• Proceedings of the KIEE Conference
• /
• 1997.07a
• /
• pp.100-103
• /
• 1997

Korea Electric Power Corporation (KEPCO) started a fuel cell project to develop alternative sources of electric power because of the rapid increase in power demand and global environmental problems. For the development of a molten carbonate fuel cell (MCFC), KEPCO started the project in 1993 to develop a 2 kW MCFC system and finished it at the end of 1996. In this project, $ASPEN^+$ was utilized to design the 2 kW MCFC generation system. Based on this simulation, a power generation system was designed and installed for operation and a long term test of internally manifolded 2 kW class MCFC stack. This stack has 20 cells with an effective electrode area of $1000\;cm^2$. It was run at 0.84 V and $150\;mA/cm^2$ and was operated for more than 3,250 hours continuously. This paper describes the system configuration and its control and measurement units. An analysis of the stack performance, the effect of gas utilization ratio, and the stack performance requirements are also discussed.

• Journal of Positioning, Navigation, and Timing
• /
• v.3 no.3
• /
• pp.107-116
• /
• 2014

When an incoming Global Positioning System (GPS) signal is acquired, pull-in search performs a finer search of the Doppler frequency of the incoming signal so that phase lock loop can be quickly stabilized and the receiver can produce an accurate pseudo-range measurement. However, increasing the accuracy of the Doppler frequency estimation often involves a higher computational cost for weaker GPS signals, which delays the position fix. In this paper, we show that the Doppler frequency detectable by a long coherent auto-correlation can be accurately estimated using a complex-weighted sum of consecutive short coherent auto-correlation outputs with a different Doppler frequency hypothesis, and by exploiting this we propose a noise resistant, low-cost and highly accurate Doppler frequency and phase estimation technique based on a reverse directional application of the finite rate of innovation (FRI) technique. We provide a performance and computational complexity analysis to show the feasibility of the proposed technique and compare the performance to conventional techniques using numerous Monte Carlo simulations.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.3
• /
• pp.625-630
• /
• 2014

The amount of information is increasing rapidly with the development of the internet and the computer. Since these enormous information is managed by the document forms, it is necessary to search and process them efficiently. The document clustering technique which clusters the related documents through the similarity between the documents help to classify, search, and process the large amount of documents automatically. This paper proposes a method to find the initial seed points through principal component analysis when the documents represented by vectors in the feature vector space are clustered by K-means algorithm in order to increase clustering performance. The experiment shows that our method has a better performance than the traditional K-means algorithm.

• Journal of Astronomy and Space Sciences
• /
• v.33 no.4
• /
• pp.335-344
• /
• 2016

Scientific CubeSat with Instruments for Global Magnetic Fields and Radiations (SIGMA) is a 3-U size CubeSat that will be operated in low earth orbit (LEO). The SIGMA communication system uses a very high frequency (VHF) band for uplink and an ultra high frequency (UHF) band for downlink. Both frequencies belong to an amateur band. The ground station that communicates with SIGMA is located at Kyung Hee Astronomical Observatory (KHAO). For reliable communication, we carried out a laboratory (LAB) test and far-field tests between the CubeSat and a ground station. In the field test, we considered test parameters such as attenuation, antenna deployment, CubeSat body attitude, and Doppler frequency shift in transmitting commands and receiving data. In this paper, we present a communication performance test of SIGMA, a link budget analysis, and a field test process. We also compare the link budget with the field test results of transmitting commands and receiving data.

• The KIPS Transactions:PartC
• /
• v.18C no.6
• /
• pp.405-412
• /
• 2011

Our proposed mobility management scheme is based on Multicasting and HIP(Host Identity Protocol) in PMIPv6(Proxy Mobile IPv6) Networks, and allows users to handoff within and across different administrative domains. The main advantage of our scheme is to enable the inter-domain handoff of both types of nodes with a reduced signalling overhead and packet losses. Specifically, the scheme enables the interworking between host-based and network-based mobility support, by means of the interaction between PMIPv6 with Multicasting and HIP. Performance evaluations demonstrate that our scheme improves the handoff latency and packet losses compared to other global mobility management protocols.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2011.04a
• /
• pp.397-400
• /
• 2011

MDO Optimization for a low pressure axial compressor rotor has been carried out to improve aerodynamic performance and structural stability. Global optimized solution was obtained from an artificial neural network model with genetic algorithm. Optimized rotor model has a high blade loading near hub and near zero incidence flow angle near tip region to reduce the incidence loss and flow separation at trailing edge region. Also the rotor shape is converged to a trapezoid shape to reduce the maximum stress occurred at the root of the blade. Numerical simulation results show that rotor has 87.6% rotor efficiency and safety factor over than 3.

• Journal of Positioning, Navigation, and Timing
• /
• v.11 no.4
• /
• pp.245-250
• /
• 2022

As location-based services using the Global Navigation Satellite System (GNSS) are diversified, concerns about the vulnerability of GNSS to radio disturbance and deception are also growing. Accordingly, countries that own and operate GNSS, such as the United States, Russia, and Europe, are also developing additional navigation systems that can compensate for GNSS' weaknesses. Among them, an R-Mode system that transmits navigation signals using an infrastructure that transmits differential GNSS (DGNSS) information using signals from the medium frequency band currently in operation is being developed in Europe and Korea. Since 2020, Korea has improved four DGNSS transmission stations, including Chungju, Eocheongdo, Palmido, and Socheongdo, to transmit R-Mode signals and test navigation performance in some parts of the West Sea. In this paper, we intend to establish a testbed for measuring the distance of R-Mode signals currently being transmitted and analyze the results. It is confirmed that the distance measurement performance varies depending on the antenna type, diurnal variation, and propagation path of the signal.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.44 no.4
• /
• pp.177-185
• /
• 2021

Over the past 40 years, Korea's defense industry has been deepening into a low-efficiency industrial structure as the government directly controls prices, quantities, and costs. By implementing the Defense Industry Building Act in 2021, the government is creating a healthy ecosystem for the defense industry and strengthening its global competitiveness. In this study, based on KPC's Productivity Management System (PMS), a diagnostic model of defense companies implemented since 2013, the on-site diagnosis was performed from 4 to 28 days depending on the size of the company data was collected based on the results. The causal relationship was analyzed through structural equation model path analysis for the effect of innovation capability on productivity performance. As a result, it suggests that defense materials suppliers should focus on which core processes to innovate and strengthen and improve their innovation capabilities.

• The Journal of Asian Finance, Economics and Business
• /
• v.9 no.8
• /
• pp.81-88
• /
• 2022

For each country, the growth of the country is significantly associated with the growth of the manufacturing industry. Especially in the early stages of development, the manufacturing industry has greatly played a great role in creating great added value for society and economic development in that country. Starting from a country with a weak manufacturing background, Vietnam is gradually opening up and integrating into the global economy, which has brought many opportunities for manufacturing enterprises in particular and the enterprise community in general, making Vietnam one of the countries with large production activities in Southeast Asia and Asia. The study evaluates the factors affecting the financial performance of manufacturing enterprises through a case study in Hanoi, Vietnam. Using a survey sample of 235 enterprises operating in production and using quantitative analysis methods, the research results show that: Enterprises with high governance quality are enterprises with high economic efficiency or enterprises with low management capacity have low business efficiency. Moreover, large-scale enterprises often have many advantages in seeking profits and improving business efficiency. Finally, the study has some recommendations to improve corporate governance and growth, create a stronger business community and contribute more to Vietnam's economic development.

• International conference on construction engineering and project management
• /
• 2022.06a
• /
• pp.599-607
• /
• 2022

Recently, there has been a steady decrease in the proportion of the construction sector among Korean engineering firms. Thus it is essential for Korean engineering firms in the construction sector, which lack experience in overseas ventures, to identify and improve their competitiveness for successful overseas expansion. Therefore, in this study, changes in Korean engineering firms' capabilities for the last decade were analyzed to promote entry into overseas road and water resource engineering markets. Competency factors that require urgent improvement were derived based on Importance-Performance Analysis (IPA) as a tool for quantitative measurement. As a result, the factor that shows low performance compared to the importance is an overall understanding of the target country in the road and water resource areas. Knowledge of regulatory issues on design, the ability of time management software, and knowledge of the regulatory problems on construction safety are also insufficient. This study can be used as a research methodology to identify competitiveness that Korean engineering firms have to strengthen when they advance into overseas markets in roads, water resources, and other areas.