• Journal of Environmental Health Sciences
• /
• v.20 no.4
• /
• pp.36-44
• /
• 1994

A study was carried out in order to investigate the removal efficiencies and removal characteristics of heaw metals such as Pb, Cd, Cr, Cu in raw water by one of conventional water treatment processes. The coagulants used in this study were Alum and PAC. Three kinds of water samples were provided: kaolin water, kaolin water mixed with humic acid and raw water from Han River mixed with suspended matter deposited on raw water inlet pipe. Heaw metals were added to the water samples with their respective turbidity, and jar tests were performed. In the results from heaw metal removal studies, lead might be adsorbed or exchanged on the particle surface (SS) rather than react with organic matter added. Cadmium was affected on the dissolved organic matter. Chromium was affected by the both dissolved organic matter and SS concentration, and the restabilization and the enmeshment appeared at moderate (50~80 NTU) and high (100 NTU) turbidity as defined in this experimenL The removal efficiency of copper was relatively little affected by the dissolved organic matter but by SS concentration in comparison with other heavy metals. In these studies as to the raw water turbidities and concentration of heaw metals, it is proved out that the removal efficiency on heaw metals in both cases of PAC and Alum as coagulants was not significantly different.

• Journal of Korean Society of Environmental Engineers
• /
• v.34 no.4
• /
• pp.239-246
• /
• 2012

This study was performed to investigate the removal characteristics and mechanism of heavy metals using pellet-type ceramics(ZS ceramics), in which natural zeolite was mixed and calcined with converter slag. The optimal calcination temperature range was measured to be $600{\sim}800^{\circ}C$. The calcination time had little effect on the removal of heavy metal in acid wastewater. The adequate dose of ceramics was shown to be 2~5% for removal of heavy metals in acid wastewater. The maximum removal capacity of ZS ceramics for heavy metals were observed to be Al 84.7 mg/g, Cd 37.3 mg/g, Cr 81.7 mg/g, Cu 55.6 mg/g, Fe 57.2 mg/g, Mn 32.1 mg/g, Ni 38.0 mg/g, Pb 71.6 mg/g, Zn 46.3 mg/g. The pH played a pivotal role in the removal of heavy metals by ZS ceramics. The analysis results of mechanism exhibited that the ZS ceramics could act as a multi-functional ceramics for removal of heavy metals in acid wastewater by adsorption, ion-exchange, or precipitation.

• Korean Journal of Soil Science and Fertilizer
• /
• v.46 no.6
• /
• pp.673-680
• /
• 2013

Phosphorus accumulating microorganisms (PAOs) are influenced by various environmental factors and heavy metals. This study was performed to evaluate the effects of the selected heavy metals on the growth and phosphorus removal capacity of Bacillus sp. 3434 BRRJ, Pseudomonas aerunogisa, and Bacillus Subtilis, well known as PAOs. The heavy metals used in this study included Cu, Cd, As, and Zn. The $IC_{50}$ (median inhibition concentration) values of Bacillus sp. 3434 BRRJ for the Cu, Cd, As, and Zn were 8.07 mg $L^{-1}$, 0.18 mg $L^{-1}$, 73.62 mg $L^{-1}$ and 0.25 mg $L^{-1}$, respectively. The $IC_{50}$ values of Pseudomonas aerunogisa for the Cu, Cd, As, and Zn were 4.45 mg $L^{-1}$, 0.16 mg $L^{-1}$, 18.51 mg $L^{-1}$ and 2.34 mg $L^{-1}$, respectively. The $IC_{50}$ values of Bacillus Subtilis for the Cu, Cd, As, and Zn were 3.81 mg $L^{-1}$, 0.18 mg $L^{-1}$, 11.31 mg $L^{-1}$ and 0.47 mg $L^{-1}$, respectively. The phosphorus removal efficiencies of the three bacteria, Bacillus sp. 3434 BRRJ, Pseudomonas aerunogisa, and Bacillus subtilis were 93.12%, 71.81%, and 65.31%, respectively. Based on the results of the three PAOs obtained from the study, it appears that Bacillus sp. 3434BRRJ may have the best results in terms of their growth rate and P removal efficiencies.

• Journal of Environmental Health Sciences
• /
• v.21 no.1
• /
• pp.21-28
• /
• 1995

The removal of heavy metals from synthetic wastewater containing Pb, Cr, Cd using previously washed and dried exhausted coffee was studied varying cohcentration, pH and temperature. All the heavy metals were removed in 3.0 minutes and the removal efficiency was maximum 80~90% with different pH and temperature conditions. The differences in removal efficiency between exhausted coffee and activated carbon under the same conditions were not seen. The removal efficiency was slightly increased with increasing pH in Cd and increasing temperature in Cr, respectively. The batch adsorption kinetics and adsorption equilibrium were examined and described by a first order reversible reaction and Freundlich isotherm, respectively. And the removal of Pb was found to have the best removal efficiency.

• Journal of Environmental Health Sciences
• /
• v.24 no.3
• /
• pp.124-130
• /
• 1998

This study was to examine the utilization of waste egg snells for removal of heavy metals in laboratory wastewater. It was estimated that pH increasing formed heavy metals into a hydroxide and then settled to remove them. Removal rate of heavy metals were increased as increased dosage, low adsorbate concentration and passed reaction time. Average adsorption volumes of Cr, Cu, Mn and Pb per g were about 1.21 mg, 1.1 mg, 0.96 mg and 1.04 mg, respectively. If we reflected the adsorption capacity(k) and adsorption intensity(1/n) of Freundlich isotherm, we couldn't consider waste egg shells as a good adsorbent. It seemed that heavy metals contained in complex wastewater was removed to be influenced by inital pH, solubilities with passed reaction rime and competitive reaction.

• Journal of Environmental Science International
• /
• v.17 no.10
• /
• pp.1147-1154
• /
• 2008

Road runoff, one of non-point source pollutants, contains various heavy metals, most of which flow into discharge waters without being treated. The mechanism of removing the heavy metals in water is similar to that of removing micro-particles. Therefore, it is considered that it is possible to remove a lot of the heavy metals contained in the road runoff by filtering or absorbing them. In this paper, performed has been a basic study on the characteristics of UNFS (Up Flow Non-Point Source Filtering System) using carbide pellet and zeolite pellet as double-layer filtering mediums to treat the road runoff. The removal rate with filtering and absorption time has been shown as follows: 29.0% for Cr; 27.8% for Cd; 25.7% for Fe; 25.4% for Co; 21.2% for Pb; ]9.6% for Zn; 18.2% for Al; 17.0% for Mn; 11.3% for Ni; 7.5% for Cu. The overall removal rate according to influx change has been shown to be approximately 30%, and the load of heavy metals flowing out in initial precipitation could be reduced by using carbide as a recycling filtering medium. When the removal as coarse particles settle is added up, it is expected that UNFS will result in a higher removal rate.

• Resources Recycling
• /
• v.31 no.4
• /
• pp.49-55
• /
• 2022

In this study, the heavy metal ions (of Pb, Cd, Cr, and Hg) in wastewater were removed using a spent Li₂O-Al₂O₃-SiO₂-based crystallized glass previously used as an induction top plate material. Changes in the removal efficiency of heavy metals according to different reaction parameters, such as the amount of zeolite used as a heavy-metal adsorbent, adsorption time, initial concentration of the heavy metals, and pH of the initial solution, were investigated. As the amount of zeolite added increased, the heavy-metal removal efficiency also increased. Adsorption time had a considerable influence on adsorption characteristics, and the removal efficiency of all heavy metals increased with increasing adsorption time. In the case of Cd, the removal efficiency was greatly improved depending on the adsorption time. The initial concentration of the heavy-metal solution did not affect the removal efficiency; however, the initial pH of the heavy-metal solution affected the removal efficiency. More specifically, the removal efficiency of Cd increased while that of Pb and Cr decreased with increasing pH. The adsorption characteristics of Hg were not significantly affected by pH.

• Journal of Environmental Science International
• /
• v.9 no.4
• /
• pp.325-330
• /
• 2000

The hydroxyapatite (HAp) for the present study was prepared by precipitation method in semiconductor fabrication and the crystallized at ambient to 95$0^{\circ}C$ for 30min in electric furnace. The ion-exchange characteristics of HAp for various heavy metal ions such as $Cd^{2+}, Cu^{2+}, Mn^{2+}, Zn^{2+}, Fe^{2+}, Pb^{2+}, Al^{3+}, and Cr^{6+}$ in aqueous solution has been investigated. The removal ratio of various metal ions for HAp were investigated with regard to reaction time, concentration of standard solution, amount of HAp and pH of solution. The order of the ions exchanged amount was as follws: $Pb^{2+}, Fe^{3+}>Cu^{2+}>Zn^{2+}>Al^{3+}>Cd^{2+}>Mn^{2+}>Cr^{6+}. The Pb^{2+}$ ion was readily removed by the Hap, even in the strongly acidic region. The maximum amount of the ion-exchange equilibrium for $Pb^{2+}$ ion was about 45 mg/gram of HAp. The HAp would seem to be possible agent for the removal of heavy metal ions in waste water by recycling of waste sludge in semiconductor fabrication.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2003.09a
• /
• pp.431-434
• /
• 2003

Environmental pollution problems due to the wastes from various industrial facilities and activities have become a serious issue. The specific problem associated with heavy metals in the environment is their accumulation in the food chain and their persistence in nature. Present work investigates the possible uses of by-products for the removal of heavy metal ions. Heavy metals used in these studies were cadmium, lead and copper. Experiments were conducted with by-products such as oyster shell and fly ash to evaluate their sorption characteristics. The results of the study indicate that oyster shell can be properly used as an adsorbent for heavy metals because of its outstanding removal rate.

• Environmental Engineering Research
• /
• v.22 no.2
• /
• pp.141-148
• /
• 2017

Globalization, industrialization, mining, and uncontrolled population growth have fostered a shortage of potable water. Therefore, it has become imperative to understand an effective and reasonable water purification technique. A renewed interest in electrocoagulation (EC) has been spurred by the search for reliable, cost-effective, water-treatment processes. This paper has elucidated a technical approach for getting rid of heavy metals and total suspended solids (TSS) from synthetic water using an aluminum electrode. The effect of operational parameters, such as current density, inter-electrode distance, operating time, and pH, were studied and evaluated for maximum efficiency. This study corroborates the correlation between current density and removal efficiency. Neutral pH and a low electrode gap have been found to aid the efficacy of the EC setup. The outcome indicates that a maximum TSS removal efficiency of 76.6% occurred at a current density of $5.3mA/cm^2$ during a contact time of 30 min. In the case of heavy metals remediation, 40 min of process time exhibited extremely reduced rates of 99%, 59.2%, and 82.1%, for Cu, Cr, and Zn, respectively. Moreover, kinetic study has also demonstrated that pollutants removal follows first-and second-order model with current density and EC time being dependent.