• International Journal of Highway Engineering
• /
• v.8 no.1 s.27
• /
• pp.77-87
• /
• 2006

Dynamic stability (DS) in the wheel tracking (WT) test is used as a basic index of rut-resistance for asphalt mixtures. In general, the deeper rut depth is obtained from the weaker mixture, resulting in the lower DS value. On the other hand, the shallower rut depth is obtained from the stronger mixture, resulting in the higher DS. However, it is not always the case when the DS is calculated by the existing method because the DS is simply determined based on the slope at the final stage of the rut depth-cycle curve. Specifically, in the case of the depth-cycle curve showing a steeper slope in the early part but flatter slope in last part, the DS is calculated to be higher than the curve showing a ever-increasing slope throughout the test. As long as the last part of slope is flatter, the deeper final rut depth is evaluated to show a higher DS than the little final rut depth. Therefore, a reasonable method for DS evaluation need to be established. Several new methods were suggested by considering the early, middle and final parts of rut depth to determine a reasonable DS. The results have shown that those new methods have demonstrated a significant improvement in distinguishing similarly performing mixtures. The result also showed that $DS_2$ had better correlation with SD than any other methods , representing the rutting resistance of asphalt mixture very well. The new DS calculation method is relatively simple and easy to follow. More validatin study is required for practical application.

• Korean Journal of Remote Sensing
• /
• v.34 no.3
• /
• pp.481-494
• /
• 2018

The accurate radiative transfer model simulation is essential for an accurate ozone profile retrieval using optimal estimation from backscattered ultraviolet (BUV) measurement. The input parameters of the radiative transfer model are the main factors that determine the model accuracy. In particular, meteorological parameters such as temperature and surface pressure have a direct effect on simulating radiation spectrum as a component for calculating ozone absorption cross section and Rayleigh scattering. Hence, a sensitivity of UV ozone profile retrievals to these parameters has been investigated using radiative transfer model. The surface pressure shows an average error within 100 hPa in the daily / monthly climatological data based on the numerical weather prediction model, and the calculated ozone retrieval error is less than 0.2 DU for each layer. On the other hand, the temperature shows an error of 1-7K depending on the observation station and altitude for the same daily / monthly climatological data, and the calculated ozone retrieval error is about 4 DU for each layer. These results can help to understand the obtained vertical ozone information from satellite. In addition, they are expected to be used effectively in selecting the meteorological input data and establishing the system design direction in the process of applying the algorithm to satellite operation.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.11 no.4
• /
• pp.216-230
• /
• 1999

A Galerkin finite element model for the analysis of harbor oscillation has been developed based on the extended mild-slope equation. Infinite elements are used to accomodate the radiation condition at infinity and joint elements to treat the matching conditions at the harbor entrance which include the energy loss due to flow separation. The numerical tests for rectangular harbors with fully or partially open entrances show that the energy loss at the harbor entrance considerably reduces the the amplification ratios at the innermost parts of the harbors and that the amplification ratios decrease considerably with increasing incident wave heights and jet lengths at the harbor entrance. Application of the model to the Gamcheon harbor show that when the incident wave amplitude is small the amplification ratios rather increase when the entrance energy loss is included than when ignored because of the shift of the resonance periods. Even though the entrance energy loss was insignificant for the measured long-period incident waves, it would be of great importance if the incident waves were large as in the attack of tsunamis. The resonance period of the Helmholtz mode at the Gamcheon Harbor was calculated to be 31 minutes, which agrees well with the measured one between 27 and 33.3 minutes. The measured resonance periods between 9.4 and 12.1 minutes and 5.2 and 6.2 minutes were also calculated by the numerical model as 10.4 minutes and 6.6 or 5.6 minutes, indicating good performance of the model. On the other hand, it was shown that a variety of oscillation modes exists in the Gamcheon Harbor and lateral resonances of considerable amplification ratios also exist at the periods of 3.6 and 1.6 minutes as in the Young-II Bay.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.7
• /
• pp.168-175
• /
• 2020

Recently, there has been an increasing need to expand the supply of renewable energy as a solution to greenhouse gas emissions. Therefore, as a measure to promote domestic renewable energy investment and gradual expansion, this study analyzed the investment value of renewable energy projects utilizing the unoccupied spaces of public enterprise's facilities and presented a strategic decision-making framework to support efficient national land development and government measures. The NPV was estimated to be 286 million won if the expansion of the facility was not considered, but it is reasonable to postpone the expansion decision because the value of -130 million won was calculated if the expansion was considered. On the other hand, the real-option value was estimated to be 444 million won, taking SMP uncertainty, expansion, and abandonment options into account, and an additional value of 288 million won was calculated from an analysis of the expansion project using the existing NPV analysis.

• The Korean Journal of Physiology
• /
• v.4 no.2
• /
• pp.25-31
• /
• 1970

Tissue homogenates of Ehrlich ascites tumor tissues and several normal tissue of mice were incubated separately in medium maintaining $C^{14}$_acetate concentrations of 5, 10, 20, 30, 40, 50 and 60 mg%, in order to determine maximum oxidative rates of acetate. In every incubation experiments, respiratory $CO_2$ samples rapped by alkaline which was placed in the center well of the incubation blask were analyzed for total $CO_2$ Production rates and their radoactivies. The fractions of $CO_2$ from medium acetate to total $CO_2$ production rate were obtained with relative specific activities (RSA) which were calculated by ratio between specific activities (SA) of $CO_2$ and medium $CO^{14}$_acetate and $CO_2$ production rates from medium acetate were calculated from RSA and total $CO_2$ production rates. Maximum plateau values of oxidative rates described above were determined at incubation experiments of various concentrations of medium acetate and compared the oxidative rates of acetate of tumor with those of normal tissues such as kidney, brain and liver. Maximum plateau values of total $CO_{2}$ Production rates were obtained at acetate concentration of 20 mg% and represent $25.0{\pm}0.54\;{\mu}M/hr/gm$ in the brain, $16.3{\pm}2.5$ in the kidney, $9.1{\pm}1.78$ in the liver and $11.5{\pm}3.2\;{\mu}M/hr/gm$ in the ascites tuners. Substancial $CO_2$ yield was observed in the tumor tissues as in the normal tissues. On the other hand, plateau values of RSA were $25.7{\pm}1.04%$ in thee brain, $9.1{\pm}0.72%$ in the kidney, $2.5{\pm}0.73%$ in the liver and $0.51{\pm}0.12%$ in the tumor tissues. $CO_2$ yields from the medium acetate, were 4.19 in the kidney, 2.28 in the brain, 0.228 in the liter and $0.059\;{\mu}M/hr/gm$ in the tumor tissue. These show wide range even in the normal tissue but remarkable decrease in the tumor tissue. This fact means that further oxidation of acetate was inhibited remarkably in the tumor tissue.

• Journal of the Korean earth science society
• /
• v.32 no.4
• /
• pp.347-359
• /
• 2011

This study has developed the index for diagnosis on possibility that typhoons (TYs) affect Korea. This index is closely related to the strength of the western North Pacific high (WNPH), which is calculated as a difference in meridional wind between at the highest correlation area (around Korea) and at the lowest correlation area (sea southeast of Japan) through a correlation analysis between TC frequency that affects Korea and 500 hPa meridional wind. In low frequency years that selected from Korea affecting TC index, anomalous northeasterly is strengthened from Korea to the South China Sea because the center of anomalous anticyclonic circulation is located to northwest of Korea. Thus, TCs tend to move westward from the sea east of the Philippines to the mainland China. On the other hand, in high frequency years, anomalous southwesterly serves as steering flow that more TCs move toward Korea because the center of anomalous anticyclonic circulation is located to sea east of Japan. Consequently, this study suggests that if this index is calculated using real time 500 hPa meridional winds that forecasted by dynamic models during the movement of TCs, the possibility that TCs approach Korea can be diagnosed in real time.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.22 no.5
• /
• pp.521-526
• /
• 2016

Sediment dredging can permanently remove pollutants from an aquatic ecosystem, which is considered an effective approach to aquatic ecosystem restoration. In this study, we quantified the effects of sediment dredging on water quality in Masan Bay by calculation of oxygen demanding rate. We applied ecosystem model including water and sediment quality module in Masan Bay. The results showed that the increase of calculated oxygen demanding rate is significant due to sediment dredging of both inner part and outer part of Masan Bay. On the other hand, the increase is gradual due to decrease of anthropogenic load. It meant sediment dredging can improve water quality of Masan Bay more. Using correlation equation between oxygen demanding rate and sediment oxygen demand, we calculated that the area of sediment dredging which is equal to the effects of 10 % reduction of anthropogenic load. It is $1.68km^2$ in inner part and $3.15km^2$ in outer part of the Masan Bay. This Meant that to improve water quality of Masan Bay, sediment dredging in inner part is efficient method.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2006.06a
• /
• pp.141-151
• /
• 2006

A blank test was done to calculatee the car itself's magnetic effect as noise and to eliminate it from the data set of total magnetic intensity(=magnetic flux density) exploration in a car-borne magnetic exploration system. To calculate the induced magnetic intensity(= magnetization) and the remanent magnetic intensity(= magnetization) of the car itself, we have installed the magnetometer on a fixed point and measured the magnetic intensity letting the car move around the magnetometer, and we have changed the data set into an analogous data set as if acquired in the condition that we have parked the car on the same fixed point and measured the magnetic intensity moving the magnetometer around the magnetometer. Through an inversion with the later data set as input, we have calculated the magnetic center and the magnetic moments of the induced magnetic intensity(= magnetization) and the remanent magnetic intensity(= magnetization) of the car itself with the two centers coincided because of some barriers of the inversion algorithm that we have used in this study. On the other hand, we have extracted the magnetic anomaly by reducing i. e. vectorially eliminating the induced magnetic intensity(= magnetization) and the remanent magnetic intensity(= magnetization) of the car itself calculated forwardly, from the magnetic exploration data set acquired by the car-borne magnetic exploration system.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.3
• /
• pp.556-563
• /
• 2020

Most of a BIPVS (Building Integrated Photovoltaic System) is installed on the rooftop or wall of a building. Therefore, the main factor to consider for selecting the installation site is the shadow effects produced by the surrounding buildings. On the other hand, when the photovoltaic was installed on soundproof walls, shadow effects were produced by not only surrounding buildings but also the surrounding trees. Therefore, a different data model and algorithm with the BIPVS case are essential for proper installation sites selection of a SIPVS (Soundproof wall Integrated Photovoltaic System). This paper deals with the DSM (Digital Surface Model)-based proper installation site analysis for SIPVS. First, the solar incident and altitude angles of the installation candidate sites (solar panel) during the year were calculated. Second, the shadow effects (shadowed or unshadowed) were determined for the candidate sites at each time with the DSM. Third, the amount of solar radiation was calculated with the incident angle for the candidate sites at an unshadowed period. The proper installation site of the SIPVS could then be selected by comparing the accumulated annual solar radiation for each candidate. The proposed algorithm was implemented as a prototype (Java program). From the experiment, the order of the installation suitability was determined among the nine candidates. The proposed algorithm could be used for proper BIPVS installation site analysis aimed at the lower part of a building and calculation of the expected power production.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.9
• /
• pp.626-633
• /
• 2020

This study examined the behavior of the ground by comparing the methods using the results of the Terzaghi formula and the ground investigation data and method considering the dilatancy effect for a circular tunnel using the finite element method. In the case of the Terzaghi formula, the tunnel load can be overestimated and cause overdesign. The method using the results of the ground investigation data cannot be applied when a reasonable coefficient of earth pressure is not determined. This is because it behaves completely differently from the actual behavior, and unexpected problems can occur. In the case of the method considering the dilatancy effect, however, both the strength enhancement effect can be considered through the dilatancy angle and relative density. Therefore, the tunnel load was calculated most reasonably using the method considering dilatancy. Finite element analysis using the geotechnical survey results showed that the tensile stress acts at the top of the tunnel when the upper soil of the tunnel is shallow. On the other hand, additional verification is necessary, such as a comparison with the field measurement results. Through additional research, if normalized, the tunnel load can be calculated reasonably at the time of tunnel design, and safe and economical design is possible.