• The Korean Journal of Pain
• /
• v.1 no.1
• /
• pp.80-86
• /
• 1988

Caudal buprenorphine was investigated as a postoperative analgesic in a randominzed double blind study of 45 patients after abdominal surgery. At the end of surgery, patients were given 0.2 mg of caudal buprenorphine in 20 ml saline(n=30, experimental group) or no injection(n=15, control group). Pain relief was evaluated by the subsequent need for systemic analgesics(pethidine). Arterial blood gas and micturition disturbance were evaluated. In the buprenophine group, use of systemic analgesics was significantly reduced for the first 24 hours postoperatively. Arterial blond gas study values 2 hollers after buprenorphine administration were within normal range. 8 patients of the buprenorphine group developed urinary retention requiring temporary Nelaton catheterization of the bladder. Caudal buprenorphine for postoperative pain control was a good alternate method of postoperative pain management.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.22 no.2
• /
• pp.153-160
• /
• 1996

A novel simple method to detect vitamins in cosmetic products by gas chromatography-mass spectrometry(GC-MS) has been developed. Three vitamins(panthenol, cholecalciferol and tocopherol) were used for this study. Vitamins were prepared by dissolving in tetrahydrofuran(THF), and silylated with bis-trimethylsilyltrifluoroacetamide-trichloromethylsilane(BSTFA). Silated vitamins were separated on a fuses-silica capillary column coated with DB-5. The identification of each vitamin was accomplished by retention time and mass spectrum library search with a computer, and the quantitation was made in the selected-ion monitoring(SIM) mode of GC-MS. SIM mode had given sensitivity to determine 50pg of panthenol, 285pg of cholecalciferol and 130pg of tocopherol. Linearity was maintained over the range 0.005-0.20% for each vitamin. Each cosmetic product(i.e. hair tonic and lotion) was found to contain amounts of the vitamins. This method was sensitive and gave 77.5-99.9% recovery of each vitamin from these cosmetic products. From these results, we concluded that silylation with BSTFA followed by GC-MS analysis allows the simple, covenient and exact determination of panthenol, cholecalciferol and tocopherol.

• YAKHAK HOEJI
• /
• v.29 no.6
• /
• pp.375-379
• /
• 1985

The gas chromatographic behavior of optically active N-(N-benzoyl-L-valyl)-anilide used as stationary phase is described. N-(N-benzoyl-L-valyl)-anilide has been synthesized with good yield under mild condition via Schotten-Bauman process and coated on the Chromosorb W AW (80-100mesh) for the purpose of enantiomer separation. The behavior of this compound as optically active stationary phase for the separation of the enantiomers of N-TFA-D, L-amino acid isopropyl esters has been examined with respect to the correlation between the separation factors and column temperatures. All amino acid enantiomers examined were eluted within one hour and the elution pattern showed retention times increasing in the order of alanine, valine, leucine, threonine, proline and methionine.

• CELLMED
• /
• v.4 no.2
• /
• pp.11.1-11.6
• /
• 2014

Cinnamomum zeylanicum (C. zeylanicum) is a tropical evergreen tree of Lauraceae family. It is one of the oldest culinary spices known and used traditionally in many cultures for centuries. In addition to its culinary uses, cinnamon also possesses as a folk remedy of many health disease condition including analgesic, antiseptic, antispasmodic, aphrodisiac, astringent, carminative, haemostatic, insecticidal, and parasiticide and memory enhancing property. This study was aimed to assess the acetylcholinesterase and butyrylcholinesterase inhibitory activity of standardized methanol extract of the C. zeylanicum. Gas chromatography - mass spectrometry (GC-MS) and high performance liquid chromatography (HPLC) analysis were done to identify the presence of eugenol as chemical component and support the neuroprotective activity in the extract. Anticholinesterase inhibitory activity of crude methanol extract of C. zeylanicum leaves and cinnamon oil were evaluated by 96-well microtiter plate assay and thin layer chromatography bioassay detection methods. This study revealed that cinnamon oil ($IC_{50}:45.88{\pm}1.94{\mu}g/ml$) has better anticholinesterase activity than methanol extract ($IC_{50}:77.78{\pm}0.03{\mu}g/ml$). In HPLC analysis, retention time of eugenol in cinnamon oil was found to be 15.81 min which was comparable with the retention time (15.99 min) of the reference standard, eugenol. Seven chemical compounds were identified by GC-MS analysis, in which eugenol as an important phytoconstituents. Thus the phytochemicals from C. zeylanicum methanol leaves extract could be developed as potential source of anticholinesterase activity, with particular benefit in the symptomatic treatment of Alzheimer's disease.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.05c
• /
• pp.178-181
• /
• 2003

In this work, we etched PZT films with various additive gases ($O_2$ and Ar) in $Cl_2/CF_4$ plasmas, while mixing ratio was fixed at 8/2. After the etching, the plasma induced damages are characterized in terms of hysteresis curves, leakage current, retention properties, and switching polarization. When the electrical properties of PZT etched in $O_2$ or Ar added $Cl_2/CF_4$ were compared, the value of remanent polarization in $O_2$ added $Cl_2/CF_4$ plasma is higher than that in Ar. added plasma. The maximum etch rate of the PZT thin films was 145 nm/min for 30% Ar added $Cl_2/CF_4$ gas having mixing ratio of 8/2 and 110 nm/min for 10% $O_2$ added to that same gas mixture. In order to recover the ferroelectic properties of the PZT thin films after etching, we annealed the etched PZT thin films at $550^{\circ}C$ in an $O_2$ atmosphere for 10 min. From the hysteresis curves, leakage current, retention property and switching polarization, the reduction of the etching damage and the recovery via the annealing was turned out to be more effective when $O_2$ was added to $Cl_2/CF_4$ than Ar. X-ray diffraction (XRD) showed that the structural damage was lower when $O_2$ was added to $Cl_2/CF_4$. And the improvement in the ferroelectric properties of the annealed samples was consistent with the increased intensities of the (100) and the (200) PZT peaks.

• Environmental Sciences Bulletin of The Korean Environmental Sciences Society
• /
• v.10 no.S_1
• /
• pp.35-40
• /
• 2001

Effect of the addition of an enzyme/microbial additive(EMA) to enhance anaerobic digestion of the primary sludge was investigated. Two laboratory scale anaerobic digester were operated with primary sludge taken from a municipal wastewater treatment plant. The digester receiving EMA with the sludge feed performed better than the control digester, when both were operated at 10-days and 15-days Solid Retention Time(SRT). Addition of EMA to the experimental digester provided 7%(10-days SRT) and 16%(15-days SRT) higher gas production compared to the control digester when both were fed with the same amount of volatile solids. The reduction in volatile solids was 24% better in the experimental digester compared to the control ar 10-days SRT, and the improvement 10% at 15-day SRT. Improvement in COD reduction, and fecal coliform density reduction were also seen in the experimental digester due to EMA addition compared to the control both ar 10-days SRT and 15-day SRT operation. Preliminary cost benefit analysis for a wastewater treatment plant showed that approximately $115/day in gas production improvements can be realized upon addition of EMA to primary sludge anaerobic digesters operating at 10-day SRT. The value of increased gas production was $172/day if the same digesters are operated with EMA addition at 15-day SRT.

• Journal of Soil and Groundwater Environment
• /
• v.21 no.3
• /
• pp.14-20
• /
• 2016

Remediation of crude oil contaminated soil is complicate and hard to apply traditional methods because of its persistency, durability, and high viscosity. Therefore, in this study, the efficiency of crude oil contaminated soil remediation was tested by developing a pilot-scale thermal desorption system using the indirect heating method with an exhaust gas treatment. Under optimal condition drawed by temperature and retention time, the remedial efficiency of crude oil contaminated soil and treatability of exhaust gas were analyzed. Total Petroleum Hydrocarbon (TPH) concentration of crude oil contaminated soil was decreased to 69.7 mg/kg on average and the remedial efficiency was measured at 99.60%. Through the exhaust gas, 86.0% of Volatile Organic Compounds (VOC) was degraded and 97.16% of complex malodor was reduced under the suggested optimum operation condition. This study provides important basic data to be useful in scaling up of the indirect thermal desorption system for the remediation of crude oil contaminated soil.

• Particle and aerosol research
• /
• v.5 no.4
• /
• pp.159-170
• /
• 2009

A depth filter medium was newly designed in order to achieve high collection of dust and low pressure drop in this work. Multilayer depth filter media consist of an upstream layer of highly porous structure which allows particles to pass through and to follow by one or more downstream layers to hold the particles inside the media. For each filter media, flat sheet and pleated module were made of newly developed depth filter media and filter media of commercial products. Commercial depth filter cartridge for gas turbine air intake cleaning were used as reference for filtration area and pleat geometry of pleated modules. This work attempts to evaluate and compare the newly developed depth filter medium and two commercial filter media in terms of filtration parameters such as air permeability, initial pressure drop, particle retention and pressure drop variation with dust loading. According to the close examination the newly developed depth filter showed better performance compared to the commercial depth filter media.

• Microbiology and Biotechnology Letters
• /
• v.24 no.5
• /
• pp.597-603
• /
• 1996

This study was carried out to examine degradation characteristics of microalgae Chlorella vulgaris in methane fermentation. We measured COD and VS reduction, gas and methane productivity, VFA (volatile fatty acid), respectively. Then we calculated material balance and hydrolysis rates in soluble and solid material. The substrate concentration was controlled from 14 gCOD$_{cr}$/l to 64 gCOD$_{cr}$/l in batch cultures, and HRT (hydraulic retention time) controlled from 2 days to 30 days in continuous experi- ments. The results were as follows. In batch culture, accumulated gas productivity increased with the increase of the substrate concentration. The SS and VSS was removed all about 30% increase of substrate concentration and the most of the degradable material removed during the first 10 days. The curve of gas and methane production rate straightly increased until substrate concentration is 26 gCOD$_{cr}$/l. In continuous culture experiments, the removal rates at HRT 10days were 20% for total COD and TOC, respectively. At longer HRT, there was no increase in the removal efficiency. At HRT 15 days, the removal rates were 30% for SS and VSS, respectively. Soluble organic materials were rapidly degraded, and so there was no accumulated. Soluble COD concentration was not increase regardless of HRT-increasing. That meaned the hydrolysis was one of the rate-limiting stage of methane fermentation. The first-order rate constants of hydrolysis were 0.23-0.28 day$^{-1}$ for VSS, and 0.07-0.08 day$^{-1}$ for COD.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.45 no.6
• /
• pp.36-43
• /
• 2013

Effects of blending of PCC manufactured with emission gas occurred at mill on the characteristics of coating color, optical and printing properties of coated paper were investigated in order to evaluate the possibility of its use as a raw material for producing environmentally friendly coated paper. Low shear viscosity and water retention value of ground PCC 1(d50 = $6.303{\mu}m$) were higher than those of ground PCC 2(d50 = $3.149{\mu}m$). Ink set properties of ground PCC 1 and ground PCC 2 were inferior to that of PCC 3. Thus, the reducing of particle size was required in order to overcome the inferior ink set properties. Ground PCC 1 had a similar properties to clay, and it showed the possibility that ground PCC 1 could be used to produce matte grade coated papers. However, it was required to improve the stability(particle shape, particle size, and compatibility with chemicals used in coating color formulation) in the case of blending with GCC in order to keep the qualities of coated paper.