• Korean Journal of Agricultural and Forest Meteorology
• /
• v.4 no.2
• /
• pp.127-132
• /
• 2002

All the countries in RA II (Asia Region in WMO) welcome the establishment of a Web site dedicated to agricultural meteorology, because it is believed that the best way to improve and speed up the flow of information is the use of the Internet and the establishment of a Web site. In providing recommendation for the promotion and improvement of the AgroMeteorological service in RA II, a couple of key suggestions were proposed: (a) Exchanges of data and AgroMeteorological knowledge between member countries and between RAs, (b) Exchanges of experts between member countries as a necessary way to share the knowledge, and (c) Joint research between member countries to solve common problems in AgroMeteorological affairs. In order to meet the above requirements for RA II, an AgroMeteorological information network will be the most critical and dynamic aspect in sustainable agriculture in this region. In addition, the establishment of a Core AgroMeteorological station, recommended by CAgM of WMO, will require its own information sharing systems for communication among member countries. Inevitable use of information technologies (IT) such as information networks, databases, simulation models, GIS, and RS for regional impact assessment of environmental change on AgroEcosystem will be enforced. Thus, the regional Internet-based Agrometeorological information network has been in place since 1999, though all contributions to it have been volunteered by individuals, institutes, universities, etc.

• Journal of Communications and Networks
• /
• v.18 no.4
• /
• pp.559-566
• /
• 2016

Software defined network (SDN) can effectively improve the performance of traffic engineering and will be widely used in backbone networks. Therefore, new energy-saving schemes must take SDN into consideration; this action is extremely important owing to the rapidly increasing energy consumption in telecom and Internet service provider (ISP) networks. Meanwhile, the introduction of SDN in current networks must be incremental in most cases, for technical and economic reasons. During this period, operators must manage hybrid networks in which SDN and traditional protocols coexist. In this study, we investigate the energy-efficient traffic engineering problem in hybrid SDN/Internet protocol (IP) networks. First, we formulate the mathematical optimization model considering the SDN/IP hybrid routing mode. The problem is NP-hard; therefore, we propose a fast heuristic algorithm named hybrid energy-aware traffic engineering (HEATE) as a solution. In our proposed HEATE algorithm, the IP routers perform shortest-path routing by using distributed open shortest path first (OSPF) link weight optimization. The SDNs perform multipath routing with traffic-flow splitting managed by the global SDN controller. The HEATE algorithm determines the optimal setting for the OSPF link weight and the splitting ratio of SDNs. Thus, the traffic flow is aggregated onto partial links, and the underutilized links can be turned off to save energy. Based on computer simulation results, we demonstrate that our algorithm achieves a significant improvement in energy efficiency in hybrid SDN/IP networks.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.1B
• /
• pp.29-40
• /
• 2004

In this paper, we propose a new early congestion detection and notification technique called QR-AQM. Unlike RED and it's variation, QR-AQM measures the total traffic rate from TCP sessions, predicts future network congestion, and determine the packet marking probability based on the measured traffic rate. By incorporating the traffic rate in the decision process of the packet marking probability, QR-AQM is capable of foreseeing future network congestion as well as terminating congestion resolution procedure in much more timely fashion than RED. As a result, simulation results show that QR-AQM maintains the buffer level within a fairly narrow range around a target buffer level that may be selected arbitrarily as a control parameter. Consequently, compared to RED and its variations, QR-AQM is expected to significantly reduce the jitter and delay variance of packets traveling through the buffer while achieving nearly identical link utilization.

• Journal of the Institute of Convergence Signal Processing
• /
• v.12 no.3
• /
• pp.157-162
• /
• 2011

This study is about implementing wireless transferring system in pre-hospital cardiopulmonary resuscitation(CPR). Also, this study includes monitoring based feedback between patient and hospital to increase the survival rate of emergency patient by developing the performance of cardiopulmonary resuscitation in pre-hospital. It minimizes the loss of flow rate or gastric inflation through the space between the airway and the esophagus, which enables the inspiration-expiration rate to be measured more precisely. Due to these reasons this study applied ET insertion based respiratory sensor to measure flow rate. The main indices of artificial ventilation are justified from minute respiration(V), end-tidal $CO_2(E_TCO_2)$, and tracheal pressure($P_{tr}$). The simulation is performed to verify the bandwidth and delay time of transport network for in-hospital monitoring even as transporting images and voice information simultaneously. The total bandwidth is 815 kbps, and WLAN (IEEE 802.11x) is used as communication protocol. The network load is under 1.5% and the transmit delay time is measured under 0.3 seconds.

• Proceedings of the KIEE Conference
• /
• 2006.07b
• /
• pp.1203-1204
• /
• 2006

Recently, utility network is getting more and more complicated and huge. In addition to, demands of power conversion devices which have non-linear switching devices are getting more and more increased. Consequently, according to the non-linear power semiconductor devices, current harmonics are unavoidable. Those current harmonics flow back to utility network and become one of the reasons which make the voltage distortion. On the other hands, voltage sag from sudden increasing loads is also one of the terrible problems inside of utility network. In order to compensate the current harmonics and voltage sag problem, AF(Active Filter) systems could be a good solution method and SMES(Superconducting Magnetic Energy Storage) system is a very good promising source due to the high response time of charge and discharge. Therefore, the combined system of AF and SMES is a wonderful device to compensate both harmonics current and voltage sag. However, unfortunately SMES needs a superconducting magnetic coil. Because of the introduction of superconducting magnetic coil, quench problem caused by unexpected reasons is always existed. In case of discharge operation, quench is a significantly harmful factor according as it decreases the energy capacity of SMES. Therefore, this paper presents a decision method of the specification of the AF-SMES system considering internal fault condition. Especially, authors analyzed the change of the original energy capacity of SMES regarding to the size of resistance caused by quench of superconducting magnetic coil. Finally, based on this simulation, authors manufactured actual Active Filter System using DSP.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.5
• /
• pp.1-6
• /
• 2007

In wireless mesh networks (WMNs), the end-to-end throughput of a flow decreases drastically according to the traversed number of hops due to interference among different hops of the same flow in addition to interference between hops of different flows with different paths. This paper proposes a distributed multi-channel assignment scheme based on hops (DMASH) to improve the performance of a static WMN. The proposed DMASH is a novel distributed multi-channel assignment scheme based on hops to enhance the end-to-end throughput by reducing interference between channels when transmitting packets in the IEEE 802.11 based multi-interface environments. The DMASH assigns a channel group to each hop, which has no interference between adjacent hops from a gateway in channel assignment phase, then each node selects its channel randomly among the channel group. Since the DMASH is a distributed scheme with unmanaged and auto-configuration of channel assignment, it has a less overhead and implementation complexity in algorithm than centralized multi-channel assignment schemes. Simulation results using the NS-2 showed that the DMASH could improve remarkably the total network throughput in multi-hop environments, comparing with a random channel assignment scheme.

• Journal of Korean Society of Transportation
• /
• v.19 no.3
• /
• pp.101-113
• /
• 2001

Since late 1970s. one of the principal research areas in transportation problem is dynamic traffic assignment (DTA). Although many models have been developed regarding DTA, yet they have some limits of describing real traffic patterns. This reason comes from the fact that DTA model has the time varying constraints such as state equation, flow propagation constraint, first in first out(FIFO) rule and queuing evolution. Thus, DTA model should be designed to satisfy these constraints as well as dynamic route choice condition, dynamic user equilibrium. In this respect, link-based DTA models have difficulty in satisfying such constraints because they have to satisfy the constraints for each link, while path-based DTA models may easily satisfy them. In this paper we develop a path-based DTA model. The model includes point queue theory to describe the queue evolution and simulation loading method for depicting traffic patterns in more detail. From a numerical test, the model shows promising results.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.37 no.6
• /
• pp.10-21
• /
• 2000

The Cellular Noninear Networks structure for Distance Transform(DT) and the robust optical flow detection algorithm based on the DT are proposed. For some applications of optical flows such as target tracking and camera ego-motion computation, correct optical flows at a few feature points are more useful than unreliable one at every pixel point. The proposed algorithm is for detecting the optical flows on the trajectories only of the feature points. The translation lengths and the directions of feature movements are detected on the trajectories of feature points on which Distance Transform Field is developed. The robustness caused from the use of the Distance Transform and the easiness of hardware implementation with local analog circuits are the properties of the proposed structure. To verify the performance of the proposed structure and the algorithm, simulation has been done about various images under different noisy environment.

• Korean Institute of Interior Design Journal
• /
• v.24 no.5
• /
• pp.128-135
• /
• 2015

The purpose of this study is to propose a planning method for increasing visitors' usage attraction by understanding user circulation in the large scale commercial complex. Focusing on the impact of anchor tenant on the pedestrian traffic arousing visitors' usage attraction flow, this study analyzed pedestrian circulation and traffic volume of Lotte World Mall, a large scale commercial complex. In this study, the change of pedestrian traffic in the commercial complex was investigated and the circulation flow of anchor tenant visitors such as movie theater in the commercial complex was simulated by computer. By analyzing both characteristics of pedestrian circulation and traffic volume in large scale commercial complex and movie theater users' pedestrian traffic with network-based computer simulation, positive relationship between pedestrian traffic to movie theater and pedestrian traffic dispersion of the whole commercial complex users was emerged. In addition, It is necessary to plan of distributing pedestrian traffic of vertical moving line in central space appropriately for using attraction function of anchor tenant.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.57 no.10
• /
• pp.1726-1730
• /
• 2008

In this paper, the application schemes for coordinated control system of multiple FACTS were presented to enhance the voltage stability around the metropolitan areas. In order to coordinated control of FACTS devices, f-V analysis method which is one of the indices for voltage stability was performed with real time network data which is transferred from SCADA/EMS system. If the system is unstable after contingencies, the new operation set-point of FACTS would be determined using bus sensitivity from tangent vector at voltage instability point. Otherwise, we would determine the new operation set-point of FACTS for considering economical operation, like as active power loss minimization using Optimal Power Flow algorithm. In simulation, the SCADA/EMS 2007's data are used for studying the coordinated control algorithm of multiple FACTS devices that is installed or will be installed in KOREA power system