• PNF and Movement
• /
• v.21 no.2
• /
• pp.171-183
• /
• 2023

Purpose: The purpose of this study was to compare universal goniometry (UG), which is commonly used in clinical practice to measure the range of motion (ROM) of finger joints with a wearable soft sensor glove, and to analyze the reliability to determine its usefulness. Methods: Ten healthy adults (6 males, 4 females) participated in this study. The metacarpophalangeal joint (MCP), interphalangeal joint (IP), and proximal interphalangeal joint (PIP) of both hands were measured using UG and Mollisen HAND soft sensor gloves during active flexion, according to the American Society for Hand Therapists' measurement criteria. Measurements were taken in triplicate and averaged. The mean and standard deviation of the two methods were calculated, and the 95% limits of agreement (LOA) of the measurements were calculated using the intraclass correlation coefficient (ICC) and Bland-Altman plot to examine the reliability and discrepancies between the measurements. Results: The results of the mean values of the flexion angles for the active range of motion (AROM) of the finger joints showed large angular differences in the finger joints, except for the MCP of the thumb. In the inter-rater reliability analysis according to the measurement method, the ICC (2, 1) value showed a low level close to 0, and the mean difference by the Bland-Altman plot showed a value greater than 0, showing a pattern of discrepancy. The 95% LOA had a wide range of differences. Conclusion: This study is a preliminary study investigating the usefulness of the soft sensor glove, and the reliability analysis showed a low level of reliability and inconsistency. However, if future studies can overcome the limitations of this study and the technical problems of the soft sensor glove in the development stage, it is suggested that the measurement instrument can show more accurate measurement and higher reliability when measuring ROM with UG.

• Journal of Korea Water Resources Association
• /
• v.53 no.12
• /
• pp.1203-1210
• /
• 2020

Drought is caused by a combination of various hydrological or meteorological factor, so it is difficult to accurately assess drought event, but various drought indices have been developed to interpret them quantitatively. However, the drought indexes currently being used are calculated from the lack of a single variable, which is a problem that does not accurately determine the drought event caused by complex causes. Shortage of a single variable may not be a drought, but it is judged to be a drought. On the other hand, research on developing indices using unstructured data, which is widely used in big data analysis, is being carried out in other fields and proven to be superior. Therefore, in this study, we intend to calculate the drought index by combining unstructured data (news data) with weather and hydrologic information (rainfall and dam inflow) that are being used for the existing drought index, and to evaluate the utilization of drought interpretation through verification of the calculated drought index. The Clayton Copula function was used to calculate the joint drought index, and the parameter estimation was used by the calibration method. The analysis showed that the drought index, which combines unstructured data, properly expresses the drought period compared to the existing drought index (SPI, SDI). In addition, ROC scores were calculated higher than existing drought indices, making them more useful in drought interpretation. The joint drought index calculated in this study is considered highly useful in that it complements the analytical limits of the existing single variable drought index and provides excellent utilization of the drought index using unstructured data.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.32 no.3
• /
• pp.268-278
• /
• 2022

Objectives: This study aimed to establish a control group based on the big data from National Health Insurance Service. We also presented presented the number of incidences for each cancer, and analyzed the cancer incidence rate among Korean workers. Methods: The cohort definition was separated by 'baseline cohort', 'dynamic cohort', and 'fixed- industry cohort' according to the definition. Cancer incidence was calculated based on the Korean Standard Classification of Disease code. Incidence rate was calculated among the group of all workers and public officials. Based on the study subjects and each cohort definition, the number of observations, incidences, and the incidence rate according to sex and age groups was calculated. The incidence rate was estimated based on the incidence per 100,000 person-year, and 95% confidence intervals calculated according to the Poisson distribution. Results: The result shows that the number of cancer cases in the all-worker group decreases after the age of 55, but the incidence rate tends to increase, which is attributed to the retirement of workers over 55 years old. Despite the specific characteristics of the workers, the trend and figures of cancer incidence revealed in this study are similar to those reported in previous studies of the overall South Korean population. When comparing the incidence rates of all workers and the control group of public officials, the incidence rate of public officials is generally observed to be higher in the age group under the age of 55. On the other hand, for workers aged 60 or older, the incidence rates were 1,065.4 per 100,000 person-year for all workers and 1,023.7 per 100,000 person-year for civil servants. Conclusions: This study analyzed through health insurance data including all workers in Korea, and analyzed the incidence of cancer of workers by sex and age. In addition, further in-depth researches are needed to determine the incidence of cancer by industry.

• The Journal of Korean Obstetrics and Gynecology
• /
• v.25 no.3
• /
• pp.95-102
• /
• 2012

Purpose: The purpose of this study is to define the cut off values of cold hypersensitivity of hands by using digital infrared thermographic imaging(DITI). Methods: Thermographic images of 130 patients with cold hypersensitivity of hands(CHHG, n=65) and non-cold hypersensitivity of hands(NCHHG, n=65) were retrospectively reviewed. We used the temperature difference the palm(PC8) and the upper arm(LU4) for diagnosing cold hypersensitivity of hands. The temperature differences of between two groups were analysed using independent samples t-tests. The cut off values were calculated by ROC curve analysis. Analyses were undertaken using SPSS version 17.0. P value of < 0.05 was considered significant. Results: The temperature difference the palm(PC8) and the upper arm(LU4) were significantly different between groups(p < 0.001). Using receiver operating characteristic curve analysis, the sensitivity, specificity, and area under the curve were 70.8%, 73.8%, respectively both hands. The AUC was 0.822 on right hand and 0.818 on left hand. The optimum cut-off value was defined as $-0.05^{\circ}C$. Conclusions: These results suggest that DITI is a reliable instrument for estimating the cold hypersensitivity of hands.

• Journal of Biomedical Engineering Research
• /
• v.37 no.1
• /
• pp.15-20
• /
• 2016

Essential tremor is a neurological disorder with a tremor of the arms and hands. It is well known that essential tremor is characterized by the postural tremor and the action tremor. There has been no report on the quantitative difference in the characteristics of two tremor types. The purpose of this study was to investigate the possible difference in tremor characteristics of postural and action tremors. Seventeen patients with essential tremor ($68.9{\pm}7.9years$, 7 men, 10 women) participated in this study. Patients performed the tasks of postural maintenance (arms outstretched) and daily actions (spiral drawing). Three-axes (pitch, roll and yaw) gyro sensors were attached on index finger, back of hand and forearm, from which the segment and the joint angular velocities were calculated. Outcome measure was the tremor amplitude defined as the root-mean-square mean of the vector-sum angular velocity at segments and joints. Two-way ANOVA showed that task and joint had main factor on the tremor amplitude (p < 0.05). Post-hoc analysis revealed that tremor amplitude at the metacarpo-phalangeal joint was not affected by task (p > 0.05). However, tremor amplitude at the wrist joint differed among the tasks (p < 0.05), and it was greater in the action tasks than in postural task. Tremor was greater at finger segments than at hand and forearm and it increased in action tasks. The results of this study would be helpful for the understanding and task-specific treatments of the essential tremor.

• Steel and Composite Structures
• /
• v.18 no.4
• /
• pp.985-1000
• /
• 2015

The method of cross-section analysis for different sections in a structural frame has been widely investigated since the 1960s for determination of sectional capacities of beam-columns. Many hand-calculated equations and design graphs were proposed for the specific shape and type of sections in pre-computer age decades ago. In design of many practical sections, these equations may be uneconomical and inapplicable for sections with irregular shapes, leading to the high construction cost or inadequate safety. This paper not only proposes a versatile numerical procedure for sectional analysis of beam-columns, but also suggests a method to account for residual stress and geometric imperfections separately and the approach is applied to design of high strength steels requiring axial force-moment interaction for advanced analysis or direct analysis. A cross-section analysis technique that provides interaction curves of arbitrary welded sections with consideration of the effects of residual stress by meshing the entire section into small triangular fibers is formulated. In this study, two doubly symmetric sections (box-section and H-section) fabricated by high-strength steel is utilized to validate the accuracy and efficiency of the proposed method against a hand-calculation procedure. The effects of residual stress are mostly not considered explicitly in previous works and they are considered in an explicit manner in this paper which further discusses the basis of the yield surface theory for design of structures made of high strength steels.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.9 no.1
• /
• pp.170-175
• /
• 2008

In this study, we developed the CCPP calculating program, which is a kind of index and can determine whether calcium carbonate would precipitate or not in pipe line of water distribution system. Through 9 complicated procedures, CCPP can be calculated. Assuming pH of equilibrium as a first trial, compare the right-hand-side result with left-hand-side result. If the percentage difference between the two results is less than a prescribed tolerance, the initial assumption for the assumed equilibrium pH is adequate. If the difference is too large, make a different assumption and repeat until a result within the prescribed tolerance is achieved. Plugging the intermediate results into the final equation, we could compute the CCPP. Using Fortran and Visual Basic languages, we developed the program. As a result of application of the program, the water quality of intaking water of Han River is highly corrosive by the index of CCPP.

• Korean Journal of Applied Biomechanics
• /
• v.16 no.3
• /
• pp.33-41
• /
• 2006

This study was to analysis three dimension angle of the upper extremity segment and trunk to putting the protector in women bowlers. For this study, the subjects selected 4 players of national and university team. All subjects putted in the same wrist support to satisfy the experiment conditions. To get three dimensions position coordination of swing motion used for 6 ProReflex MCU 240 camera produced by Qualisys. After position coordination calculation, Three dimension angle of the trunk and the upper extremity segment calculated for Matlab 6.5. the result is following; In the trunk motion, there were little differences among the subjects in a flexion and extension change. There were a lot of differences in motion change of the abduction-adduction and internal-external rotation, but the motion types translated to the adduction-abduction-adduction and from the internal rotation toward the external rotation. In the upper arm segment the Flexion and extension showed a consistent motion in the down swing and up swing phase. And the motion change of abduction-adduction and pronation-supination showed a abduction-adduction-abduction and pronation-supination change during swing phase. In the forearm segment changes, it showed a lot of differences among the subjects and a similar change with the upper arm segment. Especially, the hand segment showed a supination motion from the backswing apex to release phase, but for increasing a rotation velocity of ball, the hand segment translated toward pronation in follow throw phase.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.8 s.350
• /
• pp.103-109
• /
• 2006

In this paper, single-feed equilateral triangular microstrip antennas(ETMA) for circular polarization(CP) are designed and studied experimentally. It is demonstrated that by embedding a narrow slot or a cross of unequal slot lengths in the triangular patch circularly polarized radiation RHCP(right-hand circularly polarized wave), LHCP(left-hand circularly polarized wave) of microstrip antennas can easily be achieved using by strategically positioned coaxial single probe feed. And the size of a triangular microstrip patch antenna is smaller than that of a conventional rectangular or circular patch at a given frequency. A single-feed ETMA with a horizontal narrow slot is printed on the substrate of 60 mils thick and the other ETMA with a corss slot of unequal slot lengths is printed on the same substrate. The antenna radiation characteristics are calculated by ENSEMBLE(Ver. 5.0) software, and compared with the experimental results. This results show that the antenna size reduction of about $17%{\sim}2l%$ is obtained as compared to the regular-size CP design.

• Toxicological Research
• /
• v.21 no.4
• /
• pp.297-301
• /
• 2005

Farmers are generally expressed to pesticides through mixing loding, application activity and harvesting of crop after application of pesticides. The present work investigated the exposure and risk of furathiocarb to workers when harvesting of cucumber was carried out in green house after application of furathiocarb EC. Glove was used for the hand exposure assessment, socks for foot and dermal patches for the other parts of body. Personal air monitor equipped with a XAD-2 resin was used for the respiratory exposure assessment. During the harvest of cucumber in green house, the initial rate of potential dermal exposure (Day 1) for methidathion was 1.3 mg/hr. The major exposure parts were hand $(78\~83\%),\;thigh\;(5\~7\%)$ and arms $(6\~9\%)$ during 3 days' harvest. No exposure was detected from the respiratory monitoring. For risk assessment, the potential dermal exposure (PDE), the absorbable quantity of exposure (AQE) and the margin of safety (MOS) and margin of exposure (MOE) were calculated. In risk assessment of harvester exposure for 7days, all MOS was > 1 and MOE was > 100 indicating that possibility of risk was little.