• Environmental Engineering Research
• /
• v.21 no.2
• /
• pp.152-163
• /
• 2016

Present study investigates the potential of cassava peel and rubber tree bark for the removal of Cr (VI) from aqueous solution. Removal efficiency of more than 99% was obtained during the kinetic adsorption experiments with dosage of 3.5 g/L for cassava peel and 8 g/L for rubber tree bark. By comparing popular isotherm models and kinetic models for evaluating the kinetics of mass transfer, it was observed that Redlich-Peterson model and Langmuir model fitted well ($R^2$ > 0.99) resulting in maximum adsorption capacity as 79.37 mg/g and 43.86 mg/g for cassava peel and rubber tree bark respectively. Validation of pseudo-second order model and Elovich model indicated the possibility of chemisorption being the rate limiting step. The multi-linearity in the diffusion model was further addressed using multi-sites models (two-site series interface (TSSI) and two-site parallel interface (TSPI) models). Considering the influence of interface properties on the kinetic nature of sorption, TSSI model resulted in low mass transfer rate (5% for cassava peel and 10% for rubber tree bark) compared to TSPI model. The study highlights the employability of two-site sorption model for simultaneous representation of different stages of kinetic sorption for finding the rate-limiting process, compared to the separate equilibrium and kinetic modeling attempts.

• Korean Chemical Engineering Research
• /
• v.58 no.4
• /
• pp.624-634
• /
• 2020

The ability of natural and modified clay to adsorb phenol was studied. The clay samples were analyzed by different technical instruments, such as X-ray fluorescence (XRF), X-ray diffraction (XRD) and FT-IR spectroscopy. Surface area, pore volume and average pore diameter were also determined using B.E.T method. Up to 73 and 99% of phenol was successfully adsorbed by natural and activated clay, respectively, from the aqueous solution. The experiments carried out show that the time required to reach the equilibrium of phenol adsorption on all the samples is very close to 60 min. The amount of phenol adsorbed shows a declining trend with higher pH as well as with lower pH, with most extreme elimination of phenol at pH 4. The adsorption of phenol increases proportionally with the initial phenol concentration. The maximum adsorption capacity at 25 ℃ and pH 4 was 29.661 mg/g for modified clay (NaMt). However, the effect of temperature on phenol adsorption was not significant. The simple modification causes the formation of smaller pores in the solid particles, resulting in a higher surface area of NaMt. The equilibrium results in aqueous systems were well fitted by the Freundlich isotherm equation (R² > 0.98). Kinetic studies showed that the adsorption process is best described by the pseudo-second-order kinetics (R² > 0.99). The adsorption of phenol on natural and modified clay was spontaneous and exothermal.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.54 no.1
• /
• pp.107-110
• /
• 2021

The goal of this study was to investigate moisture sorption characteristics of Lactobacillus brevis-fermented sea tangle Saccharina japonica, Mekabu fucoidan, and these mixture powders. Moisture sorption isotherms of powders were determined at 37℃ using the static gravimetric technique in a water activity (aw) range of 0.11-0.93. Equilibrium moisture content (Xeq) values of the fermented sea tangle powder were almost 3 times when aw<0.7 and increased upto almost 4 times when aw<0.9 higher than mekabu fucoidan powder. In these reason, to improve strong hygroscopic nature of the fermented sea tangle powder, fermented sea tangle and mekabu fucoidan powders were dissolved as ratios of 7:3, 5:5, and 3:7 (w/w) in a distilled water and then freeze dried. Xeq values of mixture powders were around average value of sum of both powders at all aw ranges. All moisture sorption isotherms of powders exhibited typical J-shaped type III. Xeq of mixture powders increased with increasing aw and decreased as increasing proportion of mekabu fucoidan powder. The Peleg model was found to accurately describe moisture sorption isotherms of powders. The results can be used to understand hygroscopic nature of powders, improve shelf life, and retain quality across postharvest processing.

• Economic and Environmental Geology
• /
• v.42 no.5
• /
• pp.427-434
• /
• 2009

Indigenous bacterium which shows a tolerance to high metal toxicity was isolated from soil concomitantly contaminated with oil and heavy metals. The characteristics of the bacterium for Pb and Cd biosorption was investigated under the various experimental conditions such as bacterial growth phase, the initial metal concentration, the input biomass amount, temperature and pH. The Langmuir adsorption isotherm modeling was described to know the capacity and intensity of biosorption. The low initial concentration of heavy metals and high biomass has a maximum heavy metal removal efficiency, but biosorption capacity of Pb and Cd has different values. Biosorption efficiency was highest in the end of the microbial growth stage and under pH 5~9 condition, but was less affected by temperature variation of 25~$35^{\circ}C$. The maximum biosorption capacity for Pb and Cd was 62.11 and 192.31 mg/g, respectively and each $R^2$ was calculated as 0.71 and 0.98 by applying Langmuir isothermal adsorption equation. Biosorption for Cd was considered as monomolecular adsorption to single layer on the surface of cells, whereas biosorption for Pb was considered as accumulation process into the cell by the microbial metabolism and precipitation reaction with anion of bacteria.