• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.24 no.12
• /
• pp.1588-1595
• /
• 2000

Natural convection heat transfer in an enclosure with an opening in the right veritcal wall and a heat source at the bottom surface is investigated using a holographic interferometric technique. The effects of the opening length, divider length attached to the top wall, and heater temperature on the temperature distribution are examined. The opening length as well as the divider length greatly affects the degree of inflow and outflow of air. In the case of small opening length, the opening doesnt affect much the upward warm air flow resulting in the symmetric temperature distribution .The upward flow in hindered by the divider resulting in the decrease of heat transfer from the heater region to the upper region. The longest divider shows the highest temperature in the lower region of enclosure. In the case of large opening length, the inward cold flow moves the upward flow to the left direction. Among the cases of different divider length, the case of H(sub)d=0.25H shows the highest temperature in the lower region of enclosure.

• Journal of Advanced Marine Engineering and Technology
• /
• v.31 no.8
• /
• pp.975-982
• /
• 2007

The single-phase switched reluctance motor(SRM) drive requires DC source which is generally supplied through a rectifier connected with a commercial source. The rectifier is consist of a diode full bridge and a filter circuit. Usually the filter circuit uses capacitor with large value capacitance to reduce ripple component of DC power. Although the peak torque ripple of SRM is small, the short charge and discharge current of the filter capacitor draws the low power factor and system efficiency. A modified single phase SRM drive system is presented in this paper, which includes drive circuit realizing reduction of torque ripple and improvement of power factor. In the proposed drive circuit, one switching part and diode which can separate the output of AC/DC rectifier from the filter capacitor is added. Also, a upper switch of drive circuit is exchanged a diode in order to reduce power switching device. Therefore the number of power switch device is not changed, two diodes are only added in the SRM drive. To verify the proposed system, some simulation and experimental results are presented.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2013.05a
• /
• pp.681-683
• /
• 2013

And were the prevalence of smartphones is the Big Data era, such as Facebook or Twitter, SNS (Social Network Service) routine is used in the real world. Take advantage of the analysis, and to extract and utilize developed in the Apache Foundation Hadoop (Hadoop) without abandoning the SNS unstructured data here. Hadoop is an open source framework that can handle large amounts of data. Hadoop has been introduced in the domestic corporate and commercial development and Compared to the technology development Hadoop has been pointed out that the lack of security sector. In this paper, we propose a method to enhance the security and vulnerability analysis of security technologies and Hadoop.

• Journal of Power Electronics
• /
• v.11 no.4
• /
• pp.471-478
• /
• 2011

This paper addresses the establishment of a kVA-range plug-in hybrid electrical vehicle (PHEV) integration test platform and associated issues. Advancements in battery and power electronic technology, hybrid vehicles are becoming increasingly dependent on the electrical energy provided by the batteries. Minimal or no support by the internal combustion engine may result in the vehicle being occasionally unable to recharge the batteries during highly dynamic driving that occurs in urban areas. The inability to sustain its own energy source creates a situation where the vehicle must connect to the electrical grid in order to recharge its batteries. The effects of a large penetration of electric vehicles connected into the grid are still relatively unknown. This paper presents a novel methodology that will be utilized to study the effects of PHEV charging at the sub-transmission level. The proposed test platform utilizes the power hardware-in-the-loop (PHIL) concept in conjunction with high-fidelity PHEV energy system simulation models. The battery, in particular, is simulated utilizing a real-time digital simulator ($RTDS^{TM}$) which generates appropriate control commands to a power electronics-based voltage amplifier that interfaces via a LC-LC-type filter to a power grid. In addition, the PHEV impact is evaluated via another power electronic converter controlled through $dSPACE^{TM}$, a rapid control systems prototyping software.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.37 no.3
• /
• pp.386-398
• /
• 2013

This study analyzes the effect of clothing involvement using meta-analysis. Metal-analysis (the analysis of analyses) is widely used in various academic areas to integrate individual empirical studies and generalize the knowledge of a specific research field. Previous studies regarding clothing involvement published since 1990 were researched from the KISS database using clothing involvement and fashion involvement as a keyword; subsequently, 127 articles were identified. Studies that had insufficient statistics or included clothing involvement as a moderating (or intervening variable) were eliminated; subsequently, 36 articles provided a total of 75 data sets that were used for the final analysis. Dependent variables were grouped into 10 categories to compare the differences between high and low involvement groups. The effect size of clothing involvement was large in non-personal information source; however, it was small in utility, brand royalty and quality. In the 7 categories of relational studies that showed homogeneity, the relation size regarding conformity was smaller than the personal information source.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.17 no.6
• /
• pp.595-603
• /
• 1992

It has been establisued that the reliability of communication networks is NP hard problem owing to computationally and complexity as the number of componeuts is Increased in large networks. This paper proposed an algorithm for determining upper and lower bounds In the reliability of source-to-terminal in communication networks to solve this problem. The evaluation method follows the next procedures. First, minimal pathset and minimal cut set are serched. Second, it is sorted that the number of components is the same events and the reliability bounds Is evaluated by the section function to extract common variable. The performance of proposed algorithm is also estimate(1 as compared to the reliability of Esary-Proschan, Shogan and Copal.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.6 no.6
• /
• pp.1627-1648
• /
• 2012

We propose an adaptive method for detecting plagiarized pairs from a large set of source code. This method is adaptive in that it uses an adaptive algorithm and it provides an adaptive threshold for determining plagiarism. Conventional algorithms are based on greedy string tiling or on local alignments of two code strings. However, most of them are not adaptive; they do not consider the characteristics of the program set, thereby causing a problem for a program set in which all the programs are inherently similar. We propose adaptive local alignment-a variant of local alignment that uses an adaptive similarity matrix. Each entry of this matrix is the logarithm of the probabilities of the keywords based on their frequency in a given program set. We also propose an adaptive threshold based on the local outlier factor (LOF), which represents the likelihood of an entity being an outlier. Experimental results indicate that our method is more sensitive than JPlag, which uses greedy string tiling for detecting plagiarism-suspected code pairs. Further, the adaptive threshold based on the LOF is shown to be effective, and the detection performance shows high sensitivity with negligible loss of specificity, compared with that using a fixed threshold.

• Microbiology and Biotechnology Letters
• /
• v.31 no.1
• /
• pp.1-12
• /
• 2003

Myxobacteria are soil bacteria that move by gliding and have a complicated life cycle. In the research over the 25 years the myxobacteria have been shown to be a rich source of potentially useful bioactive substances. So far about 80 different basic compounds and 450 structural variants have been characterized. It is remarkable that myxobacteria produce the substance has special mechanisms. 26 new electron transport inhibitors,5 inhibitors of nucleic acid polymerases, 10 substances that act on the cytoskeleton, and 1 inhibitor of fungal acetyl-CoA carboxylase have been found. Presently, large-scale technical process was not fully established. But one of the compounds from myxobacteria is able to pass the many thresholds, which are on the road to application.

• Journal of The Korean Astronomical Society
• /
• v.27 no.2
• /
• pp.103-117
• /
• 1994

To extend the work of Gott, Park, and Lee (1989), statistical properties of gravitational lensing in a wide variety of cosmological models involving non-zero cosmological constant is investigated, using the redshifts of both lens and source and observed angular separation of images for gravitational lens systems. We assume singular isothermal sphere as lensing galaxy in homogenous and isotropic Friedmann­Lemaitre-Robertson- Walker universe, Schechter luminosity function, standard angular diameter distance formula and other galaxy parameters used in Fukugita and Turner (1991). To find the most adequate flat cosmological model and put a limit on the value of dimensionless cosmological constant $\lambda_0$, the mean value of the angular separation of images, probability distribution of angular separation and cumulative probability are calculated for given source and lens redshifts and compared with the observed values through several statistical methods. When there is no angular selection effect, models with highest value of $\lambda_0$ is preferred generally. When the angular selection effects are considered, the preferred model depends on the shape of the selection functions and statistical methods; yet, models with large $\lambda_0$ are preferred in general. However, the present data can not rule out any of the flat universe models with enough confidence. This approach can potentially select out best model. But at the moment, we need more data.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2006.05a
• /
• pp.82-85
• /
• 2006

As a display becomes large recently, Acquisition of high luminance and Luminance uniformity is becoming difficult in the existing CCFL or EEFL backlight system. So, study for a performance enhancement has enforced. but lamp development of flat type is asked for high luminance and a luminance uniformity security in of LCD and area anger trend ultimately. In this paper, we changed a tip shape of an electrode for production by the most suitable LCD backlight surface light source, and confirmed discharge characteristic along discharge gas pressure and voltage, and confirmed electric field distribution and discharge energy characteristic through a Maxwell 2D simulation. Therefore the discharge firing voltage characteristic showed a low characteristic than a rectangular type and round type in case of electrode which used tip of a triangle type, and displayed a discharge electric current as a same voltage was low.