• 제목/요약/키워드: hairpin

검색결과 227건 처리시간 0.029초

$\lambda$/4 Hairpin 공진기를 이용한 2.4 GHz 대역 LTCC 대역통과 필터의 설계 (The Design of 2.4 GHz Band LTCC Bandpass Filter using $\lambda$/4 Hairpin Resonators)

  • 성규제
    • 마이크로전자및패키징학회지
    • /
    • 제11권4호
    • /
    • pp.7-11
    • /
    • 2004
  • 본 논문에서는 $\lambda$/4 헤어핀 공진기를 2.4 GHz 대역의 LTCC(Low Temperature Co-fire Ceramic) 대역통과 필터의 설계에 적용하였다. $\lambda$/4 헤어핀 공진기는 전송선로의 폭을 일정하게 유지한 상태로 특성임피던스를 변화시킬 수 있어, 등가적으로 SIR(Stepped Impedance Resonator)로 동작한다. $\lambda$/4 헤어핀 공진기는 평행결합 선로와 전송선로 부분으로 구성된다. 따라서 공진기의 두 부분의 특성임피던스는 서로 다른 값을 갖는다. 또한 공진기 사이의 결합량을 조절하기 위하여 사용하는 부가적인 결합 패턴은 결합위치에 따라 결합량을 다르게 할 수 있다. 평행 결합선로의 결합 구조와 부가적인 결합 패턴을 모두 고려한 대역통과 필터를 설계하기 위해서 두 결합구조의 등가회로를 하나의 인버터로 통합하는 과정을 제시하였다. 2.4GHz 대역에서 150 MHz 대역폭의 대역통과 필터를 적층 구조로 설계하여 설계 결과와 잘 일치하는 특성을 얻었다.

  • PDF

배드민턴 포핸드 헤어핀 동작 시 숙련 정도에 따른 손가락 압력 및 운동학적 변인 비교 분석 (A Comparative Analysis of the Finger Pressure and Kinematic Variables in the Forehand Hairpin Net Shot According to Proficiency)

  • 이행섭;채원식;정재후
    • 한국운동역학회지
    • /
    • 제22권4호
    • /
    • pp.387-394
    • /
    • 2012
  • The purpose of this study was to compare and analyze the finger pressure and kinematic variables in the forehand hairpin net shot between skilled elite players and less skilled recreational players. Eight elite players(age: $18.1{\pm}0.8yrs$, height: $176.8{\pm}1.5cm$, weight: $640.9{\pm}48.6N$) with minimum of 6 years of experience and eight recreational players(age: $27.9{\pm}1.6yrs$, height: $177.1{\pm}6.1cm$, weight: $820.5{\pm}62.8N$) with less than one year experience were recruited in this study. For each trial being analyzed, four critical instants were identified from the video recordings: Right heel contact1 (E1), Right toe-off (E2), Right heel contact2 (E3), and Shuttlecock Impact (E4). Each hairpin net shot was broken into consecutive phases: E1~E2 (Right Landing Phase: RLP), E2~E3 (Sliding Step Phase: SSP), and E3~E4 (Impact Phase: IP). Temporal parameters, shuttlecock speed, linear and angular kinematics of body segments, and finger pressures were computed for this study. The results showed that The finger pressure of the ring finger and the middle finger for the skilled group during an impact had significantly greater than those of unskilled group. It is possible that all fingers were not used in the same manner when the racket was gripped in forehand hairpin. The result also suggested that the ring finger and the middle finger pushed the racket from top to bottom while having the mid-phalanx and proximal phalanx of index finger as an axis.

A GaAs Micromachined Millimeter-wave Lowpass Filter Using Microstrip Stepped-Impedance Hairpin Resonator

  • Cho Ju-Hyun;Yun Tae-Soon;Baek Tae-Jong;Ko Baek-Seok;Shin Dong-Hoon;Lee Jong-Chul
    • 한국ITS학회 논문지
    • /
    • 제3권2호
    • /
    • pp.85-93
    • /
    • 2004
  • In this paper, microstrip stepped-impedance hairpin resonator (SIR) lowpass filter f.PF) by surface rnicromachining on GaAs substrate is sugsested. This filter has the advantages of compact side, easy fabrication, and sharp cutoff frequency response. The new SIR LPF shows the 3 dB passband of dc to 33 GHz, the insertion loss of 0.82 dB, and the return loss of better than 17 dB up to 25.57 GHz. This filter is useful for many microwave system applications.

  • PDF

Fabrication of 14 GHz Hairpin Type YBCO Filters

  • 송석천;김철수;이상렬;윤형국;윤영중
    • 한국초전도학회:학술대회논문집
    • /
    • 한국초전도학회 1999년도 High Temperature Superconductivity Vol.IX
    • /
    • pp.138-141
    • /
    • 1999
  • For the enhancement of communication system performance, high quality filters are required. Conventional metal filters made of copper can be substituted by high quality high temperature superconductivity(HIS) flms for better performance. In order to reduce the size of the filter for the integration of device in the limited area, we have fabricated hairpin type filters using pulsed laser deposition(PLD) technique. The superconducting YBCO thin films have been grown on MgO substrates by PLD with Nd:YAC laser. The YBCO films were patterned by conventional wet-etching process. We have compared YBCO filters and copper filters which were made with the same spec. Simulated and measured frequency responses reveal that HIS YBCO hairpin type bandpass filters show better performance than copper filters.

  • PDF

편광기법을 이용한 수직교차평면의 PIV 속도장 동시측정 (Simultaneous Measurements of Velocity Fields at Two Vertically Crossing Planes by PIV Systems Using Polarization Technique)

  • 김상문;윤상열;권성훈;김경천
    • 한국가시화정보학회:학술대회논문집
    • /
    • 한국가시화정보학회 2004년도 추계학술대회 논문집
    • /
    • pp.60-63
    • /
    • 2004
  • A new PIV technique was developed for decreasing optical error which was created during simultaneous measurements of velocity fields at a wall-normal plane and wall-parallel plane by a plane PIV and a Stereoscopic PIV system. The two Nd:Yag laser systems and three CCD cameras were. synchronized to obtain instantaneous velocity fields at the same time. To avoid optical noise at the crossing line by the two laser light sheets, a new optical arrangement using polarization was applied. The obtained velocity fields show the existence of hairpin packet structure vividly and the idealized hairpin vortex signature is confirmed by experiment.

  • PDF

Oscillator Design and Fabrication using a Miniatured Hairpin Resonator

  • Kim, Jang-Gu;Han, Sok-Kyun;Park, Hyung-Ha
    • 한국항해항만학회지
    • /
    • 제28권4호
    • /
    • pp.293-297
    • /
    • 2004
  • In this papers, an S-band oscillator of the low phase noise property using a miniaturized micro-strip hairpin shaped ring resonator is presented The substrate has a dielectric constant $\epsilon_\gamma$=3.5, a thickness h=0.508 mm, and loss tangent $tan\delta$=0.002. A designed and fabricated oscillator shows low phase noise performance of 99. 71 dBc/Hz at 100 KHz offset frequency and of output power 19.584 dBm at center frequency 2.450 GHz. This circuit was fabricated with hybrid technique, but can be fully compatible with the MMIC due to its entirely planar structure.

편광기법을 이용한 수직교차평면의 PIV 속도장 동시측정 (Simultaneous Measurements of Velocity Fields at Two Vertically Crossing Planes by PIV Systems Using Polarization Technique)

  • 권성훈;윤상열;김경천
    • 한국가시화정보학회지
    • /
    • 제2권1호
    • /
    • pp.32-38
    • /
    • 2004
  • A new PIV technique was developed for decreasing optical error which was created during simultaneous measurements of velocity fields at a wall-normal plane and wall-parallel plane by a plane PIV and a Stereo-PIV systems. For experimental study, two different Reynolds number based on momentum thickness, Re$_{ =514 and 934 were generated in a blowing type wind tunnel under the condition of zero pressure gradient. The two Nd:Yag laser systems and three CCD cameras were synchronized. to obtain instantaneous velocity fields at the same time. To avoid optical noise at the crossing line by the two laser light sheets, a new optical arrangement using polarization was applied. The obtained velocity fields show the existence of hairpin packet structure vividly and the idealized hairpin vortex signature is confirmed by experiment.

  • PDF

Understanding β-Hairpin Formation: Computational Studies for Three Different Hairpins

  • Lee, Jin-Hyuk;Shin, Seok-Min
    • Bulletin of the Korean Chemical Society
    • /
    • 제29권4호
    • /
    • pp.741-748
    • /
    • 2008
  • We have studied the folding mechanism of $\beta$ -hairpins in the proteins 1GB1, 3AIT and 1A2P by conducting unfolding simulations at moderately high temperatures. The analysis of trajectories obtained from molecular dynamics simulations in explicit aqueous solution suggests that the positions of the hydrophobic core residues lead to subtle differences in the details of folding dynamics. However, the folding of three different hairpins can be explained by a unified mechanism that is a blend of the hydrogen-bond-centric and the hydrophobiccentric models. The initial stage of $\beta$-hairpin folding involves various partially folded intermediate structures which are stabilized by both the van der Waals interactions of hydrophobic core residues and the electrostatic interactions of non-native hydrogen bonds. The native structure is obtained by forming native contacts in the final tune-up process. Depending on the relative positions of the hydrophobic residues, the actual mechanism of hairpi n folding may or may not exhibit well-defined intermediates.

A Miniaturized Aperture-Coupled Multilayer Hairpin Bandpass Filter

  • Moon, Han-Ul;Choi, Seung-Un;Yun, Sang-Won
    • Journal of electromagnetic engineering and science
    • /
    • 제8권1호
    • /
    • pp.12-16
    • /
    • 2008
  • In this paper, we introduce a coupling, which is achieved through the aperture instead of the conventional edge coupling, so that the bandpass filter is reduced less than half in size compared to conventional planar type. The resulting filter configuration has a near two-fold symmetry, where the aperture coupling is used in the middle of the coupling stages. We designed a bandpass filter using two tapped hairpin resonators, of which the order becomes four. The designed bandpass filter has the size of $8.9{\times}18.3\;mm$. It has the return loss better than 17dB and the insertion loss of less than 5 dB in overall passband. The measured results show good agreements with simulated ones.

새로운 헤어핀 타입 대역통과필터 (New Hairpin Type Bandpass Filter (BPF))

  • 채동규;김동현;임문혁;윤기완
    • 한국정보통신학회:학술대회논문집
    • /
    • 한국해양정보통신학회 2003년도 춘계종합학술대회
    • /
    • pp.457-459
    • /
    • 2003
  • 테플론을 기반으로 기존의 interdigital 타입 공진기를 발전시킨 대역통과필터가 설계, 측정 및 시뮬레이션 결과와 비교되었다. 제안한 필터의 중심 주파수는 12 GHz이고 저가, 저손실의 장점이 있으며 크기는 34 mm $\times$ 10 mm이다.

  • PDF