• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 하계학술대회 논문집 B
• /
• pp.673-675
• /
• 1995

A nonlinear process-model based control for main steam temperature control of a 100MW oil-fired drum-type fossil power plant is delveloped and its performances are compared to those of the conventional PID control. The process model for simulation is derived based "first priciple approach" and is validated in steady and transient conditions. The model is in good agreements with the field test data. Performances of the nonlinear PMBC for main steam temperature control are far superior to those of PID in all aspects for the disturbances of ramp increase in load and step change in fuel Btu value.

• 한국수소및신에너지학회논문집
• /
• 제27권5호
• /
• pp.612-619
• /
• 2016

Pitch synthesis reaction was studied based on the effect for chemical composition of feedstock. Feedstock was selected as pyrolyzed fuel oil (PFO) and coal-tar (CT), which are by-products in petroleum and steel industry. Pitch was prepared at $420^{\circ}C$ for 180 minutes on atmospheric pressure by thermal treatment. Thermal stability and softening point (SP) of the prepared pitches were investigated and their molecular weight distribution was analyzed by MALDI-TOF. PFO has various aliphatic compounds and coal-tar has high aromaticity with 3 wt% of primary quinoline insolubles. The thermal property of PFO was enhanced with polymerization reaction during the thermal treatment with increased molecular weight range. But CT was inferior to PFO because of side reaction by hetero elements. CTP was appeared molecular weight by 0~200 m/z.

• 한국분말재료학회지
• /
• 제12권2호
• /
• pp.151-158
• /
• 2005

Porous graphite was synthesized by removal of template in HF after pyrolysis of pyrolyzed fuel oil (PFO) at $900^{\circ}C$ using the template of Co or Ni intercalated magadiite. Porous graphite had a plate structure like template, and d-spacing value of about 0.7 nm. The extent of crystallization of porous graphite was dependent on the contents of Co or Ni intercalated in interlayer. It can be explained that the metal such as Co and Ni acts as a promotion catalyst for graphite formation. Porous graphite shows the surface area of $328\sim477 m^2/g$.

• Environmental Engineering Research
• /
• 제10권3호
• /
• pp.122-130
• /
• 2005

Gasification of carbonaceous wastes such as shredded tire, waste lubricating oil, plastics, and powdered coal initiates a single-stage reforming reactor(reformer) Without catalyst and a syngas burner. Syngas is combusted with $O_2$ gas in the syngas burner to produce $H_2O\;{and}\;CO_2$ gas with exothermic heat. Reaction products are introduced into the reforming reactor, reaction heat from syngas burner elevates the temperature of reactor above $1,200^{\circ}C$, and hydrogen gas fraction reaches 65% of the product gas output. Reactants and heat necessary for the reaction are provided through the syngas burner only. Neither $O_2$ gas nor steam is injected into the reforming reactor. Multiple syngas burners may be connected to the reforming reactor in order to increase the syngas output, and the product syngas is recycled into syngas burner.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2006년도 춘계학술대회
• /
• pp.29-32
• /
• 2006

Recently, many researches of the alternative and renewable energy have introduced due to the increasing oil price, the limited natural resources and the environmental pollution. In case of hydrogen energy, it has some merits, which can be substituted the existing the fossil fuel because of no contaminants from the combustion and the chemical reaction. We have been developing 1kW Hydrogen Linear Generator. In this paper, the thermal characteristic of this prototype linear generator has been investigated and obtained reliable analysis results comparing with experimental measurements. Especially, it is predicted that in case of 1kW, 60Hz test sample, the results satisfy with the temperature standards of H type insulation, which is shown average $69.0^{\circ}C$ temperature distribution at the coil.

• Corrosion Science and Technology
• /
• 제9권6호
• /
• pp.310-316
• /
• 2010

Recently a fuel oil of the diesel engine of the marine ship is being changed with heavy oil of low quality as the oil price is higher more and more. Therefore the wear and corrosion in all parts of the engine such as cylinder liner, piston crown, spindle and seat ring of exhaust valves are predominantly increased. In particular the degree of wear and corrosion of piston crown is more seriously compared to the other parts of the engine due to operating in severe environment such as the high temperature of exhaust gas and repeating impact. Thus the repair weldment of the piston crown is a unique method to prolong the its life in a economical point of view. In this case, filler metals having a high corrosion and wear resistance such as stellite 6, Inconel 625 and Inconel 718 are mainly being used for repair welding. However it has been often happened that piston crown on the ship,s job site is being actually inevitably welded with mild filler metals. Therefore in this study, filler metals such as E4301, E4313 and E4316 were welded at SS401 steel as the base metal, and corrosion property of their weld metals in the case of post weld heat treatment or not was investigated with some electrochemical methods such as measurement of corrosion potential, cathodic and anodic polarization curves, cyclic voltammogram and polarization resistance etc. in 0.1% $H_2SO_4$ solution. Corrosion resistance of the weld metal of E4301 was better than the other weld metals in the case of no heat treatment, however, its resistance was considerably decreased with post weld heat treatment(annealing:$625^{\circ}C$, 2 hr) compared to other weld metals. The weld metals of E4313 and E4316 showed a relatively good corrosion resistance by post weld heat treatment.

• KSBB Journal
• /
• 제25권5호
• /
• pp.483-489
• /
• 2010

Biodiesel has attracted great attention as an alternative renewable energy source for the replacement of petroleumbased diesel fuel, yet its high production cost due to expensive oil feedstock remainsas the major economical obstacle. In this study, we investigated catalysts and reaction conditions for the acid catalyzed pre-conversion of free fatty acid (FFA) to fatty acid methyl ester (FAME) in cheap low-grade oils of high acid value. The NaOH base catalyzed reaction of vegetable oil of the initial acid value of 2 mg KOH/g led to a high FAME conversion above 95.4%, but the conversion abruptly decreased at higher initial acid values. This base catalyzed reaction was practically ineffective displaying the FAME conversion below 15% even at the initial acid value of 10 mg KOH/g by the severe saponification side reaction. Among the various catalysts studied for the pre-conversion of FFA to FAME, Amberlyst-15 was the most effective in reducing the acid value, and the optimum reaction condition identified was $65^{\circ}C$ with oil to methanol ratio of 1:3 and catalyst concentration of 15% (w/w). As the results, great enhancements in the overall biodiesel conversion were achievable via a consecutive reaction of the acid catalyzed FFA pre-conversion to FAME under the optimal condition obtained with Amberlyst-15 followed by the NaOH base catalyzed reaction, far above the extent which was obtainable by the single NaOH catalyzed reaction.

• Mass Spectrometry Letters
• /
• 제14권2호
• /
• pp.42-47
• /
• 2023

Carthamus tinctorius L. (known as safflower) is a valuable oil plant whose importance is increasing rapidly in the world due to its high adaptation to arid regions. The seeds of this unique plant are especially used in edible oil, soap, paint, varnish and lacquer production. Its flowers are used in vegetable dye production and medicinal purposes beside its features as a coloring and flavoring in food. After the oil is removed, the remaining pulp and plant parts are used as animal feed, and dry straw residues are used as fuel. Beside all these features, its usage as a herbal medicinal plants for various diseases has gained importance on recent years. In this study, it was designed a plant metabolomic approach which transfers all the recent data processing strategies of untargeted metabolomics in clinical applications to the present study. Q-TOF LC/MS-based analysis of the extracts (70% ethanol, hexane, and chloroform) for both seed and flowers was performed using a C18 column (Agilent Zorbax 1.8 µM, 100 × 2.1 mm). Differences were observed in seed and fruit extracts and these differences were visualized using principal component analysis (PCA) plots. The total number and intersections of the peaks in the extracts were visualized using peak count comparison graph. Based on the experimental results, the number of the detected peaks for seeds was higher than the ones for the flowers for all solvent systems to extract the samples.

• 한국자원식물학회지
• /
• 제25권5호
• /
• pp.624-632
• /
• 2012

본 연구는 주요 구성지방산이 Oleic acid인 유채유, 동백유, 올리브유와 Palmitic acid가 주요 구성 지방산인 팜유를 기준으로 중량비로 혼합하여 지방산 조성 및 물성변화를 관찰 하였다. 지방산 조성의 변화를 전체적으로 살펴보면 50:50(w/w)비율에서는 Oleic acid은 유채유와 대두유의 혼합 시 42.8%로 가장 낮았고 동백유와 유채유의 혼합비율에서 72.1%로 가장 높았다. 75:25(w/w)유채유와 대두유 혼합비율에서 가장 낮았고 동백유와 올리브유의 혼합비에서 가장 높았다. 팜유를 기준으로 식물성 유지를 혼합하였을 시에는 다른 유지와 혼합 후 총 포화지방산은 감소하였다. 혼합 후 지방산 조절을 통한 산화안정성 및 저온에서의 유동성 개선이 기대 된다. 혼합 후 동백유 > 올리브유 > 유채유 순으로 산가 안전화 경향을 보였으며 이는 Oleic acid 함량에 따라 기인한 것으로 보인다. 또한 혼합을 통한 산화안정성을 개선시킬 수 있을 것으로 판단되며, 색도는 비율 및 유지에 따른 유의적인 변화를 보이지는 않았으나 바이오디젤 생산 정제공정에 있어서 혼합비율 조절에 따른 정제비용 절감이 기대 된다. 본 연구를 통하여 유지간 혼합에 의한 특성변화를 확인하고, 혼합유의 원료 다양성 확보 및 품질개선을 위한 정보를 얻어 향후 연구수행의 기초자료로 활용이 가능할 것으로 생각된다.

• 한국유기농업학회지
• /
• 제20권3호
• /
• pp.267-282
• /
• 2012

In this study, RPS system, one of the renewable energy support systems, is utilized for economic analysis of solar generation equipment and the fuel cost savings plan for controlled horticulture farms with high fuel-cost dependency and facility applicability were evaluated. On the exterior of the upper layer of glass greenhouse (9917$m^2$) of controlled horticulture farms using bunker C oil, half of the area (4958$m^2$) was utilized for theoretical installation and operation of 450kW-level solar power generator, and as the result, first, the effect of investment cost only of solar generation system was found to be quite excellent, but it was analyzed that there were limits to saving the fuel costs of the controlled horticulture farms. Second, when geothermal system was first introduced in the farm and solar system was additionally introduced, it was analyzed that the effect of introducing solar system was excellent. In order to apply such effects to the sites of farming, partial supplementation of RPS system which is being uniformly applied regardless of the purpose of renewable energy is necessary. When the subject of use directly install facilities where it is directly connected to national added-value such as food security created by the farming industry, it is necessary to introduce appropriate system that corresponds to such. Moreover, it was studied that the quick development of demonstrative complex that can practically evaluate the applicability of renewable energy in farming industry and interest and preparation of related institutions in financial support structure for its site application would lead to success.