• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1992.05a
• /
• pp.114-116
• /
• 1992

ITO/TiO$_2$/Se solar cell were fabricated by vacuum deposition method, the Se and TiO$_2$were deposited on the ITO/Glass. Prior to the electrical properties of film, the provide Te between the ITO and the Se film were deposited by substrate temperature 20[$^{\circ}C$] and evaporation time 15[min], next time TiO$_2$ were treated by rf-magnetron sputtering in substrate temperature 250[$^{\circ}C$]. Fabricated ITO/TiO$_2$/Se solar cell were as follows : Open Voltage V$\_$oc/=848[mV], Short Circuit Current I$\_$sc/=10.79[mA/$\textrm{cm}^2$]. Fill Factor FF=0.518, energy conversion efficiency η=4.74[%] under the illumination of AM 1.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.9 no.10
• /
• pp.4160-4176
• /
• 2015

Data compression like image and video compression has come a long way since the introduction of Compressive Sensing (CS) which compresses sparse signals such as images, videos etc. to very few samples i.e. M < N measurements. At the receiver end, a robust and efficient recovery algorithm estimates the original image or video. Many prominent algorithms solve least squares problem (LSP) iteratively in order to reconstruct the signal hence consuming more processing time. In this paper non-iterative threshold based recovery algorithm (NITRA) is proposed for the recovery of images and videos without solving LSP, claiming reduced complexity and better reconstruction quality. The elapsed time for images and videos using NITRA is in ㎲ range which is 100 times less than other existing algorithms. The peak signal to noise ratio (PSNR) is above 30 dB, structural similarity (SSIM) and structural content (SC) are of 99%.

• Bulletin of the Korean Chemical Society
• /
• v.7 no.1
• /
• pp.73-77
• /
• 1986

Data on the concentration of Na, K, Sc, Cr, Fe, Co, Cu, Ga, Rb, Cs, Ba, La, Ce, Sm, Eu, Tb, Lu, Hf, Ta, and Th obtained by neutron activation analysis have been used to characterize Korean porcelainsherds by multivariate analysis. The mathematical approach employed is principal component analysis (PCA). PCA was found to be helpful for dimensionality reduction and for obtaining information regarding (a) the number of independent causal variables required to account for the variability in the overall data set, (b) the extent to which a given variable contributes to a component and (c) the number of causal variables required to explain the total variability of each measured variable.

• Current Photovoltaic Research
• /
• v.6 no.4
• /
• pp.94-101
• /
• 2018

Light elevated temperature induced degradation (LeTID) was noted as an issue in multi-crystalline silicon solar cells (MSSC) by Ram speck in 2012. In contrast to light induced degradation (LID), which has been researched in silicon solar cells for a long time, research about both LeTID and the mechanism of LeTID has been limited. In addition, research about LeTID in single-crystalline silicon solar cells (SSSC) is even more limited. In order to improve understanding of LeTID in SSSC with a passivated emitter rear contact (PERC) structure, we fabricated four group samples with boron and oxygen factors and evaluated the solar cell characteristics, such as the cell efficiency, $V_{oc}$, $I_{sc}$, fill factor (FF), LID, and LeTID. The trends of LID of the four group samples were similar to the trend of LeTID as a function of boron and oxygen.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.19 no.2
• /
• pp.151-161
• /
• 2007

Statistical characteristic analysis was carried out using the non-tidal components computed by the harmonic analysis of the tidal elevation data in East coast. The tide gauging stations included in this study are the Sokcho, Mukho, Hupo, Pohang, Ulsan and Ulreungdo stations. In this study, the variance and skewness coefficient (SC) information changes, i.e., the max. value, min. value, mean and standard deviation of the variance and SC, are compared and analysed in detail by the various analysis periods increased from one year to the maximum available period. Based on the result of the statistical information (SI) range analysis, the minimum analysis period required in order to satisfy the confidence interval of the ${\pm}5%$ range of the variance and the ${\pm}0.1$ range of the SC is suggested as the 12 years, except the Ulreungdo stations. The auto-correlation and spectral density change patterns show the very similar shapes in every stations even though the absolute values are a little bit different each other.

• Journal of the Korean Vacuum Society
• /
• v.16 no.5
• /
• pp.388-396
• /
• 2007

KSTAR (Korea Superconducting Tokamak Advanced Research) current lead system (CLS) has a role to interconnect magnet power supply (MPS) in room temperature (300 K) and superconducting (SC) bus-line, electrically. For the first plasma experiments, it should be assembled 4 current leads (CL) on toroidal field (TF) current lead box (CLB) and 14 leads on poloidal field (PF) CLB. Two current leads, with the design currents 17.5 kA, and SC bus-lines are connected in parallel to supply 35 kA DC currents on TF magnet. Whereas, it could supply $20\;{\sim}\;26\;kA$ to each pairs of PF magnets during more than 350 s. At the cold terminals of the leads, there are joined SC bus-lines and it was constructed helium coolant control system, aside from main tokamak system, to protect heat flux through current leads and enhanced Joule heat due to supplied currents. Throughout the establishment processes, it was tested the high vacuum pumping, helium leak of the helium lines and hardwares mounted between the helium lines, flow controls for CL, and liquid nitrogen cool-down of possible parts (current leads, CL helium lines, and thermal shield helium lines for CLB), for the accomplishment of the required performances.

• Korean Journal of Optics and Photonics
• /
• v.2 no.3
• /
• pp.139-148
• /
• 1991

A fiber-optic magnetic sensor system for the detection of small ac magnetic field(200Hz-2 kHz) was constructed. Magnetic field sensing part was fabricated by bonding a section of optical fiber to amorphous metallic glass(2605SC) having large magnetostriction effect. And with the directional coupler, all fiber type Mach-Zehnder interferometer was constructed to measure the variation of the external magnetic field by translating it into the optical phase shift in the interferometer. The signal fading problem of the interferometer, which is due to random phase drifts originated from the environment, i.e., temperature fluctuation, vibrations, etc., was elliminated by feedback phase compensation. This allows the sensitivity to be maintained at the maximum by keeping the interferometer in quadrature phase condition. The frequency response of metallic glass was found to be nearly flat in the range of 90 Hz-2 kHz and dc bias field for the maximum ac response was 3.5 Oe. The interferometer output showed good linearity over the range $\pm$0.5 Oe. For 1 kHz ac magnetic field the scale factor S and the minimum detectable magnetic field were measured to be 8.0 rad/Oe and $3X10^{-6} Oe/\sqrt{Hz}$at 1 Hz detection bandwidth respectively.

• Journal of the Korean Society of Physical Medicine
• /
• v.13 no.2
• /
• pp.61-68
• /
• 2018

PURPOSE: This study aimed to examine the effects of self-stretching (SS) and joint mobilization (JM) on pain, craniovertebral angle (CVA), autonomic system function in chronic cervical pain patient with forward head posture (FHP). METHODS: A total of 30 male college students were selected as study subjects, and were divided into Group I (general physical therapy; GPT, n=10), Group II (GPT+SS, n=10), Group III (GPT+JM, n=10). All groups were evaluated three times a week for 4 weeks. Pain was measured by visual analogue scale (VAS), CVA was measured using digital goniometer and autonomic system function (heart rate; HR, skin conductivity; SC, LF norm, HF norm, LF/HF ratio) was measured by Biofeedback ProComp Infiniti. After 4 weeks, paired t-test was used to compare the changes within the group and one way ANOVA was used to compare those between the groups. RESULTS: In Group I, VAS was significantly decreased. In Group II and III was a significantly change in all items. In comparison between Group I and II was a difference in all items except HR. In comparison between Group I and III was a difference in all items. In comparison between Group II and III was a difference in VAS, LF norm and LF/HF ratio. CONCLUSION: This study showed that SS and JM can effectively reduce pain and normalize the autonomic system function.

• Korean Journal of Psychosomatic Medicine
• /
• v.5 no.1
• /
• pp.97-107
• /
• 1997

As a preliminary step to develop the Daily stress Inventory(DSI) for assessing minor stressors frequently experienced in everyday lift. We examined the reliability and validity of the DSI. The Daily Stress Inventory(DSI), the Beck Depression Inventory(BDI), the State-Trait Anxiety Inventory(STAI), the Social Readjustment Rating Scale(SRRS) and the Minnesota Multiphasic Personality Inventory(MMPI) were administered to 111 college students. Compared with the weekly DSI Event, Impact and I/E ratio scores of the American college students, the weekly event and I/E ratio scores of the Korean college students were significantly higher but weekly Impact score was lower. The internal consistency reliability of the DSI as computed by Cronbach alpha was .98. The DSI I/E ratio scores were significantly correlated with the scores of State Anxiety$({\gamma}=.27)$ and Trait Anxiety${\gamma}=.24)$, but not with BDI scores. And the SSRS scores were not significantly correlated to the DSI Event or Impact and In ratio scores. Significant correlations were revealed between the DSI Impact scores and the Sc and Ma scales of the MMPI. And the correlation between the DSI I/E ratio scores and the L, D, Hy, Pd and Pa scales of the MMPI was also significant. But no significant correlation was found between the DSI Event scores and all the scales of the MMPI. This study suggests that the DSI can be a reliable and valid tool to assess the minor stress frequently experienced in everyday life future study should be directed to obtain normative data based on more varied and larger population. Especially gathering additional evidences for the validity of the DSI using other minor stressor scale will be required.

• Imaging Science in Dentistry
• /
• v.40 no.2
• /
• pp.63-68
• /
• 2010

Purpose : To compare the CT numbers on 3 cone-beam CT (CBCT) images with those on multi-detector CT (MDCT) image using CT phantom and to develop linear regressive equations using CT numbers to material density for all the CT scanner each. Materials and Methods : Mini CT phantom comprised of five 1 inch thick cylindrical models with 1.125 inches diameter of materials with different densities (polyethylene, polystyrene, plastic water, nylon and acrylic) was used. It was scanned in 3 CBCTs (i-CAT, Alphard VEGA, Implagraphy SC) and 1 MDCT (Somatom Emotion). The images were saved as DICOM format and CT numbers were measured using OnDemand 3D. CT numbers obtained from CBCTs and MDCT images were compared and linear regression analysis was performed for the density, $\rho$ ($g/cm^3$), as the dependent variable in terms of the CT numbers obtained from CBCTs and MDCT images. Results : CT numbers on i-CAT and Implagraphy CBCT images were smaller than those on Somatom Emotion MDCT image (p<0.05). Linear relationship on a range of materials used for this study were $\rho$=0.001H+1.07 with $R^2$ value of 0.999 for Somatom Emotion, $\rho$=0.002H+1.09 with $R^2$ value of 0.991 for Alphard VEGA, $\rho$=0.001H+1.43 with $R^2$ value of 0.980 for i-CAT and $\rho$=0.001H+1.30 with $R^2$ value of 0.975 for Implagraphy. Conclusion: CT numbers on i-CAT and Implagraphy CBCT images were not same as those on Somatom Emotion MDCT image. The linear regressive equations to determine the density from the CT numbers with very high correlation coefficient were obtained on three CBCT and MDCT scan.