sellae and pituitary gland. The authors investigated the relationship between dura and structures surrounding pituitary gland, morphometric aspects of pituitary gland and stalk, and morphometric aspect of central opening of diaphragma sellae. Results: The boundary between the lateral surface of pituitary gland and the medial wall of cavernous sinus was formed by the thin dural layer and pituitary capsule. The pituitary capsule adherent tightly to the pituitary gland was observed to continue from the diaphragma sellae. Mean width, length, and height of the pituitary gland were 14.3${\pm}$2.1, 7.9${\pm}$1.3, and 6.0${\pm}$0.9 mm in anterior lobes, and 8.7${\pm}$1.7, 2.9${\pm}$1.1, and 5.8${\pm}$1.0 mm in posterior lobes, respectively. Although all dimensions of anterior lobe in female were slightly larger than those in male, statistical significance was noted in only longitudinal dimension. The ratio of posterior lobe to the whole length of pituitary gland was about 27%. The mean thickness of pituitary stalk was 2 mm. The diaphragmal opening was 5 mm or more in 26 (78.8%) of 33 specimen. The opening was round in 60.6% of the specimen, and elliptical oriented in an anterior-posterior or transverse direction in 39.4%. Conclusion: These results provide the safe anatomical knowledge during the transsphenoidal surgery and may be helpful to access the possibility of the development of empty sella syndrome.

• Journal of Ecology and Environment
• /
• v.41 no.9
• /
• pp.246-255
• /
• 2017

Background: The aim of this study was to examine the resource allocation among the organs and the leaf morphology of Polygonatum humile. The data were collected from June 2014 to May 2015 in a natural P. humile stand of a temperate forest gap. Results: The dry weight of new rhizome ($R_0$) sharply decreased to the time of new shoot sprouting in next year and was constant for 2 ~ 3 years. However, dry weight of root on $R_0$ increased to the end of growth season and, thereafter, decreased slowly along the time elapsed. The correlation coefficients between the rhizome and the leaf sizes were 0.5 for the last year's rhizome ($R_1$) and 0.6 for $R_0$ and were significant at 0.1% level for $R_0$. The increase of one leaf a plant led to increase of the total leaf area, total leaf weight, and stem length. Moreover, the organ sizes' differences between two plants of the one leaf difference were almost significant at 1% level. In 11-leaf plant, the leaf length/width ratio and specific lea area increased to the second, relative leaf area to the fourth and relative leaf dry weight to the fifth, and thereafter, decreased to the last leaf. The differences in the values of these four parameters between two leaves on a stem were almost significant at 5% level. Conclusion: P. humile examined showed the close relationships between the last year's rhizome or this year's one and the shoot system (leaf and stem) sizes. The leaf number a shoot greatly influenced specific leaf area. P. humile's leaf might showed diverse morphology with leaf rank on a stem in a forest gap environment.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.12 no.4
• /
• pp.28-34
• /
• 1975

텔레비젼 수신용 안테나로써 가장 널리 사용되고있는 Yagi안테나는 구조가 간단하고 지향성 이득등이 좋으나 방사주파수에 대한 반파장길이의 소자를 사용하므로 칫수가 커지고 주파수대역이 좁다. 따라서 설치 취급등에 불편을 느낄 경우가 많다. 한편 최근 일반적으로 아무곳에서나 용이하계 설치할 수 있을만큼 소형이면서 화질이 좋은 수상이 가능한 수신안테나에 대한 요망이 커지고 있는데 본 연구에서는 그 파장에 비해서 소형인 폴디드·다이폴 안테나 소자 2개를 좁은 간격으로 배열하고 이들을 이상결합하므로써 VHF텔레비젼전파의 고채널 주파수대에서 비교적 양한 단일지향성을 얻고 있다. 본 안테나에 능동소자를 이용한 저잡음광대역증폭기를 삽입한다면 다소자 Yagi안테나에 비나될 전후방비를 갖는위에 그의 이득도 크게 증가되어 일반수상안테나로 뿐만 아니라 고우스트 방지용실내안테나로서 상당한 기여틀 할것으로 생각된다. The Yagi antenna, which is most widely used for television receiving, has simple form and good directiyity as well as high gain, but it must be made with linear elements of half wave length. Therefore, the dimension of multi-element Yagi antenna becomes bulky and so a(ten it is inconvenient to install and handle, because of its big size. Moreover the frequency band width of the Yagi antenna is usually not broad enough to cover the total frequency range of VHF TV channels in our country. Recently, the aemand for an antenna which is not only small enough to install it easily anywhere but also assures good quality of pictures is generally increasing. In this study 2 elements o( folded dipole, which is small compared to its electrical ways length, are fixed parallel to each other with a narrow distance and the emfs induced in them are made to get together with some phase difference. This new phased array antenna has shown a relatively good unidirectivity through over the high channel VHF television frequency hand as well as the good PIB ratio which is comparable to that of multielements Yagi antenna. As a result this new antenna will be used as a VHF high channel TV receiving antenna and it may become better antighost antenna when used inside the room than other room antennas.