• 대한소아치과학회지
• /
• 제24권3호
• /
• pp.710-717
• /
• 1997

Autotransplantation is the transplantation of embeded, impacted, or unerupted tooth, into extraction socket or surgically prepared socket in the same individual. Clinically, successful autotransplantation must show radiolucent space(periodontal ligament space) between transplanted tooth and supporting bone, lamina dura, no root resorption, no ankylosis, no inflammatory change, and physiologic tooth mobility. It is important that procedure is atraumatic, and the instruments should not contact the root surface during procedure. We performed autotransplantation of impacted mandibular canine that transversely located beneath the apices of the mandibular incisors with uncompletely developed apex. In radiographs and clinical evaluation, this transplant showed successful clinical finding except irregularity of mesial root surface after 14 months. It is conclued that transplantation of canine with $\frac{1}{2}{\sim}\frac{3}{4}$ root development provides a good chance of pulp survival, limited risk of root resorption and ensures sufficient final length, and is thus recommended.

• 대한기계학회논문집
• /
• 제17권11호
• /
• pp.2752-2761
• /
• 1993

The purpose of this study is to confirm the decreasing problems of residual bending strength, and the fracture machanism experimentally when CFRP composite laminates are subjected to Foreign Object Damage. Composite laminates used for this experiment are CFRP orthotropy laminated plates, which have two-interfaces [O/sub 6//sup o//90/sub 6//sup o/]sub sym/ and four-interfaces [O/sub 3//sup o//90/sub 6//sup o//O/sub 3//sup o]/sub sym/. When the specimen is subjected to transverse impact by a steel ball, the delamination area generated by impact damage is observed by using SAM(Scanning Acoustic Microscope). also, Thefracture surfaces obtained by three-point bending test were observed by using SEM (Scanning Electron Microscope). Then, fracture mechanism was investigated based on the observed delamination area and fracture surface. The results were summarized as follows; (1) It is found that for the specimen with more interface, the critical delamination energy is increased while delamination-development energy is decreased. (2) Residual bending strength of specimen A is greater than that of Specimen B within the impact range of impact energy 1. 65J (impacted-side compression) and 1. 45J (impacted-side tension). On the other hand, when the impact energy is beyond the above ranges, residual bending strength of specimen A is smaller than that of specimen B. (3) In specimen A and B, residual strength of CFRP plates subjected to impact damage is lower in the impacted-side compression than in the impacted-side tension. (4) In the case of impacted-side compression, fracture is propagated from the transverse crack generat-ed near impact point. On the other hand, fracture is developed toward the impact point from the edge of interface-B delamination in the case of impacted-side tension.

• ALGAE
• /
• 제32권3호
• /
• pp.223-233
• /
• 2017

Kelp forests and the many vital ecosystem services they provide are threatened as the severity of climate change and other anthropogenic stressors continues to mount. Particularly in the North Pacific, sea surface temperature is warming and glacial melt is decreasing salinity. This study explored the resiliency of early life-history stages of these foundation species through a factorial laboratory experiment. The effects of rising sea surface temperature under low salinity conditions on kelp spore settlement and initial gametophyte growth in Eualaria fistulosa, Nereocystis luetkeana, and Saccharina latissima were investigated. Decreased settlement and growth were observed in these species at elevated temperatures and at low salinity. Eualaria fistulosa spores and gametophytes were the most negatively impacted, compared to the more widely distributed N. luetkeana and S. latissima. These results suggest that N. luetkeana and S. latissima could potentially outperform E. fistulosa under projected conditions. However, despite decreased performance among all species, our findings indicate that these species are largely resilient to temperature changes when exposed to a low salinity, even when the temperature changes are immediate and extreme. By exploring how early life-history stages of several key kelp species are impacted by dual stressors, this research enhances our understanding of how kelp forests will respond to projected and extreme changes in temperature when already stressed by low salinity.

• 치과방사선
• /
• 제12권1호
• /
• pp.57-61
• /
• 1982

The author has made a study on the classification of the mandibular 3rd molars of Korean youths through dental radiography by means of Pell & Gregory's classification and on the prevalence of the dental caries of distal surface of the mandibular 2nd molar adjacent to the mandibular 3rd molars turned anteriorly. The results are as follow; 1. It was found that the largest case number was class I (272 cases, 52.9%) in the relation of the tooth to the ramus of the mandible and 2nd molar. 2. The mesio-angular position was the largest number (239 cases, 46.5%) in the relation of the long axis of the impacted mandibular 3rd molar to the long axis of the 2nd molar. 3. The mesio-angular position of class I was the largest number (140 cases, 27.2 %) in the relation of the tooth to the ramus of the mandible and 2nd molar and the long axis of the impacted mandibular 3rd molar to the long axis of the 2nd molar. 4. The average angle of the long axis of mandibular 3rd molar in mesioangular position or horizontal position to the occlusal plane was 143° 5. Mandibular 3rd molar with lesion such as dental caries or pericoronitis was 73 cases (14.2). 6. The caries incidence rate of the distal surface of the 2nd molar was about 3.1%.

• 대한소아치과학회지
• /
• 제35권2호
• /
• pp.339-344
• /
• 2008

상악 영구 견치의 매복에 비해 하악 영구 견치의 매복은 매우 드물게 일어난다. 치아가 매복된 경우 장애물 존재 여부와 매복 위치와 방향, 맹출 가능한 공간의 유무, 치근의 형성 단계 등의 요소에 따라 매복 치아의 발거 혹은 장애물의 제거 후 주기적 관찰, 맹출이 지연된 치아의 외과적 노출, 교정적 견인 등의 방법으로 치료하게 된다. 본 증례는 하악골의 골절 부위에 시행된 골간 강선 결찰과 미니 플레이트에 의해 하악 좌측 견치가 매복되어 있었던 경우로 CT 검사 결과 하악 정중부위 플레이트의 스크류가 맹출을 방해하고 있는 것으로 판단되어 전신 마취 하에 플레이트를 제거하였다. 이후 자연적인 맹출을 기대하였으나, 맹출력이 부족하여 교정적 견인으로 양호한 결과를 얻었기에 보고하는 바이다.

• Carbon letters
• /
• 제27권
• /
• pp.12-17
• /
• 2018

We fabricated a Li-S battery with post-treated carbon nanotube (CNT) films which offered better support for sulfur, and investigated the effect of the surface properties and pore structure of the post-treated CNT films on Li-S battery performance. Post-treatments, i.e., acid treatment, unzip process and cetyltrimethylammonium bromide (CTAB) treatment, effectively modified the surface properties and pore structure of the CNT film. The modified pore structure impacted the ability of the CNT films to accommodate the catholyte, resulting in an increase in initial discharge capacity.

• 한국윤활학회:학술대회논문집
• /
• 한국윤활학회 1998년도 제28회 추계학술대회
• /
• pp.67-74
• /
• 1998

Two kinds of polished and unpolished freestanding films prepared by DC plasma CVD method were impacted by SiC particles to understand erosion mechanism. Erosion damage caused by solid impact was characterized by surface profilometer, scanning electron microscopy and Raman spectroscopy. Gradually decrease of surface roughness and sharp reduction of crystallinity for unpolished CVD films were observed with increasing erosion time. It was found that smaller grains of the diamond were removed in early stage of erosion process and larger grains were eroded with further impingement. By introduction of re-growth method on polished diamond, further understanding of erosion mechanism was achieved. Most of the surface fractures were initiated at the grain boundary.

• Journal of Korean Dental Science
• /
• 제16권1호
• /
• pp.63-73
• /
• 2023

Purpose: Hyperdontia is a developmental disorder of the oral cavity. Mesiodens refers to the hyperdontia located between the maxillary central incisors. During the surgical procedure, the anesthetic method for pain control should be considered along with factors related to the surgery itself. The purpose of this study was to evaluate the effect of the impacted position of the mesiodens on the selection of sedation method and to suggest incisive foramen as a brief reference. Materials and Methods: This study included 126 patients who were scheduled for extraction of mesiodens. The selection criteria included patients with one palatally impacted inverted mesiodens accessible from the palatal gingival margin, and those with good cooperation potential in order to control for clinical information. Using cone beam computed tomography, vertical, horizontal, and palatal positional factors were measured, and the anesthetic method was determined by two examiners. The patients were grouped into vertical and horizontal groups based on the position of the incisive foramen. Data were statistically analyzed using the Mann-Whitney test, the chi-square test, and logistic regression analysis. Result: All positional factors differed between the outpatient and inpatient anesthetic groups. The vertical minimum distance from the alveolar ridge to the mesiodens (Va) and the minimum distance from the palatal surface to the crown tip of the mesiodens (Tc) were factors affecting the choice of anesthetic method. The distribution of the vertical and horizontal positional groups differed between the outpatient and inpatient anesthetic groups. Conclusion: The incisive foramen can be used as a brief reference to determine the appropriate anesthetic method. Referral for inpatient anesthesia may be a priority if they are in the V₂H₂ group with Va ≥5 mm, and Tc ≥6 mm, and outpatient sedation may be considered if they are in the V₁H₁ group with Va ≤1.5 mm, and Tc ≤2.5 mm.

• 대한치과교정학회지
• /
• 제4권1호
• /
• pp.57-61
• /
• 1974

The patient, a girl of 19 years in good health, had a class I malocclusion. The maxillary left centra1 incisors and both lateral incisors had already erupted. But the space for the right central incisor was partially closed by the mesial drifting of the neighboring teeth. The caused a shift in the midline and a cross-bite relation on the incisors. X-ray examination revealed the presence of the right central incisor in the alveolar bone and odontoma just above the crown of the right central incisor. After enough space for the impacted incisor was created in the dental arch with a open-coil spring the rectangular incision was made. Removing the odontoma uncovered the flat surface of the labial aspect of the incisor. During the tooth had erupted of its own accord, any unnecessary force had been imposed on the tooth. When it was decided that the tooth should be brought out by the mechanical device, the gold cast onlay with hook was used and run a light elastic between this hook and the main arch wire. Finally the tooth was brought down to the arch level. The result was excellent. Fortunately the esthetic problem and any detrimental effects on the psychological make-up could be avoided.

• Imaging Science in Dentistry
• /
• 제41권3호
• /
• pp.115-121
• /
• 2011

Purpose : This article is to describe a modified device for intraoral radiography which was developed to obtain reproducible radiographic images for assessment of distal osseous defects of the mandibular second molar (2 Mm) after impacted third molar (3 Mm) surgery. Materials and Methods : A commercial available alignment system for posterior region was modified by adding a reference gauge pin (millimetric) and threading a hollow acrylic cylinder at the ring of the radiographic positioner to attach the X-ray collimator. The design included customized resin acrylic stent for the occlusal surface of the 2Mm in maximum intercuspal position, individualizing the biteblock positioner. Periapical radiographs were taken before and after surgical extraction of 3 Mm, employing the radiographic technique of parallelism described by Kugelberg (1986) with this modified film holder and inserting the gauge pin on the deepest bone probing depth point. Results : This technique permitted to obtain standardized periapical radiographs with a moderate to high resolution, repeatability, and accuracy. There was no difference between the measurements on the pre- and post-operative radiographs. This technique allowed better maintenance of the same geometric position compared with conventional one. The insertion of the gauge pin provided the same reference point and localized the deepest osseous defect on the two-dimensional radiographs. Conclusion : This technique allowed better reproducibility in posterior radiographic records (distal surface of 2 Mm) and more accurate measurements of radiographic bone level by the use of a millimetric pin.