• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.11a
• /
• pp.277-284
• /
• 2000

Using the large diameter (D ＝ 2,500mm, L ＝ 40m) batter steel pipe piles, designed as compression piles but used as reaction piles during the static compression load test of socketed test piles (D ＝ 1,000mm, L ＝ 40m), static pile load tests for large diameter instrumented rock-socketed piles were performed. The reaction steel pipe piles were driven 20m into the marine deposit and weathered rock layer and then l0m socketed with reinforced concrete through the weathered rock layer and into hard rock layer. Steel pipe and concrete in the steel pile part, and concrete and rebars in the socketed parts were instrumented to measure strains in each part. The pullout amounts of reaction pile heads were also measured with LVDT. During the static pile load test, total compressional load of about 20MN was loaded on the head of test piles, but load above 20MN was not loaded due to lack of loading capacity of loading system. Over the course of the study, maximum pullout amount up to 7mm was measured in the heads of reaction piles when loaded op to 10MN and 1mm of pullout amount was measured. More than 85% of pullout load was transfered in the residual weathered rock layer and about 10% in the soft rock layer, which was somewhat different transfer mechanism in the static compressional load tests.

• International Journal of Fluid Machinery and Systems
• /
• v.4 no.2
• /
• pp.243-254
• /
• 2011

In the present paper, we focus on the flow computation of a low head Propeller turbine at a wide range of design and off-design operating conditions. First, we will present the results on the efficiency hill chart prediction of the Propeller turbine and discuss the consequences of using non-homologous blade geometries for the CFD simulation. The flow characteristics of the entire turbine will be also investigated and compared with experimental data at different measurement planes. Two operating conditions are selected, the first one at the best efficiency point and the second one at part load condition. At the same time, for the same selected operating points, the numerical results for the entire turbine simulation will be compared with flow simulation with our standard stage calculation approach which includes only guide vane, runner and draft tube geometries.

• Journal of radiological science and technology
• /
• v.20 no.1
• /
• pp.35-38
• /
• 1997

Scintigraphic measurement of gastric emptying time has been reported to be influenced by the variation in depth of radionuclide within the stomach. This study was designed to clarify whether a part of the variability in gastric emptying could be ascribed to a relationship between anterior image, the total anteroposterior Image and the tissue attenuation correction(geometric mean). A dual-head scintillation camera(ADAC, USA) was used to investigate effect of such changes. We were performed 16 normal subject gastric emptying studies with $^{99m}TC$ labelled scramble egg, milk and solid meal(610 Kcal, 300 g) The results are as follows; On anterior Image, $T_{1/2}$ emptying time was delayed by 5 min, 6.5%(range $3{\sim}18\;min,\;5{\sim}31.4%$) compared with the geometric mean. But there was no different gastric emptying time between the total anteroposterior image and geometric mean. Therefore, if will be useful to use the method of geometric mean or the total anteroposterior image to evaluate the gastric emptying time accurately.

• The Journal of the Acoustical Society of Korea
• /
• v.24 no.2
• /
• pp.103-110
• /
• 2005

Providing adequate amount of spatial impression for spaciousness) has been known to be one of the most important design considerations for the good acoustics of rooms for music. and the measurement, of room acoustics using parameters. such as LEF and IACC, forms an essential part of such evaluation. However. it is unavoidable to use different transducers (figure of eight microphones. head and torso) for the measurement of each parameter and it tends to make the measurement procedure complicated. The Present work tried to provide a simpler way to measure these binaural room acoustic parameters including monaural ones with a single measurement system using both spatial information collected through a 5-channel microphone and a trained neural network. A computer simulation program, CATT-Acoustic V7.2. which allowed us to obtain exactly the same spatial information as a 5-channel microphone was used. since it requires quite a large amount of data for practical training of a neural network. Since each reflection has different energy. delay and direction, energy should be integrated properly. the concept of ray tracing method was applied inversely in this work. Also applying weightings according to the delay times was considered in this work. Finally, predicted results were compared with the measured data md their correlations were analyzed and discussed.

• Journal of Environmental Impact Assessment
• /
• v.22 no.3
• /
• pp.241-254
• /
• 2013

The nutria(Myocastor coypus) that is originated from South America is a representative Invasive alien species in Korea. invasive alien species is one of the biggest causes for the loss of biodiversity and it may threaten the conservation and function of ecology as well as the welfare of mankind. Intense habitation has been made around the Nakdong River basin area that this study has analyzed the habitat density of nutria for the subject of 3 survey sites in the Nakdong River basin area. As a result of survey on habitation density in 2011 and 2012, under St.1 it was shown $2.01{\pm}0.21$/ha in 2011 and $0.69{\pm}0.55$/ha in 2012. Under St.2, it was shown $0.91{\pm}0.37$/ha in 2011 and $0.55{\pm}0.39$/ha in 2012. Under St.3, it was shown $5.31{\pm}0.72$/ha in 2011 and $3.99{\pm}2.31$/ha in 2012. The wet survey areas of St.1 and St.3 had shown relatively high habitation density compared to St. 2, the river survey area, and the average annual habitation density of the survey area was $2.74{\pm}2.29$/ha in 2011 and $1.74{\pm}1.18$/ha in 2012 that it has shown slightly reducing trend. As a result of measuring the morphology by capturing the habitation individuals, the average body length of adults is $92.23{\pm}9.41cm$, the length from the head to body for $53.90{\pm}5.15cm$, tail length for $38.33{\pm}4.83cm$, hind foot length for $13.82{\pm}1.00cm$, front foot length for $6.02{\pm}0.56cm$, and weight for $5.48{\pm}1.08kg$. As a result of comparing the types between genders, male showed a slightly higher figure in all parts compared to female and it showed significantly difference in total body length, head-body length, front foot length and total weight. As a result of analysis for each head-body length, other measured parts, weight and relativity for each measured part, all bodily part is shown to have the higher volume of correlations. The condition index of individuals in the survey area was shown in the average of $35.67{\pm}4.78$ with female for an average of $36.60{\pm}5.19$ and male for an average of $34.73{\pm}4.34$. The winter temperature in the southern area of Korea is considered for not greatly impacting on the habitation and development of nutria that, if there is no artificial control, it is considered to have certain concern of showing drastic breeding and territory expansion for the habitation group.

• Korean journal of applied entomology
• /
• v.43 no.1
• /
• pp.85-89
• /
• 2004

Numerical measurements were made for fresh weight, body length and width, head width, and color and length of antenna of Japanese pine sawyer, Monochamus alternatus adults, a primary vector of pine wood nematode, Bursaphelenchus xylophilus in Korea. We measured 563 females and 601 males that emerged out of dead pine logs from 2001 to 2002. General linear model analysis showed that measurements of fresh weight, body length, and body width were significantly higher in females than in males. Head width was not significantly different between sexes. Antennal length of males was significantly longer than that of females. For females and males respectively, average fresh weights were 0.305g and 0.277g, body lengths 20.97mm and 19.93mm, body widths 6.52mm and 6.18mm, head widths 3.78mm and 3.70mm, and antennal lengths 31.19mm and 45.49 mm. Antennal length or ratio of antennal length to body length overlapped in some ranges between 2 sexes. Therefore antennal length itself or ratio of antennal length to body length could not be used as a definite criterion to discriminate sexes. However, check on color of the antennae of 4,033 adults revealed without exception that basal part of every segment of flagellum of female antenna was covered with whitish-grey hairs, while whole part of every segment of male flagellum was covered with brownish-black hairs. This characteristics might be a best way to differentiate sex of this species.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.6
• /
• pp.1083-1088
• /
• 2016

25.8kV GIS part generated by sensors to measure contact an inflow of noise depending on the extent of the measured discharge occurs often not easy. Partial discharge signal measurement sensor suitable for developing a more useful measurements at the scene to this, partial discharge waveform analysis developed a sensor, and to utilize forSensor on the development of the most important is VSWR decided to (voltage standing wave ratio) voltage standing-wave ratio less than 1.5 and decided less than at the full spectrum bands that are measured, this time Return loss, as measured value by absolute criteria 14.0 dB produced the sensor, designed to or more. UHF 1.5~0.5 GHz bandwidth spectrum to be measured in GIS. UHF bands were designed to be able to measure the best signal. Recently, 25.8kV GIS production company has been increasing variety of GIS were made open spacer in partial discharge in accordance with the not very easy to detect the signal. The sensor is designed height of four cm external spacer is attachment GIS in an influx of outside noise measurement, and be so manufactured as to facilitate the least we've done. Also, since partial discharge which occur can measure the frequency of the 170kV GIS external partial-discharge signals that occur at the scene of insulation applied to the spacer. Features, and also derived good results using global positioning. Also measured discharge point about sensors that are stable and the reliability of the development and local substation equipment failure occurring signal analysis through the discharge for the prevention of widely. There should be to believe that used.

• Imaging Science in Dentistry
• /
• v.43 no.3
• /
• pp.191-196
• /
• 2013

Purpose: This study assessed the accuracy of linear and angular measurements on panoramic radiographs taken at different positions in vitro. Materials and Methods: Two acrylic models were fabricated from a cast with normal occlusion. Straight and $75^{\circ}$ mesially and lingually angulated pins were placed, and standardized panoramic radiographs were taken at standard position, at an $8^{\circ}$ downward tilt of the occlusal plane compared to the standard position, at an $8^{\circ}$ upward tilt of the anterior occlusal plane, and at a $10^{\circ}$ downward tilt of the right and left sides of the model. On the radiographs, the length of the pins above (crown) and below (root) the occlusal plane, total pin length, crown-to-root ratio, and angulation of pins relative to the occlusal plane were calculated. The data were subjected to repeated measures ANOVA and LSD multiple comparisons tests. Results: Significant differences were noted between the radiographic measurements and true values in different positions on both models with linear (P<0.001) and those with angulated pins (P<0.005). No statistically significant differences were observed between the angular measurements and baselines of the natural head posture at different positions for the linear and angulated pins. Conclusion: Angular measurements on panoramic radiographs were sufficiently accurate and changes in the position of the occlusal plane equal to or less than $10^{\circ}$ had no significant effect on them. Some variations could exist in the pin positioning (head positioning), and they were tolerable while taking panoramic radiographs. Linear measurements showed the least errors in the standard position and $8^{\circ}$ upward tilt of the anterior part of the occlusal plane compared to other positions.

• The Journal of the Korea Contents Association
• /
• v.8 no.6
• /
• pp.8-15
• /
• 2008

In this paper, in order to analyze property of frequency response in optical microphone, system was implemented. The capacitance microphone and fiber-optic transmission path type fiber-optic microphone (FOM) have weaknesses in directivity, size, weight, and price. However suggested optical microphone can be constituted by cheap devices, so it has many benefits like small size, light weight, high directivity, etc. Head part of optical microphone which is suggested in this paper is movable back and forth by sound pressure with the attached reflection plate. Operating point is determined by measuring the respond characteristics and choosing the point on which has maximum linearity and sensitivity while changing the distance between optical head and vibrating plate. We measured the output of the O/E transformed signal of the optical microphone while frequency of sound signal is changed using sound measurement/analysis program, Smaart Live and USBPre, which are based on PC, and compared the result from an existing capacitance microphone. The measured Optical microphone showed almost similar output characteristics as those of the compared condenser microphone, and its bandwidth performance was about 300[Hz]-3[kHz] at up to 3 [dB].

• Journal of Korean Biological Nursing Science
• /
• v.15 no.4
• /
• pp.210-218
• /
• 2013

Purpose: The purpose of this study was to identify the characteristics and nursing activities of severe trauma patients regarding damaged body parts in Busan Regional Emergency Medical Center. Methods: A survey using a 'trauma patient information questionnaire and a list of nurse activities' was conducted with 133 patients over 15 points ISS on EMR from June 1, 2011 to May 31, 2012. The collected data were analyzed by the SPSS/WIN 12.0 program. Results: Almost all of the subjects were men, and the mean age was 48.8. The amount of road traffic accidents was 60.4%, and the mean RTS and ISS were 6.08, and 23.14 points. Nursing activities in common were airway management, assessment of LOC & GCS, and EKG monitoring. Most of head and neck trauma patients were cared for manasing using intracranial pressure: each patience had the following assessed: pupil size and light reflex, they were checked the leak of CSF, kept $30^{\circ}$ head elevation, and administered medications. Some of chest trauma patients were treated for chest tube and central venous catheter insertion. Partial abdominal trauma patients were administered analgesic and cared for using arterial pressure measurement. Part of the limbs and pelvis trauma patients were given a blood transfusion. Conclusion: Based on the results, the characteristics and nursing activities were specific according to the specific damaged body parts.