• Journal of The Korean Society of Agricultural Engineers
• /
• v.61 no.4
• /
• pp.55-61
• /
• 2019

Motor pumps cannot be used in those areas where electricity is not accessible such as remote rural areas in many African countries. Hydraulic ram pump is one of the solutions for supplying water for irrigation or domestic uses. The hydraulic ram pumps are working based on the water hammer effect for pumping without external power or electricity. This study was conducted to investigate the effect of air chamber volume and operation parameters on the performance of the hydraulic ram pump which was assembled with common plumbing parts. The experimental results showed the volume of the air chamber did not affect the performance such as discharge rate and head. When drive heights were 1.7 and 2.35 m, the maximum discharge heads were up to 7 m and 10 m, respectively. When the air chamber volume was 1 L, discharge rates were 0.23 and 2.12 L/min under the drive heights of 1.7 and 2.35 m, respectively. The average energy efficiency of the hydraulic ram pump assembled in this study was about 60% for all the experimental conditions.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.24 no.2
• /
• pp.228-236
• /
• 2021

In order to understand the underwater noise source factor of the linear pump type forced ejection system, a reduced-model compressed water experiment device was developed. The reduced-model compressed water experiment device consists of a reverberation tank, a linear pump type forced ejection device, and an underwater vehicle. The underwater noise source was selected from the hydraulic ram moving speed, the hydraulic ram/piston pipe spacing, the ejection pipe inlet/water ram area ratio, and the number of water ram inlets. The underwater vehicle was ejected into the reverberation tank by the device. The source level was derived from the measured sound pressure. The source level tends to increase as the hydraulic ram/piston tube spacing and the hydraulic ram moving speed increase. The source level tended to increase as the area ratio was increased, but the level was weak. The number of water ram inlet did not affect the source level.

• Economic and Environmental Geology
• /
• v.49 no.3
• /
• pp.243-248
• /
• 2016

This study was conducted to evaluate the applicability and efficiency of water supply using hydraulic ram pump. Study area is the Imgok-ri, Hwanam-myeon, Sanju-si, Kyeongsangbuk-do. There is an abandoned coal mine, where groundwater is discharged from its entrance with a flow rate of approximately $260m^3/day$. Hydraulic ram pump uses the waterhammer phenomenon and utilizes the power of falling water for pumping part of that water to a higher elevation than the water sources without electric power. To determine the efficiency of hydraulic ram pump, the flow rate was measured at three points according to the altitude difference (${\Delta}h=19m$ (point 1), 30 m (point 2), 40 m (point 3)). Flow rate measured at 1, 2, and 3 were about $8.6{\sim}10.8m^3/day$, $3.98{\sim}4.39m^3/day$, and $2.35{\sim}2.59m^3/day$, respectively. The current results suggested that, hydraulic ram pump could be applicable for the water supply system in mountain areas without external power supply.