• New & Renewable Energy
• /
• v.2 no.2 s.6
• /
• pp.23-27
• /
• 2006

The power split hybrid powertrain is considered to be one of the most prospective configuration for the hybrid electric vehicle (HEV). Toyota Prius, representing this type of vehicle, showed outstanding performances in fuel efficiency, emission reduction and acceleration. The excellence is largely due to the fact that it utilizes almost all operation modes of HEV. Those modes include ZEV (Zero Emission Vehicle) driving, idle stop, fuel cut-off, power assist, active charging, regenerative braking and so forth. In this paper, a few of the mode operations were simulated using AVL Cruise. Also, control logics to operate the powertrain in each mode were developed. The states of powertrain components were displayed and analyzed. By controlling the three components (engine, motor and generator), it was possible to run the powertrain in several hybrid operation modes.

• Journal of the Korean Society for Precision Engineering
• /
• v.23 no.2 s.179
• /
• pp.172-180
• /
• 2006

Although there existed many types of manual/power hybrid wheelchairs, their use was not widespread because of their inconvenience in converting drive system and in folding frames. To carry a wheelchair in the car or to convert driving methods, some hard work of disassembling or exchanging wheels was required for most of currently available hybrid wheelchairs. In this study, the standard foldable manual wheelchair was reformed to a power wheelchair by installing the newly developed Axial Flux Permanent Magnet(AFPM) type of brush less direct current(BLDC) motor on each rear hub of wheelchair. This wheelchair could be driven by manual or electric power without exchanging. wheels, thus no additional work was needed for carriage or for power conversion. The developed wheelchair was evaluated for durability, stability, maneuverability, cost, and reliability in accordance with the Korean standards. The results indicated that the developed hybrid wheelchair was good enough for commercialization comparing to other imported wheelchairs.

• Journal of Industrial Technology
• /
• v.27 no.A
• /
• pp.141-147
• /
• 2007

In this paper, we define the multi-states exponential cell resident time mobility model for describing the mobility characteristics of mobile user and analyzed the total cost of the hybrid method using multi-states cell resident time. Generally, the mobile user has three states for its movement, such as staying, walking and driving. This multi-states cell resident time based hybrid method reflects the movement characteristics of mobile user and adapts the location update period according to the states of mobility speed. As a results of the performance analysis, we can get the optimum parameters of the hybrid method for multi-states based mobile users.

• 한국신재생에너지학회:학술대회논문집
• /
• 2006.06a
• /
• pp.547-550
• /
• 2006

The power split hybrid power train is considered to be one of the most prospective configuration for the hybrid electric vehicle (HEV). Toyota Prius, representing this type of vehicle, showed outstanding performances in fuel efficiency, emission reduction and acceleration. The excellence is largely due to the fact that it utilizes almost all operation modes of HEV. Those modes include ZEV (Zero Emission Vehicle) driving, idle stop, fuel cut-off, power assist, active charging, regenerative braking and so forth. In this paper, a few of the mode operations were simulated using AVL Cruise. Also, control logics to operate the powertrain in each mode were developed. The states of powertrain components were displayed and analyzed. By controlling the three components (engine, motor and generator), it was possible to run the powertrain in several hybrid operation modes.

• Journal of Advanced Navigation Technology
• /
• v.24 no.3
• /
• pp.212-217
• /
• 2020

Recently, with the interest in the 4th industrial revolution, the demand for autonomous driving technology is increasing. V2X communication technology is a core technology for autonomous vehicles that exchanges information with objects such as vehicles, infrastructure, networks, and pedestrians through wired and wireless networks. In this paper, we present the results of the hybrid V2X communication system, which is a hybrid design of WAVE and LTE, and the coverage test to confirm the performance of the system. Through coverage measurement, we show that the hybrid V2X communication performance is superior to the existing LTE or WAVE single communication system in communication coverage, so it can be effectively applied to autonomous driving services.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.40 no.8
• /
• pp.485-494
• /
• 2016

In this work, we conducted a study of fuel consumption characteristics and regenerative braking recovery rate by conducting an experiment using a TMED type parallel hybrid electric vehicle. As regenerative braking technology is considered essential to improve the energy efficiency of the hybrid vehicle, it is necessary to conduct research on the regenerative braking system. Therefore, the electrical characteristics, current balance, and fuel consumption were investigated using an EC type chassis dynamometer with experimental conditions as per IM240 mode. From the results, it was observed that when the initial SOC condition was lower, the engine operating time of the hybrid vehicle increased, and the energy efficiency decreased. While operating in the driving mode characteristics condition and the driving characteristics condition, the difference in the average fuel consumption was not significant. However, after completion of the experiment, there was a difference in the engine operation.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.3 no.2
• /
• pp.465-470
• /
• 1999

This paper presents a design method of driving system for EV(Electric Vehicle). EV driving system consist of batteries, battery interface system and inverter. The power control circuit of the driving system is simple, since only one PWM(Pulse Width Modulation) inverter is used. These test spectrums and waveforms can be used to determine the filter component ratings as well as to compute the harmonics injected into the source. The hybrid control strategy which can reduced harmonic components. The analysis results indicate that the required capacity of the condenser can be reduced with LC filter. In this paper, the design and implementation of the proposed systems are described and some experimental results are given to show the performance of this driving system. The control strategy of the system to available inverter's power and motor's power and torque is discussed.

• The Journal of Korea Robotics Society
• /
• v.14 no.3
• /
• pp.186-190
• /
• 2019

When problems occurred in the unstable and/or extreme terrain environment, formal field-driving robots were unable to provide any other options such as the transformation of the wheel and body structure, and so on. For such reason, this paper proposed a novel type of integrated wheel mechanism that can be operated as a conventional driving wheel mode and hybrid wheel-leg mode in order to be negotiated in an unstable terrain environment. The mechanical effect of the proposed variable wheel mechanism was analyzed considering the geometric constraint and power requirement of the actuator for the transformation. In addition, we designed and manufactured the prototype of field-driving robot, which reliably control the variable wheel shape. Finally, the effectiveness of the variable wheel mechanism was verified by preliminary experimental approach.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.23 no.4
• /
• pp.436-443
• /
• 2015

In order to develop the PHEV(plug-in hybrid electric vehicle), the specific power transmission systems considering the PHEV system characteristics should be applied. A PHEV applied to series-parallel type hybrid power transmission system is a typical example. In this paper, the novel hybrid power systems are proposed by analyzing the existing PHEV system. The backward simulation program is developed to analyze the fuel efficiency of hybrid power system. Quasi-static models for each components such as engine, motor, battery and vehicle are included in the developed simulation program. To obtain an optimal condition for hybrid systems, an optimization approach called the dynamic programming is applied. The simulation is performed in various driving cycles. A weakness for the existing system is found through the simulation. To compensate for a discovered weakness, novel hybrid power systems are proposed by adding or moving the clutch to the existing system. Comparing the simulation results for each systems, the improved fuel efficiency for proposed systems are verified.

• Proceedings of the IEEK Conference
• /
• 2005.11a
• /
• pp.797-800
• /
• 2005

In this paper, the designed 10-bit current steering data driving circuit consists of bias circuits, shift registers, data and line latches, level shifters, and 10-bit D/A converters. This data driving circuit can improve image quality, driving speed, and can reduce process error, DNL error, and glitch noise. To reduce current cells, the 10-bit D/A converter was designed 3+3+4 hybrid type. As a result 49 current cells are decreased. The transient analysis shows that currents flows a few of mA in data line and the currents have 1024 gray levels of current values. Total circuits are designed for 10 ${\mu}s$ speed. Thus the designed 10-bit current steering data driving circuit can be usable in HDTV/XGA AMOLED displays. These data driving circuits are designed for 0.35 ${\mu}m$ CMOS process at 3.3 V and 18 V supply voltage and simulated with HSPICE..