• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39A no.6
• /
• pp.350-356
• /
• 2014

In this paper, we design a local signal to improve a tracking performance of time-multiplexed binary offset carrier (TMBOC) signal, which was adopted in modernized global positioning systems (GPS). Specifically, considering that TMBOC signal includes BOC(6,1) components, we first obtain local signal by evenly dividing sub-carrier of TMBOC(6,1,4/33) by the period of a BOC(6,1) pulse. Finally, we remove side-peaks of TMBOC(6,1,4.33) autocorrelation via combination of partial correlations given from designed local signal and solve the ambiguity problem. From numerical results, when performing signal tracking using the designed local signal, we demonstrate that the improved tracking error standard deviation (TESD) performance is offered as compared its autocorrelation and the conventional correlation functions.

• The Journal of Korea Robotics Society
• /
• v.7 no.3
• /
• pp.205-215
• /
• 2012

A GPS sensor is widely used in many areas such as navigation, or air traffic control. Particularly, the car navigation system is equipped with GPS sensor for locational information. However, when a car goes through a tunnel, forest, or built-up area, GPS receiver cannot get the enough number of satellite signals. In these situations, a GPS receiver does not reliably work. A GPS error can be formulated by sum of bias error and sensor noise. The bias error is generated by the geometric arrangement of satellites and sensor noise error is generated by the corrupted signal noise of receiver. To enhance GPS sensor accuracy, these two kinds of errors have to be removed. In this research, we make the road database which includes Road Database File (RDF). RDF includes road information such as road connection, road condition, coordinates of roads, lanes, and stop lines. Among the information, we use the stop line coordinates as a feature point to correct the GPS bias error. If the relative distance and angle of a stop line from a car are detected and the detected stop line can be associated with one of the stop lines in the database, we can measure the bias error and correct the car's location. To remove the other GPS error, sensor noise, the Kalman filter algorithm is used. Additionally, using the RDF, we can get the information of the road where the car belongs. It can be used to help the GPS correction algorithm or to give useful information to users.

• Korean Journal of Remote Sensing
• /
• v.37 no.5_3
• /
• pp.1349-1359
• /
• 2021

Acquisition of precise position and velocity information of GNSS-INS (Global Navigation Satellite System; Inertial Navigation System) sensors in obtaining SAR SLC (Single Look Complex) images from raw data using BPA (Backprojection Algorithm) was regarded decisive. Several studies on BPA were accompanied by Kalman Filter for sensor noise oppression, but often implemented once where insufficient information was given to determine whether the filtering was effectively applied. Multiple operation of Kalman Filter on GNSS-INS sensor was presented in order to assess the effective order of sensor noise calibration. FMCW (Frequency Modulated Continuous Wave)-SAR raw data was collected from twice airborne experiments whose GNSS-INS information was practically and repeatedly filtered via Kalman Filter. It was driven that the FMCW-SAR raw data with diverse path information could derive different order of Kalman Filter with optimum operation of BPA image restoration.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.33 no.5
• /
• pp.343-351
• /
• 2015

It is well-known that even the DGNSS (Differential Global Navigation Satellite System) technique in navigation for ground vehicles can only provide several meters of accuracy, such that it is suitable for simple guidance. On the other hand, centimeter to millimeter level accuracy can be obtained by using carrier phase observables in the field of precision geodesy/surveying. In this study, a preliminary study was conducted to apply NRTK (Network-RTK) by NGII (National Geographic Information Institute) to ground vehicle navigation. Onboard GNSS receivers were used for NRTK throughout the country, and the applicability of NRTK on navigation was analyzed based on NRTK surveying results. The analysis shows that the overall ambiguity fixing rate of NRTK is high and is therefore possible to apply it for navigation. In urban areas, however, the fixing rate decreases sharply, therefore, it needs to employ a method to minimize the effect of the float solutions, which can reach up to 10 meters. It is still feasible to obtain a centimeter level of accuracy in some area using NRTK under certain conditions. But, the ambiguity fixing rate of FKP falls down to 55% for high speed vehicles, and so the surveying accuracy should be determined by considering various factors of surveying environments. In addition, it is difficult to fix ambiguities using single-frequency GPS receivers. Finally, several suspicious NRTK(FKP) connection problems occurred during atmospheric disturbances (phase two or up), which should be investigated further in upcoming research.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.12A
• /
• pp.1225-1232
• /
• 2008

In this paper, we describe a compensation method of diurnal effect which is one of the factors giving large effect on the performance when using ground-wave signals like Loran-C for a backup and substitute navigation system of global satellite navigation system such as GPS, and currently many researches of the topics are doing in USA and in Europe. In order to compensate diurnal effect, we find periodic frequency components by using the Least Square Spectral Analysis (LSSA) method at first and then compensate the effect by subtracting the estimated compensation signal, obtained by using the estimated amplitude and phase of the individual frequency component, from the original signal. In this paper, we propose a simple compensation algorithm and analysis the performance through simulations. From the results, it is observed that the amplitude and phase can be estimated with under 5 % and 0.17 % in a somewhat poor receiving situation with 0 dB Signal to Noise Ratio (SNR). Also, we analyze the obtainable performance improvement after compensation by using the measured Loran-C data. From the results, it is observed that we can get about 22 % performance improvement when a moving average with 5 minutes interval is employed.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.7C
• /
• pp.724-729
• /
• 2009

Binary offset carrier (BOC) signal synchronization is based on the correlation between the received and locally generated BOC signals. Thus, the multiple side-peaks in BOC autocorrelation are one of the main error sources in synchronizing BOC signals. Recently, new correlation functions with no side-peak were proposed for sine and cosine phased BOC signal synchronization, respectively, by the authors [3]. In this paper, we propose a new correlation function with no side-peak for composite BOC (CBOC) signals by using the similar approach to that in the previous work.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.35 no.5
• /
• pp.339-348
• /
• 2017

Due to recent improvements in computer processing speed and image processing technology, researches are being actively carried out to combine information from a camera with existing GNSS (Global Navigation Satellite System) and dead reckoning. In this study, the mathematical model based on SPR (Single Photo Resection) is derived for image-based assistant algorithm for vehicle positioning. Simulation test is performed to analyze factors affecting SPR. In addition, GNSS/on-board vehicle sensor/image based positioning algorithm is developed by combining image-based positioning algorithm with existing positioning algorithm. The performance of the integrated algorithm is evaluated by the actual driving test and landmark's position data, which is required to perform SPR, based on simulation. The precision of the horizontal position error is 1.79m in the case of the existing positioning algorithm, and that of the integrated positioning algorithm is 0.12m at the points where SPR is performed. In future research, it is necessary to develop an optimized algorithm based on the actual landmark's position data.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.61 no.10
• /
• pp.1483-1488
• /
• 2012

This paper analyzed the precision and accuracy of the altitude-aided GNSS using the altitude information from digital map. The precision of altitude-aided GNSS is analysed using the theoretically derived DOP. It is confirmed that the precision of altitude-aided GNSS is superior to the general 3D positioning method. It is also shown that the DOP of altitude-aided GNSS is independent of altitude bias error while the accuracy was influenced by the altitude bias error. Furthermore, it is shown that, since the altitude bias error influenced differently to each pseudorange measurement, the effect of the altitude bias error is more serious than clock bias error which does not influence position error at all. The results are evaluated by the simulation using the commercial RF simulator and GPS receiver. It confirmed that altitude-aided GNSS could improve not only precision but also accuracy if the altitude bias error are small. These results are expected to be easily applied for the performance improvement to the land and maritime applications.

• Journal of Institute of Control, Robotics and Systems
• /
• v.18 no.4
• /
• pp.391-399
• /
• 2012

Multipath remains a dominant source of ranging errors in GNSS (Global Navigation Satellite System). And it is generally considered undesirable in the context of GNSS, since the reception of multipath can make significant distortion to the shape of the correlation function. In this paper, therefore, the model of the distorted shape of the correlation function is formulated and a MBME (Model-Based Multipath Estimation) technique for GPS L1/L5 receivers is proposed in order to estimate the parameters of the indirect signal such as the amplitude and the delay. The MBME technique does not require the any hardware modifications and it can estimate the parameters for both the short and long-delay multipath. Especially, it would be the very effective technique for the short-delay multipath if the L5 signal is available. Finally, the feasibility of the proposed technique has been confirmed by simulation results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.11
• /
• pp.970-972
• /
• 2013

Signal acquisition performance is evaluated for the tiered polyphase code (TPC) which is proposed as a ranging signal structure for global navigation satellite systems (GNSSs). Compared to the tiered code (TC) which is adopted in European Union's GALILEO system, the TPC shows robust performance to frequency offset in acquiring signal. Therefore the TPC should have SNR gain in signal acquisition and can reduce computational complexity in the receiver. In this paper, we compare the signal detection probability of the TC and TPC under the same receiver architecture and GALILEO E5a-I signal parameters.