• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2003년도 춘계전력전자학술대회 논문집(2)
• /
• pp.987-993
• /
• 2003

The module UPS can flexibly implement expansion of power system capacities. Furthermore, it can be used to build up the parallel redundant system to improve the reliability of power system operation. To realize the module UPS, load sharing without interconnection among parallel connecting modules as well as a small scale and lightweight topology is necessary. In this paper, the three-arm converter/inverter is compared with the general full-bridge and half-bridge topology from a practical point of view and chosen as the module UPS topology. The switching control approaches based on a pulse width modulation of the converter and inverter of the system are presented independently The frequency and voltage droop method is applied to parallel operation control to achieve load sharing. Two prototype 3kVA modules are designed and implemented to confirm the effectiveness of the proposed approaches. Experimental results show that the three-arm UPS system has a high power factor, a low distortion of output voltage and input current, and good load sharing characteristic.

• International Journal of Automotive Technology
• /
• 제7권2호
• /
• pp.173-177
• /
• 2006

A noise transfer function(NTF) is the frequency response function between an input force applied to an exterior point of a vehicle body and the resultant interior sound pressure usually measured at the driver's ear position. It represents the measure of noise sensitivity for the output force transmitted to the joints between the body and chassis. The principle of vibro-acoustic reciprocity is often utilized in the measurement of NTF. One difficulty in using the volume source is that most of the previously proposed methods require the knowledge of the volume velocity of the acoustic source in advance. A new method proposed in the present work does not require any calculation related with the volume velocity of the acoustic source, but still yields even more accurate results both in the amplitude and phase of the NTF. In the present work, the new method is applied to obtain NTF data for a midsize sedan.

• KIEE International Transactions on Electrophysics and Applications
• /
• 제5C권5호
• /
• pp.204-210
• /
• 2005

Alternating current (AC) losses of two Bi-2223 ([Bi, Pb]: Sr: Ca: Cu: O = 2:2:2:3) tapes [(Tape I, un-twist-pitch) and the other with a twist-pitch of 10 mm (Tape II)] were measured and compared. These samples, produced by the powder-in-(Ag) tube (PIT) method, are multi-filamentary. Also, it's produced by non-twist and different twist pitch (8, 10, 13, 30, 50 and 70 mm). The critical current measurement was carried out under the environment in liquid Nitrogen and in zero-field by 4-probe method. Susceptibility measurements were conducted while cooling in a magnetic field. Flux loss measurements were conducted as a function of ramping rate, frequency and field direction. The AC flux loss increases as the twist-pitch of the tapes decreased, in agreement with the Norris Equation. Neutron-diffraction measurements have been carried out investigate the crystal structure, magnetic structures, and magnetic phase transitions in Bi-2223([Bi, Pb]:Sr:Ca:Cu:O)

• 한국음향학회:학술대회논문집
• /
• 한국음향학회 1996년도 제11회 수중음향학 학술발표회 논문집 11th Underwater Acoustics Symposium Proceedings
• /
• pp.9-12
• /
• 1996

This paper introduces an analysis of the non-axisymmetric mode due to in-plane vibration of an annular type piezoelectric actuator using FEM(Finite Element Method). The actuator is used as stator of ultrasonec motor. The freqrency charecterisrics and non-axisymmetric mode of the annular piezoelectric acruator are considered at a steady-state condition. The non-axisymmetric mode is occured by two sinusodial voltage sources with $\pi$/2 phase difference on the time domain. The resonant frequency of non-axisymmetric of non-axisymmetric mode is 60.358 kHz and 59.880 kHz for calculation and measurement, respectivly. The error was 0.8% between calculation and measurement. The revolution of the non-axisymmetric mode for actuator is analized at a period of exciting voltage sources using annimation. It is confirmed that the actuator has an usefulness as the stator of ultrasonic motor and the preposed method has a properity.

• 제어로봇시스템학회논문지
• /
• 제19권10호
• /
• pp.879-885
• /
• 2013

By performing interval analysis on the system transfer function, we propose an improved method of control loop design for a DC/DC converter. In conventional design methods, the effect of system parameter change due to the specified range of operating conditions and production tolerances in power components should be checked a posteriori, because this may result in a transfer function shift and performance degradation. In the proposed method, a possible parameter change is considered a priori in the design step in order that the desired crossover frequency and sufficient phase margin can be achieved even in the worst case condition. As an illustrative example, a buck dc/dc converter is designed by two different methods and performance comparisons are performed to verify the feasibility of the proposed scheme.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 하계학술대회 논문집 B
• /
• pp.1224-1226
• /
• 2000

In this paper, load paralleled type FB series resonant inverter of a new novel type is proposed. In the output control method, phase-shift driving signal control method with CVCF introduces. Also by driving signal patterns, the operation principle of the proposed circuit in detail is described and its characteristics are compared on separated ratio(n). According to each the mode in order to the analysis and characteristic evaluation of the circuit state equations are derived and presented using normalized parameter. To verify the theoretical analysis result, experimental results are provided.

• Structural Engineering and Mechanics
• /
• 제62권2호
• /
• pp.171-178
• /
• 2017

Nonlinear vibrations of an Euler-Bernoulli beam resting on a nonlinear elastic foundation are discussed. In search of approximate analytical solutions, the classical multiple scales (MS) and the multiple scales Lindstedt Poincare (MSLP) methods are used. The case of primary resonance is investigated. Amplitude and phase modulation equations are obtained. Steady state solutions are considered. Frequency response curves obtained by both methods are contrasted with each other with respect to the effect of various physical parameters. For weakly nonlinear systems, MS and MSLP solutions are in good agreement. For strong hardening nonlinearities, MSLP solutions exhibit the usual jump phenomena whereas MS solutions are not reliable producing backward curves which are unphysical.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 1998년도 춘계종합학술대회
• /
• pp.351-358
• /
• 1998

This paper deals with the underwater image transmission system which includes in AUV(Autonomous Underwater Vehicle) Project(that is VORAM(Vehicle for Ocean Research And Monitoring)), developed by KIMM for survey and investigation of a sea-bed through transmitting the underwater image to the mother ship. The system presented in this paper consists of a transducer which has a 136KHz center frequency and it's 10KHz bandwidth, pre-amplifier, $\pi$/4 QPSK(Quadreature Phase Shift Keying) modulation/demodulation method, image compressing method using JPEG technique and modified Stop & protocol. The experimental results of the system is verified to a high performance with 9600 bps for transmitting the underwater image through the basin test. The results of test are also verified which allows to desirable transmission performance compared with the existing developed system and the possibility to put the practical use of survey and investigation. And, the viterbi coding and adaptive equalizer for cancelling the multipath effect are developing for more effective image transmission system. Also, these technique will very effectively adapt to realtime image transmission system.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 제36회 하계학술대회 논문집 B
• /
• pp.1477-1479
• /
• 2005

In this paper, we proposed the electric circuit using one common arm of H-Bridge inverters to reduce the number of switching component in multi-level inverter combined with H-Bridge Inverters and Transformers. and furthermore we suggested the new multi-level PWM inverter using PWM level to reduce THD(Total Harmonic Distortion) and we used the switching method that can be same rate of usage at each transformer. Also, we tested the proposed prototype 15-level inverter to clarify the proposed electric circuit and reasonableness of control signal for the proposed multi-level PWM inverter.

• 한국운동역학회지
• /
• 제13권2호
• /
• pp.29-47
• /
• 2003

This study is to analyze the kinematic variables in release motion of discuss throwing. For the matter, 5 people from the national team and collegiate discuss throwing in the year 2001 were chosen as the subjects and two S-VHS video cameras set in 60frames/sec were used for recording their motions. Coordinated raw positions data through digitizing are smoothing by butter-worth 's low-pass filtering method at a cut off frequency 6.0Hz. and the direct linear transformation(DLT) method was employed to obtain 3-D position coordinates. The conclusions were as follows; 1. The better record players showed the shorter approach time in the last support phase. 2. In the displacement CG, the better record players showed the shorter displacement in medial-lateral direction, and the longer displacement in horizontal direction. In the motion, the COG showed longer displacement vertical direction. 3. The better record players showed the faster horizontal velocity than vertical velocity in the release. 4. The better record players showed to take the posture of vertical axis in the release.