• Economic and Environmental Geology
• /
• v.9 no.1
• /
• pp.1-11
• /
• 1976

It is believed that geological survey, drilling and geophysical survey which was carried out on Tertiary deposits in Pohang is a valuable but through the studying of many Tertiary sediments in Japan discovered many questions on analysis of final report prepared by National geological survey. The main reason is: 1. The seismic sound velocity which have regulated in the final report prepared by geological survey for Tertiary deposits in Pohang was 1,500-2,000m/sec in spite of oil bearing sediments of same age in Japan are 2,000-3,800m/sec. These may means the requirement of reconsideration of seismic velocity for Tertiary deposits in Pohang and required to have a dipper drilling. 2. Stratigraphically, geophysically, and paleontologically, the Tertiary deposits in Pahang land area is similar with that of Nishiyama-Hunakawa formations of Akita oil field in Japan. Nishiyama-Hunakawa formation is the main oil bearing formation in Japan. 3. Those valcanic rock including andestitic rock and liparitic rock which have extensively distributed over either at land area or at sea bottom, assumed by geological survey as the base of Tertiary sediments. But in case of Japan many oil bearing deposits are in over laid by these kind of volcanic rock. Therefore a possible of same condition with Japan is presumable on Tertiary sediments in Pohang. 4. It is believed that the Tertiary sediments of land area in Pohang is the extension of offshore basin but is wandering that the final report submitted by geologic survey have not remain any word on report of ECAFE discribed so much problematics as followed: A. Although it was assumed that no great thickness exceeding 1,000 meters, or major structures would be encountered in the Tertiary offshore sequence, it was hoped that shallow hydrocarbon deposits might be found, because these sediment are lithologically similar to those of the same age in the producing area of the northwest Honshu region of Japan where hydrocarbon are extracted from depths of only 500 to 600 meters. B. Four possible hydrocarbon trap conditions are represented in the survey area: anticlinal folds, faults, pinch outs, along the igneous basement and lateral facies changes. C. Most of the prime possible reservoir area are beyond the 50 meter water depth mark, except for the structures in Yonil Bay. D. Despite the shallowness of the offshore basin, sufficient trap condition exist in the area to warrant further exploration for hydrocarbon. 5. All of the problems mentioned above have gave us a strong reasons to have us hesitating to make a final conclusion on Tertiary problems in Pohang, before to have a drill to a depth to 3,000 meters or more whatever it is the Tertiary or a Mesozoics below 1,000 meters.

• Economic and Environmental Geology
• /
• v.25 no.1
• /
• pp.61-72
• /
• 1992

The Danyang area consists of the thrust and folded sedimentary rocks of Paleozoic and Mesozoic Era. The area is bounded by major tectonic units which are the Gagdong Thrust to the west and the Okdong Fault to the east. According to the structural analyses, the area is affected by polyphase deformation. This study establishes deformational sequence in the area. Mylonite zone along the Okdong Fault corresponds to the first generation of structures ($D_1$). $D_1$-structures are discrete shear zone in the Jangsan Formation and bedding parallel extensional deformation in the Cambro-Ordovician sequences. $D_2$-structures were formed prior to the sedimentation of the Jurassic Bansong Group, which are the NW-trending fold and linear structures. After sedimentation of the Bansong Group, the area is strongly affected by the Daebo Orogeny which produces NE-trending thrusts, folds and linear structures. Earlier structures were tightened and rotated toward NE. Some thrust faults did not propagate into the Bansong Group. It is suggested either the Bansong Group acted as a decoupling horizon or rest on unconformably on the thrust faults. The area is weakly affected by $D_4$-event of which structures are E-W trending folds and faults. The Jugryeong Fault clearly cut the earlier folds and thrust faults. The rocks within the fault zone were sliced and rotated during the strike-slip movements. Block rotation and transpressional features can be commonly observed.

• Journal of the Korean earth science society
• /
• v.34 no.3
• /
• pp.235-248
• /
• 2013

The purpose of this study is to investigate a feasibility of a small mountain as a field work site on geological features in Earth sciences classes at all levels. Mt. Geumdang with the height of 305 meters from the sea level is located in the metropolitan city of Gwangju, southern part of Korea. The study reviews the human and natural geography, geological features, geomorphic resources, landscapes, and conveniences of the mountain for a possibility of meaningful field work. The population within the distance of 5 km from the mountain stands at about 620,000 and 170,000 of them are students and teachers. Mt. Geumdang has a warm temperature climate with low rainfall throughout the year, so it seems suitable for a field survey. Road network and public transportation system around the area are well-developed and easily accessible. Mt. Geumdang shows various rock type and geological structures. The basement rock is Gwangju granite, which is plutonic body of the Jurassic period. Also, granophyre (micrographic granite) and various volcanic rocks distributed as bedded tuff, lapilli tuff, and rhyolite of the Cretaceous period. Many andesitic and felsic dykes were intruded into the rock by joint system. In Mt. Geumdang, many geomorphic resources are found such as U shaped mountain, joint, fault, lamination, gnamma, tor, cliff, groove, block stream and block field, regolith, and saprolite. It has a beautiful mountain scenery including the view of whole shape of Mt. Mudeung, panoramic view of the town, Pungam lake, World Cup stadium and sunrise and sunset. Furthermore, the area has ecologic study facilities related to geology, emergency medical and convenience facilities for field works. In conclusion, Mt. Geumdang is highly feasible for geological field studies at all levels.

• Spatial Information Research
• /
• v.10 no.2
• /
• pp.247-261
• /
• 2002

There are much damage of people and property because of heavy rain every year. Especially, there are problem to major facility such as dam, bridge, road, tunnel, and industrial complex in the ground stability. So the counter plan for landslide or ground failure must be necessary In the study, the technique of regional landslide susceptibility assessment near the Ulsan petrochemical complex and Kumgang railway bridge was developed and applied using GIS. For the assessment, the geological structures such as bedding and fault were surveyed and the geological structure, topographic, soil, forest, and land use spatial database were constructed using CIS. Using the spatial database, the factors that influence landslide occurrence, such as slope, aspect, curvature and type of topography, texture, material, drainage and effective thickness of soil, type, age, diameter and density of forest, and land use were calculated or extracted from the spatial database. For application of geological structure, the geological structure line and fault density were calculated. Landslide susceptibility was analyzed using the landslide-occurrence factors by probability method that is summation of landslide occurrence probability values per each factors range or type. The landslide susceptibility map can be used to assess ground stability to protect major facility.

• The Journal of the Petrological Society of Korea
• /
• v.20 no.2
• /
• pp.115-135
• /
• 2011

Fe-Ti ore bodies and mafic granulite occur in the Sancheong anorthosites, south Korea. In order to determine their petrogenetic relationship and to classify the Fe-Ti ore bodies, we have synthetically analyzed characteristics in the field, such as distribution and occurrence, and petrologic features through detailed outcrop sketches. The ore bodies are divided into the regular vein dike- and irregular veinlet swarm types, according to their characteristics of contact with the anorthosites and internal structures. The former shows the tabularly intrusive contact and the pervasively ductile-sheared interior, while the latter, the irregularly tortuous contact and the almost intact interior. Most of the ore bodies are cross-cutting the foliation of the anorthosites and possess abundant anorthositic xenoliths, indicating their intrusion after the formation of foliation in the anorthosites. The mafic granulite, also bearing abundant anorthositic xenoliths, shows interior foliations nearly parallel to intrusion contact, and has abundant ilmenites approximately the same as those of the Fe-Ti ore bodies in chemical composition. And its intrusion into adjacent anorthosites is observed and the intrusion is finally changed into an irregular veinlet swarm type ore body. It is, thus, interpreted that the granulite in the study area was the host material of Fe-Ti ore bodies.

• Journal of the Korean GEO-environmental Society
• /
• v.14 no.4
• /
• pp.39-46
• /
• 2013

Recently, there have been various researches on the cost reduction and savings during the construction activities with the development of automation and computerized information system. Considering the cost savings during the construction, the development of the geological and geotechnical information system with high practical use becomes very important since the geologic and geotechnical data are required for the design of the various structures. Currently, the geological and geotechnical data are collected and distributed as a geological/geotechnical map or engineering geology map and map with other specific purpose through geoinfo system at Korea Institute of Geoscience and Mineral Resources, Korea Mineral Resources GIS at Korea Mineral Resources Corporation, Geotechnical Information Portal System at Korea Institute of Construction Technology, Geotechnical Information System at the City of Seoul and the Ocean Data Integration Material System at Korea Hydrographic and Oceanographic Administration. Furthermore, the information on the groundwater is monitored and collected via Integrated Ground Water Information Service at Korea Water Resources Corporation and Rural Groundwater net at Korea Rural Community Corporation. Therefore, in this study, the contents of the geological and geotechnical data collected from the above mentioned government organization are compared and the DB and distribution system with higher utilization are suggested based on the comparisons with those from other countries such as United States of America, Japan and Germany.

• Tunnel and Underground Space
• /
• v.32 no.6
• /
• pp.435-450
• /
• 2022

In step-by-step site selection for geological disposal of high-level radioactive waste, parameters necessary for site selection will be acquired through deep drilling surveys from the basic survey stage. Unlike site investigations of rock mass structures such as tunnels and underground oil storage facilities, those related to the geological disposal of high-level radioactive waste are not only conducted in relatively deep depths, but also require a high level of quality control. In this report, based on the 750 m depth drilling experience conducted to acquire the parameters necessary for deep geological disposal, the methodology for deep drilling and the geology, geophysics, geochemistry, hydrogeology and rock mechanics obtained before, during, and after deep drilling are discussed. The procedures for multidisciplinary geoscientific investigations were briefly described. Regarding in-situ stress, one of the key evaluation parameter in the field of rock engineering, foreign and domestic cases related to the geological disposal of high-level radioactive waste were presented, and variations with depth were presented, and matters to be considered or agonized in acquiring evaluation parameters were mentioned.

• The Journal of Engineering Geology
• /
• v.32 no.4
• /
• pp.449-466
• /
• 2022

The establishment of a complete geological model that includes information about all the various components at a site (such as underground structures and the compositions of rock and soil underground space) is difficult, and geological modeling is a developing field. This study uses commercial software for the relatively easy composition of geological models. Our digital modeling process integrates a model of Jeju Island's 3D geological information, models of cave shapes, and information on the state of a road at the site's upper surface. Among the numerous natural caves that exist in Jeju Island, we studied the Jaeamcheon lava tube near Hallim town, and the selected site lies below a road. We developed a digital model by applying the principles of building information modeling (BIM) to the cave (CaveBIM). The digital model was compiled through gathering and integrating specific data: relevant processes include modeling the cave's shape using a laser scanner, 3D geological modeling using geological information and geophysical exploration data, and modeling the surrounding area using drones. This study developed a global-scale model of the Hallim region and a local-scale model of the Jaeamcheon cave. Cross-validation was performed when constructing the LSM, and the results were compared and analyzed.

• The Journal of the Petrological Society of Korea
• /
• v.23 no.2
• /
• pp.105-117
• /
• 2014

The Ogcheon and Joseon Supergroups are distributed in the Bonghwajae area, Jecheon-si, Chungcheongbuk-do, Korea which is located in the northeastern fore-end of the Ogcheon Metamorphic Zone. This paper researched the geological structures based on the geometric and kinematic characteristics and the forming sequence of the major multi-deformed rock and microstructures. Most of regional foliations are not the S0 bedding but the S0-1 composite foliations defined by the preferred orientation of stretching minerals, some are recognized as the S0-1-2 composite foliations by the preferred orientation of insoluble opaque minerals and cleavage lamella. The geological structures were formed at least by three phases of deformations i.e. NNE-SSW trending D1, E-W trending D2, N-S trending D3 compressions. The S0-1 composite foliation, which shows a similar zone-distribution trend of the constitution strata of the Ogcheon and Joseon Supergroups, trended WNW before D2 deformation, but it was reoriented into N-S which was parallel to the trend of S2 foliation by D2 deformation, and it was rearranged into NW, NE, N-S trends as it is now by D3 deformation. The structural characteristics of each deformation phase and the deformation history are very similar to those in the eastern domain of Busan area into which the Ogcheon and Joseon Supergroups in this area are extended as NNW trend. It is expected to be very valuable data in interpreting the tectonic evolution of the northeastern fore-end of the Ogcheon Metamorphic Zone.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.36 no.5
• /
• pp.891-901
• /
• 2016

By comparing test blasting data experimented in three layered-structure polymorphic grounds to a geological profile, influence of blast vibration with respect to uncontrollable ground characteristics was analyzed. Inefficient blast have been performed without sufficient verifications or confirmations because insufficiencies with regard to experiments and data of blasting engineering on the layered structures to be irregularly repeated clinker layer consisted of volcanic clastic zones. It is difficult to quantify N values of clinkers within test blasting region because they have diverse ranges, or coverages. An absolute value of attenuation coefficient N in a field, estimated by blasting vibration predictive equation (SRSD), are lesser than criteria of a design instruction, meaning that vibrations caused by blast can spread far away, and the vibrational characteristics of blasting test No.1, indicating relatively small values, inferred by the geological profile, pressures of gas by the explosion may be lost into a widely distributed clinker layers by penetrating holes resulted from blast into vicinity of clinker layers located in bottom of soft rock layers at the moment of blast. As a result, amounts of spalling rocks are decreased by almost half. Also, ranges of primary frequencies in the fields are identified as similar to those of natural frequency of typical structures.