• 한국세라믹학회지
• /
• 제29권3호
• /
• pp.177-182
• /
• 1992

The effect of heat-treatment temperature on the microwave absorbing properties was investigated in Ni0.8Zn0.2Fe2O4 specimens. The composite specimens were prepared by modling and curing the mixture of prereacted ferrite powder and silicone rubber. The measurement of complex permeability and permittivity was made by the reflection/transmission method. The most sensitive material constants with heat-treatment temperature is the imaginary (loss) component of permeability. The higher the heat-treatment temperature, the greater the magnetic loss. The composite specimens with high magnetic loss exhibited superior microwave absorbing properties. The quantitative estimation of microwave absorbing properties were made by plotting the observed material constants on the calculated solution map of impedance-matching.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2003년도 춘계학술대회 논문집 디스플레이 광소자분야
• /
• pp.115-118
• /
• 2003

Complex impedances with frequency and voltage variation were analyzed in $ITO/Alq_{3}/Al$(100nm)/Al device structure. At low frequency, complex impedance is mostly expressed by resistive component, and at the high frequency by capacitive component. Also, we have evaluated resistance, capacitance and permittivity.

• 한국콘텐츠학회논문지
• /
• 제6권2호
• /
• pp.99-104
• /
• 2006

이 논문은 GPS 안테나로 사용될 수 있는 Offset Slotted 직사각형 마이크로스트립 패치 안테나를 디자인하기 위한 기법을 제안하였다. 안테나 특성을 해석하기 위해 Multi-port connection 기법과 Desegmentation 기법을 사용하였고, 고유전율의($\varepsilon_{\gamma}$=10.2) 기판과 직사각형 슬롯을 이용하여 안테나의 사이즈를 줄일 수 있었다. 제작된 안테나의 치수는 $20\times30\times1.27$[mm]로 작은 사이즈이므로 GPS 안테나 또는 핸드폰에 사용될 수 있을 것이다.

• 한국전기전자재료학회논문지
• /
• 제17권10호
• /
• pp.1061-1067
• /
• 2004

In this study, ferroelectric (Ba,Sr)TiO$_3$ and high temperature superconductor YBCO thin films were fabricated by PLD (Pulsed Laser Deposition) method and tuneable bandstop filters were implemented with two different IDC(Interdigital Capacitance) gap patterns, 20${\mu}{\textrm}{m}$ and 30${\mu}{\textrm}{m}$ using these two thin film layers. The resonant frequency was changed by DC bias voltage. By comparing measured results with simulation, the dielectric properties of ferroelectric thin film have been extracted. The permittivity was 820 ～ 900 at 30 K and had an acceptable error range but the loss tangent had a great difference, 0.018 in 30${\mu}{\textrm}{m}$ IDC gap pattern and 0.037 in 20 ${\mu}{\textrm}{m}$.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1994년도 하계학술대회 논문집 C
• /
• pp.1351-1353
• /
• 1994

High strengh pocelain insulators with 35wt% alumina were manufactured by wet produce technique. The microstructure and crystalline phases of this samples and the effect of CaO addition to insulator bodies were studied. Electrical and mechanical properties (permittivity, dissipation factor, modulus of rupture, Young's modulus etc,) were studied. The relation between microstructure and electrical, mechanical properties were analyzed.

• ETRI Journal
• /
• 제39권6호
• /
• pp.813-819
• /
• 2017

A slotted rectangular nameplate antenna design with a patch bearing the name of the first author is presented. A $6.8mm{\times}26mm{\times}1.6mm$ substrate of FR-4 epoxy material having a relative permittivity of 4.4 and a dielectric loss tangent of 0.02 is used. Additionally, the feeding technique used is a coaxial mechanism. The standard antenna design parameters, including the reflection coefficient, bandwidth, radiation pattern, gain, directivity, and voltage standing wave radio (VSWR) for the proposed prototype are analyzed using a high-frequency structure simulator (HFSS) v-15, and are compared to the measured results. The designed structure may be considered for different satellite- and radio-determination applications at the respective resonant frequencies.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 제36회 하계학술대회 논문집 전기설비
• /
• pp.82-84
• /
• 2005

In a transformer, thermal stress is the most influential parameter affecting the aging behavior of insulation system. The aging behavior of insulation system in transformer is determined mainly by the thermal conditions inside the transformer. The thermal stress on the insulation system may occur from operation in a high temperature caused by overloading or local overheating. Thus, this paper investigated the condition monitoring of insulation condition in thermally accelerated aged transformer oils by in-situ sensor. The condition of aged samples was investigated by measurements of relative permittivity i.e. capacitance change by capacitive sensor. Results from the experiments are presented in this paper.

• 한국복합재료학회:학술대회논문집
• /
• 한국복합재료학회 2004년도 춘계학술발표대회 논문집
• /
• pp.169-172
• /
• 2004

We fabricated MWNT-added glass fabric/epoxy composites. We observed the distribution of MWNTs in the composites using scanning electron microscopy and conformed that most of MWNTs exist in matrix rich region and interface between yams in warp and fill directions. We also investigated the change of permittivities with MWNT concentrations. Only $1wt\%$ MWNTs leads to high permittivity and electromagnetic waves are impossible to be transmitted to more than $3wt\%$ MWNT-added composites, which means the characteristics of these composites are comparable to those of metals or carbon fiber-reinforced composites.

• 한국마이크로전자및패키징학회:학술대회논문집
• /
• 한국마이크로전자및패키징학회 2002년도 추계기술심포지움논문집
• /
• pp.143-146
• /
• 2002

A multilayer two-stage bandpass filter using dissimilar low-temperature cofired-ceramic (LTCC) materials is proposed in this paper. The proposed bandpass filter is composed of ceramic substrates with different dielectric constant instead of single ceramic material from top to bottom layer. Inductive elements are designed in a low permittivity ceramic layer to reduce parasitic effects and loss, while capacitive elements are designed in a high pertimitivity ceramic layer for size reduction. The center frequency of the proposed filter is 1.842 GHz, and the performance of the filter is analyzed and compared with the conventional LTCC filter with single material in terms of integration density, size reduction, and performance improvement.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1992년도 춘계학술대회 논문집
• /
• pp.129-132
• /
• 1992

Rutile was among the first dielectric materials used. However, rutile exhibits a very high temperature coefficient of capacitance (about -750[ppm/$^{\circ}C$]) which resticts its practical application. Since this first use of titania, other materials have also been studied with the object of decreasing the temperature dependence whilst retaining favorable dielectric loss, Q, and relative permittivity. The temperature coefficient of temperature compensation capacitor is +100~750[ppm/$^{\circ}C$], dielectric constant 10~150. Low loss ceramics with dielectric constants in the 10～150 range also found application. Recently, their applications are extended in EMI filter and dielectric materials for microwave. There temperature coefficient of dielectric materials approaches 0[ppm/$^{\circ}C$]. The dielectric preperties of zirconia titanate ceramics prepared by addition of $Ta_2O_{5}$ were investigated.