• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.10a
• /
• pp.68-70
• /
• 2015

The four-port coupler circuit consists of input port, isolation port and two output ports. When it inserts a signal at the input port and the isolation port, the magnitude and phase of the output signal at two output ports are decided by the magnitude and phase of the input signal. This paper analyzes the output signal characteristic of two output ports due to the input signal magnitude and phase of two input ports using the typical 4-port coupler circuit, Branchline hybrid coupler and Ring-hybrid coupler. And, it studies about new way to use branchline hybrid coupler and ring-hybrid coupler on the basis of the this information.

• Journal of Power Electronics
• /
• v.15 no.6
• /
• pp.1429-1437
• /
• 2015

A new parallel hybrid soft switching converter with low circulating current losses during the freewheeling state and a low output current ripple is presented in this paper. Two circuit modules are connected in parallel using the interleaved pulse-width modulation scheme to provide more power to the output load and to reduce the output current ripple. Each circuit module includes a three-level converter and a half-bridge converter sharing the same lagging-leg switches. A resonant capacitor is adopted on the primary side of the three-level converter to reduce the circulating current to zero in the freewheeling state. Thus, the high circulating current loss in conventional three-level converters is alleviated. A half-bridge converter is adopted to extend the ZVS range. Therefore, the lagging-leg switches can be turned on under zero voltage switching from light load to full load conditions. The secondary windings of the two converters are connected in series so that the rectified voltage is positive instead of zero during the freewheeling interval. Hence, the output inductance of the three-level converter can be reduced. The circuit configuration, operation principles and circuit characteristics are presented in detail. Experiments based on a 1920W prototype are provided to verify the effectiveness of the proposed converter.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2002.05a
• /
• pp.318-321
• /
• 2002

A static var compensator using hybrid cascade 5-level PWM inverter is presented for high voltage/high power applications. The proposed system is modelled by circuit DQ transformation, and thus an equivalent circuit is obtained which reveals the important characteristics of the system and lead to the related equations. The proposed system has advantages of hybrid structure which enhances the better utilization of power semiconductor switches, that is, both high power-low frequency switch, GTO and low power-high frequency switch, IGBT can be used in the same circuit. In this paper, circuit structure and characteristics is presented and the validity of the characteristics analysis is shown through PSIM simulation.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.441-441
• /
• 2014

The characteristics of hybrid conductive films based on multilayer graphene and silver grid have been investigated for the high-performance and flexible organic solar cells. The hybrid conductive films have been prepared on glass and polyethylene terephthalate (PET) substrates using conventional photolithography process and transfer process of graphene. The optical and electrical properties of prepared conductive films show transmittance of 87% at 550nm and sheet resistance of $28{\Omega}/square$. The electromechanical properties were also investigated in detail to confirm the flexibility of the hybrid films. OSCs have been fabricated on the hybrid conductive films based on graphene and silver grid on glass substrate. The power conversion efficiency of 2.38%, a fill factor of 51%, an open circuit voltage of 0.58V and a short circuit current of $8.05mA/cm^2$ were obtained from the device on glass substrate. The PCE was enhanced 11% compared with OSCs on the MLG films without silver grid.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.29A no.3
• /
• pp.25-32
• /
• 1992

In UHF, VHF new design method of samll-sized 3-dB 0$^{\circ}$/180$^{\circ}$ ring hybrid terminated arbitrary impedance using both lumped elements and distributed elements is presented. At the center frequency of 900 MHz, 3-dB 0$^{\circ}$/180$^{\circ}$ ring hybrid terminated arbitrary impedance is designed, analyzed and tested. Good agreements are obtained between measured and theoretical modeling results, and at the same time, the circuit area of hybrid fabricated with two dimensional parallel coupled line, distributed elements and lumped elements is reduced by more than 70% compared with only distribyted-type circuits.

• Proceedings of the KIPE Conference
• /
• 2015.07a
• /
• pp.319-320
• /
• 2015

A hybrid converter for the on-board charger consisting of a soft switching full bridge (SSFB) and a half bridge (HB) LLC resonant converter is proposed. The proposed topology adopts an additional switch and a diode at the secondary side of SSFB converter to guarantee the wide ZVS range of primary side switches and to eliminate the circulating current. The output voltage is regulated by controlling the duty cycle of secondary side switch. The effectiveness of the proposed converter was experimentally verified using a 10-kW prototype circuit. The experimental results show 96.8% peak efficiency.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2007.11a
• /
• pp.87-88
• /
• 2007

• Proceedings of the KIEE Conference
• /
• 2015.07a
• /
• pp.601-602
• /
• 2015

Interruption of AC is easier due to natural occuring of zero crossings. In DC, zero crossings is achieved by Forced commutation technique. In this paper an alternative counter voltage(ACV) DC Hybrid Circuit breaker(DC-HCB) is modeled using EMTP/ATP tool, Results show that, ACV DC-HCB can interrupt DC with in 5ms with a source voltage of upto 1 KV.

• Proceedings of the Korean Institute of Intelligent Systems Conference
• /
• 1993.06a
• /
• pp.838-841
• /
• 1993

This paper describes a fuzzy network circuit of analogue and digital mixed operation. The circuits are suggested for membership function, MIN function and normalization function using either linear voltage-controlled MOSFET resistance or pulse stream operation. The analogue-digital hybrid fuzzy hardware is extensible to the fuzzy-neural network as its basic configurations are already used in URAN-I of 135,424 synaptic connections.

• The Magazine of the IEIE
• /
• v.17 no.6
• /
• pp.53-60
• /
• 1990

본 글은 완성된 circuit를 thick-film hybrid IC화 하기 위하여 고려하여야 할 사항인 설계의 기본개념, 기판 재질의 소개 및 특성, 도체, 저항, 유전체 paste를 소개하고 제조 기술 분야에서는 기본공정인 인쇄, 소성, 트리밍, packaging에 대하여 기술하였다.