• Journal of Bio-Environment Control
• /
• v.31 no.4
• /
• pp.438-443
• /
• 2022

In this study, the lateral loading test was performed to analyze structural performance of multi-span plastic greenhouse through full-scale experiment and numerical analysis. In order to analyze the lateral stiffness and stress, we installed 9 displacement sensors and 19 strain gauge sensors on the specimen, respectively, and load of l mm per minute was applied until the specimen failure. In the comparison between the full-scale experiment and the structural analysis results of a multi-span greenhouse with venlo-type roof according to bracing installation, there was a large difference in the lateral stiffness of the structure. By installing a brace system, the lateral stiffness measured near the side elevation of the specimen increased by up 44%. As the bracing joint used in the field did not secure sufficient rigidity, the external force could not be transmitted to the entire structure properly. Therefore, it is necessary to establish a bracing construction method and design standards in order for a greenhouse to which bracing applied to have sufficient performance.

• Korean Chemical Engineering Research
• /
• v.50 no.4
• /
• pp.654-658
• /
• 2012

In this study, $CO_2$ capture efficiency in relation to the inlet moisture content of the regenerator was investigated using potassium-based sorbents in the continuous process composed of two bubbling fluidized-bed reactors, where solid outlet configuration in the regenerator was converted from underflow to overflow. XRD (X-ray Diffraction), SEM (Scanning Electron Microscope) and TGA were performed to find out the effect of water pre-treatment according to inlet moisture content in the regenerator. The $K_2CO_3{\cdot}1.5H_2O$ structure of solid sorbents has been increased as inlet moisture content of the regenerator increased. As a result, the $CO_2$ capture efficiency increased as the $K_2CO_3{\cdot}1.5H_2O$ structure of solid sorbents increased since the reactivity of the sorbents has been improved by that structure generated by the water pre-treatment. And $CO_2$ capture efficiency increased about 3~8% after sorbent outlet configuration of the regenerator was changed underflow to overflow.

• Journal of Bio-Environment Control
• /
• v.23 no.2
• /
• pp.148-157
• /
• 2014

The purpose of this study was to investigate greenhouse maintenance by farms by looking into greenhouses across the nation for greenhouse specification, disaster-resistance greenhouse construction, types and degree of damage due to natural disasters, pre-inspection in case of typhoon or heavy snow forecast, and fire-fighting facilities to prevent a fire. The findings were summarized as follows: as for greenhouse specification, the highest proportion of them were 90 m or longer both in single- and multi-span greenhouses in terms of length; 8 m or wider and 7.0~7.9 m in single- and multi-span greenhouses, respectively, in terms of width; 1.5~1.9 m and 2.0~2.9 m in single-and multi-span greenhouses, respectively, in terms of height; and 3.0~3.9 m and 6 m in single- and multi-span greenhouses, respectively, in terms of diameter. As for disaster-resistance greenhouses, farmers were reluctant to install such greenhouses. The low distribution of disaster-resistance greenhouses was attributed to the greenhouses built dependent on the old practice, the greenhouses already completed, and relatively high construction costs. As for damage by natural disasters, greenhouses were subject to more damage by typhoons than heavy snow. They mainly inspected the ceiling and side windows, entrances, and fixation bands for covering materials in case of typhoon forecast and the heating devices in case of heavy snow forecast. As for repair methods for greenhouse pipe corrosion, they preferred partial replacement to painting and did not use stiffeners for structures to prevent a natural disaster in most cases. As for the maintenance of greenhouse covering materials, most farmers inspected their sealing property but did not clean the coverings for light transmission. The destruction of structural materials can be prevented by eliminating greenhouse covering materials during a typhoon, but they were not able to do so because of the covering material replacement costs and the crops they were growing. The study also examined whether greenhouse farms had fire-fighting facilities to prevent a fire and found that they lacked the perception of greenhouse fire prevention to a great degree.

• Journal of Bio-Environment Control
• /
• v.18 no.3
• /
• pp.192-199
• /
• 2009

This study was conducted to find proper structural reinforcement methods for the 4.5m-high (eaves height) 1-2W type plastic greenhouse. 3D finite element analysis was used to analyze the steel-tube structure. The 4.5m-high 1-2W type plastic greenhouse was modified by welding 1.5m-long steel-pipes into a 3.0m-tall columns of the standard 1-2W type plastic greenhouse. This remodeling method is widely used in Korea with farmer's discretion to increase the production when they grow paprika. But it is not based on the quantitative structural analysis. The proposed reinforcement methods were proved to stand against the design wind velocity of $40m{\cdot}s^{-1}$ and snow depth of 40cm. It strongly implies that the cross beam between side columns and wind resistance walls, and the lattice type cross beam should be good reinforcements to improve the structural safety of the elevated eaves height plastic greenhouse.

• Journal of Bio-Environment Control
• /
• v.29 no.4
• /
• pp.473-479
• /
• 2020

In this study, the structural experiment was conducted with two types of specimens to investigate the mechanical behavior of the column-rafter-purlin connection of an arch-type greenhouse under monotonic loading. Based on the experimental results, the flexural performance was analyzed for two types of connections, and connection classification was attempted. Type B showed 77% of flexural performance compared to Type A, and both types showed that the rigidity and flexural strength did not reach the level of the full rigid. The behavior of the column-rafter-purlin connection was dominated by local buckling due to deformation of the weld and fasteners. As a result of connection classification by AISC standard, both Type A and B connections showed a result that did not meet the rigid connection performance assumed during design, and were classified as simple connection. Therefore, the connection performance evaluation and classification results show that the greenhouse design should be made in consideration of connection performance and in order to design a reliable greenhouse structure, a study on establishing clear design standards for the greenhouse connection is necessary.

• Journal of Bio-Environment Control
• /
• v.14 no.3
• /
• pp.166-173
• /
• 2005

This study was carried out to evaluate the structural stability in a non-heating greenhouse with a single cover for Citrus cultivation which was built up in Jeju on the basis of the drawing designed by Jejudo Agricultural Research & Extension Services and also to make use of the data for developing a standardized non-heating greenhouse in Jeju. The analysis of a structural stability was conducted by using CFX-5.7 and ANSYS under the design condition of a maximum accumulated snow-depth of 19.1 cm as well as an instantaneous maximum wind velocity of $36.6\;m{\cdot}s^{-1}$ which was set up on the basis of meteorological statistics in Jeju. As a result, the maximum von-Mises stress applied on pipes under the wind velocity of $36.6\;m{\cdot}s^{-1}$ showed a value of $250\;N{\cdot}mm^{-2}$ which was greater than the allowable stress of the pipe with a value of $235.4\;N{\cdot}mm^{-2}$ (=$2,400\;kg{\cdot}cm^{-2}$) and also $53.8\;N{\cdot}mm^{-2}$ under the snow-depth of 19.1 cm, respectively. This result suggested that the greenhouse be unstable under the design condition of an instantaneous wind velocity of $36.6\;m{\cdot}s^{-1}$ so that it was necessary for the greenhouse to be reinforced to secure the structural stability.

• Journal of Climate Change Research
• /
• v.9 no.2
• /
• pp.181-195
• /
• 2018

On December 12, 2015, the Conference of the Parties to the United Nations Framework Convention on Climate Change (UNFCCC) adopted the Paris Agreement, in which several developed and developing countries all committed to participating in the reduction of greenhouse-gas (GHG) emissions. South Korea has submitted an intended nationally determined contribution (INDC) proposal with a target to cut down 37% greenhouse gas business as usual (BAU) until 2030 in preparation for the 2030 GHG BAU. Under the post-2020 regime, which will be launched from 2021 as the agreement entered into force early, it is expected that efforts to support GHG reduction and adaptation to climate change in developing countries will be accelerated with the utilization of technologies and financial resources of developed countries. South Korea has established the Basic Plan for Climate Change Response and the Basic National Roadmap for Greenhouse Gas Reductions by 2030 to promote the response to climate change at the government level. The Ministry of Science and ICT, as the National Designated Entity designated by the UNFCCC, has come up with middle and long-term strategies for climate technology cooperation. South-Korea has an abundance of energy-consuming industries to support its export-oriented industrial structure; it is thus expected that achieving the GHG reduction target will incur a considerable cost. Moreover, in order to meet the reduction target (11.3%) of the intended nationally determined contribution proposed by South Korea, it is necessary for South Korea to actively promote projects that can achieve GHG reduction achievements, and financial resources are needed as leverage to reduce risks that can occur in the early stages of projects and attract private sector investment. This paper summarizes the theoretical discussions on climate finance and conducted a comparative analysis on the status of the funds related to climate change response in the UK, Germany, Japan and Denmark. Through this, we proposed the legal and policy tasks that should be carried forward to raise public funds that can be used for creation of new industries related to climate change as well as to reduce GHG emissions in South Korea. The Climate Change Countermeasures Act, which has been proposed by the National Assembly of South-Korea, stipulates the establishment of funds but there is no additional funding except for general account. In this regard, it is also possible to take measures such as the introduction of carbon tax or the collection and use of royalties through technology research and development projects for climate change, such as Industrial Technology Innovation Promotion Act. In addition, since funds are used in various fields such as domestic greenhouse gas reduction, technology development, and overseas projects, it is necessary to establish a system in which various ministries cooperate with the operation of the fund.

• Korean Journal of Soil Science and Fertilizer
• /
• v.40 no.1
• /
• pp.4-11
• /
• 2007

There have been increasing concerns about decreasing crop productivity due to salt accumulation in greenhouse soils. The objective of the study was to investigate the impact of rice straw and woodchip application to a salt accumulated greenhouse soil on crop productivity and soil quality. The application of rice straw (RS) and woodchip (W) increased tomato yield and decreased blossom-end rot, and increased yield of Chinese cabbage compared with standard recommended fertilization ($204-103-122kg\;ha^{-1}\;N-P_2O_5-K_2O$ for tomato and $222-64-110kg\;ha^{-1}\;N-P_2O_5-K_2O$ for Chinese cabbage), while less soil residual nitrate, phosphatephosphorus, and potassium. In addition to the organic material application, fertilization reduction based on soil testing may also contribute to relatively low level of soil residual nutrients. Application of the organic material reduced soil bulk density presumably because of improved soil aggregation and structure, and increased biomass C and dehydrogenase activity. In comparison to rice straw, woodchip application resulted in higher crop yield, less amount of soil residual nitrate and lower soil EC, and greater biomass and dehydrogenase activity. The results obtained in this study indicateshowed that woodchip amendment along with reduced fertilization based on soil testing can be one of essential management practices for salt accumulated greenhouse soils.

• Environmental and Resource Economics Review
• /
• v.31 no.1
• /
• pp.113-139
• /
• 2022

The iron and steel industry is a manufacturing industry with the largest greenhouse gases emissions and has a great ripple effect on the national economy as a core material industry. This study internationally compared the decoupling patterns of greenhouse gases emissions in the iron and steel industry from 1990 to 2019, focusing on Korea, Japan, and Germany. In particular, unlike previous studies that considered only fuel combustion emissions, this study considered all fuel combustion emissions, industrial process emissions, and indirect emissions from the use of electricity and heat. As a result of the analysis, Korea is interpreted as expansive coupling, Japan as decoupling, and Germany as unclear. Therefore, the decoupling path that the Korean iron and steel industry should take should not be in Germany, but in the form of seeking a decoupling method similar to Japan or more effective than Japan. In addition, this study considered the characteristics of the iron and steel industry as much as possible and presented the causes of the decoupling analysis results and implications for the Korean iron and steel industry through comparison with Japan and Germany. In particular, four factors were suggested as factors which has promoted decoupling in Japan: high value-added of Japanese iron and steel products, development of energy efficiency technology in the Japanese iron and steel industry, strategic M&A of the Japanese iron and steel industry, and maintaining competitiveness according to the closed distribution structure of Japanese iron and steel products. The Korean iron and steel industry should also use the case of Japan as a benchmark to further increase added value through quality uprade and product diversification of iron and steel products, while at the same time making efforts to fundamentally reduce greenhouse gas emissions through the development of new technologies.

• Proceedings of the Korean Society for Bio-Environment Control Conference
• /
• 1994.05a
• /
• pp.88-91
• /
• 1994

최근 국내에서도 시설원예가 급격하게 보급되고 있는 실정이다. 하지만, 시설원예가 에너지 소비형의 농경방식이라 지적되고 있는바 에너지절약형 온실의 개발이 필요할 것으로 판단되어, 본 실험실에서는 본 연구와 관련하여 비닐하우스의 벽체를 이중으로 하여 이중벽사이에 단열입자를 송풍기의 케이싱내로 직접 통하게하는 직송방식으로 충전ㆍ회수하는 실험을 실시한 바가 있으며, 그 결과 외기온의 평균이 -4.9$^{\circ}C$인 겨울철 야간에 입자를 충전한 이중비닐 하우스의 내부온도는 평균 9.8$^{\circ}C$로 단열성이 우수함을 알 수 있었다.(중략)