• Journal of Communications and Networks
• /
• v.10 no.1
• /
• pp.71-78
• /
• 2008

We propose a sub-band spreading technique for adaptive modulation (AM) in orthogonal frequency division multiplexing (OFDM) systems in order to reduce signaling overheads and to average frequency selective fading channels causing different signal-to-noise ratio (SNR) values for subcarriers in each subband. The conventional sub-band based AM schemes can also reduce signaling overheads and complexity for allocating a resource per sub-band at a time. However, they may suffer from the channel variation in a sub-band when the sub-band size is larger than the channel coherence bandwidth (BW). The sub-band spreading at the transmitter enables the received symbols in each sub-band to have an identical reliability even in a frequency selective fading channel. We rigorously analyze the averaged SNR value at the receiver of the sub-band spreading system and the analyzed average SNR in a sub-band is used for an adaptation criterion. The proposed AM scheme outperforms the conventional sub-band based OFDM scheme without spreading, and it can yield better throughput performance than the conventional subcarrier based AM schemes when we consider the signaling overheads.

• Journal of IKEEE
• /
• v.26 no.4
• /
• pp.693-704
• /
• 2022

5G service uses mid-band (n78) than existing mobile communication frequencies, so it is necessary to improve 5G coverage by utilizing low-band frequencies below 2 GHz. To this end, the application of Dynamic Spectrum Sharing technology of LTE and 5G-NR system using most of the low-band frequencies is required. In this paper, signaling overhead factors for DSS application and RF issues for terminal implementation are derived, and signaling overhead ratios from the respective perspectives of 5G-NR and LTE for the 1.8GHz band (50MHz width) that can utilize wide-bandwidth among low-band frequencies are estimated. Also handset RF issues were analyzed. Based on the analysis results, if DSS technology using low band is applied, it is expected that excellent 5G service quality can be provided due to 5G coverage improvement when LTE traffic quickly migrates to 5G-NR.

• Journal of Communications and Networks
• /
• v.4 no.2
• /
• pp.97-101
• /
• 2002

Based on their shift and scale orthogonality properties, scaling and wavelet functions may be used as signaling functions having good frequency localization as determined by the fractional-out-of-band power (FOOBP). In this paper, application of Daubechies' wavelet and scaling functions as baseband signaling functions is described, with a focus on finding discretely realizable pulse-shaping transfer function circuits whose outputs approximate scaling and wavelet functions when driven by more conventional digital signaling waveforms. It is also shown that the inter-symbol interference (ISI) introduced by the approximation has negligible effect on the performance in terms of signal-to-noise ratio (SNR). Moreover, the approximations are often more bandwidth efficient than the original wavelet functions. These waveforms thus illustrate an example solution of a tradeoff between residual ISI and bandwidth efficiency as a signal design problem.

• Proceedings of the KSR Conference
• /
• 2007.05a
• /
• pp.1408-1415
• /
• 2007

To operate Platform Screen Door (PSD) automatically, the operational data of PSD and the train must be interfaced properly. PSD and train are operated together by the signaling system in Automatic Train Operation (ATO) signaling system zone where interfaces are provided between PSD and train. However, the additional PSD interface system with train is required in train operating zone without the interface between PSD and train. For the PSD interface, the wireless communication system or the train status (train correct stop status / train door status) detection system has been used. Seoul Metro line No.2. has the PSD wireless communication system using 447MHz band RF. For the safety of PSD operation, it is required to prevent RF interference in the subway environment where many frequencies exist. In this paper, the PSD wireless communication system is developed using 2.4GHz band RF to prevent the interference of the wireless communication and increase the traffic of the PSD interface. Furthermore, the improved system can store, manage and display the PSD and train operational data using Human Machine Interface (HMI) in the train's driver cab.

• Journal of Communications and Networks
• /
• v.14 no.6
• /
• pp.710-718
• /
• 2012

The implementation of a common control channel is one of the most challenging issues in cognitive radio networks, since a fully reliable control channel cannot be created without reserving bandwidth specifically for this purpose. In this paper, we investigate a promising solution that exploits the ultra wide band (UWB) technology to let cognitive radio nodes discover each other and exchange control information for establishing a communication link. The contribution of this paper is threefold: (i) We define the communication protocol needed to let cognitive radio nodes discover each other and exchange control information for link set up, (ii) we overcome the gap in coverage, which typically exists between UWB and long-medium range technologies, by using multi-hop communication, (iii) we evaluate the performance of our approach by adopting an accurate channel model and show its benefits with respect to an in-band signaling solution.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.10A
• /
• pp.1588-1596
• /
• 1999

This paper describes a signaling processor IC for land mobile radio systems. This IC generates CTSS tone or DCS code signals for signaling between the land mobile radio systems and decodes them to open the audio path. The CTSS tone or DCS code signals occupy the subaudio band and are transmitted with voice signal. The audio and subaudio paths consist of switched capacitor filters. The IC has been implemented in 0.6-$\mu\textrm{m}$ 2-poly 3-metal CMOS process. The chip size is 3 mm$\times$4.3 mm and total current is about 3.4 ㎃ at 3.3 V.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.38 no.8
• /
• pp.1-10
• /
• 2001

This paper describes new line code algorithm, called NIDI(Nibble Inversion mock Inversion) which is well suited for interconnection and transmission technology, The proposed line code which includes only one redundancy bit serves primary features of line code and synchronization patterns for byte or frame synchronization in interconnection, Also, this line code provides in-band signals and speciaI characters.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.12B
• /
• pp.1058-1067
• /
• 2006

In this paper, we propose a inband/outband broadcast method for hidden incumbent system detection of medium access control layer for wireless regional area network systems using cognitive radio technology. Through some extra channels that are not currently used, a short message is broadcasted. The message allows CPE detecting an appearance of incumbent system to send sensing report to CR BS. For the hidden incumbent system report message, the BS needs a process or method for allocation of upstream resource to CPEs. And transmitting multiple out-band signals has a possibility to collide with out-band signals of other co-located WRAN BSs. To avoid out-band signal collision, BSs randomly select it out-band signal broadcasting time within the pre-defined explicit out-band signaling, period. And fractional Bandwidth Usage allows WRAN BSs to efficiently use bandwidth.

• Journal of Ginseng Research
• /
• v.19 no.2
• /
• pp.117-121
• /
• 1995

We studied the effects of ginsenoside-$Rg_1$ (G-$Rg_1$) extracted from Panax ginseng C.A. Meyer on $p56^{kk}$ kinase and cell proliferation in Jurkat T cells. $p56^{kk}$ was maximally activated within 5 min after the treatment of 16.7 $\mu\textrm{g}$/ml of G-$Rg_1$ increasing the activity by 1.2-2 times relative to untreated control, thereafter its activity was gradually decreased to the level of untreated control. The action of EGTA on the kinase was altered by the addition of G-$Rg_1$, accompanying the band shift of $p56^{kk}$ to $p60^{kk}$. In addition, G-$Rg_1$promoted cell proliferation in a concentration-dependent manner. These results suggest that G-$Rg_1$ may be involved in T cell receptor-CD3 (TCR) signaling via the activation of $p56^{kk}$ and the chance of cellular calcium concentration.

• The KIPS Transactions:PartC
• /
• v.9C no.1
• /
• pp.73-78
• /
• 2002

In WATM networks, in order to perform dynamic slot allocation required slots of mobile terminals are estimated based on DP (Dynamic Parameter) reflecting characteristics of traffic. In VBR (Variable Bit Rate) traffic, slot allocation is done at MT considering both time-dependent characteristics and QoS (Quality of Service) requirements. In this paper, DPs-buffer state information and buffer state change-are transmitted through in-band signaling. BS (Base Station) performs dynamic slot allocation considering traffic characteristics of each MT (Mobile Terminal), in other words, buffer state information informs the potentiality of 'buffer full state'to BS if MT buffer is over the specific threshold value and buffer state change notifies change in buffer state of incoming cells to MT. If buffer state information is equal to 'low (more than threshold)' and 'abrupt increase' it generates 'buffer full' state cell transmission delay or cell loss might occur. At this time BS should assign additional slots to MT, and then MT consumes cells in its buffer. In simulation, the proposed scheme shows better performance in cell delay and loss than EPSA (Estimation-Prorated Slot Assignment) in-band scheme.