• 한국염색가공학회지
• /
• 제9권2호
• /
• pp.10-16
• /
• 1997

Merino wool top and fabric have been treated with steams such as superheated steam or high pressure steam. Moisture regain, water absorbency, water penetration, zeta potential, ESCA, SEM, and dyeing behavior were studied. Negative electric potential on the surface of wool fibers by steam treatment became higher than untreated. From the results of ESCA measurement, intensity of $O_{1s}$ was increased by steam treatment. Rate of dyeing and saturation dye exhaustion of wools increased by steam treatment, especially high pressure steam treatment. Moisture regain, water absorbency, water penetration, and surface appearances by SEM photographs of the steam-treated wools didn't change. There is no relationship between dyeing of the steam-treated wool and wettability to water. Therefore It seems likely that relaxation of adhesive filler in interscale of wool by steam treatment accelerate dye penetration into the fiber.

• 한국세라믹학회지
• /
• 제31권4호
• /
• pp.375-380
• /
• 1994

Matrices retaining electrolyte in phosphoric acid fuel cell were prepared with SiC to SiC whisker mixing ratios of 1:0.5, 1:1, 1:1.5, 1:2, 1:3 by tape casting method. When viscosity of the slurry was 5.9 poise and the SiC to SiC whisker mixing ratios were 1:1, 1:1.5, 1:2, the ranges of porosity, acid absorbency and bubble pressure were 80~90%, 2.5~6 and 700~2200 mmH2O, respectively. Those ranges are acceptable for a practical electrolyte-retaining matrix. With increasing the mixing ratio of SiC whisker to SiC, the porosity and the vol.% of large pores in the main pore size distribution which is between 1 and 10 ${\mu}{\textrm}{m}$, increased rapidly. Impedance spectroscopy was measured to know characteristics of matrix inside and contact region of matrix to catalyst layer. When the SiC to SiC whisker mixing ratio was 1:2, hydrogen ions were transported in the matrix most effectively because of high ionic conductivity and low activation energy due to high acid absorbency in spite of high interfacial resistance. The cell current density of the cell made using the matrix was 220 mA/$\textrm{cm}^2$ at 0.7 V.

• 한국의류산업학회지
• /
• 제11권6호
• /
• pp.947-952
• /
• 2009

The purpose of this study is to analyze skin wettedness($w$) used as the rate index of thermal comfort, and to evaluate the wear comfort of outdoorwear. Skin wettedness is widely used to express the degree of thermal comfort. If skin wettedness exceeds a certain threshold, the body feels damp and discomfort. An experiment which consisted of rest(30 min), exercise(30 min) and recovery(20 min) periods was administered in a climate chamber with 10 healthy male participants. Two kinds of outdoorwears made of 100% cotton fabrics (Control) and specially engineered fabrics having feature of quick sweat absorbency and high speed drying fabric (Functional) were evaluated in the experiment. The condition of climate chamber was controlled according to the thermal insulation of 4 kinds of experimental ensembles(E1~E4). Total sweat loss, sweat loss absorbed into clothing and skin temperature were measured. Skin wettedness was calculated from the ratio of evaporative rate to the maximal evaporative capacity. Skin wettedness of 'Functional' was lower than 'Control' in the 3 kinds of ensembles(E1, E2, E4) because the materials of 'Functional' were composed of quick sweat absorbency and high speed drying fabrics, water vapour permeability and waterproof fabrics.

• Preventive Nutrition and Food Science
• /
• 제10권2호
• /
• pp.198-205
• /
• 2005

Korean medicated diet (KMD) is not a simple combination of food and Chinese drugs, but a special carefully constructed diet made from Sasang constitutional medicines, food and condiments under the theoretical guidance of diet preparation based on differentiation of symptoms and signs of traditional Sasang medicine (TSM). It combines the functional efficacy of medicine with the delicacy of food, and can be used to prevent and cure diseases, build up one's health and prolong one's life. Korean traditional medicated diet has a long history of development. Although influenced by Chinese medicine, Korean traditional medicine has been developed into a unique system of traditional medicine that has surpassed the continental medical practice, sublimating itself into a native medical practice suitable to Korean lifestyles and physical constitutions. In the 19th century, Lee Jema's Sasang medicine (medicine of four types of energy determining the physical constitution) was introduced. It is an integration of mind and body according to the individual's physical constitution that is categorized allowing a customized method of treatment ideal for each category-making the content of Korean traditional medicated diet even richer. The characteristics of Korean medicated diet are as follows: (1) Laying stress on the wole, selecting medicated diet on the basis of differential diagnosis. (2) Suitable for prevention and treatment, outstanding in effect. (3) Good in taste, convenient for taking. KMD refers to drink and food according to certain prescriptions, by processing and cooking that can be used either for prevention and cure of diseases, or for health care and recovery. The purpose of this review is to introduce TSM and KMD based on Sasang constitutional medicines.

• Macromolecular Research
• /
• 제17권10호
• /
• pp.734-738
• /
• 2009

Biodegradable, pH-sensitive, glycol chitosan (GC) hydrogels were prepared using divinyl adipate (DVA) as a crosslinker and acetic acid as a catalyst. DVA has highly reactive double vinyl ester groups and GC contains a high density of hydroxyl groups, with two in every glucosamine unit. The transesterification reaction between vinyl esters and hydroxyl groups produced crosslinked GC hydrogels. The initial crosslinking reaction was monitored by measuring the viscosity of the reaction mixture. When DVA was added to the GC solution and heated to $50^{\circ}C$, the viscosity of the GC solution gradually increased, implying a crosslinking reaction and hydrogel formation. A new peak from the ester group was observed in the FTIR spectra of the GC hydrogels, confirming the crosslinking reaction. The synthesized GC hydrogel showed pH-dependent water absorbency, mainly due to the presence of amine groups ($-NH_2$) at the C-2 position of the glucosamine unit of GC. The water absorbency greatly increased at acidic pH and slightly decreased at alkaline pH. The GC hydrogel gradually degraded in $37^{\circ}C$ water due to hydrolysis of the ester bonds, which were intermolecular crosslinking sites. A red dye, 5-carboxyltetramethyl-rhodamine (CTMR), was entrapped in the GC hydrogels as a model compound. CTMR was released from GC hydrogels in two steps: an initial burst release mainly due to desorption and diffusion, and a second sustained release possibly due to gradual degradation.

• 한국가정과교육학회지
• /
• 제7권1호
• /
• pp.1-10
• /
• 1995

This study was intended to provide an improved method for testing textiles in high school. Four kinds of test subjects were selected and applied to the classes. Problems of the methods in the textbooks were corrected as follows: 1)Burning test: The number of specimen is reduced to 3 kinds of fibers(cotton, wool, and polyester) and recommends are given to make result by comparing with the burning characteris-tics of paper and hair. 2) Absorbency test: Test Method is changed to drop test. The result is recorded by measuring time required for the water drops absorbed to the specimen. 3) Wrinkle recovery test: A glass is provided instead of metal weight. The method of measuring angle which is made by the specimen is shown in figure. 4) Effects of Detergent: 0.2% of detergent solution is provided before class. The amount of oil and carbon black is specified. Students have generally agreed that the improved methods were better than those in the text-books after they made the above 4 recommendable experiments(p<.001)

• 한국감성과학회:학술대회논문집
• /
• 한국감성과학회 2003년도 추계학술대회 논문집
• /
• pp.1311-1318
• /
• 2003

최근 흡한 속건성은 사이언스 소재로 가장 보편적으로 이용되고 있는 소재 성능이다. 하지만 아직 제대로 된 측정 평가법이 존재하고 있지 않고, 몇몇 의류업체에서는 단순히 객관적 속성만을 측정하고 있다. 본 연구에서는 객관적 속성인지들의 연속적이 값들이 실제 인체에서는 얼마만큼의 변별력으로 인식되는지 정신물리학적 측정법으로 최소 자극치(PSE)를 구하여 등급을 나누어 보았다. 시료는 흡한속건성 직물로 가장 많이 이용되고 있는 Coolmax(R), Coolever(R), 친수성 이중직물의 3개 그룹으로 나누었고, 측정 인자로 객관적 속성인자는 cling force, drying time을, 이와 대응하는 주관적 속성인자는 clinginess, dampness를 측정하고 각각의 PSE값을 구하였다. 그룹에 따라 객관적 속성인자 값들이 이라고 느끼는 PSE 구간까지 도달하는 시간과 속력을 측정하여 그룹마다의 흡한속건 등급을 정하였다. 또한 설계된 소재의 성능을 간접적으로 알 수 있는 transmissibility라는 인자도 도입하여 수분 전달성도 객관적으로 살펴볼 수 있었다. Clinginess, Dampness, Transmissibility 각 인자들을 평가해본 결과 Coolmax(R) 가 가장 우수함을 알 수 있었다.

• 한국자기학회지
• /
• 제4권3호
• /
• pp.208-213
• /
• 1994

복합 Ferrite 전파흡수체의 성능은 두께가 얇으며 대역폭이 넓을수록 우수하다. 본 연구에서는 복합 Ferrite 전파흡수체의 정합두께를 감소시키기 위하여 Ferrite-Iron-Rubber 복합체를 제조하고 그 특성을 고찰하였다. ${\alpha}-Fe$ 분말의 첨가에 의하여 복합체의 유전율 실수항과 투자율 실수항이 증가하여 정합주파수와 정합두께의 고하기 항인 $f_{m}.d_{m}$ 항이 감소하였고, 3~17 GHz의 주 파수 범위에서 Ferrite-Rubber 복합체에 비하여 정합두께가 0.5 mm~2 mm 정도 감소함을 확인할 수 있었다.

• 대한가정학회지
• /
• 제19권2호
• /
• pp.143-149
• /
• 1981

Consumer consider the purpose for which they plan to use clothes when they purchase it, and the socks in textile products is evaluated in the same way. serviceability is judged by the extent to which the socks will be useful for its intended purpose. It should retain its original shape and size, good air permeability, good absorbency, good abrasion resistance, high fastness etc. Owing to importance of serviceability in socks, in this paper, these end-use requirement characteristics were tested. The results obtained were as follows: 1. Blend ratios were different between the indicated fiber contents on labels and the testing ones. 2. Air permeability was higher in the samples which contain less stitch density, and hydroscopicity was higher in those which contain natural fibers such as cotton and wool. 3. Shrinkage depended on the blend ratios of cotton and wool, and elastic recovery was better in the course direction than in the wale direction. 4. Pilling was conspicuous in the synthetic fibers such as polyester and nylon, and fastness of laundering and perspiration was higher in the fading grade than in the staining grade.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2016년도 제50회 동계 정기학술대회 초록집
• /
• pp.290.1-290.1
• /
• 2016

Grapehen, a single atomic layer of graphite, has been in the spotlight and researched in vaious fields, because its fine mechanical, electrical properties, flexibility and transparence. Synthesis methods for large-area graphene such as chemical vaper deposition (CVD) and mechanical, chemical exfoliation have been reported. In particular, chemical exfoliation method receive attention due to low cost process. Chemical exfoliation method require reduction of graphene oxide in the process of exfoliation such as chemical reduction by strong reductant, thermal reduction on high temperature, and optical reduction via ultraviolet light exposure. Among these reduction methods, optical reduction is free from damage by strong reductant and high temperature. However, optical reduction is economically infeasible because the high cost of short-wavelength ultraviolet light sorce. In this paper, we make graphene-oxide and lanthanoid ion mixture aqueous solution which has highly optical absorbency in selective wevelength region. Sequentially, we synthesize reduced graphene oxide (RGO) using the solution and visible laser beam. Concretely, graphene oxide is made by modified hummer's method and mix with 1 ml each ultraviolet ray absorbent Gd3+ ion, Green laser absorbent Tb3+ ion, Red laser absorbent Eu3+ ion. After that, we revivify graphene oxide by laser exposure of 300 ~ 800 nm layser 1mW/cm2 +. We demonstrate reproducibility and repeatability of RGO through FT-IR, UV-VIS, Low temperature PL, SEM, XPS and electrical measurement.