• 한국물환경학회지
• /
• 제21권3호
• /
• pp.242-247
• /
• 2005

In this study, we investigated the removal efficiencies of pollutants and permeate fluxes depending on chemistry of feed water, various molecular weight cut-offs (MWCOs) and materials of membrane, operating pressure. We used seven MWCO membranes of YC0.5, YM1, YM3, YM10, YM30, YM100 and PM30, humic acid solution and surface water as feed water, and examined variation in permeate flux. Results of TOC removal experiment demonstrate that MWCO lower 1,000daltons could remove humic acid effectively. As increasing solution pH and decreasing divalent cations ($Ca^{2+}$) concentration, TOC removal increased. But $UV_{254}$ removal efficiency increased with higher divalent cation concentration and solution pH. Membrane fouling increased with increasing electrolyte (NaCl), divalent cation concentration and decreasing solution pH. In spite of initial permeate flux of the hydrophobic membrane (PM30) was higher than that of the hydrophilic membrane (YM30), flux decline of PM30 was significant during operation. At higher operating pressure, compactness of the cake layer on the membrane surface increased, resulting in gradual increase in hydraulic resistance.

• Nuclear Engineering and Technology
• /
• 제22권1호
• /
• pp.66-74
• /
• 1990

원자력 7, 8호기에 장전된 17$\times$17 최적 핵연료집합체의 열수력학적 특성을 원자력 5, 6호기에 장전된 17$\times$17표준 핵연료집합체와 비교하여 분석하였다. 분석된 열수력학적 특성은 정상상태와 과도출력상태에서의 최소 DNBR, 연료봉 중심온도, 출구 기포율등이며, 아울러 연료봉의 중심이 용융되는 국부선출력과 원자로 운전변수들에 대한 DNBR 민감도 계수도 계산하였다. 사용된 코드는 COBRA-IV-I이며, 임계열속 계산에는 R형 그리드에 대해 수정된 W-3 상관식을, 기포율계산에는 drift-flux model을 이용하였다. 계산결과, DNB가 발생할 확률은 최적 핵연료집합체가 더 높았으나, 연료봉의 중심이 용융되는 국부선출력은 표준 핵연료집합체와 거의 동일한 것으로 나타났다.

• Nuclear Engineering and Technology
• /
• 제55권9호
• /
• pp.3313-3319
• /
• 2023

A phenomenological study on CHF in a bilaterally heated annulus with equal heat flux on both sides was experimentally performed. The working fluid of the present test was R-134a. Variation characteristics of CHF and transition of CHF occurrence location were investigated under different pressure, mass flux and quality conditions. With the increase of critical thermodynamic quality, it was found that CHF first occurred on the outer surface of the annulus, then simultaneously occurred on both sides, and finally occurred on the inner surface at relatively high critical quality. After the CHF location transitioned to the inner rod, the sharp fall of CHF in the limiting critical quality region was observed. The critical quality corresponding to the CHF location transition decreased with the increase of mass flux and pressure. Besides, CHF in tube, internally heated, externally heated and bilaterally heated annuli were compared under the same hydraulic diameter conditions. The present study is conducive to improving the understanding of complicated CHF mechanism in bilaterally heated annulus, enriching the experimental database, and providing evidence for developing accurate CHF mechanism model for annuli.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2004년도 춘계학술대회
• /
• pp.1458-1463
• /
• 2004

By using unique experimental techniques and careful construction of the experimental apparatus, the characteristics of the local heat transfer were investigated using the condensing R134a two-phase flow, in horizontal single mini-channels. The circular channels ($D_h=0.493$, 0.691, and 1.067 mm) and rectangular channels ($D_h=0.494$, 0.658, and 0.972 mm) were tested and compared. Tests were performed for a mass flux of 100, 200, 400, and 600 $kg/m^2s$, a heat flux of 5 to 20 $kW/m^2$, and a saturation temperature of $40^{\circ}C$. In this study, effect of heat flux, mass flux, vapor qualities, hydraulic diameter, and channel geometry on flow condensation were investigated and the experimental local condensation heat transfer coefficients are shown. The experimental data of condensation Nusselt number are compared with existing correlations.

• Nuclear Engineering and Technology
• /
• 제55권11호
• /
• pp.3996-4001
• /
• 2023

The High-flux Advanced Neutron Application Reactor (HANARO) produces radioisotopes (RIs) (¹³¹I, ¹⁹²Ir, etc.) through neutron irradiation on various RI production targets. Among them, ¹⁷⁷Lu and ¹⁶⁶Ho are particularly promising owing to their theranostic characteristics that facilitate simultaneous diagnosis and treatment. Prior to neutron irradiation, evaluating the nuclear heating of the RI production target is essential for ensuring the thermal-hydraulic safety of HANARO. In this study, the feasibility of producing ¹⁷⁷Lu and ¹⁶⁶Ho using irradiation holes of HANARO was investigated in terms of thermal-hydraulic safety. The nuclear heating rates of the RI production target by prompt and delayed radiation were calculated using MCNP6. The calculated nuclear heating rates were used as an input parameter in COMSOL Multiphysics to obtain the temperature distribution in an irradiation hole. The degree of temperature increase of the ¹⁷⁷Lu and ¹⁶⁶Ho production targets satisfied the safety criteria of HANARO. The nuclear heating rates and temperature distribution obtained through the in silico study are expected to provide valuable insight into the production of ¹⁷⁷Lu and ¹⁶⁶Ho using HANARO.

• 대한토목학회논문집
• /
• 제43권6호
• /
• pp.749-762
• /
• 2023

천수 방정식 흐름률 계산에 근사 Riemann 해법을 채택한 수심 적분 모형을 도수 실험에 적용하였다. 도수 때문에 단일 수로에서 서로 다른 흐름 양상이 동시에 나타나므로 흐름 저항에 대해 수심이나 유속에 무관한 Manning 조도 계수보다는 흐름 조건을 반영할 수 있는 Weisbach 저항 계수를 채택하였다. 모의 결과는 실험 결과에 잘 부합되었으며, Weisbach 계수로부터 환산한 Manning 계수는 사류 구간과 상류 구간에서 각 각 적절하게 설정되고 있음을 확인하였다. 도수 실험과 비교에서 정수압 가정에 기반한 천수 방정식의 한계가 드러나 비정수압 천수 흐름 모형 도입의 필요성이 높아졌다.

• 한국지하수토양환경학회:학술대회논문집
• /
• 한국지하수토양환경학회 2006년도 총회 및 춘계학술발표회
• /
• pp.220-223
• /
• 2006

To investigate the effect of solution pH and particle size of Na-bentonite on swelling characteristics and relative hydraulic conductivity, four kinds of acids and two alkali were selected. The results showed that the swelling was decreased to half of the original Na-bentonite's swelling index. Also the decrease in SI was most distinctive in pH 3.5 of HCl. But changes of swelling index between initial and stabilized were minimal in alkali treatment, compared to the change by acid treatment. No flux was detected under atmospheric pressure although there was drastic decrease in swelling. However, leaching started after application of 1.5 bars of air-pressure equivalent to 15 m of water head.

• Journal of international Conference on Electrical Machines and Systems
• /
• 제2권2호
• /
• pp.239-245
• /
• 2013

Modern electric controlled valves are demanded that its solenoid actuator should be smaller size, lighter weight, lower consumption power, and higher response time. For achieving these purposes, the major design factors of solenoid actuator such as magnetic flux density, coil turn numbers, plunger size, bobbin dimension, and etc. are must be optimized. In this study, for optimal design of high speed solenoid actuator for hydraulic servo valve operation, we draw up governing equations which are composed by combination of electromagnetic theories and empirical knowledge, and deduct the values of major design factors by use of them. For more increase the operating speed, voice coil are used as main armature in manufacturing of prototype actuator. And, we have proven the propriety of the governing equations and speed increasing method by experiments using the hydraulic valve assembly adopted the prototype of solenoid actuator.

• 에너지공학
• /
• 제20권1호
• /
• pp.30-35
• /
• 2011

2중관형과 판형 열교환기에 에틸렌 클리콜-물 수용액으로 만들어진 아이스슬러리를 적용하는 경우의 유동 및 열적 특성을 규명하기 위하여 실험을 수행하였다. 아이스슬러리의 질량유속과 얼음 분율은 각각 800에서 3500 kg/$m^2s$과 0에서 25%이었다. 실험을 통해, 압력강하와 열전달율은 질량유속과 얼음 분율에 따라 증가하였다. 그러나 얼음 분율의 효과는 높은 질량유속 영역에서는 크지 않은 것으로 나타났다. 낮은 질량유속에서는 압력강하와 열전달율의 급속한 증가가 질량 유속에 관계되는 것으로 나타났다.

• 설비공학논문집
• /
• 제13권11호
• /
• pp.1065-1071
• /
• 2001

To investigate hydraulic and thermal characteristics of ice slurries in a circular tube, ice slurries were tested in a flow loop with a constant heat flux test section, for ranges of flow velocity, ice fraction and heat flux. Heat transfer coefficients and friction factors of ice slurries were calculated by measuring the outer wall temperatures of the test section and the pressure drops over the test section. Heat transfer coefficients of ice slurries were 9% higher than the heat transfer coefficients expected by Petukhov. Friction factors were about 4% lower than the friction factors expected by Petukhov. The effective thermal capacity of ice slurry with 12.8% ice fraction, was found to be about 3 times higher than the thermal capacity of water.