• Korean Journal of Plant Resources
• /
• v.25 no.1
• /
• pp.24-30
• /
• 2012

Naehanyuchae and Youngsanyuchae were originated from the cross between "Erra(female)" and "Tower(male)". The cultivars were made at Bioenergy Crop Research Center, National Institute of crop science, Rural Development Administration, Korea in order to develop the high cold tolerant and yielding rapeseed variety with non-erucic acid and non-glucosinolate as good seed quality indicator. The superiorities of these varieties have been shown through the regional performance trials and demonstration farmers fields. Naehanyuchae and Youngsanyuchae had good agronomic characteristics related to yield potential such as many valuable branches and pods, and long pod length. The seeds of these new varieties composed of the 80% of oleic acid and linoleic acid without erucic acid, and glucosinolate was not extracted in the oil cake. The average grain yields increased by the from 16% to 22% according to the regional performance trials compared to check variety.

• Journal of the Korean Geotechnical Society
• /
• v.24 no.10
• /
• pp.147-160
• /
• 2008

This paper presents the results of full-scale loading tests performed on 54 passive anchors and 4 group anchored footings grouted to various lengths at several sites in Korea. The test results, the failure mechanisms as well as uplift capacities of rock anchors depend mostly on rock type and quality, embedded fixed length, properties of the discontinuities, and the strength of rebar. Anchors in poor quality rocks generally fail along the grout/rock interfaces when their depths are very shallow (a fixed length of less than 1 m). However, even in such poor rocks, we can induce a more favorable mode of rock pull-up failure by increasing the fixed length of the anchors. On the other hand, anchors in good quality rocks show rock pull-up failures with high uplift resistance even when they are embedded at a shallow depth. Laboratory test results revealed that a form of progressive failure usually occurs starting near the upper surface of the grout, and then progresses downward. The ultimate tendon-grout bond strength was measured from $18{\sim}25%$ of unconfined compressive strength of grout. One of the important findings from these tests is that the measured strains along the corrosion protection sheath were so small that practically the reduction of bond strength by the presence of sheath would be negligible. Based on test results, the main parameters governing the uplift capacity of the rock anchor system were determined. By evaluation of the ultimate uplift capacity of anchor foundations in a wide range of in situ rock masses, rock classification suitable for a transmission tower foundation was developed. Finally, a very simple and economical design procedure is proposed for rock anchor foundations subjected to uplift tensile loads.

• Clean Technology
• /
• v.7 no.2
• /
• pp.127-132
• /
• 2001

The effects of activated-carbon (AC) packing length on the Pressure Swing Adsorption (PSA) performance was investigated for the hydrogen separation from the multicomponent mixture gas. Linear driving force model was used to describe mass transfer between two phase and coupled Langmuir isotherm was used for each component as a nonlinear adsorption isotherm. When two adsorbents with a different adsorption capacity were packed consecutively in one bed, it is very important to determine the packing ratio of zeolite to activated carbon affecting the purity and recovery of the product. The activated carbon packing length in adsorption tower of 120 cm was determinated by the ending point of $CO_2$ contration. The optimum length of an activated carbon layer was 65 cm for production of high-purity hydrogen.

• Journal of architectural history
• /
• v.22 no.5
• /
• pp.23-35
• /
• 2013

This study aims to investigate the architectural characteristics of the Da-bo stupa by examining the correlation among architectural languages and by studying the features of its architectural components and transitional changes shown in Da-bo stupa line drawings in Dunhuang Mogao Grottes. The results are as follows. 1st, the Da-bo stupa of Dunhuang faithfully follows the sutra of lotus, and although the form changes, the fundamental essence of Bo-tap-yong-chul and two seated Buddhas provided by the Gyun-bo-tap-pum in the sutra of lotus is consistent. 2nd, the pagoda body can be periodically divided into parasol, stupa, and royal palace types. The parasol type has an incomplete tower body, which makes distinguishing each of its architectural components difficult. The stupa type appeared between the early (AD 618-712) and middle (AD 766-835) Tang dynasty. It combines the form of Indian stupa type and East Asian wood structural architecture. The royal palace type, which appeared between the peak period of the Tang (713-765) and Sung Dynasties, shows the standardized pattern of the Da-bo stupa described as two seated Buddhas and Bo-tap-yong-chul. 3rd, the use of a stylobate does not appear in the early construction of Da-bo stupa, only in the later period, in the form of high pillars. Forms include many Su-mi-jwah and three-way stairways and Dab-do, but as time passes, the forms are simplified to the form of high pillars. 4th, the purpose of early Da-bo stupa was to provide space for Da-bo-yu-rae of Gyun-bo-tap-pum; hence, it did not have sangryoon(the top part). However, after it was influenced by general pagodas, sangryoon was established. Toward the Tang Dynasty, sangryoon has come to emphasize the forms of boryoon(nine wheels) or dome. However, this form is eventually simplified to only retain bo-joo(the orb).

• Journal of Environmental Health Sciences
• /
• v.18 no.2
• /
• pp.102-105
• /
• 1992

Introduction : Isothiazolinone product is one of new preservatives used in cooling tower, paper mill, and general industrial waters.l) It is also effective in controlling bacteria and fungi in the manufacture and storage of dispersed pigments, such as kaolin clays, titanium dioxide, calcium carbonate and others\ulcorner Its broad-spectrum activity, excellent physical and chemical compatibility with anionic, nonionic and cationic surfactants and most organic and inorganic compounds and low toxicity at recommended use levels provide formulators with an effective, economical, and environmentally acceptable alternative to other commercial biocides. It dose not contain or generate formaldehyde and is easy to formulate (1.5% solution is supplied as an aqueous solution), so that it gains advantage over the other preservatives. The active ingredients of the isothiazolinone product are unchlorinated compound (2-methyl-4-isothiazolin-3-one) and chlorinated one (5-chloro-2-methyl-4-isothiazolin-3-one). Methods preferred for the analysis of preservatives are chromatographic methods, especially high performance liquid chromatograph (HPLC). Although several methods were satisfactory in respect to separation, no offical method has been published for the isothiazolinone components. This study was performed to search for an alternative method in order to show flexible operating conditions of HPLC and to reduce assay time.

• Transactions of the Korean hydrogen and new energy society
• /
• v.22 no.1
• /
• pp.13-20
• /
• 2011

$SO_2$ has been absorbed and separated selectively by an ionic liquid from $SO_2/O_2$ mixture decomposed from sulfuric acid during the thermochemical SI cycle for the water splitting. In order to design and operate high pressure $SO_2/O_2$ separation system, the solubility of $SO_2$ in [EMIm]$EtSO_4$ (1-ethyl-3-methylimidazolium ethylsulfate) has been measured by Magnetic Suspension Balance at high pressure and temperature. Based on the measured solubility, a pressurized separation system was set up and operated. 194 L/h of $SO_2$($SO_2:O_2$=0.65:1) has been separated with 99.85% of $O_2$ at the vent of absorption tower, which is 22.7% of the theoretically ideal capacity of the system. This discrepancy results from the reduced contact between the gaseous $SO_2$ and the ionic liquid. Increased $SO_2$ supply, scale-up of the absorption column, and a faster ionic liquid circulation speed were suggested to improve the separation capacity.

• Proceedings of the Safety Management and Science Conference
• /
• 2012.04a
• /
• pp.43-59
• /
• 2012

As contemporary building construction type is getting higher and deeper,construction equipment usage is getting more, and related fatal accidents are on an increasing trend. In these days, due to the deteriorating construction business circumstance, job finding problem of equipment operator, and dumping contract, equipment lease suppliers are putin jeopardy. In high-rise building construction, especially tower crane, mobile elevated work platform and other High place operation cars among construction equipment cause many critical accidents because of drop supply of construction biding bringing out dumping contract could cause unsafe and poor construction management. Because of this, a method was drawn which could grasp the present state of construction equipment management and manage safety of the equipment more easily for accident prevention by choosing 2 kinds of Construction equipment which cause safety accident frequently among the equipment mainly used in construction site. This study suggested a method about construction equipment safety management using "smart phone" base which could be used in safety management for construction equipment by whomever in construction site. After attachment of QR code included safety checklist, It became possible that site managers could check more efficiently by scanning with their smart phone when they inspect equipment. Moreover, by the construction interested who didn't know what and how they have to inspect could point out unsafe condition in the early stage of equipment entering or take unsafe one out of the site by using new smart phone safety checking system is installed, it became possible that critical accident caused by construction equipment was prevented in advance.

• 한국태양에너지학회:학술대회논문집
• /
• 2011.04a
• /
• pp.179-184
• /
• 2011

The development of new energy has attracted consideration attention due to the high oil price and environmental problems. In advanced country, they have tried to carry out a long range plan for energy. We need to develop new energy for Low Carbon Green Growth in Korea. The building is 30% among ratio of energy consumption in Korea. And in the past, heating energy was high ratio for energy using at home. But recently, the demand for cooling energy keeps growing due to rising average temperature on the earth and improvement of life quality. In this situation, the energy of lake water and ocean water has studied to utilize in advanced country because of low temperature at underwater. But the study for deep water is still a lot left to do. In this study, we analyzed district cooling system and the present condition. Analyzing the deep lake water cooling system in Toronto, we found an application of district cooling system using deep ocean water. Deep lake water uses heat source for district cooling and water source for city in Toronto. So reducing the initial cost, this city had economic effect. When DLWC was applied at existing building, the heat exchanger was installed instead of cooling tower and refrigerator. And the heat exchanger used to connect main pipe with cool water on city. System using deep ocean water can be applied as a similar way to supply cool water from lake to building.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.3 no.4
• /
• pp.335-341
• /
• 2015

Various display devices has been increasing also using waste LCD glass in accordance with the used developed, because circumstances that are most landfill or incineration, are needed research on recycling measure of the using waste LCD glass. Therefore, in this study, to try to assess the basic mechanical properties of concrete mixed with using waste LCD glass micropowder through the room mixed test. According to the study results, the more replacement rate increases, the characteristics of the concrete showed a tendency to decrease slightly. However, according to the small value, it is expected to improve the advanced experimental values by refining the grain size of the materials used to be processed into spheres.

• Resources Recycling
• /
• v.26 no.6
• /
• pp.10-19
• /
• 2017

It is studied the effect of crystal structure of domestic High-Ca limestones using absorbent for desulfurization on the grinding characteristics and dissolution rates in wet flue gas desulfurization process of domestic coal fired power plant. It compared the crystal structure, grinding work index and dissolution rates with 4 Limestones from Jecheon-Danyang with different crystal structure, and we found that grinding work index differ in crystal size and crystal structure of limestones : The lower the value of the grinding work index is, the higher the dissolution rates of limestones. Confirmed that we have important indicators of grinding characteristics for crystal structure with CaO content of limestones.