• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2008년도 추계 학술발표회
• /
• pp.1693-1706
• /
• 2008

It is of importance to determine the zero effective stress void ratio($e_{00}$), which is the void ratio at effective stress equal to zero, and the relationships of void ratio-effective stress and of void ratio-hydraulic conductivity for characterizing non-liner finite strain consolidation behavior for ultra-soft dredged materials. The zero effective stress void ratio means a transitional status from sedimentation to self-weight consolidation of very soft soil deposits, and acts as a starting point for self-weight consolidation in the non-linear finite strain numerical analysis such as PSDDF. In this paper, a new method for determining the zero effective stress void ratio has been introduced with the aid of measuring electrical resistivity of the specimen. A correlation between the zero effective stress void ratio and the initial slurry void ratio has been proposed, which can be used in PSDDF analysis as an input parameter. Combining all of the accessible experimental data, the consolidation characteristics of a dredged soil from the Incheon area has been studied in detail.

• 한국농공학회지
• /
• 제26권3호
• /
• pp.59-67
• /
• 1984

This study was carried out to find physical and mechanical properties of soil in Yongsan project area to support basic data for tidalland reclamation. The main results are as follows. 1. Most of the soils in this area consist of clay and silt, and inorganic materials. 2. Natural moisture contents are ranged from 42.2% to 92.9% initial void ratio, from 1.4 to 2.3 Therefore it takes a longtime in Settlement of considerable depth. 3. Wet unit weights decrease with increasing of the nataral moistare contents as rt=2. 005-0. 0065wn.4. The relationships between compression index. and liquid limit, initial void ratio and natural moisture contents are found as follows respectively. Cc =0. 046+0. O12LL Cc=-0. 068+0.367eo Cc =0. 056+0. OO8Wn 5. Natural moisture content, plastic limit, plastic index, initial void ratio and liquid :limit are directly proportional to clay content ratio. The relationships are found as Wn=26. 083+0. 797Cy PL=14. 223+0. 128Cy P1=0. 457+0. 492Cy eo=0. 757+0. O2Ocy LL=14. 695+0. 620Cy. 6. Initial void ratio and liquid limit are directly proportional to natural moisture con-tent as follows. eo=0. 310+0.022wn LL=6. 275+0.592wn

• 한국지반환경공학회 논문집
• /
• 제25권10호
• /
• pp.11-18
• /
• 2024

본 연구에서는 국내 해안에 분포하는 세립토의 침강압밀특성을 평가하기 위해 10개의 시료에 대하여 161회의 침강압밀실험을 수행하고, 이를 3개 권역(서해안, 경남, 전남)으로 구분하여 Yano(1985)가 제안한 특성치로 분석 평가하였다. 침강압밀실험은 서해안권역 4개와 경남권역 3개 및 전남권역 각 3개의 시료에 대하여 높이 1m의 컬럼을 이용하여 초기함수비와 초기높이를 변화하면서 실험을 진행하였다. 각 권역별 침강압밀계수와 초기침강속도를 분석하여 대표 상관식을 제시하였다. 각 실험조건별로 자중압밀 개시 간극비를 분석하여 권역별 초기함수비와의 상관관계식을 제안하였으며, 초기 슬러리 간극비와의 관계도 분석하여 세립토의 압밀 개시 간극비 범위를 제시하였다.

• 소성∙가공
• /
• 제19권8호
• /
• pp.480-485
• /
• 2010

In this work, the closing behavior of cylindrical-shaped voids was experimentally investigated according to various parameters such as reduction ratio in height, initial void size and billet rotation during hot open die forging process. The reduction ratio in height, number of path, and billet rotation were chosen as key process parameters which influence the void closing behavior including the change of void shape and size. On the other hand, values of die overlapping and die width ratio were set to be constant. Void closing behavior was estimated by microscopic observation. Based on the observations, it was confirmed that application of billet rotation is more efficient to eliminate the void with less reduction ratio in height. The experimental results obtained from this study could be helpful to establish the optimum path schedule of open die forging process.

• 한국농공학회논문집
• /
• 제52권6호
• /
• pp.101-110
• /
• 2010

This study was performed to evaluate the void ratio and strength of porous polymer concrete used coarse aggregates and unsaturated polyester resin to find optimum mix design of porous polymer concrete for planting block. Also, this study was performed to evaluate the planting properties of herbaceous plant and cool-season grass in porous polymer blocks based on the experimental results of porous polymer concrete to develop environmentally friendly planting blocks. Tests for the void ratio and compressive strength of porous polymer concrete were performed at the curing age 7 days. Also, kinds of plants such as Tall fescue, Perennial ryegrass, Lespedeza and Alfalfa for planting were applied to porous polymer blocks. Within 6 weeks after seed, initial germination ratio, cover view and growth length for planting blocks were estimated by various methods.

• Geomechanics and Engineering
• /
• 제24권3호
• /
• pp.295-305
• /
• 2021

In this study, design charts for estimating consolidation settlement are proposed according to finite strain consolidation theory using a nonlinear constitutive relationship equation. Results of parametric sensitivity analysis shows that the final settlement, initial height, and initial void ratio exerted the greatest effect, and the coefficients of the void ratio-effective-stress. Proposed design charts were analyzed for three regions using a representative constitutive relationship equation that enables major dredged-reclaimed construction sites in Korea. The regional design charts can be calculated accurately for the final settlement because it is applied directly to the numerical analysis results, except for reading errors. A general design chart applicable to all marine clays is proposed through correlation analysis of the main parameters. A final self-weight consolidation settlement with various initial void ratios and initial height conditions should be estimated easily using the general design chart and constitutive relationship. The estimated final settlement using the general design chart is similar to the results of numerical analysis obtained using finite strain consolidation theory. Under an overburden pressure condition, design charts for estimating consolidation settlement are proposed for three regions in Korea.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2008년도 추계 학술발표회
• /
• pp.1290-1295
• /
• 2008

The relative density of soil indicate loose and dense state of sand. Because sand is low compressibility, initial relative density of sand is important effect factor of compression and shear behavior. To measure exactly relative density, the exactly maximum and minimum void ratio was determinated by laboratory tests. Generally, vibrating table method is adapted for minimum void ratio(KS F 2345). However KS F 2345 is not consider the particle break during the vibrating table test. In this study, The minimum void ratio is compared with a method of Pluviation and Vibrating table test results using the K-7(crushed sand). It is concluded that the K-7 sand particles were crushed during the vibrating table test and vibrating table test is not a suitable test for a crushed sand $e_{min}$.

• 한국지반공학회논문집
• /
• 제17권6호
• /
• pp.235-244
• /
• 2001

액상화는 비배수조건에서 흙 강도의 갑작스러운 감소에 기인한다. 이러한 흙 강도의 손실은 과잉간극수압의 발현과 관련된다. 본 연구에서는 최대 및 최소간극비에 영향을 미치는 세립분 함유량이 조사되었다. 또한 포화된 실트질 모래에 대한 정적 및 동적 삼축시험의 결과를 제시하였다. 이들 시험은 액상화강도와 정적 및 동적 거동 특성을 평가하기 위해 수행되었다. 시료는 새만금 유역에서 채취되었으며 공기건조되었다. 결과를 요약하면 다음과 같다. 1) 최대 및 최소간극비선은 유사한 경향으로 나타났다. 2) 최대 및 최소간극비는 20~30%의 세립분 함유량에서 얻어졌다. 3) 구속압력과 과압밀비가 증가할수록 액상화에 대한 저항은 증가하였다. 4) 불안정마찰각은 초기상대밀도의 증가와 함께 커졌다. 5) 유효응력비가 증가함에 따라 액상화에 대한 저항은 감소하였다.

• 한국농공학회지
• /
• 제18권4호
• /
• pp.4242-4250
• /
• 1976

The determination of the pre-consolidation load known to have a great effect on the consolidation characteristics of the soil have been researched and discussed in detail by many other researchers. A study was undertaken to investigate and compare the effect of pre-consolidation loads on the coefficient of permeability and the consolidation characterisics of soil through the consolidation test on the three types of soil samples. The results of this study are follows; 1. Large compression index is dependent on initial void ratio of the sample being used and the pressure-void ratio curve shows a curved linear relationship in over-consolidated area but a linear relationship in normally consolidated area.2. Settlement-time curve is S-shaped where the pressure is larger than pre-consolidation load and regardless of over-burden pressure, it is a similar straight line respectively in the secondary consolidation area. 3. Primary consolidation ratio of the sample increases almost linearly with the increase of over-burden pressure but the coefficient of volume compressibility decreases linearly with the increase of it. 4. Time factor of a certain degree of consolidation increases with over-burden pressure but the coefficient of consolidation decreases with it in over-consolidated area. There is a linear relationship between them in normally consolidated area. 5. The void ratio of completion point of primary consolidation decreases linearly with over-burden pressure. 6. The coefficient of permeability of sample decreases linearly with over-burden pressure in normally consolidated area, also it increases linearly with increment of the void ratio of the sample.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2010년도 춘계 학술발표회
• /
• pp.489-494
• /
• 2010

A geo-composite soil (GCS) is a stabilized mixture of bottom ash, cement and dredged soil. Various samples with different mass ratios of mixtures were tested under curing time of 7 and 28 days to investigate physical properties and compressive strength. This paper focused on the effect of bottom ash on the strength characteristics of Busan marine dredged soil. Cement has been added as an additive constituent to enhance self-hardening of the blended mixture. The unconfined compressive strength of GCS increases with an increase in curing time due to pozzolanic reaction of the bottom ash. The strength after 28 days of curing is found to be approximately 1.3 to 2.0 times the strength after 7 days of curing, regardless of mixture conditions. The secant modulus of GCS is in the range of 55 to 134 times the unconfined compressive strength. The correlation of unconfined compressive strength with bottom ash content and initial void ratio are suggested.