• Nuclear Engineering and Technology
• /
• 제28권2호
• /
• pp.103-117
• /
• 1996

본 논문에서는 증기폭발의 전파과정을 해석하기 위한 수학적 모델을 제시하였다. 이 모델은 용융물, 용융파편, 그리고 냉각재 기상과 액상 등 4상 유체의 2차원적인 천이거동을 지배방정식 및 관련상관식의 수치적 해를 구함으로서 예측할 수 있다. 모델에 사용된 주요 상관식은 용융물 분쇄, 냉각재 상변화, 에너지 교환, 그리고 운동량 교환항으로 구성되어 있다. 그리고, 냉각재(물)의 상태방정식은 냉각재의 기상과 액상 사이의 열역학적 인 비평형을 허용할 수 있는 독특한 형태로 구성되었다. 주석 /물의 중기폭발에 대한 예제계산을 수행한 결과 본 모델이 폭발의 전파속도 및 압력 -비록 그 정량적인 값은 관련상관식의 인자들에 좌우되지마는- 등의 증기폭발 전파과정의 주요현상을 적절히 모사할 수 있음을 알 수 있었다. 또한 중요한 초기변수(중기 분율, 용융물 분율) 및 관련상관식에 대한 민감도 분석도 수행되었다.

• 전력전자학회논문지
• /
• 제15권2호
• /
• pp.134-141
• /
• 2010

소형 PEM (Proton Exchange Membrane) 연료전지 시스템은 가습이 필요치 않아 상용화의 가능성이 크지만 그 제어 방법은 뚜렷하게 정립되어 있지 않다. 따라서 본 논문에서는 소형 PEM 연료전지 시스템의 제어를 위해 이중 루프 구조의 제어방식을 정립하고 DSP (Digital Signal Processor)를 이용하여 구현한다. 일반적으로 연료전지 시스템에서 제어의 핵심 요소는 크게 공기와 수소의 공급, 스택 내부의 수분 관리, 스택의 온도 관리로 나뉜다. 별도의 가습이 없이 공랭식으로 구동되는 소형 PEM 연료전지 스택의 제어에 있어서 팬은 스택의 공기 공급과 열관리 및 수분관리를 위한 핵심적인 역할을 하며, 퍼지밸브는 스택 내부의 잉여수분을 배출한다. 제안된 방식은 이중 제어루프를 이용한 팬의 제어를 통해 팬의 과도응답을 빠르게 하여 공기의 공급 속도를 개선시키며, 연료전지 스택의 전압변화를 피드백 하여 보상해줌으로써 연료전지가 부하변동에 대해 신속한 응답 특성을 갖도록 하였다. 제안된 방법의 유용함은 60W급 소형 PEM 연료전지 시스템의 실험과 이를 이용한 노트북 컴퓨터의 구동을 통해 검증된다.

• 한국농공학회논문집
• /
• 제59권6호
• /
• pp.1-8
• /
• 2017

The purpose of this study was to provide basic data for development of environmental design technology for greenhouses constructed in reclaimed lands. We analyzed the climatic conditions around seven major reclaimed land areas in Korea, which have a plan to install advanced horticultural complexes. The characteristics of heating load through the thermal environment measurement of the greenhouse in Saemangeum were analyzed. The part to be applied to the environmental design of the greenhouses in reclaimed lands were reviewed. The overall heat transfer coefficient of the experimental greenhouse with the aluminum screen and multi-layer thermal curtain averaged $3.79W/m^2^{\circ}C$. It represents a 44 % heat savings rate compared with plastic greenhouses with a single covering, which was significantly lower than that of the common greenhouses with 2-layer thermal curtains. This is because the experimental greenhouse was installed on reclaimed land and wind was stronger than the inland area. Among the total heating load, the transmission heat loss accounted for 96.4~99.9 %, and the infiltration loss and the ground heat exchange were low. Therefore, it is necessary to take countermeasures to minimize the transmission heat loss for greenhouses constructed in reclaimed lands. As the reclaimed land is located on the seaside, the wind is stronger than the inland area, and the fog is frequent. Especially, Saemangeum area has 2.6 times stronger wind speed and 3.4 times longer fog duration than the inland area. In designing the heating systems for greenhouses in reclaimed lands, it is considered that the maximum heating load should be calculated by applying the wind coefficient larger than the inland area. It is reasonable to estimate the operation cost of the heating system by applying the adjustment factor 10 % larger than the average in calculating the seasonal heating load.

• 오토저널
• /
• 제10권6호
• /
• pp.72-84
• /
• 1988

Engine performance is one of the main objectives specified at the beginning of a new engine design project. The cycle simulation for SI engine is based on the zero-dimensional gas exchange model and a heat release expression by Viebe. This program also requires minimum input data and takes only a short time to run. Heat transfer from cylinder transfer formula. The flow coefficient (effective area) is calculated from valve lift using the standard flow coefficient curve and engine friction is calculated from the Millington and Hartles' engine friction formula. The chemical species considered in burned gas are 6 species CO, CO, H$_{2}$, H$_{2}$O, $O_{2}$, N$_{2}$ and the cylinder pressure, homogeneous cylinder temperature, gas composition and burned fraction are calculated at each crank angle through the cycle. To check the validity and accuracy, experimental study was done with 3 engines for measuring cylinder pressure, indicated mean effective pressure, brake mean effective pressure and air flow rate, etc. Despite its simple assumptions, cycle simulation showes excellent breathing and performance correlation when compared with data of tested engines, and have been proved useful in engine design.

• 설비공학논문집
• /
• 제28권9호
• /
• pp.361-366
• /
• 2016

As an alternative of well-mixed storage tank with lower coil only, we have proposed a tank with lower and upper coils and verified a superior thermal stratification in a tank, which results in increased collector efficiency and solar fraction. But the phenomenon of temperature reversal was often experimentally observed in the tank, so a revised control was successfully applied which is to heat only lower coil using three way valve if temperature reversal occurs and to operate the collector with low flow rate when the condition of solar radiation is not good. In the present study, using TRNSYS we compared the existing lower heating and the proposed lower and upper heating with a control preventing temperature reversal. The results showed that the proposed method has an increase of collector efficiency by 5.1% and solar fraction by 3.2%.

• 설비공학논문집
• /
• 제21권1호
• /
• pp.41-48
• /
• 2009

The present study has been performed to investigate the thermal characteristics of under-ventilated compartment fire which is a typical fire condition in structures. A series of fire experiments was conducted to characterize the thermally driven flow in a 2/5 scale ISO 9705 fire compartment. Three different fuels were used in this test series, methane gas, heptane pool, and polystyrene pellets fire. In order to measure accurate temperature, double shield aspirated thermocouples reducing the effect of radiative energy exchange on temperature measurement were used in addition to bare bead thermocouples. The upper layer temperature for well ventilated fire was increased with increasing heat release rate, but it was slightly decreased for under-ventilated fire. The measured temperatures in the upper layer at the front sampling location were higher than at the rear. Thermal characteristics through the doorway were also analysed for a wide range of heat release rates. This study provides a comprehensive and quantitative assessment of fire behavior for under-ventilation condition of fire.

• 생태와환경
• /
• 제56권4호
• /
• pp.420-429
• /
• 2023

This study was designed to examine the immune response in Korean rockfish during water temperature fluctuation and to elucidate the factors contributing to streptococcal pathogenesis in cultured Korean rockfish, S. schlegeli. We investigated cumulative mortality against Streptococcus iniae (FP5228 strain) infection in the exposed Korean rockfish (39.7±5.8 g) to environmentally relevant temperature (Control, 23℃; High temperature, 28℃ and 23℃ and 28℃ with 12 hours interval exchange, 23↔28℃) for 48 hours. Also, the expression of the mRNA related to the immune response genes (heat shock protein 70, interleukin1β, lysozyme g-type and thioredoxin-like 1) were measured in spleen and head kidney by real-time PCR analysis in the exposed fish to thermal stress. In this study, the combined stress with bacterial challenge in fishes exposed to thermal stress lowered the survival rate than that of control (23℃). The cumulative mortality in the group of control, 28℃ and 23↔28℃ was 24%, 24% and 40% (P<0.05), respectively. Also, thermal stress modulated the mRNA level of immune related genes; heat shock protein 70, interleukin-1β, lysozyme g-type and thioredoxin-like 1 in Korean rockfish. The present study indicates that a high and sudden water temperature change affect immune responses and reduce the disease resistance in Korean rockfish.

• 대한토목학회논문집
• /
• 제32권5C호
• /
• pp.177-183
• /
• 2012

최근 들어 경제적인 에너지 활용을 위하여 지열에너지 필요성이 증대되고 있다. 특히 보편적으로 사용되고 있는 U자형 지중열교환기보다 열교환 면적이 넓어 더 높은 열 교환 효율을 보이는 코일형 지중열교환기의 적용이 확대되고 있다. 본 논문에서는 다양한 피치 간격에 따른 코일형 지중열교환기의 실험적 연구를 수행하였다. $5m{\times}1m{\times}1m$ 크기의 모형 토조 내에 주문진 모래가 균질하게 조성되었으며 열응답 시험이 수행되었다. 코일형 지중열교환기 내를 순환하는 순환수 온도값을 이용하여 선형 열원 이론과 고리-코일 열원 모델을 적용하여 지반의 열전도도를 도출하였다. 또한 모형 토조 내의 코일에서 일정한 거리의 계측 온도값과 이론해를 비교하였으며 고리-코일 열원 모델이 선형 열원 모델과 원통형 열원 모델보다 코일형 지중열교환기가 설치된 지반의 온도값을 보다 정확하게 예측함을 알 수 있다.

• 열처리공학회지
• /
• 제23권3호
• /
• pp.150-155
• /
• 2010

Generally, plasma nitriding process has composed with a nitriding layer within glow discharge region occurred by energy exchange. The dissociations of nitrogen molecules are very difficult to make neutral atoms or ionic nitrogen species via glow discharge area. However, the captured electrons in which a double-folded screen with same potential cathode can stimulate and come out some single atoms or activated ionic species. It was showed an important thing that is called "hat is a dominant component in this nitriding process?" in plasma nitriding process and it can take an effective species for without compound layer. During a plasma nitriding process, it was able to estimate with analyzing and identification by optical emission spectroscopy (OES) study. And then we can make comparative studies on the nitrogen transfer with plasma nitriding and ATONA process using plasma diagnosis and metallurgical observation. From these observations, we can understand role of active species of nitrogen, like N, $N^+$, ${N_2}^+$, ${N_2}^*$ and $NH_x$-radical, in bulk plasma of each process. And the same time, during DC plasma nitriding and other processes, the species of FeN atom or any ionic nitride species were not detected by OES analyzing.

• International Journal of Air-Conditioning and Refrigeration
• /
• 제9권1호
• /
• pp.71-76
• /
• 2001

Factors governing the rate of heat exchange comprise temperature, air velocity, relative humidity, and relation indoors. Recently, there are many researches on the transient analysis of indoor environmental factors such as dry bulb temperature, relative humidity and air velocity in miniature models. The purpose of this study is to measure the environmental factors and to analyze and evaluate the characteristics of indoor environment in different envelop structures using granite dome models. The interior relative humidity is constant regardless of exterior humidity although a little range of variation is shown in comparison to the cement model.