• Resources Recycling
• /
• v.17 no.3
• /
• pp.29-34
• /
• 2008

Solvent extraction behaviors of iron(III) from chloride solution at high ionic strength condition between Alamine336 and TBP were compared by using MaCabe-Thiele diagram. Extraction isotherms of iron by the two extractants were obtained by calculating the equilibrium concentrations of iron in both phases from the initial extraction conditions. In calculating the equilibrium concentration of iron, chemical equilibria in the aqueous phase and mass balance together with the solvent extraction reaction were considered. MaCabe-Thiele diagram of iron by 1M Alamine336 indicated that two extraction stages could lead to complete extraction of 0.5M iron from 3M HCl solution at an A/O ratio of 6/5. The extraction power of 1M Alamine336 was found to be the same as 2-3M TBP. MaCabe-Thiele diagram together with the physical properties of the two extractants indicated that Alamine336 is superior to TBP in extracting ferric iron from chloride solution.

• Particle and aerosol research
• /
• v.9 no.2
• /
• pp.89-102
• /
• 2013

24-hr $PM_{2.5}$ samples were collected from January 19 through February 27, 2009 at an urban site of Gwangju and analyzed to determine the concentrations of organic and elemental carbon(OC and EC), water-soluble OC(WSOC), eight ionic species($Na^+$, $NH^{4+}$, $K^+$, $Ca^{2+}$, $Mg^{2+}$, $Cl^-$, ${NO_3}^-$ and ${SO_4}^{2-}$), and 22 elemental species. Haze phenomena was observed during approximately 29%(10 times) of the whole sampling period(35 days), resulting in highly elevated concentrations of $PM_{2.5}$ and its chemical components. An Asian dust event was also observed, during which $PM_{2.5}$ concentration was 64.5 ${\mu}g/m^2$. Crustal materials during Asian dust event contributed 26.6% to the $PM_{2.5}$, while lowest contribution(5.1%) was from the haze events. OC/EC and WSOC/OC ratios were found to be higher during haze days than during other sampling days, reflecting an enhanced secondary organic aerosol production under the haze conditions. For an Asian dust event, enhanced concentrations of OC and secondary inorganic components were also found, suggesting the further atmospheric processing of precursor gases during transport of air mass to the sampling site. Correlations among WSOC, EC, ${NO_3}^-$, ${SO_4}^{2-}$, and primary and secondary OC fractions, which were predicted from EC tracer method, suggests that the observed WSOC could be formed from similar formation processes as those of secondary organic aerosol, ${NO_3}^-$ and ${SO_4}^{2-}$. Results from principal component analysis indicate also that the observed WSOC was strongly associated with formation routes of the secondary organic and inorganic aerosols.

• Journal of the Korean Chemical Society
• /
• v.40 no.6
• /
• pp.394-400
• /
• 1996

The conformational transitions of oligopeptide -(HPPHPPP)$_n$- (H: hydrophobic amino acid, P: polar amino acid) which becomes cross linked-dimer are detected at various temperatures, pHs, ionic strengths, and the concentrations of denaturant. In this study, the transitions of oligopeptide due to denaturant, and those due to temperature are theoretically studied. Oligopeptide 20R as chain-dimer and guanidum-HCl as denaturant are used(20R, which contains 10 interchain and /or 10 intrachain electrostatic repulsions). Alpha helix-coil transitions by denaturant are very steep. This shows that the denaturations have transition states of, presumably all helical forms and random coils. The transitions by temperature are smoother than those by the concentration of denaturant. At low temperature the oligopetides which contain long helices exist more than those which contain short helices. As temperature rises, the mole fractions of the partially denatured oligopeptides increase. So the partially denatured oligopeptides are widely distributed at the transition temperature.

• The Korean Journal of Physiology and Pharmacology
• /
• v.15 no.5
• /
• pp.285-289
• /
• 2011

Shilajit, a medicine herb commonly used in Ayurveda, has been reported to contain at least 85 minerals in ionic form that act on a variety of chemical, biological, and physical stressors. The substantia gelatinosa (SG) neurons of the trigeminal subnucleus caudalis (Vc) are involved in orofacial nociceptive processing. Shilajit has been reported to be an injury and muscular pain reliever but there have been few functional studies of the effect of Shilajit on the SG neurons of the Vc. Therefore, whole cell and gramicidin-perfotrated patch clamp studies were performed to examine the action mechanism of Shilajit on the SG neurons of Vc from mouse brainstem slices. In the whole cell patch clamp mode, Shilajit induced short-lived and repeatable inward currents under the condition of a high chloride pipette solution on all the SG neurons tested. The Shilajit-induced inward currents were concentration dependent and maintained in the presence of tetrodotoxin (TTX), a voltage gated $Na^+$ channel blocker, CNQX, a non-NMDA glutamate receptor antagonist, and AP5, an NMDA receptor antagonist. The Shilajit-induced responses were partially suppressed by picrotoxin, a $GABA_A$ receptor antagonist, and totally blocked in the presence of strychnine, a glycine receptor antagonist, however not affected by mecamylamine hydrochloride (MCH), a nicotinic acetylcholine receptor antagonist. Under the potassium gluconate pipette solution at holding potential 0 mV, Shilajit induced repeatable outward current. These results show that Shilajit has inhibitory effects on the SG neurons of Vc through chloride ion channels by activation of the glycine receptor and $GABA_A$ receptor, indicating that Shilajit contains sedating ingredients for the central nervous system. These results also suggest that Shilajit may be a potential target for modulating orofacial pain processing.

• Polymer(Korea)
• /
• v.35 no.3
• /
• pp.216-222
• /
• 2011

A multi-walled carbon nanotube (MWNT) support with dual properties, an ionic property via tetra-amine and unpaired electrons via tri-amine, was prepared by radiation-induced graft polymerization of glycidyl methacrylate (GMA) and the subsequent amination of its epoxy group. The electrochemical microbial biosensor (EMB) was then fabricated by immobilization of a microbe (Alkaligenes spp.) onto the dual property-modified electrode, which was prepared with the mixture of the MWNT support and a $Nafion^{(R)}$ solution on a glass carbon (GC) electrode surface by a hand-casting method. The sensing range of the prepared EMB for phenol in a phosphate buffer solution was 0.005~7.0 mM. The total concentration of phenolic compounds in a commercial red wine was also determined using the EMB.

• Macromolecular Research
• /
• v.16 no.6
• /
• pp.549-554
• /
• 2008

Proton conducting crosslinked membranes were prepared using polymer blends of polystyrene-b-poly(hydroxyethyl acrylate)-b-poly(styrene sulfonic acid) (PS-b-PHEA-b-PSSA) and poly(vinyl alcohol) (PVA). PS-b-PHEA-b-PSSA triblock copolymer at 28:21:51 wt% was synthesized sequentially using atom transfer radical polymerization (ATRP). FT-IR spectroscopy showed that after thermal ($120^{\circ}C$, 2 h) and chemical (sulfosuccinic acid, SA) treatments of the membranes, the middle PHEA block of the triblock copolymer was crosslinked with PVA through an esterification reaction between the -OH group of the membrane and the -COOH group of SA. The ion exchange capacity (IEC) decreased from 1.56 to 0.61 meq/g with increasing amount of PVA. Therefore, the proton conductivity at room temperature decreased from 0.044 to 0.018 S/cm. However, the introduction of PVA resulted in a decrease in water uptake from 87.0 to 44.3%, providing good mechanical properties applicable to the membrane electrode assembly (MEA) of fuel cells. Transmission electron microscopy (TEM) showed that the membrane was microphase-separated with a nanometer range with good connectivity of the $SO_3H$ ionic aggregates. The power density of a single $H_2/O_2$ fuel cell system using the membrane with 50 wt% PVA was $230\;mW/cm^2$ at $70^{\circ}C$ with a relative humidity of 100%. Thermogravimetric analysis (TGA) also showed a decrease in the thermal stability of the membranes with increasing PVA concentration.

• Membrane Journal
• /
• v.25 no.5
• /
• pp.440-446
• /
• 2015

Nanofiltration composite membranes were prepared through the ion exchange polymers coating onto the porous microfiltration polyethylene (PE) membrane surfaces the salting-out and phase separated and pressurization (PSP) methods. The existence of coating on the surfaces was confirmed by the scanning electronic microscopy. The resulting membranes were characterized under the various conditions, such as the coating material, coating time, ionic strength etc., in terms of flux and rejection for NaCl 100 ppm solution. Under the same coating conditions of 10,000 ppm coating solution concentration and 3 atm coating pressure for both the coating materials of PEI and PSSA_MA, the flux 91.2 LMH and rejection 64.6% were obtained for PEI whereas 122.7 LMH and 38.1% were observed for PSSA_MA. From this study, it may be concluded that the composite membrane preparation is possible.

• Archives of Pharmacal Research
• /
• v.25 no.4
• /
• pp.505-510
• /
• 2002

An improved kinetic assay for prekallikrein activator (PKA), a potential vasodilator, has been developed to be used as an indicator for quality control during production of human albumin preparations. It consists of two reaction stages. In the first stage, PKA and prekallikrein are incubated at $37^{\circ}C$ for 45 min to allow the transformation into kallikrein. Kallikrein, a serine protease, catalyzes the splitting of p-nitroaniline (pNA) from its substrate H-D-Pro-Phe-Arg-pNA(S-2302). The rate at which pNA is released was measured spectrophotometrically at 405 nm. Prekallikrein, a substrate of PKA was purified by DEAE ion-exchange chromatography and the major potential variations in the assay were optimized; pH 8.0 and 150 mM sodium chloride were chosen to give a proper ionic strength. Reaction times in the range of 10 to 360 min provided linear dose-response curves. The concentration of prekallikrein was adjusted to fall between 1:1 and 1:3 dilutions to generate a linear standard calibration curve. Under the optimized conditions, reproducibility was checked. In a precision test, the coefficient of variation (CV) stayed within ${\pm}4%$ and the dose-response curve showed a good correlation (${r^2}=0.999$). An accuracy test with an international standard of PKA afforded a mean recovery of 97.5%.

• Journal of the Korean Applied Science and Technology
• /
• v.35 no.4
• /
• pp.1031-1037
• /
• 2018

The formation of a complex between PVP or HPC and iodine was indicated by a red shift in the tri-iode band while PVA-iodine complex showed its characterized band around 500 nm in pure aqueous media. Addition of surfactant SDS resulted in a disapperance of the characteristic blue color of the PVA-iodine complex indicating that the complex is not formed in aqueous surfactant media. However in case of PVP or HPC, presence of the monomers of SDS favored the complex formation but in higher concentration, the micelles of SDS decreased the complex. Complexation was found to increase with increasing content of n-propanol in the system since n-propanol inhibits the formation of gels or microgels in the polymer solution. But in case of PVA-iodine complex, addition of n-propanol led to conversion of bigger polyiodides into smaller ones, which is indicative of increased intermolecular hydrogen bond interaction between propanol and PVA effecting a decrease in the PVA aggregate space.

• Membrane Journal
• /
• v.29 no.2
• /
• pp.96-104
• /
• 2019

The purpose of this paper is whether or not the in-situ restoration of the reverse osmosis (RO) membranes which its membrane function is lost is possible. The damaged RO membranes are double coated through the salting-out method by the poly(styrene sulfonic acid) sodium salt as the cationic exchange polymer and the polyethyleneimine as the anionic exchange polymer and also conducted the opposite order of the coating materials. And according to the concentration, time and ionic strength, the flux and rejection are measured for the coated membranes. Then the best coating condition is to apply for the RO membrane module of the household water purifier to know the possibility of the in-situ restoration for the commercial module. When the condition of the PEI 30,000 ppm (IS = 0.1)/PSSA 20,000 ppm (IS = 0.7) is applied, the rejection was enhance from 69% for the damaged module to 86% (90% for the pristine module).